Ignition and burning rates of segregated waste combustion in packed beds

Recent developments in national recycling and re-use programmes for municipal waste have led to segregation of an increasing proportion of waste to enhance material recovery. Several of the segregated streams contain materials that can not viably be re-used or recycled but can be used for energy recovery. In this study, the combustion of cardboard and waste wood was investigated in a small-scale packed bed reactor in order to provide fundamental data for the design/operation of moving bed furnaces. Key parameters of combustion including the ignition and burning rates were evaluated for various air flowrates and compared to the modelling results. Two successive stages of combustion were identified for both samples: the propagation of ignition front into the bed and combustion of the fuel above the ignition front. The burning rate of cardboard reached a peak of about 300 kg/m(2)h at the air flowrate of 936 kg/m(2)h and decreased at higher air flowrates. For waste wood, both the ignition and burning rates increased in the tested range of the air flowrate up to 702 kg/m(2)h, of which the values were very close to those for the cardboard. The model prediction was in good agreement with the test results for waste wood. However, the burning rate for cardboard was under-predicted due to strongly irregular shapes of the fuel.     

Waste polyvinylchloride derived pitch as a precursor to develop carbon fibers and activated carbon fibers

Polyvinylchloride (PVC) was successfully recycled through the solvent extraction from waste pipe with an extraction yield of ca. 86%. The extracted PVC was pyrolyzed by a two-stage process (260 and 410 degrees C) to obtain free-chlorine PVC based pitch through an effective removal of chlorine from PVC during the heat-treatment. As-prepared pitch (softening point: 220 degrees C) was spun, stabilized, carbonized into carbon fibers (CFs), and further activated into activated carbon fibers (ACFs) in a flow of CO2. As-prepared CFs show comparable mechanical properties to commercial CFs, whose maximum tensile strength and modulus are 862 MPa and 62 GPa, respectively. The resultant ACFs exhibit a high surface area of 1200 m2/g, narrow pore size distribution and a low oxygen content of 3%. The study provides an effective insight to recycle PVC from waste PVC and develop a carbon precursor for high performance carbon materials such as CFs and ACFs.     

Catalytic activity of Ru/Al2O3 for ozonation of dimethyl phthalate in aqueous solution

With dimethyl phthalate as the model pollutant and Ru/Al(2)O(3) as catalyst, this paper systemically investigates the removal of total organic carbon (TOC) of system. Our results have confirmed that Ru/Al(2)O(3) can significantly increase the effect of ozonation. TOC removal in 120 min can reach 72% while only 24% with ozone alone. The optimal catalyst preparing condition was 0.1 wt% Ru content, 600 degrees C calcination temperature, 0.5-1.0mm particle diameter, which is characterized by a high surface area and a large population of surface active sites. The contrasting experiments of ozone alone, catalyst adsorption after ozonation, and catalytic ozonation confirmed that catalytic reaction was the most important process to TOC removal in system with Ru/Al(2)O(3) as catalyst.     

Monitoring of organochlorine pesticides using PFU systems in Yunnan lakes and rivers, China

Polyurethane foam unit (PFU) systems were collected from 11 lakes and three rivers in the Yunnan Plateau, China and, the PFU extrusion liquids were analyzed for organochlorine pesticides (OCPs) by gas chromatography with electron capture detection (GC-ECD). The concentrations of pp'-DDE, HCB and HCHs were undetectable to 1.86 microgl-1 (mean 0.27 microgl-1), undetectable to 0.72 microgl-1 (mean 0.11 microgl-1), and 0.24-21.95 microgl-1 (mean 7.39 microgl-1) respectively in lakes; and those in rivers were undetectable to 0.23 microgl-1 (mean 0.08 microgl-1), 0.68-2.93 microgl-1 (mean 1.70 microgl-1), and 2.71-37.56 microgl-1 (mean 17.01 microgl-1) respectively. Notably, some residue levels of OCPs exceeded the US National Recommended Water Quality Criteria, implying Yunnan has levels of OCPs potentially harmful to human health. Further, the contamination by OCPs showed an obvious spatial distribution pattern. Amongst the lakes, Dianchi, Xingyun, Lugu and Yangzonghai had the highest OCP levels dominated by beta-HCH, whereas among rivers, Nujiang and Lancang Rivers had the highest contents of OCPs dominated by alpha-HCH. This demonstrates that HCHs are the predominant contaminants and some point sources of HCHs may still exist in Yunnan. The pollution levels in Yunnan were compared with other studies, suggesting the PFU method is suitable for long-term on-line monitoring of trace OCPs in aquatic ecosystems. Therefore, continuous studies monitoring OCPs in lakes and rivers are needed to further understand the future trend of contamination.     

Sample storage and extraction efficiencies in determination of polycyclic and nitro musks in sewage sludge

Analytical technology is continuously improving, developing better methods for isolating and concentrating trace compounds in environmental samples. Polycyclic and nitro musks (PNMs) are one group of emerging trace compounds detected in municipal wastewater. Differences in sample storage, preparation, and extraction methods for their measurement have led to variability in results. We analyzed 11 PNMs by GC/MS and compared the results of different storage times and extraction methods (supercritical fluid (SFE) or microwave-assisted (MAE)) for 202 samples of primary sludge, waste activated sludge (WAS), raw sludge, and aerobically/anaerobically digested biosolids collected from Canadian municipal wastewater treatment plants. Sixty-three air-dried samples were extracted by SFE, and 139 air-dried, centrifuged, or filtered samples were extracted by MAE. The mean surrogate recoveries were 89% (standard deviation (SD)=11%) for d(10)-anthracene by SFE and 88% (SD=14%) for d(10)-phenanthrene by MAE. Storage study results showed that PNM concentrations changed by a mean of 7% and 9% for primary sludge and WAS respectively after four weeks and decreased up to 25% after 13.5 months of storage in amber glass containers at -18 degrees C. Air-drying of sludge at room temperature caused losses of about 50% of PNM concentrations compared to centrifugation. The proportions of PNMs present in the liquid phase of sludge samples were less than 5% compared to proportions in the sludge solids. The most complete liquid-solid separation was achieved by filtration of frozen/thawed sludge samples, producing a liquid phase that contained less than 1% of the total musk content of the sample.     

Influence of start-up on PCDD/F emission of incinerators

This study aims to evaluate the influence of start-up on polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) concentration in the stack flue gas of incinerators and its contributing PCDD/F emission. The PCDD/F emission of the first sample among three consecutive stack flue gas samples of five intermittent incinerators, which sampled at a stable combustion condition after start-up, is 2-3 times higher than the mean of the others. For verifying the PCDD/F characteristics of incinerators during start-up, one continuous MSWI was investigated for two years. The elevated PCDD/F emissions of the MSWI during start-up could reach 96.9 ng I-TEQN m(-3) and still maintained a high PCDD/F emission (40 times higher than the Taiwan emission limit) even 18 h after the injection of activated carbon, indicating the memory effect. Taking the MSWI for example, which consists of four incinerators, the estimated annual PCDD/F emission from normal operational conditions was 0.112 g I-TEQ. However, one start-up procedure can generate approximately 60% of the PCDD/F emissions for one whole year of normal operations. And the PCDD/F emission, which is the result of the start-ups of four incinerators, was at least two times larger than that of a whole year's normal operations, without consideration for the PCDD/F emission contributed by the long lasting memory effect.     

Influences of metals on kinetics of methyl tert-butyl ether biodegradation by Ochrobactrum cytisi

The influence of zinc, manganese, and nickel on the degradation of MTBE (methyl tert-butyl ether), by an aerobic MTBE-degrading strain, Ochrobactrum cytisi, were investigated. The result showed that unlike previous findings, O. cytisi was able to degrade MTBE through direct metabolism when MTBE was present as the only carbon source. The degradation rate of MTBE was rapid, completed within 80 h. MTBE biodegradation by this strain was stimulated at low concentrations of Zn(2+) (1-5 mg l(-1)) and Mn(2+) (1-5 mg l(-1)) but inhibited at high concentrations of Zn(2+) (20 mg l(-1)) and Mn(2+) (20 mg l(-1)), and at low concentration of Ni(2+) (1-4 mg l(-1)). Kinetic parameters for MTBE degradation in the presence or absence of metals were obtained through nonlinear regression and a least-square minimization procedure. In all cases, a good agreement was achieved between kinetic simulations and experimental results.     

Effects of pH, organic acids, and competitive cations on mercury desorption in soils

The effects of pH, organic acids, and competitive cations on Hg(2+) desorption were studied. Three representative soils for rice production in China, locally referred to as a yellowish red soil (YRS), purplish clayey soil (PCS), and silty loam soil (SLS) and classified as Gleyi-Stagnic Anthrosols in FAO/UNESCO nomenclature, were, respectively, collected from Jiaxin County, Deqing County, and Xiasha District of Hangzhou City, Zhejiang Province. Most of the added Hg(2+) was adsorbed at low initial concentrations (<2 mg l(-1)). Desorption of the adsorbed Hg(2+) in 0.01M KCl (simulating soil solution) was minimal, but was significantly enhanced by the change of pH, and the presence of organic acids or competitive cations. The desorption of Hg(2+) in the soils decreased with pH from 3.0 to 5.0, leveled off at pH 5.0-8.0, but increased with pH from 7.0 to 9.0. The presence of organic ligands enhanced Hg(2+) desorption in the soils except for YRS, in which the addition of tartaric, malic, or oxalic acid reduced Hg(2+) desorption at low concentrations (<10(-4)M), but Hg(2+) desorption generally increased with organic acid concentration. Citric acid was most effective in increasing Hg(2+) desorption, followed by tartaric acid and malic acid; and oxalic acid was the least effective. Desorption of adsorbed Hg(2+) increased with increasing concentrations of added Cu(2+) or Zn(2+). Applied Cu(2+) increased Hg(2+) desorption more than Zn(2+) at the same loading rate. CAPSULE: The effects of organic acids and competitive cations on Hg desorption in soil-water system are related to their concentrations, basic chemical properties, and soil properties.     

Well water contaminated by acidic mine water from the Dabaoshan Mine, south China: chemistry and toxicity

An investigation into well water quality was carried out in a rural area subject to irrigation with acidic mine water from the Guangdong Dabaoshan Mine, southern China. The results of water pH measurements from 112 wells in two different seasons suggest that the well water has been contaminated to varying degrees in the investigated Shangba floodplain (approximately 11km south of the Guangdong Dabaoshan Mine). There is a trend that well water pH increased southwards, suggesting that the impacts of acidic irrigation water on groundwater decreased with increasing distance to the entry point of acidic irrigation water. Water quality monitoring results of the selected wells show that Cu and Cd in the water exceeded the limits set in the Chinese National Standards for Drinking Water (GB 5749-85) for the wells close to the irrigation water source. If the World Health Organization (WHO) standard was considered, Cd in some wells was almost 10 times as high as the WHO guideline value (0.003mg l(-1)). Water collected from the location closest to the acidic irrigation water source was acutely toxic to the test organism (Daphnia carinata) even after 51 time dilution. It is likely that the extremely high mortality rate of the local population reported for the study area is at least partly related to the high levels of heavy metals, particularly Cd in the drinking well water.     

Bioavailability to grains of rice of aged and fresh DDD and DDE in soils

DDT had been widely used around the world before 1980s and is still under production and use for non-agricultural purposes in China. Because of their special physicochemical properties, p,p'-DDT and its main metabolites, p,p'-DDD and p,p'-DDE, accumulated and persisted in the environment, presenting potential menace on biota. A green-house study was conducted to determine the bioavailability of p,p'-DDD and p,p'-DDE to grains of rice and the influences of traditional Chinese farming practices on their bioaccumulation. Paddy rice and dry rice were grown in submerged paddy soils and non-submerged upland soils, respectively. Two types of soil, Hydragric Anthrosols (An) and Hydragric Acrisols (Ac), were employed. Bioaccumulation factors (BAFs) of DDE ranged from 0.67 for rice grown in non-submerged An to 0.84 in submerged An in the control group, whilst BAFs were all below 0.04 in experimental groups. BAFs of DDD varied from 1.39 for submerged An to 2.26 for submerged Ac in original soils. In contrast, BAFs were between 0.05 for non-submerged Ac and 0.08 for submerged An in DDD-contaminated soils. Flooding seemed to have two contradictory effects on the DDE/DDD accumulation by rice: on one hand, it made the pollutants more mobile and bioavailable; while on the other hand, it enhanced the degradation and binding of POPs. Adding rice straw to the soils protected DDE from being taken up yet promoted DDD accumulation by rice. Furthermore, the distinct inorganic component of the soils might also play an important role in the environmental activities of POPs.