Selecting objectively defined reference sites for stream bioassessment programs

Our study develops and demonstrates an objective method for selecting reference sites for the assessment of ecological condition in freshwater ecosystems. The method uses widely available GIS data to group potential sites based on their natural environments. It then establishes the degree and types of human activities each site is exposed to prior to scoring the sites in each group by the relative amount of human activity present. Finally, the sites in each group with the least amount of human activity are categorized as reference sites, with the boundary between reference and test sites defined to maximize the distinctiveness of the two categories with respect to human activity. Application of this technique for the purpose of identifying headwater reference basins in rural areas of southwestern Ontario resulted in the classification of basins into six natural groups based on the dominant texture of the surface geology. Development of a human activity gradient indicated that basins varied according to the amount of exposure to agricultural activities with most basins having at least moderate exposure. Establishment of the reference test boundary indicated that the selected reference basins exhibited substantively lower extents of agricultural activity than test sites for most groups. Because this method uses only widely available GIS data, it enables rapid and cost-effective identification of candidate reference sites, even for large, remote, and understudied regions.     

Classical indicators in the 21st century--far and beyond the coliform.

Indicators have been used for many years to designate the microbiological quality of water. In 1914, the U.S. Public Health Service set a standard that required that drinking water show no evidence of coliform organisms (U.S. Treasury Department, 1914). Today, almost 100 years later, drinking waters in the United States must meet the standards established in the Total Coliform Rule, which requires that drinking water show no evidence of the presence of total coliform bacteria in 100 mL of water (U.S. EPA, 1989). However, as limitations with the use of coliforms have become apparent and the applications for indicator microorganisms have expanded, new indicators have been proposed and, in some cases, adopted, for specific purposes, as discussed in detail in a number of recent reports (i.e., National Research Council, 2004; World Health Organization, 2003).     

Assessing the relation between the distribution of salt-marsh communities and the sediment budget of the North Norfolk coast

Very high resolution imagery from an airborne multi-spectrål scanner has been used to estimate the distribution of different salt-marsh communities along a 30-km stretch of the North Norfolk coast. Field observations have been used to develop a mathematical relationship between the vegetation, physical environment and sediment accumulation. This relationship has been used to produce provisional sediment accretion maps for the north Norfolk coast.     

Optimal Advanced Credit Releases in Ecosystem Service Markets

Ecosystem service markets are popular policy tools for ecosystem protection. Advanced credit releases are an important factor affecting the supply side of ecosystem markets. Under an advanced credit release policy, regulators give ecosystem suppliers a fraction of the total ecosystem credits generated by a restoration project before it is verified that the project actually achieves the required ecological thresholds. In spite of their prominent role in ecosystem markets, there is virtually no regulatory or research literature on the proper design of advanced credit release policies. Using U.S. aquatic ecosystem markets as an example, we develop a principal–agent model of the behavior of regulators and wetland/stream mitigation bankers to determine and explore the optimal degree of advance credit release. The model highlights the tension between regulators’ desire to induce market participation, while at the same time ensuring that bankers successfully complete ecological restoration. Our findings suggest several simple guidelines for strengthening advanced credit release policy.     

Effect of combined application of methyl isothiocyanate and chloropicrin on their transformation

Combining several soil fumigants to increase the broad spectrum of pest control is a common fumigation practice in current production agriculture. In this study, we investigated the effect of combined application of chloropicrin and methyl isothiocyanate (MITC) on their transformations and persistence in the environment. In aqueous solution, no direct reaction between MITC and chloropicrin occurred and relatively slow rates of hydrolysis of these compounds were observed in aquatic environments free of suspended solids. The transformation of chloropicrin, however, was accelerated in aqueous solution with MITC because of a reduction reaction with bisulfide (HS(-)), which is a by-product of MITC hydrolysis. In soil, when fumigants were applied simultaneously, the degradation of MITC was suppressed under the bi-fumigant application due to the inhibition of soil microbial activity and a possible abiotic competition with chloropicrin for a limited number of reaction sites on the surface of soil particles. However, the degradation rate of chloropicrin was significantly enhanced in the bi-fumigant soil system, which was primarily attributed to the reaction of chloropicrin and HS(-). Two sequential application approaches were developed to investigate the feasibility of the combined application of metam sodium (parent compound of MITC) and chloropicrin in soil and assess their potential effects on environmental fate. For both application sequences, the degradation of chloropicrin was accelerated and that of MITC, as a major breakdown product of metam sodium, was inhibited in soil.     

Partitioning and persistence of trichlorfon and chlorpyrifos in a creeping bentgrass putting green

Golf course putting greens typically receive high pesticide applications to meet high quality demands. Research on pesticide fate in turf ecosystems is important to better understand the potential impact of pesticide use on the environment and human health. This research was conducted to evaluate the environmental fate of two commonly used insecticides--trichlorfon (dimethyl 2,2,2-trichloro-1-hydroxyethylphosphonate) and chlorpyrifos (O,O-diethyl O-3,5,6-trichloro-2-pyridylphosphorothioate)--in a creeping bentgrass (Agrostis palustris Huds.) putting green under customary field management practices at the University of California-Riverside Turf Research Facility during 1996 and 1997. The two insecticides were chosen because of their difference in water solubility, persistence, adsorption, and vapor pressure. Volatilization, clipping removal, and soil residues of the insecticides were quantified and leaching was monitored using lysimeters installed in putting green plots. Results showed trichlorfon volatilization, clipping removal, and leaching loss was insignificant (in the range of 0.0001-0.06% of applied mass) both in 1996 and 1997. No significant difference in clipping removal of trichlorfon and chlorpyrifos was observed in both years (0.06 and 0.05% of applied mass for trichlorfon and 0.15 and 0.19% of applied mass for chlorpyrifos, respectively, in 1996 and 1997), but significantly lower cumulative leaching and lower soil concentration was observed in 1997 than in 1996. Volatilization loss of chlorpyrifos was not significantly different between 1996 (2.05%) and 1997 (2.71%). Volatilization loss of trichlorfon in 1996 (0.01%) was significantly higher than in 1997 (0.008%). This study demonstrated the fraction of applied insecticides leaving the turf putting greens was minimal.     

Degradation of soil fumigants as affected by initial concentration and temperature

Soil fumigation using shank injection creates high fumigant concentration gradients in soil from the injection point to the soil surface. A temperature gradient also exists along the soil profile. We studied the degradation of methyl isothiocyanate (MITC) and 1,3-dichloropropene (1,3-D) in an Arlington sandy loam (coarse-loamy, mixed, thermic Haplic Durixeralf) at four temperatures and four initial concentrations. We then tested the applicability of first-order, half-order, and second-order kinetics, and the Michaelis-Menten model for describing fumigant degradation as affected by temperature and initial concentration. Overall, none of the models adequately described the degradation of MITC and 1,3-D isomers over the range of the initial concentrations. First-order and half-order kinetics adequately described the degradation of MITC and 1,3-D isomers at each initial concentration, with the correlation coefficients greater than 0.78 (r2> 0.78). However, the derived rate constant was dependent on the initial concentration. The first-order rate constants varied between 6 and 10x for MITC for the concentration range of 3 to 140 mg kg(-1), and between 1.5 and 4x for 1,3-D isomers for the concentration range of 0.6 to 60 mg kg(-1), depending on temperature. For the same initial concentration range, the variation in the half-order rate constants was between 1.4 and 1.7x for MITC and between 3.1 and 6.1x for 1,3-D isomers, depending on temperature. Second-order kinetics and the Michaelis-Menten model did not satisfactorily describe the degradation at all initial concentrations. The degradation of MITC and 1,3-D was primarily biodegradation, which was affected by temperature between 20 and 40 degrees C, following the Arrhenius equation (r2 > 0.74).     

Theory and laboratory study of a tall passive chamber for measuring gas fluxes at soil surface

A tall passive flux chamber with a height significantly greater than its horizontal dimensions is proposed for measuring fluxes of volatile organic compounds (VOCs) at the soil surface. The main feature of this tall chamber is the presence of a vertical concentration gradient of the target gas in the chamber. The emission and transport behavior of the target gas in the soil-chamber system are analyzed using the diffusion theory. A mathematical model is developed to estimate the flux from the soil into the tall chamber, providing the target gas establishes a detectable vertical concentration gradient in the chamber. To obtain the data required for calculating flux, only two gas concentrations (C1 and C2) at two heights (h1 and h2) within the chamber need to be measured at the end of a short chamber placement time (tp). To evaluate the applicability of the tall chamber for measuring flux, several laboratory tests have been conducted, using CH2Cl2 and CH3Br as the target gases. The results indicate that the proposed tall chamber has promising potential as a method for measuring fluxes of VOCs at the soil surface.     

Effect of formulation on the behavior of 1,3-dichloropropene in soil

The fumigant 1,3-dichloropropene (1,3-D) has been identified as a partial replacement for methyl bromide (CH3Br) in soil fumigation. 1,3-Dichloropropene is formulated for soil fumigation as Telone II (Dow AgroSciences, Indianapolis, IN) for shank application and as an emulsifiable concentrate (EC) (Telone EC or InLine; Dow AgroSciences) for drip application. This study investigated the effect of formulation on the phase partitioning, transformation rate, and volatilization of 1,3-D isomers. Air-water partitioning coefficients (K(H)) were slightly higher for Telone II than for Telone EC, presumably due to the higher apparent water solubility of the EC formulation. Sorption of 1,3-D isomers in two soils was not affected by formulation. Formulation had no significant effect on the rate of 1,3-D transformation in water or soil. In general, differences in the rate of 1,3-D transformation and phase partitioning due to formulation as Telone II or Telone EC were very small. Thus, the effect of formulation on 1,3-D fate may be ignored in transformation and phase partition of 1,3-D in water and soil. Packed soil columns without plastic tarp indicated that with relatively shallow subsurface (10 cm) drip application of Telone EC, emission of 1,3-D isomers was more rapid and produced greater maximum instantaneous flux than deeper (30 cm) shank injection of Telone II. Both application methods resulted in the same cumulative emissions for both isomers, 45% for (E)-1,3-D and approximately 50% for (Z)-1,3-D. These results suggest that for drip application of fumigants to be effective in reducing emissions, the fumigant must be applied at sufficient depths to prevent rapid volatilization from the soil surface if the water application rate does not sufficiently restrict vapor diffusion.     

UN/ECE ICP Materials Dose-response Functions for the Multi-pollutant Situation

A “multi-pollutant exposure programme” reflecting the new pollution situation where SO₂ is no longer the dominating pollutant has been performed by the International Co-operative Programme on Effects on Materials, including Historic and Cultural Monuments (ICP Materials) within the activities of the Convention on Long-range Transboundary Air Pollution. The main results obtained in the period 1997–2003 are summarised. Dose-response functions are presented for carbon steel, zinc, copper, bronze and limestone. Parameters involved in the functions include besides SO₂ and pH, which were included in the previously developed functions from ICP Materials, also the effect of particulate matter and HNO₃.