Comparisons of soil surface sealing methods to reduce fumigant emission loss

State and federal regulatory agencies depend on quality field data for determining the effects of agricultural management practices on fumigant emissions to develop sound, science-based policies and regulations on preplant soil fumigants. Field plot tests, using growers' standard field operation procedures, were used to simultaneously determine the effectiveness of several commonly proposed emission reduction methods, in a trial involving shank injection of Telone II [a.i. 1,3-dichloropropnene (1,3-D)] to a sandy loam soil to a target rate of 372 kg ha(-1). The experiment was conducted in late September 2008 in the San Joaquin Valley of California. Fumigant emissions were captured using dynamic flux chambers. The results showed that virtually impermeable film (VIF) reduced emissions >95% when compared to bare soil, and the glue joints in the film did not significantly affect the tarp performance. The VIF also created a more uniform distribution of gaseous fumigant in the soil profile, which would likely benefit pest control efficacy. Standard high-density polyethylene (HDPE) tarp reduced total 1,3-D emissions about 50% (higher than most reported values) in this trial, whereas postfumigation intermittent water treatments (seals) reduced cumulative emission losses by approximately 20%. Adding 49.4 Mg ha (equivalent to 20 tons per acre) of composted dairy manure to surface soils did not reduce 1,3-D emissions during this experiment. Use of VIF was the most promising technique in reducing emissions and has the potential to allow lower application rates while providing satisfactory pest control.     

Successful early in utero management of fetal hydrothorax in a twin pregnancy

We present a case of dichorionic diamniotic twin pregnancy in which one of the fetuses was found to have a major pleural effusion at 15 weeks of gestation. A single-needle pleural fluid aspiration was performed at 15 and 16 weeks, but the fluid reaccumulated quickly after each procedure and at 16 weeks, the fetus was found to become progressively hydropic. A shunt was then successfully inserted at 17 weeks, which is the earliest gestation reported so far in the literature for such a procedure to treat isolated hydrothorax. Because we felt that the fetus would be too small for a classical double-pigtail pleuroamniotic shunt, we used a multilength double-pigtail bladder stent (Harrison drain; Cook; Spencer; Indiana; USA) via a 13-gauge echo tip trocar. This shunt could be used for both singleton and twin pregnancies presenting with fetal pleural effusion from as early as 16 to 17 weeks to prevent the development of fetal hydrops and polyhydramnios and subsequent premature delivery. Treatment at this stage of gestation would also minimize the risk of lung hypoplasia, which is the main clinical issue when shunts are inserted after 24 weeks. Copyright © 2003 John Wiley & Sons, Ltd.     

Spray atomization characteristics as a function of pesticide formulations and atomizer design

Abstract

The use of formulation adjuvants to increase the drop size of pesticide sprays has followed a practice which has evolved through many years of experimentation and development. The earliest materials used were simply designed to make the spray mix viscous on the premise that a mayonnaise‐like fluid would produce larger drops and hence increase the deposit efficiency. These viscomer materials, emulsions and water soluble thickeners such as starch and agars, as well as more complex cellulose materials, produced thick non‐Newtonian fluids which were difficult to mix, pump and spray, and provided questionable results. First, the larger drops reduced target coverage from a given volume of spray; and second, field tests with these definitely showed that a large volume of small drops were still being produced even with the thickest of formulations.

The next step in adjuvant evolution was the introduction of polyvinyl, polyacrylamide and polyamide elastomer materials. These polymers are also non‐Newtonian, but due to their peculiar molecular bonding, they have the capability of forming long string‐like streams which when atomized can retract into a spray of large drops. Pure forms of these polymers are blended by commercial producers to enable compatibility with pesticide chemicals. We have conducted a series of laboratory and wind tunnel tests; first, to try and establish some physical parameters identifying their characteristics and second, to determine how these adjuvants affect atomization and the production of small drift‐prone drops (i.e., those smaller than 120 μm in diameter).

Our results with the laboratory studies of physical properties and of the wind tunnel drop size tests have been inconclusive. The elastomer materials have relatively low viscosity (1.5 to 6 mPa.s) and reduced surface tension (50 to 60 mN/m) but our stream‐flow extension tests were non‐productive. The drop size studies comparing water sprays with polymer‐water mixtures gave us a mixed picture. Generally drop size was increased for all of the fan (deflector and milled orifice) and cone type atomizers. But an increase was also indicated of the volume of spray in drops less than 120 μm showing that the polymer did not fully control the production of these small drops under all of the testing procedures we studied.

It is difficult to evaluate the capability of these additives for controlling or reducing production of the drift‐prone small drops. While the pure solutions of the water soluble polymers would appear to be capable of this desirable effect, it is also evident that in order to make these formulations compatible with pesticide spray solutions, several other solvents, emulsifiers and surface active chemicals are added to the formulation, thus affecting the atomization characteristics and hence their drift‐control capability.     

Production and dispersal of Colletotrichum gloeosporioides spores on Stylosanthes scabra under elevated CO2

This paper reports the effect of twice-ambient (700 ppm) atmospheric CO(2) concentration on infection, disease development, spore production and dispersal of the anthracnose pathogen Colletotrichum gloeosporioides in susceptible (Fitzroy) and partially resistant (Seca) cultivars of the tropical pasture legume Stylosanthes scabra under controlled environment and field conditions. Reduction in plant height due to anthracnose was partially compensated for by growth enhancement at elevated CO(2) in Fitzroy but not in Seca. Anthracnose severity was reduced under elevated CO(2) although the reduction was only significant in Fitzroy. Delayed and reduced germination, germtube growth and appressoria production were partly responsible for the reduced severity. Despite an extended incubation period, C. gloeosporioides developed sporulating lesions faster and produced more spores per day within the same latent period at high CO(2) and ambient CO(2). When Fitzroy seedlings grown at 700 ppm CO(2) were exposed to pathogen inoculum under field conditions, they consistently developed more severe anthracnose with more lesions than seedlings grown at ambient CO(2). The environmental variable, which correlated most strongly with the dispersal and infection of C. gloeosporioides spores in the field, was relative humidity in plant canopy. We have shown that an enlarged Stylosanthes canopy under elevated CO(2) can trap more spores, which can lead to more severe anthracnose under favorable weather. The implications of these findings for perennial Stylosanthes pastures are discussed.     

Gas-phase sorption-desorption of propargyl bromide and 1,3-dichloropropene on plastic materials

The goal of this research was to provide information for choosing appropriate materials for studying gas-phase concentrations of propargyl bromide (3BP) and 1,3-dichloropropene (1,3-D) in laboratory experiments. Several materials were tested and found to sorb both gas-phase chemicals in the following order: stainless steel (SS) < Teflon polytetrafluoroethylene (PTFE-FEP) approximately flexible polyvinyl chloride (PVC) approximately acrylic < low-density polyethylene (PE) < vinyl approximately silicone < polyurethane foam (PUF). Sorption of SS was insignificant and PUF sorbed all the fumigant that was applied. For the other materials, linear sorption coefficients (Kd) for 3BP ranged from 3.0 cm3 g(-1) for PVC to 215 cm3 g(-1) for silicone. Freundlich sorption coefficients for 1,3-D ranged from 11.5 to 371 cm3 g(-1). First-order desorption rate constants in an open system ranged from 0.05 to 1.38 h(-1) for 3BP and from 0.07 to 1.73 h(-1) for 1,3-D. In a closed system, less than 2% of sorbed fumigant desorbed from vinyl while up to 99% desorbed from PVC within 24 h when equilibrated at the highest headspace concentration. Sorption of both fumigants was linearly related to the square root of time except for vinyl and silicone. This may indicate non-fickian diffusion of fumigant into the polymer matrix. Vinyl, silicone, PE, and PUF should be avoided for quantitative study of organic gases, except possibly as a trapping medium. Use of PTFE, PVC, and acrylic may require correction for sorption-desorption and diffusion.     

Competitive degradation between the fumigants chloropicrin and 1,3-dichloropropene in unamended and amended soils

The mixture of 1,3-dichloropropene (1,3-D) and chloropicrin (CP) is used as a preplant soil fumigant. In comparison with individual fumigants, application of a mixture may affect the environmental dissipation and fate of each chemical, such as emission and degradation. We investigated the degradation of CP, 1,3-D, and their mixture in fresh soils and sterile soils, and evaluated the competitive characteristic of fumigants in the mixture. The degradation of low concentrations of CP in fresh soil was accelerated at early times in the presence of 1,3-D, whereas the addition of CP reduced the degradation rate of trans-1,3-D, possibly by inhibiting the activity of trans-1,3-D degrading microorganisms. The potential of applying amendments to the soil to increase the rate of CP and 1,3-D degradation was also illustrated. The degradation of both fumigants was significantly enhanced in soils amended with ammonium thiosulfate (ATS) and sodium diethyldithiocarbamate (Na-DEDTC) compared with unamended soil. Competitive degradation was observed for CP in amended soils in the presence of 1,3-D. The degradation of cis-1,3-D in amended soils spiked as a mixture of 1,3-D and CP was repressed compared with the rate of degradation in samples spiked with 1,3-D only. This implied that in abiotic degradation, CP and cis-1,3-D competed for a limited number of reaction sites in amended soil, resulting in decreased degradation rates. No significant influence of fumigant mixtures was observed for trans-1,3-D in amended soil.     

The influence of prenatal diagnosis on postnatal outcome in patients with structural congenital heart disease

Examination of the fetal heart has become an established part of mid-trimester anomaly scanning. Along side this has emerged the ability to diagnose congenital heart disease in the fetus with accuracy. Despite this, the development of screening programmes to look for fetal cardiac disease has only been partially successful. Furthermore, when detected, there seems to be little survival advantage associated with prenatal diagnosis. Demonstrating such an advantage is complicated by the nature of fetal cardiac disease, which tends to be severe and is often associated with extra-cardiac abnormalities. More selective studies, mostly involving small numbers of cases, are now beginning to demonstrate both improved survival and reduced morbidity in prenatally diagnosed infants presenting to cardiac intensive care units compared to those with a postnatal diagnosis. Copyright © 2004 John Wiley & Sons, Ltd.     

Developments and prospects of world lead and zinc mining

World developments in lead and zinc are examined for 1970-90 and projections presented for 1995. Although lead consumption has Increased during the period under review, lead mine production has been on a decline, the differences being made up from secondary lead sources. Lead mine production is projected to be steady to 1995, with increased consumption continuing to be met from secondary sources. Zinc mine production increased at a trend rate of about 1% per year between 1970 and 1990, but for 1991-95, production is expected to grow at a lower rate. For 1990-95 zinc consumption is expected to grow at a rate of 2.3%. This modest mine production increase to 1995 is unlikely to be adequate to meet growth in MEC zinc consumption.     

Persistently highest risk areas for hantavirus pulmonary syndrome: potential sites for refugia.

Interannual variation in the number of cases of human disease caused by hantaviruses in North America has been hypothesized to reflect environmental changes that influence rodent reservoir populations. This hypothesis postulates that when cases are rare reservoir populations are geographically restricted in patches of suitable habitat. Identifying these sites, which is needed to test the hypothesis, has proven to be a challenge. Satellite imagery of the U.S. Southwest has shown associations among the likelihood of human hantaviral disease and increases in the rodent populations, as well as increased prevalence of Sin Nombre virus (SNV) in rodent populations. In this study we characterize local areas that had environmental signatures that persisted as predicted highest risk sites for human disease through much of the 1990s. These areas represent a small percentage (0.3%) of the region. Exploratory analyses indicate that these areas were not randomly distributed, but were associated with certain landscape characteristics. Characteristics of elevation, slope, aspect, and land cover were associated with persistent high risk. Using multivariate Poisson regression to control for confounding effects, sites with deciduous- or mixed-forest land cover on moderate to steep slopes (>5 degrees) above 2130 m elevation were associated with increasing numbers of years at highest risk. These are candidate locations for refugia. Sites associated with cleared ground or shrubland were less often associated with high risk compared to reference conditions. The seasonal patterns of vegetation growth in persistently high-risk areas were compared to matched locations using MODIS (moderate resolution imaging spectroradiometer) NDVI (normalized difference vegetation index) during a time of a severe drought in the region from 2002 to 2004. Despite the drought and regardless of land cover, the NDVI in persistently highest risk areas had an early onset, with significantly higher levels of green vegetation that lasted longer than at comparable sites. These observations identify locations that can be monitored for the abundance of P. maniculatus and presence of SNV. If these sites are refugia, we predict they will be occupied by infected deer mice when other monitored sites are unoccupied.     

Effect of soil properties on degradation and sorption of methyl bromide in soil

Methyl bromide (CH₃Br) is currently the most widely used soil fumigant, and its emission into the atmosphere after application reportedly contributes to ozone depletion in the stratosphere. Irreversible degradation and partially reversible sorption reactions affect the quantity of this furnigant reaching the soil surface and escaping into the atmosphere. Incubation studies in closed headspace vials under controlled conditions showed that degradation of CH₃Br was highly dependent on soil organic matter content, and to a lesser extent, on the moisture level in the soil. Methylation of CH₃Br on organic matter was suggested to be the major reaction that CH₃Br undergoes in the soil environment. Other soil constituents such as clay did not contribute to the degradation under moist or air-dried conditions, though enhanced degradation was observed on oven-dried montmorillonite and kaolinite clays. Within soil profiles, degradation of CH₃Br decreased with soil depth mainly due to the reduction of soil organic matter content with depth. In both Greenfield and Wasco sandy loams, the degradation rate of CH₃Br in soil layers from 0 to 270 cm could be estimated from soil organic matter content. Sorption of CH₃Br on moist soils was generally limited, and varied with soil depth. The degree of sorption could be predicted from soil moisture alone or soil moisture and organic matter content.