臭氧氧化—包埋菌流化床生物处理组合工艺深度处理煤气化废水

采用臭氧氧化—包埋菌流化床生物处理组合工艺对煤气化废水进行深度处理。实验结果表明：当臭氧的质量浓度20 mg/L、臭氧进气流量1.5 L/min、臭氧通气时间30 min、包埋菌流化床水力停留时间24 h时,臭氧氧化工序的COD去除率达到30.0%~40.0%,总酚去除率达到100.0%;包埋菌流化床工序的COD去除率达到60.0%以上,氨氮的去除率大于95.0%;经组合工艺处理后,出水COD<60 mg/L,ρ（氨氮）<1.0 mg/L,ρ（总酚）未检出,色度小于50倍,达到GB8978—1996《污水综合排放标准》中的一级排放标准。     

CuO/γ-Al2O3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH(4~5)条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为:pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为:pH>反应时间>H2O2用量>催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。     

重庆主城区秋冬季逆温对空气质量影响的观测分析

2013年9—11月利用RPG-HATPRO地基多通道微波辐射计对重庆主城区大气进行连续探测,统计了大气逆温情况,并对典型重污染天气下大气逆温与空气质量状况进行综合分析。结果表明,逆温出现的频率为63.3%,基本为接地逆温类型,逆温层厚度为953 m,逆温强度为0.3℃/hm;逆温的存在为气溶胶的积聚和凝聚创造了有利条件。     

基于CA-MAS的水域总有机碳扩散模拟研究

当前水环境污染扩散研究一般基于普通数值模型模拟,忽略了水污染扩散微观驱动力的影响。为能更真实地反映其动态扩散过程,针对水域总有机碳(TOC)扩散机理,基于CA和MAS技术,将影响TOC扩散的自然和社会经济因素抽象为微观的水流Agent、风速Agent、径流量Agent、污水排放口Agent、人工管理Agent以及农业生产地Agent,将研究水域抽象为CA元胞空间,建立了CA-MAS水域总有机碳扩散模型,对水域总有机碳的动态演化过程进行模拟,并以武汉理工大学鉴湖水域作为实验区域,借助NetLogo仿真平台完成了模型的实现与验证。模拟结果表明,该模型基本能够反映水体总有机碳的扩散规律,可以为水环境污染控制提供参考。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

温度对正渗透工艺性能的影响

正渗透技术是一种以渗透压差为驱动力的新型膜分离工艺。温度是影响正渗透过程的关键因素。为考察温度在工艺运行中的重要作用,研究了温度对正渗透膜特性及工艺性能的影响,探讨通量衰减机制。结果表明,温度影响汲取液动态稀释、浓差极化和膜污染等的效应程度,进而影响正渗透性能。高温能够明显增加水通量和回收率,且汲取液温度影响比原料液显著。因此,合理优化温度条件是降低能耗提高正渗透性能的有效途径。     

The Relationship between the Quantity of Heavy Metal and PAHs in Fly Ash

ABSTRACT

Heavy metal and polycyclic aromatic hydrocarbons (PAHs) in flue gas have received considerable attention in recent years due to their mutagenic or carcinogenic properties. The present study is carried out to investigate the influence of the quantity of heavy metals on PAHs formation in fly ash.

A fluidized bed incinerator was used in this experiment to obtain fly ash of chemical similarity by incinerating various compositions of waste. The obtained fly ash, both with and without heavy metal, were used to adsorb the PAHs in the flue gas and to investigate the formation of PAHs in fly ash. The results indicate that carbon and heavy metals most greatly influence the formation of PAHs in the fly ash. Carbon is absorptive; heavy metals encourage not only absorption of PAHs but also catalyze PAHs formation.     

Causes of decreased reference evapotranspiration and pan evaporation in the Jinghe River catchment, northern China

This study focused on the changes of reference evapotranspiration (ET₀) and pan evaporation (ET_pan) to study the impacts of climate change on the hydrological cycle in the Jinghe River catchment. Based on the Penman–Monteith equation, the ET₀ was calculated. The temporal trend and spatial distribution of ET₀ and E_pan measured with a 20-cm pan were examined at the 14 stations during 1957–2005. The effects of meteorological factors on the variation of ET₀ were determined by analyzing the trends in themselves with comparison between original climate and detrended climate scenarios and then their sensitivity to ET₀. Both the ET₀ and E_pan showed remarkable decreasing trends from 1957 to 2005 and their decreasing rate was 40.9 and 17.7 mm per 10 years, respectively. Trend analysis of meteorological factors exhibited that the reduction in ET₀ and ET_pan was principally caused by both significant decreases in wind speed and sunshine hours. Furthermore, the decreasing trend of ET₀ was mainly dominated by the significant decrease in wind speed with high sensitivity, to a less extent, by the decrease in net radiation. Although relative humidity is one of the most sensitive variables, its effect on ET₀ was negligible because of its temporal constancy. The contribution of wind speed reduction to decreased ET₀ has increased from 50 to 76.1%, but net radiation, by contrast, decreased from 50 to 23.9%.