前处理-水解-生物接触氧化工艺处理染料废水

介绍了前处理-水解-生物接触氧化工艺处理染料废水的工程实例.当进水COD≤8000 mg/L时,出水可达到国家〈污水综合排放标准〉（GB8978-1996）二级标准.     

The effects of elevated CO2 on clonal growth and nutrient content of submerge plant Vallisneria spinulosa

An approximately four months long glasshouse experiment was conducted to examine the effects of elevated carbon dioxide (CO(2)) concentration (1,000 +/- 50 micromol mol(-1)) in the atmosphere on biomass accumulation and allocation pattern, clonal growth and nitrogen (N), phosphorus (P) accumulation by the submerged plant Vallisneria spinulosa Yan. Elevated CO(2) significantly increased V. spinulosa total fresh biomass ( approximately 130%) after 120 days, due to more biomass accumulation in all morphological organs than in those at ambient CO(2) (390 +/- 20 micromol mol(-1)). About 75% of the additional total biomass at elevated CO(2) was accounted for by leaf and rhizome (above ground) biomass and only 25% of it belonged to root and turion (below ground). However, the turions biomass exhibited a greater increase rate than that of organ above ground, which caused reduction in the above/below ground biomass ratio. The clonal growth of V. spinulosa responded positively to elevated CO(2). The number of primary ramets increased up to 1.4-folds at elevated CO(2) and induced a dense growth pattern. For nutrients absorption, concentration of N in leaf and in turion was significantly (p 相似文献   

Removal of cyanobacterial blooms in Taihu Lake using local soils. I. Equilibrium and kinetic screening on the flocculation of Microcystis aeruginosa using commercially available clays and minerals

Algal removal abilities of 26 clays/minerals were classified into three categories according to the 8-h equilibrium removal efficiency (Q8h) and removal rate at a clay loading of 0.7 g/L. Type I clays (sepiolite, talc, ferric oxide, and kaolinite) had a Q8h > 90%, a t50 (time needed to remove 50% of the algae) < 15 min, and a t80 < 2.5 h. Type II clays (6 clays) had a Q8h 50-90%, a t50 < 2.5 h, and a t80 > 2.5 h. Type III clays (14 clays) with Q8h < 50%, t50 > 8 h and t80 > 14 h had no practical value in removal of algal blooms. When the clay loading was reduced to 0.2 g/L, Q8h for all the 25 materials decreased to below 60%, except for sepiolite whose Q8h remained about 97%. The high efficiency for sepiolite to flocculate M. aeruginosa cells in freshwaters was due to the mechanism of netting and bridging effect.     

微波加热对活性炭表面基团及其对SO2吸附性能的影响

采用了微波加热技术,通过在不同微波功率和辐射时间条件下对不同粒径活性炭进行改性,研究了改性前后活性炭的表面化学基团、元素组成的变化,以及对SO2吸附性能的影响.结果表明,经过微波改性后活性炭的SO2吸附性能大为提高,微波功率是影响改性活性炭脱硫性能的主要因素.活性炭经微波热处理后,酸性基团发生分解,表面含氧量减少,碱性特征增强,是吸附性能增加的主要原因之一.     

Status of trace elements in paddy soil and sediment in Taihu Lake region

Thirteen paddy soil profiles and river sediments which are sources of irrigation water were collected around the Taihu Lake, and the trace elements were estimated. The content of La and Ce in paddy soil and sediment were 39.3 and 68.6 mg/kg soil and 36.9 and 65.1 mg/kg soil, being within the range of background values. The values for Pb, Cu, Ni, Cr, Co, Mn, Zn, Se in paddy soil were 23.3, 27.8, 25.5, 63.5, 10.2, 386, 68.7 and 0.25 mg/kg soil respectively, all below the national permission level. There was a decline of Zn in paddy soil. Some of the river sediments were seriously polluted. The river in Yangjin site was most contaminated with 5.47 g Cu/kg and 7.4 g Zn/kg. The high concentration of Pb and Ni also was observed in this sediment. River in Weitang, Huashi, Xinzhuang and Meiyan were contaminated with Pb, Cu and Ni to some extent. Zn, Cu and Pb were the main pollutants in present experiment sites. The fast development of village/township industries have caused severe environmental pollution in the Taihu Lake region, especially irrigation river sediments. Se content in plant and seed was 0.04 and 0.03 mg/kg respectively, showed Se-deficiency in paddy soil in the Taihu Lake region.     

制浆废液降低普钙水分的应用研究

针对我国采用高临界流动水分的磷矿进行湿法生产普钙普遍存在产品水分达不到部颁标准的难题,直接采用制浆废液(利用其主要对环境有害成分之一--MNA作减水剂)进行降低普钙水分的研究和应用.实验结果表明,添加少量的减水剂MNA可显著降低国内朝阳、昆阳、浏阳和国外摩洛哥等单种磷矿以及昆阳-朝阳混矿的矿浆粘度和水分.采用国产昆阳-朝阳混矿进行工业生产试验结果表明,添加0.35%～0.4%干矿粉重量的减水剂MNA,不仅可使球磨添加水量从145 kg降至103 kg,矿浆含水量从30.5%降至27%,成品肥含水量从16.24%降至13.77%,而且可使有效磷从10.67%升至12.24%,转化率由86.57%提高到90.45%,矿浆细度由90.18%提高到93.12%.实验和工业生产试验表明,直接用造纸制浆废液降低普钙水分,既确保和改善了普钙的产品质量,又治理了环境污染,取得了较好的经济、环境和社会效益.     

错流式动态膜-生物反应器中污泥活性的研究

应用错流式动态膜-生物反应器(CDMBR)对己内酰胺废水进行了180 d的实验,实验过程中测定反应器的膜出水和上清液的水质,并对污泥进行了耗氧呼吸速率测定.结果表明,上清液COD一直保持在100mg/L以下,而膜出水的则保持在50 mg/L以下,膜对上清液的COD去除率达50%,而对氮的去除没有贡献.可溶性细胞产物(SMP)在反应器内容易积累,停留足够的时间后能被生物降解.通过投加抑制剂测定耗氧呼吸速率,发现异养菌、硝化细菌和亚硝化细菌的活性由于F/M的降低和SMP积累受到一定的抑制,但不影响系统的处理效率.跨膜压力、膜面流速越大,通量衰减得也就越快.     

一种高速反硝化颗粒污泥的培养

以葡萄糖为碳源,在USB反应器内接种好氧活性污泥在40 d内培养出良好的反硝化颗粒污泥.颗粒污泥形成经历了2个阶段:起始阶段,接种的好氧活性污泥中非反硝化菌逐渐衰亡演变为"惰性固体",与原有的固体一起,成为反硝化菌附着生长的载体,与此同时,反硝化菌在载体表面渐渐繁殖,形成细颗粒污泥;随后,反硝化菌在细颗粒污泥表面不断增殖,颗粒长大,发育成为成熟的颗粒污泥.成熟的颗粒污泥密实,表面均为杆状菌,且排列紧密,当污泥床容积负荷为19.1 g N/L·d时,去除率高达98.4%(N).     

林可霉素制药废水的臭氧氧化处理

考察了臭氧氧化对林可霉素的效价削减效果。在初始抗生素浓度为100 mg·L⁻¹时,林可霉素效价削减50%所需消耗的臭氧量为0.118 mg·mg⁻¹抗生素,降解过程符合一级降解动力学特征。进一步采用林可霉素实际废水考察了污水化学需氧量(COD)和pH对抗生素臭氧氧化处理的影响,发现废水的COD每增加100 mg·L⁻¹,则单位抗生素实现50%削减需要增加的臭氧量约为1.64 mg。碱性条件下,臭氧可催化分解生成羟基自由基等活性基团而加速林可霉素的降解。同时,臭氧氧化后林可霉素生产废水的厌氧可生化性提高了98.51%。研究结果可以为林可霉素生产废水的处理技术选择提供参考。     

低碳排放的生物絮凝中试系统污染物去除特性及污泥EPS变化

用中试规模生物絮凝工艺处理含化学絮凝剂的生活污水,分别研究了HRT和进水SS对生物絮凝系统污染物去除特性、剩余污泥产量、污泥特性和温室气体排放的影响。结果表明：生物絮凝系统对COD、TN和TP有较好的去除效果,且污染物去除效果受进水SS影响较大;生物絮凝系统平均污泥产量和平均有机物产量最高可达 53.63 kg·d⁻¹和21.14 kg·d⁻¹;污泥胞外聚合物EPS浓度和PN/PS均与有机负荷呈反比;化学絮凝剂通过影响PN/PS和EPS浓度,可间接影响污泥的沉降性能;生物絮凝系统与AAO工艺相结合,可降低50.12 g·m⁻³温室气体的排放。因此,生物絮凝工艺可为污水处理厂节能降耗运行奠定基础,有望得到广泛应用。