中国南方塑料大棚气象灾害风险区划

利用中国南方地区15个省市自治区160个气象观测站台1990-2009年的气象资料,综合考虑气温、光照、风速、降水等主要致灾因子,并根据这些数据建立了基于实数编码的加速遗传算法的南方塑料大棚气象灾害的投影寻踪等级评价模型,计算出南方塑料大棚的气象灾害月份和季节的风险等级,并按季节进行了风险区划。结果表明:春季四川盆地地区气温回升较快,有利于设施作物生长,风险最低,重庆、贵州等地由于由于太阳总辐射低,设施作物易受到寡照灾害,风险等级最高;夏季沿海地区暴雨、台风等自然灾害频发,对设施结构有较大影响,有较高的风险;秋季高灾害风险等级分布较少,以低风险为主;冬季以北纬25°为分界线,北部地区气温低、热量条件缺乏,不适宜塑料大棚发展,南部地区则相反,风险低。我国南方秋季西部地区、冬季南部地区及春夏两季的四川盆地地区的气象灾害风险最小,适合塑料大棚的发展,研究结果为我国南方塑料大棚发展的合理布局和气象灾害防御提供参考。     

台风灾害风险区划模型

台风灾害发生频率高,影响严重,是人类面临的全球性重大问题之一。对台风灾害进行科学、合理的风险评估显得尤为重要。以宁波市为研究对象,在隶属函数和自然灾害风险理论的基础上,综合考虑形成台风灾害风险危险性、暴露性和脆弱性,结合GIS技术建立了台风灾害风险区划模型,绘制了宁波市台风灾害风险区划图;并利用灾级指数对模型结果进行了验证。结果表明:宁波市各区、县的台风灾害风险指数中,宁海、鄞州、余姚、奉化、象山和慈溪台风灾害的总风险指数较大,老城区(海曙区、江东区、江北区)、镇海和北仑较小;宁波市东南沿海、城镇和部分山区台风灾害风险等级较高;灾级指数与台风风险指数的相关性较好,决定系数达到0.7181,且通过了0.01的置信区间。     

水下公路隧道纵向疏散通道加压送风系统研究

为研究水下公路隧道纵向疏散通道加压送风系统的关键设计参数,结合纵向疏散通道的特点,借鉴一般建筑加压送风系统的设计要求,提出了纵向疏散通道内加压送风量的计算方法,并通过数值模拟方法对纵向疏散通道加压送风系统进行了研究。结果表明,利用风速法计算得到的送风量比压差法计算得到的结果大20倍左右,并且压差法计算送风量时受疏散口缝隙宽度影响较大,工程适用性差。通过数值模拟可知,疏散通道内的送风风速达到1.5m/s时即能够满足人员安全疏散要求,这与风速法计算的结果一致。研究结果可供采用纵向疏散模式的隧道疏散通道加压送风系统设计参考。     

Transmissometer Measurement of Participate Emissions from a Jet Engine Test Facility

The body of information presented in this paper is directed toward those individuals involved with handling hazardous materials, whether in actual use of such chemicals, or in monitoring atmospheric emissions. Although specifically relating experience in the design and testing of phosgene emission control equipment, it attempts to establish general guidelines for effectively dealing with emissions of hazardous materials. An approach for handling chemical pollutants having no established air quality emission standards is developed. The paper presents a technique for establishing process emissions at acceptably low levels to insure the health and safety of the general population as well as that of the process workers themselves. Methods, suitable for measuring phosgene at these low levels, have been investigated, and problems associated with such an investigation are discussed. While complete theoretical scrubber design criteria are beyond the scope of this paper, many of the "real world" problems which affected scrubber performance are presented. Finally, the practical aspects of process emissions control are illustrated by actual results from the system test.     

Urban-Center CO Air Quality Projections

The distribution of mutagenic activity and nitroaromatic components of polycyclic organic matter (POM) in ambient air at industrial, urban, suburban, rural, and remote sites was studied using organic extracts from high volume aerosol samples. Direct-acting mutagens including 1-nitropyrene (1-NP), dinitropyrenes (DNP), and hydroxynitropyrenes (HNP) were measured by high performance liquid chromatography while the mutagenicity was determined in the Salmonella bioassay with strain TA-98. Benzo(a)pyrene (BaP), one of the possible precursors of nitroaromatic compounds in POM, was also measured. In comparing samples from a range of sites, TSP and the concentration of BaP per mass of particulate matter decreased, as expected, at greater distances from urban and industrial combustion sources. However, the concentrations of polar nitroaromatic POM compounds per mass of particles were higher at a remote site than in nonindustrial urban and suburban areas. The mutagenicity in particulate matter extracts from the remote area was predominantly (>90 percent) in the very polar fractions. There were also high atmospheric levels of nitroaromatic compounds and mutagenicity in heavily industrialized areas. These observations may reflect the influences of source emissions, atmospheric transformations of POM compounds, and ther atmospheric processes on the composition of ambient suspended particulate matter.     

Testing and Commercialization of Byproduct Dibasic cids as Buffer Additives for Limestone Flue Gas esulfurization Systems

Pilot plant (0.1 MW) tests and utility boiler full scale demonstration (194 MW) of byproduct organic dibasic acids (DBA) as buffer additives to limestone scrubbers have shown performance improvements equivalent to those achieved by the addition of pure adipic acid. Both SO₂ removal efficiency and limestone utilization increased, and no significant operating problems were observed with three of the four DBA tested. Chemical and biological evaluations of scrubber samples taken during the DBA testing indicated no detectable tOxicity or mutagenicity, and no significant environmental impact is expected as a result of DBA addition. Economic estimates indicate that substitution of DBA for pure adipic acid as a buffer additive will result in additive cost savings of 30 % or greater.     

A Survey of Nitrogen Dioxide Levels Measured Inside Mobile Homes

As part of the California Mobile Home Study, over 250 mobile homes from throughout the state were monitored for nitrogen dioxide (NO₂) concentrations. Week-long average measurements were taken with Palmes tubes in the kitchen and bedroom of each mobile home during the summer of 1984 and the winter of 1985. The study was conducted entirely by mail with the participants providing all the necessary information. Mobile homes using gas for cooking had significantly higher indoor NO₂ levels than those using electricity. Mobile homes located in the Los Angeles basin had significantly higher indoor NO₂ concentrations than did mobile homes in the rest of the state. Gas cooking, the inverse of the house volume and geographic location (as a surrogate of outdoor NO₂) were the most important variables identified by multiple linear regression.     

Trends and Relationships of O3, NOx and HC in the South Coast Air Basin of California

A basin-wide air quality trend analysis for the South Coast Air Basin of California is conducted for hydrocarbons (HC), NO_x, O₃ and CO using multi-station composite daily maximum-hour average ambient concentrations for the third quarter (July, August and September) from 1968 to 1985. Emissions and air quality trends are compared for the period 1968-1984. Ambient HC and NOX trends are somewhat different from estimated emission trends of HC and NO_x, while a definite, downward trend of ambient CO is consistent with vehicular emission control measures. Basin-wide ambient HC, NO_x and O₃ appear to show downward trends for the period 1970-1985, but because of high fluctuations it is difficult to delineate trends for shorter periods. The meteorology (850 mb temperature)-adjusted O₃ shows a more consistent downward trend than does unadjusted O₃. Polynomial and multiplicative regression models for basin-wide empirical O₃-HC-NO_x relationships Indicate that the O₃ variation is explained largely by the meteorological variable (850 mb temperature) although model estimations are improved by adding HC and NO_x concentration terms.     

The Potential of Pulse-Jet Baghouses for Utility Boilers. Part 2: Performance of Pulse-Jet Fabric Filter Pilot Plants

Pulse-jet fabric filters (PJFFs) are widely used in U.S. industrial boiler applications and in utility and industrial boilers abroad. Their small size and reduced cost relative to more conventional reverse-gas baghouses makes the use of PJFFs appear to be an attractive particulate control option for utility boilers. This paper (Part 2 of a three-part series) summarizes the results of pilot PJFF studies sponsored by the Electric Power Research Institute at different utility sites in the United States. The purpose of these tests is to evaluate PJFF performance for U.S. fossil-fuel-fired applications. These data are also used to corroborate the results of a recent worldwide survey of PJFF user experience, as described in Part 1 of this series. Part 3 will provide a cost comparison of PJFFs to other particulate control options such as electrostatic precipitators and reverse-gas baghouses.     

An Analysis of Biomedical Waste Incineration

The California Air Resources Board (ARB) completed a series of source tests of eight operating biomedical waste incinerators (BMWI) under conditions of typical operation. The emissions of certain metals, and chlorinated dioxins and furans in the flue gases of BMWI are relatively high in comparison to emissions from other combustion sources, such as hazardous waste or municipal waste incinerators of modern design. This study reports on an analysis of the status of the existing regulatory framework and the California data base. Clarification of definitional issues at the federal level is needed to effectively treat BMWI management issues. Although few relationships among combustion parameters and emissions were uncovered, patterns of emissions were evident, suggesting commonality and relationships among the waste stream constituents and emissions. Potential implications for future research, operation of BMWI, controls and source reduction and waste segregation strategies are also discussed.