空气污染与儿童呼吸系统患病率的相关分析

 在流行病学调查和空气污染物监测的基础上，研究讨论了儿童呼吸系统患病率与空气污染之间的相关关系，结果表明，空气中细颗粒物（PM_2.5）和可吸入颗粒物（PM₁₀）与儿童呼吸系统患病率呈线性正相关关系，其影响比SO₂、Nox更密切．哮喘明显受颗粒物、SO₂、Nox的综合作用的影响．未感冒咳嗽发生率明显受细颗粒物和Nox污染综合作用的影响．     

跨海大桥主墩桩基钢护筒腐蚀损伤识别

跨海大桥主墩桩基施工过程中采用的钢护筒被保留作为桩基的外层,容易受到海洋环境的腐蚀破坏。提出一种基于插值曲率模态指纹库比对的桩基损伤识别方法,为解决测试数据不完备的问题,采用三次样条函数几何插值得到扩展后的桩基振型,然后在扩展振型的基础上采用中心差分计算得到曲率模态指标。以金塘大桥为工程背景,建立索塔-基础多尺度有限元模型,考虑海水腐蚀造成桩基钢护筒局部损失情况,以损失减薄区域的位置、轴向长度、深度为损伤参数,设置多种损伤工况样本,计算并建立基于插值曲率模态的桩基损伤识别指纹库,最后通过指纹库以外损伤工况与库内样本比对的方式,验证损伤识别效果。研究表明,为保证三次样条函数几何插值得到扩展振型对真实振型的拟合精度,至少需要沿桩基均布6个位移插值点。通过指纹库比对,能够准确识别桩基钢护筒减薄区域的位置与轴向长度。     

污泥基活性炭去除水中重金属离子效能与动力学研究

以城市污泥为主要原料制备了污泥基活性炭(SAC),考察了其对重金属离子的吸附去除效能和吸附动力学规律.并选择了2种商品活性炭(煤质炭,MAC和椰壳炭,YAC)作为对比,以初始浓度为50mg/L的Cu(II),Pb(II),Cd(II),Cr(VI)4种重金属离子为去除对象,分别进行了3种活性炭的表面理化性质分析及其对4种重金属离子的吸附试验.结果表明,SAC的比表面积和微孔容积仅为YAC和MAC的1/3~1/2,吸附速率也相对较慢,但其对Cu(II),Pb(II),Cr(VI),Cd(II)的平衡吸附量却远大于2种商品活性炭,分别为9.9,8.9,8.2,5.4mg/g,说明SAC表面的高酸性基团含量对重金属离子的吸附起到了关键作用;Langmuir与Freundlich吸附等温模型均能较好地拟合SAC对Cu(II)和Pb(II)的吸附,SAC对Cr(VI)的吸附过程更符合Langmuir模型,而SAC对于Cd(II)的吸附过程用Langmuir与Freundlich两个模型均不能较好地拟合,说明SAC表面缺少能够与Cd(II)发生反应的结合位点.     

乳状液膜法处理煤制兰炭废水

以磷酸三丁酯(TBP)为载体、煤油为膜溶剂、NaOH水溶液为内水相,采用乳状液膜法处理兰炭废水。实验结果表明:当TBP体积分数为4%、表面活性剂质量分数为4%、内水相NaOH质量分数为12%、油内比(乳状液的油相与内水相的体积比)为3∶2、乳水比为1∶5、萃取时间为15min时,废水中的酚类(以苯酚计)去除率达到85%以上,COD去除率达83%以上。     

组氨酸-Co(Ⅱ)光度法测定水中溶解氧的研究

以氧载体作显色体系,提出了组氨酸－Ｃｏ（Ⅱ）光度法测定水中溶解氧的方法;并用从实验中得到的（Ｃｏ）－（Ｏ２）关系,尝试用Ｃｏ标准溶液代替Ｏ２标准,解决了Ｏ２标准的难题。该方法简单、快速、取样量少、准确度高。ＤＯ的测定范围为０．１￣２０ｍｇ／Ｌ。     

考虑偏应力比影响的主应力轴旋转下重塑黄土变形研究

采用浙江大学空心圆柱扭剪仪对重塑黄土试样进行了3种复杂应力路径下的试验,研究了主应力轴旋转条件下偏应力比η对重塑黄土变形特性的影响。试验结果表明,不同偏应力比下重塑黄土的强度差异较大,η=0.133时归一化强度最小,而η=0.433时强度最大,偏应力比η从0.133到0.5时归一化强度呈现增大—减小—增大—减小的规律。主应力轴旋转对重塑黄土的各应变增量均有影响,并且对中间主应变增量的影响最大,其中大主应变和小主应变在ε-q平面内对称开展,且总体表现出Δεz0,Δεθ0的趋势,中间主应变整体呈现Δεr0的发展趋势,当应力主轴旋转目标角度α45°时,中间主应变呈现出不同的开展形式,重塑黄土在应力主轴旋转下向异性较为显著。     

臭氧/活性炭协同作用去除二级出水中DON

为探讨臭氧氧化和活性炭吸附对城市污水厂二级出水中溶解性有机氮(DON)的去除机制,首先测定二级出水DON、溶解性有机炭(DOC)、UV254、pH值等指标.接着通过臭氧氧化试验和活性炭吸附试验来考察二级出水中DON、DOC和UV254变化,以及DON分子量分布和DON亲疏水性变化,并应用三维荧光光谱对二级出水中DON变化进行表征.结果表明,当臭氧投加量为8mg/L,DON的去除率大约为33.9%,DOC和UV254去除率约21.2%、66.7%;当活性炭投加量为2.0g/L,DON、DOC和UV254的去除率大约为43.4%、27.6%、92.2%;臭氧氧化和活性炭吸附组合试验时,对DON的去除率大约为83.3%和81.5%;臭氧氧化提高小分子量( 20kDa)的DON所占比例;活性炭吸附降低小分子量( 20kDa)DON所占比例为;臭氧氧化和活性炭吸附都提高亲水性DON所占比例,而降低疏水性和过渡性DON所占比例;三维荧光光谱证实,二级出水中DON变化与3个主要峰有关,分别代表物质为色氨酸类蛋白质、芳香族类蛋白质和富里酸类物质.     

The research of market structures for remanufactured products

The rapid development of technology has made it easier to distribute products directly, and many enterprises excel at executing a multi-channel strategy to distribute products. The introduction of direct channel adds a new competition dimension to the enterprises. This paper considers three market channel structures: R-Channel, D-Channel and H-Channel. In R-Channel, both new products and remanufactured products are sold through a retailer. In D-Channel, new products are sold through retailers and remanufactured products are sold directly to consumers. In H-Channel, new products are sold through retailers, while remanufactured products through dual channel. Using the game theory, we obtain and analyse the equilibrium prices, market demands and the profits gain under these three settings. At the same time, the influence of consumers’ willingness to pay on the environment performance is researched. Our results show that the manufacturer prefers H-Channel. By introducing the direct channel the manufacturer is always economically better off, but it is not for the retailer. The numerical simulation also confirms the theoretical analysis and shows that H-Channel has advantages of economic benefit and environmental performance. It is feasible for practical application.     

The impact of government subsidy and tax policy on the competitive decision-making of remanufacturing supply chains

In this paper, we consider a two-period competition model of a remanufacturing supply chain consisting of three members: a new product manufacturer, a recycler and a remanufacturer. The manufacturer supplies new products in the first period and the remanufacturer participates in the competition in the second period. We consider three scenarios in the second period: (1) there is no government subsidy in the competition; (2) there is only government subsidy in the competition; (3) there are both government subsidy and tax in the competition. First, we give the optimal decision-making of the manufacturer, the remanufacturer and the government in the three scenarios; second, we analyse changes in the decision-making of the manufacturer and remanufacturer in the three scenarios and compare their results. We analyse the effects of government subsidy and tax and their asymmetric use on manufacturers’ and remanufacturers’ decision-making variables and competitive performance. We also take consumer awareness of environmental protection into account and examine its impact on subjects’ decisions. Lastly, we operate a numerical example to show the results.     

Estimate on spillover effect of environmental pollution between peripheral areas

ABSTRACT

Interaction of environmental pollution between peripheral areas has become a central topic in the field of resources and environment but little is known about the actual impact on peripheral areas in the current literature. This paper sets out a simultaneous equation model to investigate the spillover effect of environmental pollution between China’s peripheral areas utilizing the panel data of 218 cities in China. Making use of indicators for measuring the impact on environmental pollution, it identifies that environmental pollution between cities of China has a significant two-way spillover effect. After standardization of variables, it is found that the spillover effect of peripheral areas on urban environmental pollution cannot be neglected. Nearly, a third of the environmental pollution level in a city is induced by the environmental pollution in peripheral areas. If the indicator of environmental pollution in peripheral areas is missing, wrong conclusions will be drawn. Therefore, government should shift the emphasis of environmental regulation from local to global, and improve the overall environmental quality through coordinated management of regional environment.