超强静磁场对染料脱色菌Escheriehia coli的acpD基因的影响

将大肠杆菌E.coli ATCC8739置于12.0 T超强静磁场(ultra-strong static magnetic field,SMF)中进行处理,获得了磁场处理0.5、1、2、4和8 h的菌株E.coli-SMFn(n=0.5、1、2、4、8)。在37℃、pH 7、静置的条件下,菌株对偶氮染料AR14(I.C.Acid Red 14)的脱色结果指出,当反应进行到4、6和8 h时,E.coli-SMF8的脱色效率分别为18%、55%和96%,远高于E.coli ATCC8739的3%、19%和50%,表明SMF作用显著地增强了菌株的脱色效率。基因组DNA提取、PCR扩增、分子克隆以及基因测序的实验结果进一步表明,全部6例E.coli ATCC8739菌株的偶氮还原酶基因(acpD)序列均与GenBank中报道的完全一致;而E.coli-SMF8菌株的acpD-SMF8核酸序列中缺失了第99位的胞嘧啶。该缺失突变不仅使acpD-SMF8的核酸序列与acpD的存在显著不同,同时得到了具新活性中心的偶氮还原酶AzoR-SMF8。这个新的活性中心具有更强的黄素(FMN)结合能力,因此使该酶与偶氮染料的亲和力大大增加,促进了脱色效率的提高。     

烟气同时脱硫脱氮生物膜填料塔的适用外加碳源

实验分别考察了外加乙酸钠、葡萄糖、酒石酸钾钠、甲醇等4种低分子有机碳源对生物膜填料塔烟气同时脱硫脱氮效率的影响。结果表明,外加乙酸钠的脱氮效果最佳,对NOx的平均去除率为62.05%;外加葡萄糖、酒石酸钾钠、甲醇时的NOx平均去除率分别为51.03%、46.98%、58.71%。乙酸钠、酒石酸钾钠、甲醇均能使SO2的去除率达到100%,葡萄糖显著降低了SO2的去除率。乙酸钠是在生物膜填料塔烟气同时脱硫脱氮技术中适宜的外加碳源。     

抗压实验法厌氧颗粒污泥机械强度的测定及影响因素分析

通过首先对厌氧颗粒污泥样品进行筛分,然后测定其机械强度,解决了实际操作过程中现有抗压实验法出现的精确度与重现性较差的问题。通过对不同来源厌氧颗粒污泥样品机械强度的测定、对比分析发现,厌氧颗粒污泥的机械强度大小与反应器的规模、反应器所采用水力负荷存在一定的正相关性,且与其主要金属元素（Ca、Fe和Mg）含量的大小存在着密切的关系。     

生物膜填料塔净化模拟烟气和电厂烟气中SO2和NOx的对比实验

对生物膜填料塔对模拟烟气和电厂烟气的净化效果进行了实验研究。实验对比分析了在相同的实验条件下生物膜填料塔对不同烟气中SO2和NOx的净化效率。实验结果表明,在循环液温度在24～35℃、空床停留时间（EBRT）为60s、喷淋量为8～10L／h、脱硫塔的pH为0．8～1．5、脱氮塔的pH为7．5～8．0的条件下,生物膜填料塔对模拟烟气和电厂烟气中SO2的净化效率都很高,但模拟烟气条件下的总脱氮率的平均值为80％,而在电厂烟气条件下只有35％。经分析认为,脱氮率产生差异的主要原因是电厂烟气中杂质的影响,以及烟气中氧气含量的不同,同时因为生长条件不同从而驯化出的微生物群体组成也不同。     

Spatial distribution of perfluoroalkyl acids in the Pearl River of Southern China

An intensive campaign was conducted in September 2012 to collect surface water samples along the tributaries of the Pearl River in southern China. Thirteen perfluoroalkyl acids (PFAAs), including perfluorocarboxylates (PFCAs, C4–C11) and perfluorosulfonates (PFSAs, C4, C6–C8, and C10), were determined using high-performance liquid chromatography/negative electrospray ionization–tandem mass spectrometry (HPLC/(-)ESI–MS/MS). The concentrations of total PFAAs (ΣPFAAs) ranged from 3.0 to 52 ng L⁻¹, with an average of 19 ± 12 ng L⁻¹. The highest concentrations of ΣPFAAs were detected in the surface water of the Dong Jiang tributary (17–52 ng L⁻¹), followed by the main stream (13–26 ng L⁻¹) and the Sha Wan stream (3.0–4.5 ng L⁻¹). Perfluorooctanoate (PFOA), perfluorobutane sulfonate (PFBS), and perfluorooctane sulfonate (PFOS) were the three most abundant PFAAs and on average accounted for 20%, 24%, and 19% of ΣPFAAs, respectively. PFBS was the most abundant PFAA in the Dong Jiang tributary, and PFOA was the highest PFAA in the samples from the main stream of the Pearl River. A correlation was found between PFBS and PFOA, which suggests that both of these PFAAs originate from common source(s) in the region. Nevertheless, the slope of PFBS/PFOA was different in the different tributaries sampled, which indicates a spatial difference in the source profiles of the PFAAs.     

碘掺杂Ti02可见光光催化性能研究

在低于100℃温度条件下,采用溶胶一凝胶法以钛酸正丁酯为钛源,碘酸钾为碘源,制备了I掺杂纳米TiO2催化剂（I-TiO2）,运用x-射线衍射（XRD）、透射电镜（TEM）及x-射线光电子能谱（XPS）等对催化剂进行表征,结果表明,TiO2及I-TiO2催化剂均为锐钛矿,I吸附并包裹在TiO2表面或以间隙进入的形式存在,并未进入TiO2晶格。通过在可见光照射下（A〉420nm）以罗丹明B（RhodamineB,RhB）的光催化降解为探针反应研究了在不同条件下制备催化剂的催化性能,结果表明,掺杂比为n1：n^ti=0．05：l,焙烧温度为400℃,降解介质条件pH=7时,l-TiO2光催化活性明显优于未掺杂的TiO2。光催化降解过程通过红外光谱（IR）,总有机碳（TOC）跟踪测定,比较了TiO2掺杂前后降解RhB和对氯苯酚（4-CP）的光催化特性差异;同时采用苯甲酸荧光光度法跟踪测定体系中的氧化物种,表明在可见光下,I-TiO2光催化体系中产生·OH高活性氧化物种从而氧化降解目标化合物。     

粉煤灰免烧陶粒制备及其重金属废水净化性能

摘要重金属废水对环境的污染已经引起科研人员的广泛关注。以粉煤灰和水泥为原料、添加活性成分FeS,制备一种免烧陶粒用于含重金属Cu2＋、Zn2＋、Pb2＋的废水处理。探讨了物料配比及蒸养时间对陶粒筒压强度及其比表面积的影响;研究了固液比、接触时间、pH、温度及初始溶液浓度等因素对Cu2＋、Zn2＋、Pb2＋离子净化效果的影响规律,并对实验结果进行了等温线拟合。XRD分析显示,免烧陶粒中存在Ca（OH）2、C—D—H、FeS等矿物相,对重金属离子具有非常好的固定化作用。该免烧陶粒对重金属离子具有很好的去除效果,具备较好的应用前景。     

高职教育考试方法改革的探索与实践

根据高职教育教学的要求和课程特点,尤其是为适应培养应用型人才的教学模式,打破“高分低能”的现象,充分发挥考试在高职教育中的指导性作用,本文以食品质量与安全专业的课程为例,对考试考核方法的改革进行了探索与实践。高职教育的考试应突出应用能力考核,加强实践技能检验,坚持在实践中学习、在实践中考核,全面推行操作技能考核,施行“考教分离”,考试形式多样化的原则。     

Accelerated seeded precipitation pre-treatment of municipal wastewater to reduce scaling

Membrane based treatment processes are very effective in removing salt from wastewater, but are hindered by calcium scale deposit formation. This study investigates the feasibility of removing calcium from treated sewage wastewater using accelerated seeded precipitation. The rate of calcium removal was measured during bench scale batch mode seeded precipitation experiments at pH 9.5 using various quantities of calcium carbonate as seed material. The results indicate that accelerated seeded precipitation may be a feasible option for the decrease of calcium in reverse osmosis concentrate streams during the desalination of treated sewage wastewater for irrigation purposes, promising decreased incidence of scaling and the option to control the sodium adsorption ratio and nutritional properties of the desalted water. It was found that accelerated seeded precipitation of calcium from treated sewage wastewater was largely ineffective if carried out without pre-treatment of the wastewater. Evidence was presented that suggests that phosphate may be a major interfering substance for the seeded precipitation of calcium from this type of wastewater. A pH adjustment to 9.5 followed by a 1-h equilibration period was found to be an effective pre-treatment for the removal of interferences. Calcium carbonate seed addition at 10 g l⁻¹ to wastewater that had been pre-treated in this way was found to result in calcium precipitation from supersaturated level at 60 mg l⁻¹ to saturated level at 5 mg l⁻¹. Approximately 90% reduction of the calcium level occurred 5 min after seed addition. A further 10% reduction was achieved 30 min after seed addition.     

How should environmental exposure risk be assessed? A comparison of four methods for exposure assessment of air pollutions

Methods commonly used to assess the environmental exposure risk at a location (e.g., proximity models) are usually based on different assumptions, leading to conflicting results and recommendations in epidemiological studies. In this case study, a comparative evaluation of the accuracy levels associated with four commonly used exposure risk estimate models [i.e., traditional proximity model (TPM), emission weighted proximity model (EWPM), the American Meteorological Society/EPA regulatory model (AERMOD), and ordinary kriging interpolation (OKI)] were conducted. Results show that at the annual and the monthly scales, the normalized exposure risk values simulated by AERMOD and EWPM have higher accuracy levels than the simulations from the TPM and OKI methods. However, AERMOD has higher accuracy than that of the EWPM, and this was attributed to the differences of input data. EWPM provided the most accurate simulations when analysts have access to only point emission source data. The results also indicate that the accuracies of the exposure risks simulated by AERMOD and EWPM can be influenced by factors such as the modeling extent, the distance settings, and so forth.