Levels of synthetic musk fragrances in human milk from three cities in the Yangtze River Delta in Eastern China

Synthetic musks are used as additives in many household products. After absorption into the human body, they accumulate and their concentrations in human milk reflect both the mother and her infant’s exposure level. Concentrations of four synthetic musks, musk xylene (1-tert-butyl-2,6-dimethyl-2,4,6-trinitrobenzene, MX), musk ketone (4-tert-butyl-2,6-dimethyl-3,5-dinitroacetophenone, MK), 1,3,4,6,7,8-hexahydro-4,6,6,7,8,8-hexamethylcyclopenta[ ]-2-benzopyran (HHCB) and 7-acetyl-1,1,3,4,4,6-hexamethyl-1,2,3,4- tetrahydronaphthalene (AHTN), were determined in human milk samples collected from Shanghai, Wuxi, and Shaoxing in Eastern China. The four synthetic musks were found in most samples analyzed, with HHCB the dominant component followed by MX. The median (mean) values for HHCB, AHTN, MX and MK concentrations were 63 (82), 5 (12), 17 (24) and 4 (9) ng/g lipid weight, respectively. These data suggested the total synthetic musk contamination was low, and the distribution percentage was HHCB > MX > AHTN MK. The relative high ratio of nitro to polycylic musk indicated that nitro musks were still widely used. The musk concentrations in these cities were not significantly different from each other (p > 0.05). Principal components score plots were obtained, which showed similar exposure sources. The amount of total synthetic musks in human milk were not associated with mother’s age, although HHCB was significantly correlated with AHTN (p < 0.05). Daily ingestion of HHCB, AHTN, MX and MK for infants from human milk were estimated as (2526 2926), (370 524), (7391 832), and (277 462) ng/day, respectively. Those doses were 1–2 orders of magnitude below the provisional tolerable daily intakes.     

Polybrominated diphenyl ethers in surface sediments of the Yangtze River Delta: Levels, distribution and potential hydrodynamic influence

A total of 32 surface sediments collected from the Yangtze River Estuary, Hangzhou Bay and the Qiantang River were analyzed for polybrominated diphenyl ethers (PBDEs). The concentrations of summation operatorPBDEs (sum of 12 PBDE congeners without BDE 209) and BDE 209 varied from n.d. to 0.55 and from 0.16 to 94.6 ng/g, respectively. The spatial variability of summation operatorPBDEs concentrations indicated that waste discharge from the urban areas might been the main source of PBDEs in the Yangtze River Delta. BDE 209 was the predominant congener (approximately 90-100%) detected among the 13 congeners, consistent with the fact that technical deca-BDE mixtures are presently the dominant technical PBDE mixtures used in China. Compared to published data acquired from other locales, PBDE congeners with less than four bromines were more abundant in the present study area. The hydrodynamic conditions may likely be a significant factor in dictating the observed levels and congener distribution patterns of PBDEs.     

Insight into the mechanisms of trichloronitromethane formation by vacuum ultraviolet: QSAR model and FTICR-MS analysis

Vacuum ultraviolet(VUV) photolysis is recognized as an environmental-friendly treatment process. Nitrate(NO-3) and natural organic matter(NOM) are widely present in water source.We investigated trichloronitromethane(TCNM) formation during chlorination after VUV photolysis, because TCNM is an unregulated highly toxic disinfection byproduct. In this study:(1) we found reactive nitrogen species that is generated under VUV photolysis of NO-3react with organic matter to form nitrogen-containing compo...     

驯化筛选微生物对油制气废水的降解特性

从5个菌源分离到的16株菌中筛选出S－2、Y－3和XH－3为优势菌种,分别用它们及其混合菌M－3研究对油制气废水的降解,60h之后CODcr的去除率为38．4％－44．0％,酚类化合物的去除率为95．4％－97．0％,芳烃类化合物的去除率为47．1％－53．7％,但氨氮的去除率只有14．0％－17．6％。采用GC／MS分析了处理前后废水中的芳烃类化合物,所筛选的微生物对芳环数≤3的芳烃类化合物降解能力强,还可去除一定量芳环数为4－6的芳烃类化合物。加入共代谢基质葡萄糖,可使CODcr、氨氮及可萃取有机物的去除率分别提高13．1％－22．9％、18．4％－22．7％及13．1％－18．1％;加入乙醇,可使CODcr、氨氮及可萃取有机物的去除率分别提高12．5％－21．2％、29．7％－42．2％及6．7％－7．7％。废水中芳烃类化合物的总去除率分别比无葡萄糖和无乙醇时提高了17．7％－21．7％和15．4％－21．2％。所筛选驯化的菌种有效地提高了油制气废水的降解效率。     

Reductive degradation of nitrobenzene in aqueous solution by zero-valent iron

The reductive degradation of nitrobenzene (NB) by zero-valent iron was investigated. Experimental results showed that the degradation of NB was influenced by pH and NB concentration. The optimum pH value was found to be 3.0 for the reductive degradation of NB in the tested pH ranges of 3.0-12.0. The formation rate of aniline, a major reductive product of NB, followed zero-order kinetics at various pH levels. Furthermore, GC/MS analysis showed that aniline, azobenzene and azoxybenzene were the reductive products of NB by zero-valent iron. With the analysis of the products with GC/MS and FTIR, possible reductive pathways of NB by zero-valent iron were suggested.     

Fractionation and composition of colloidal and suspended particulate materials in rivers

The association of pollutants (nutrients, heavy metals and organic compounds) with colloidal and suspended particle matter (SPM) plays a dominant role in determining their transport, fate, biogeochemistry, bioavailability and toxicity in natural waters. A scheme for the fractionation and composition of colloidal and SPM from river waters has been tested. All four separation methods, i.e. sieving, continuous flow centrifugation, tangential flow filtration, sedimentation field-flow fractionation, were for the first time used to separate five size particulate fractions from river. Significant (gram) amounts of colloidal material (<1 microm) in three size ranges, nominally 1-0.2, 0.2-0.006 and 0.006-0.003 microm were obtained. The separation scheme was able to process large samples (100 l), within reasonable times (1 day) and the apparatus was portable. The aquatic colloid size was also characterized with high resolution by using sedimentation field-flow fractionation technique. The mass-based particle size distribution for the water sample showed a broad size distribution between 0.05 and 0.4 microm with the maximum around 0.14 microm. There was a systematic increase in the content of organic carbon (estimated by loss on ignition), Mg, Ca, Na, Cu and Zn with decreasing particle size, highlighting the importance of the colloidal (<1 microm) fraction. It was concluded that the colloidal Cu and Zn concentrations in rivers might be much higher than those reported before.     

Influences of pH value in deposition-precipitation synthesis process on Pt-doped TiO2 catalysts for photocatalytic oxidation of NO

This work has been undertaken to study the influences of pH value on the characteristics and activity of photocatalyst by deposition-precipitation method during its preparation process. A series of Pt-modified TiO₂ were prepared by deposition-precipitation method at different pH values as well as wet impregnation method, and characterized by XRD, XPS, TEM, UV-Vis and photoluminescence (PL). It was found that the catalysts had the highest photocatalytic activity for NO conversion when pH value was kept at around 7. And the sample prepared by deposition-precipitation method showed higher activity than that by impregnation method. This was mainly due to their high value in highly-dispersed platinum oxides (PtOx) content on the surface of the catalysts. The results from UV-Vis absorption showed that highest absorbance was obtained for Pt/TiO₂ prepared at pH values of around 7. And PL spectra results indicated that the recombination rate of photogenerated electrons and holes of the samples prepared by deposition-precipitation method was lower than that prepared by impregnation method. And in the zeta potential study, the pH values for the isoelectric point of the preparing slurry of 0.05 wt.%Pt/TiO₂ and 0.5 wt.%Pt/TiO₂ were determined to be 6.5-8.5, which further confirmed the enrichment of PtOx dopants for the catalysts repapered when pH value was around 7.     

Polychlorinated biphenyls contamination in urban soil of Shanghai: level, compositional profiles and source identification

Surface soil samples taken from 55 sampling sites at the urban areas of Shanghai were collected and analyzed for the occurrence of 144 polychlorinated biphenyls (PCBs) by GC-μECD. The results showed that totally 74 PCB congeners were identified and the mean concentration of total PCBs was 3057 ng kg⁻¹ with a range of 232 to 11325 ng kg⁻¹. Compared with the related reports, the level of PCBs contamination in this study was approximately equal to the global background value in soils, but higher than Chinese background for rural and urban soils. According to the compositional profiles of PCBs homologues, a higher proportion of low chlorinated (from tri-CBs to hexa-CBs) was observed. The results indicated that PCB15 + 13, PCB18, PCB28, PCB104 + 47 and PCB153 were the most dominant congeners among the identified PCBs. Through homologues analysis, cluster analysis and principal component analysis (PCA), it was found that PCBs were stretched from mixed local sources, and appeared to be mostly originated by Aroclor 1260- and 1254-like mixtures as well as some samples influenced by Aroclor 1232 and 1242. The correlation analysis showed the relatively good correlation among the PCB homologues and soil total organic carbon (TOC), suggesting important influence of soil TOC on PCBs contamination in soil matrix in Shanghai region. The toxic equivalency (TEQ) concentrations of these six dioxin-like PCBs detected in urban soil samples range from 2.71 to 24.9 pg kg⁻¹-PCDDeq with a mean 8.18 pg kg⁻¹-PCDDeq.     

Application of an enzyme-linked immunosorbent assay for the detection of clenbuterol residues in swine urine and feeds

The present study outlines applications of an enzyme-linked immunosorbent assay (ELISA) for the analysis of clenbuterol residues. Antisera were raised from rabbits immunized with diazotized clenbuterol-bovine serum albumin (BSA) conjugate. The assay was specific to clenbuterol with a half-maximum inhibition concentration (IC(50)) of 1.8 ng/mL and 2.5 ng/mL in blank swine urine and phosphate buffer solution, respectively. The assay had high cross-reactivity (86%) with mabuterol, but low with other adrenergic agonists and antagonists. The average recovery of clenbuterol, as measured with the ELISA, ranged from 90% to 112% in swine urine samples and from 86% to 95% in feeds, respectively. This new assay was compared with commercial ELISA test kits. An excellent correlation (r(2) = 0.98) between the two methods and satisfactory recoveries suggest that the new assay can be suitable for the determination of clenbuterol residues in real samples. The assay was used to analyze clenbuterol residues in 103 swine urine samples and 68 feed samples collected from northern China. Approximately 50% of the urine samples and 25% of the feed samples analyzed were found positive (concentration of clenbuterol > or = 1 ppb). The results indicate that clenbuterol was misused in some of the areas surveyed.     

Preliminary study on the occurrence and distribution of polycyclic musks in a wastewater treatment plant in Guandong, China

The occurrence and distributions of six polycyclic musks were studied in influent, primary and effluent waters from a municipal wastewater treatment plant (WWTP) in Guangdong. Five polycyclic musk compounds, 1,2,3,5,6,7-hexahydro-1,1,2,3,3-pentamethyl-4H-inden-4-one (DPMI), 4-acetyl-1,1-dimethyl-6-tert-butylindan (ADBI), 6-acetyl-1,1,2,3,3,5-hexamethylindan (AHMI), 1,3,4,6,7,8-hexahydro-4,6,6,7,8,8-hexamethylcyclopenta(g)-2-benzopyran (HHCB) and 7-acetyl-1,1,3,4,4,6-hexamethyl-1,2,3,4-tetrahydronaphthalene (AHTN) were found in wastewater in the WWTP. DPMI, HHCB and AHTN were measured at 0.38-0.69, 11.5-146, 0.89-3.47 microg/l, respectively, in influents. Meanwhile 0.06-0.10 microg/l DPMI, 0.95-2.05 microg/l HHCB, 0.10-0.14 microg/l AHTN were detected in effluents, ADBI and AHMI were also detected in some primary waters and effluents. The results suggested that wastewater from cosmetic plants cause high loadings of polycyclic musks to this WWTP. Under the currently applied treatment technology, the removal efficiencies achieved were 61-75% for DPMI, 86-97% for HHCB and 87-96% for AHTN by transfer to sludge as the main removal route.