The organic composition of diesel particulate matter, diesel fuel and engine oil of a non-road diesel generator

Diesel-powered equipment is known to emit significant quantities of fine particulate matter to the atmosphere. Numerous organic compounds can be adsorbed onto the surfaces of these inhalable particles, among which polycyclic aromatic hydrocarbons (PAHs) are considered potential occupational carcinogens. Guidelines have been established by various agencies regarding diesel emissions and various control technologies are under development. The purpose of this study is to identify, quantify and compare the organic compounds in diesel particulate matter (DPM) with the diesel fuel and engine oil used in a non-road diesel generator. Approximately 90 organic compounds were quantified (with molecular weight ranging from 120 to 350), which include alkanes, PAHs, alkylated PAHs, alkylbenzenes and alkanoic acids. The low sulfur diesel fuel contains 61% alkanes and 7.1% of PAHs. The identifiable portion of the engine oil contains mainly the alkanoic and benzoic acids. The composition of DPM suggests that they may be originated from unburned diesel fuel, engine oil evaporation and combustion generated products. Compared with diesel fuel, DPM contains fewer fractions of alkanes and more PAH compounds, with the shift toward higher molecular weight ones. The enrichment of compounds with higher molecular weight in DPM may be combustion related (pyrogenic).     

Groundwater quality under the influence of spent mushroom substrate weathering

Nitrate and other solutes resulting from field-weathering of spent mushroom substrate (SMS) percolate into underlying soils and may migrate to groundwater. A field trial was conducted to investigate the potential influences of SMS weathering on groundwater quality. Spent mushroom substrate was deposited at 90 and 150 cm pile depths over a Typic Hapludult and weathered for 2 years. Eight casing wells were installed around the SMS piles to monitor the quality changes of groundwater with a high seasonal water table of 760 cm below the surface. Although leachate solutes had moved more than 200 cm deep in soil from the surface, no significant changes of groundwater quality caused by SMS weathering were observed even one year after removal of the SMS piles (3 years total). The groundwater had pH, electrical conductivity (EC) and dissolved organic carbon (DOC) of 4.3-5.7, 0.2-0.3 dS m(-1) and 0.7-2.2 mg L(-1), respectively. The major inorganic ions were Mg(2+), Ca(2+), Na(+), Cl(-), SO(4)(2-) and NO(3)(-), with a concentration range of 2.5-68.3 mg L(-1). The results suggest that SMS leachate solutes migrated fairly slow in deep subsurface soils of the experimental field. Considering that leachate solutes may move several meters in soil through preferential flow channels, weathering of SMS in fields with a high seasonal groundwater table >or=5 m below the ground is recommended. Conservatively, SMS weathering should be conducted on compact surfaces and leachate be collected and reused as liquid fertilizers.     

Interlaboratory evaluation of endotoxin analyses in agricultural dusts--comparison of LAL assay and mass spectrometry

Endotoxin exposure is associated with wheeze and asthma morbidity, while early life exposure may reduce risk of allergy and asthma. Unfortunately, it is difficult to compare endotoxin results from different laboratories and environments. We undertook this study to determine if lipopolysaccharide (LPS) extraction efficiency could account for differences among laboratories. We generated and collected aerosols from chicken and swine barns, and corn processing. We randomly allocated side-by-side filter samples to five laboratories for Limulus assay of endotoxin. Lyophilized aliquots of filter extracts were analyzed for 3-hydroxy fatty acids (3-OHFAs) as a marker of LPS using gas chromatography-mass spectrometry. There were significant differences in endotoxin assay and GC-MS (LPS) results between laboratories for all dust types (p < 0.01). Patterns of differences between labs varied by dust type. Relationships between assay and GC/MS results also depended on dust type. The percentages of individual 3-OHFA chain lengths varied across labs (p < 0.0001) suggesting that each lab recovered a different fraction of the LPS available. The presence of large amounts of particle associated LPS and absence of a freezing thawing cycle were associated with lower correlations between LPS and bioactivity, consistent with an absence of Limulus response to cell-bound endotoxin. These data suggest that extraction methods affect endotoxin measurements. The LAL methods may be most suitable when comparing exposures within similar environments; GC-MS offers additional information helpful in optimizing sample treatment and extraction. GC-MS may be of use when comparing across heterogeneous environments and should be considered for inclusion in future studies of human health outcomes.     

Organic contaminants in the Firth of Clyde following the cessation of sewage sludge dumping

To assess contaminant concentrations in the Firth of Clyde in relation to the former sewage sludge dump site at Garroch Head, and investigate any temporal changes, fish have been sampled annually since 1992 and sediment since 1999. In addition, a further four locations in the Clyde (Holy Loch, Hunterston, Skelmorlie and Irvine Bay) have been sampled for fish and sediment since 1999. Chlorobiphenyls (CBs) were measured in fish samples and polycyclic aromatic hydrocarbons (PAHs) and CBs in sediment. Since sampling was initiated the concentration for the summation operatorICES7 CBs in fish liver has been consistently >500 microg kg(-1) lipid weight at Garroch Head and the other Clyde sites and lower at the reference sites (Pladda, Colonsay, Broad Bay). Although the lowest CB concentrations of the eleven year period in plaice liver from Garroch Head were found in 2002, CB concentrations were found not to have decreased significantly since sewage sludge dumping ceased in 1998. However, a change in CB profile was observed with fish liver collected between 1992 and 1998 from Garroch Head showing a lower proportion of the less chlorinated CBs compared to the 1999-2002 liver samples. Highest CB and PAH concentrations in sediment were found at Garroch Head and Holy Loch with concentrations at these sites being significantly higher than at all other sites.     

Influence of environmental parameters on the accuracy of nitrogen dioxide passive diffusion tubes for ambient measurement

Two studies at three sites in the UK provided confirmation that systematic positive bias in NO2 diffusion tube measurement occurred because of changes to "within-tube" chemistry, rather than eddy diffusion at the mouth of the tube. In the first study in Cambridge, UK, sampler overestimation for 1 and 2 week exposures was compared to corresponding time-averaged monitor measurements (NO-NO2-NOx, O3) and weather variables. Noninearity between sampler and monitor NO2 measurements was interpreted in terms of spatial and temporal variations in relative and absolute availability of NO, NO2 and O3 at the site. A maximum overestimation occurred for an exposure mean NO2/NOx approximately 0.5. The separate contributions of reduced NO2 photolysis and eddy diffusion were compared in Study II using samplers of two materials, acrylic and quartz, and of different lengths (40, 55, 71 and 120 mm) at three sites: Norwich background, Cambridge intermediate, London kerbside. For compared sites, NO2 measured by acrylic samplers was significantly higher than for equivalent quartz samplers. For quartz samplers [NO2]mean was only just above the monitor at Norwich and London; sampler/monitor NO2 = 1.04 (P = 0.59) and 1.01(P = 0.76), respectively. For acrylic samplers the order of [NO2]mean was 40 mm > 120 mm > 71 mm > or = 55 mm. Excepting 40 mm samplers, this accords with a chemical bias where co-diffusing NO and 03 molecules in longer tubes have more time to react to form excess NO2. Bias in 40 mm samplers is discussed. Eddy diffusion is negligible for standard samplers because [NO2]mean was equivalent for 55 mm and 71 mm acrylic samplers and close to monitor NO2 for 71 mm quartz tubes. Both studies showed that sampler accuracy was dependent on location. Significantly, overestimation was greatest (approximately 3-4 ppb) where the NO2 annual mean was approximately 20 ppb, close to the UK and EU air quality standard of 21 ppb.     

The importance of temperature in assessing iron pipe corrosion in water distribution systems

Temperature is expected to play a significant role in the corrosion of iron pipes in drinking water distribution systems. Temperature impacts many parameters that are critical to pipe corrosion including biological activity, physical properties of the solution, thermodynamic and physical properties of corrosion scale, and chemical rates. Moreover, variations in temperature and temperature gradients may give rise to new corrosion phenomena worthy of consideration by water treatment personnel.     

Nitrogen isotope ratios in pine bark as an indicator of N emissions from anthropogenic sources

The article describes the use of Scots pine bark to identifynitrogen sources in eastern Germany, as well as background areas in Russia and Bulgaria, by using natural isotope ratios of total nitrogen (N_t) and individual N compoundssuch as ammonium (NH₄ ⁺), nitrate (NO₃ ^-)and amid nitrogen (amide-N). The samples collected were analysed using an elemental analyser in connection with a gas isotope mass spectrometer (EA-IRMS). Natural ¹⁵N abundances in pine bark from impact areas suggest that the ammonium accumulated on the surface of the bark is releasedfrom livestock management. Bark of Scots pines growing near agricultural land had highly depleted ¹⁵N_t values (between –8 and –12), while bark from background areas (unpolluted areas) displayed slightly negative ¹⁵N_t values (mean ¹⁵N_t = –3.8). It is assumed that part of the N adsorbed on the bark surface is mainly derived from ammonia(mean ¹⁵N_t = –40.3) escaping from livestock housing and during the application of manure. This assumption is confirmed by experiments under controlled conditions in which manure samples were spread on soil. In addition, temporal and spatial variations of ¹⁵N_t abundances in pine bark from various locations in eastern Germany as wellas pine stands in Nature Park Dübener Heath are discussed.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Data needs for occupational epidemiologic studies

Data needs in an epidemiologic study can appear to be substantial in light of the other responsibilities of an industrial hygienist. Many of the data needed for this type of investigation, however, are already collected for other exposure assessment purposes. To increase understanding of this concept, the data needs for the major purposes for conducting an exposure assessment are identified. The purposes include determining compliance; implementing industrial hygiene programs, such as personal protective and respiratory equipment, hazard communication training, and medical surveillance; investigating health complaints and worker concerns; investigating tasks or engineering control effectiveness; investigating toxic tort or worker compensation claims; and conducting epidemiologic studies. A comprehensive exposure assessment system is then described that incorporates the data needs for all these purposes, including epidemiologic studies. The data needs of epidemiologic studies and how the data are used are then described and illustrated with examples taken from published epidemiologic studies.     

Evaluation of two adsorbents for diffusive sampling and thermal desorption-gas chromatographic analysis of monoterpenes in air

Tube type samplers with two different adsorbents, Chromosorb 106 and Tenax TA, were evaluated by laboratory experiments and field tests for simultaneous diffusive sampling of alpha-pinene, beta-pinene and delta 3-carene and subsequent thermal desorption-gas chromatographic analysis. No statistically significant effects of exposure time, concentrations of monoterpenes or relative humidity were found for samplers with Chromosorb 106 when running a factorial design, with the exception of the adsorption of delta 3-carene, for which some weak effects were noted. Samplers with Tenax TA were affected by the sampling time as well as the concentration for all terpenes, with a strong interaction effect between these two factors. The terpenes showed good storage stability on both adsorbents. No effect of back-diffusion was noted when using Chromosorb 106, while Tenax TA showed some back-diffusion effects. The uptake rates, in ml min-1, for the terpenes on Chromosorb 106 were 0.36 for alpha-pinene, 0.36 for beta-pinene and 0.40 for delta 3-carene. The corresponding average values on Tenax TA were 0.30 for alpha-pinene, 0.32 for beta-pinene and 0.38 for delta 3-carene. The field validation proved that diffusive sampling on Chromosorb 106 agreed well with pumped sampling on charcoal for stationary samples, while the personal samples indicated a discrepancy of 25% between Chromosorb 106 and charcoal samples. Tenax TA generally gave lower results than Chromosorb 106 in all field samples. Samplers packed with Chromosorb 106 could be used to monitor terpene levels in workplaces such as sawmills. The major advantages with this method are the sampling procedure, which is simple to perform compared to other techniques, the easily automated analysis procedure and the possibility to reuse the samplers.