Adsorption characteristics of a phenoxy acetic acid herbicide on activated carbon

The adsorption of 2,4-dichlorophenoxyacetic acid (2,4-D) by two powdered coal activated carbons was studied in aqueous solution. The modelling of the adsorption equilibrium showed that the adsorption of 2,4-D fitted a Langmuir isotherm. Adsorption was influenced by the activated carbon type, adsorbent concentration and solution characteristics. The adsorption was found to decrease with an increase in pH over the range 1.5-9. Maximum adsorption occurred at pH approximately 2.5, which corresponds to the 2,4-D pKa value. The amount of 2,4-D adsorbed was also found to depend on the NaCl concentration.     

Determination of n-alkanes and polycyclic aromatic hydrocarbons in atmospheric particulate and vapour phases in Oviedo, Spain, by GC-MS

A GC-MS procedure for the determination of hydrocarbons in air samples from Oviedo, Spain, was developed. Air hydrocarbons were sampled with a high volume sampler equipped with a holder containing a glass fiber filter, to trap the particulate phase, and two polyurethane foams to capture hydrocarbons of the vapour phase. Compounds were extracted with CH2Cl2 by Soxhlet extraction and then fractionated using column chromatography with alumina silica. Analyses of the fractions were performed by GC-MS in the electron ionization mode. PAHs and n-alkanes were the compounds examined in this work. Samples collected in the vicinity of the Faculty of Chemistry (a semi-urban area) were analysed. The total concentration of PAHs in the air samples analysed ranged from 28 to 76 ng m(-3). The total concentration of n-alkanes and PAHs in the vapour phase exceeded the concentration in the particulate phase in the samples analysed.     

A novel sensor for monitoring leakage of petroleum and other liquid hydrocarbons into soil environments

This paper describes the use of a potentially implantable infrared reflectometer for the qualitative detection of petroleum and a number of other hydrocarbon solvents. A rugged, low-power, re-useable sensor was evaluated in the laboratory for its ability to detect petrol in soil. A hydrophobic fluoropolymer was used as the sensing surface due to its high selectivity for petroleum hydrocarbons. The photocurrent reflected by this surface from a near IR source was measured to test for petroleum saturation within the membrane, which in turn was an indicator of petroleum in the surrounding soil. The simplicity in the sensor design enabled a stable, low cost detection method for petroleum and other hydrocarbons, ideal for use in sub-surface applications.     

Air pollution exposure monitoring and estimation. Part VI. Ambient exposure of adults in an industrialised region

This paper presents methodology and results of a dynamic individual air pollution exposure model (DINEX) that calculates the hourly exposure for each adult in a panel study. Each of over 260 participants, through the use of a diary, provided information used in the model to calculate his/her personal, individualised exposure. The participants filled out the diary daily, hour by hour, over two, two month periods. The exposure assessment model coupled the diary information and results of an indoor/outdoor measurement program, with the results of dispersion modelling on an hourly basis for an industrial area in Norway. The estimated air pollution concentrations from the dispersion model, based on continuous meteorological measurements, were calibrated with air pollutant concentrations measured continuously.     

Collaborative study to improve the quality control of rare earth element determinations in environmental matrices

In order to control the quality of rare earth determinations in environmental matrices, the Standards, Measurements and Testing Programme (formerly Community Bureau of Reference, BCR) of the European Commission has started a project, the final aim of which is to certify four types of matrices (tuna muscle, mussel tissue, aquatic plant and estuarine sediment) for their contents of a range of rare earth elements (Sc, Y and the lanthanides: La, Ce, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Ho, Er, Tm, Yb and Lu). The elements U and Th were added to the study. The first part of this project consisted of an interlaboratory study which aimed to test the feasibility of preparation of environmental reference materials and to detect and remove most of the pitfalls observed in rare earth determinations. This paper presents the preparation of the four matrices for the intercomparison study and for the candidate reference material. The main results are presented of the interlaboratory study that was carried out prior to the certification campaign. This collaborative trial is the first attempt ever carried out at this scale to evaluate the state-of-the-art of rare earth determinations in the environment. Its impact on the improvement of chemical measurements will have positive effects on the comparability of data necessary for environmental monitoring.     

Improvement of the BCR three step sequential extraction procedure prior to the certification of new sediment and soil reference materials

The Standards, Measurements and Testing Programme (formerly BCR) of the European Commission proposed a three-step sequential extraction procedure for sediment analysis, following extensive expert consultations and two interlaboratory studies. This scheme was recently used to certify the extractable trace element contents of a sediment reference material (CRM 601). Although this procedure offers a means to ensure the comparability of data in this field, some difficulties concerning the interlaboratory reproducibility still remain, and a new project is currently being conducted to determine the causes of poor reproducibility in the extraction scheme. The final objective of the project is the certification of new sediment and soil reference materials for their extractable contents of Cd, Cr, Cu, Ni, Pb and Zn. This paper presents the results of a small-scale interlaboratory study, which aimed to test a revised version of the extraction schemes by comparing the original and the modified protocols using the CRM 601 sample. This work offers an improvement to the BCR sequential extraction procedure through intercomparison exercises. This improved procedure will allow the obtaining of CRMs to validate analytical data in the analysis of soils and sediments, and it will also facilitate comparability of data in the European Union.     

Stakeholder Opinions on the Assessment of MPA Effectiveness and Their Interests to Participate at Pacific Rim National Park Reserve,Canada

As the number of marine protected areas (MPAs) is globally increasing, information is needed on the effectiveness of existing sites. Many protected area agencies however have limited resources and are unable to evaluate MPA effectiveness. An evaluation conducted entirely by the managing agency may also lack credibility. Long-term monitoring and evaluation programs should ideally offer opportunities for participation of diverse groups in the selection of evaluation indicators and their assessment. A participatory approach has the potential to enhance evaluation capacity, to increase credibility and acceptance of results, to strengthen relationships between managers and local stakeholders, and to address more locally relevant information. Using a case study approach, this paper investigates diverse stakeholder groups’ opinions on the design of an evaluation and their interest to participate in an assessment. Respondents were most interested in the assessment of MPA achievements and outcome indicators. Most groups identified a range of government agencies and stakeholders that should participate in an assessment but only half of all respondents were interested to participate in monitoring activities. Most frequently mentioned limitations for more participation were a lack of time and money, but also governance shortcomings such as limited participation possibilities and not paying enough credit to stakeholders’ input. Participation interest was also influenced by occupation, place of residency, and familiarity with the marine environment. Differences exist among stakeholders about suitable evaluators and preferred monitoring partners, which could affect the credibility of evaluation results and affect monitoring activities.     

Absorptive Capacity as a Guiding Concept for Effective Public Sector Management and Conservation of Freshwater Ecosystems

The ability of an organisation to recognise the value of new external information, acquire it, assimilate it, transform, and exploit it, namely its absorptive capacity (AC), has been much researched in the context of commercial organisations and even applied to national innovation. This paper considers four key AC-related concepts and their relevance to public sector organisations with mandates to manage and conserve freshwater ecosystems for the common good. The concepts are the importance of in-house prior related knowledge, the importance of informal knowledge transfer, the need for motivation and intensity of effort, and the importance of gatekeepers. These concepts are used to synthesise guidance for a way forward in respect of such freshwater management and conservation, using the imminent release of a specific scientific conservation planning and management tool in South Africa as a case study. The tool comprises a comprehensive series of maps that depict national freshwater ecosystem priority areas for South Africa. Insights for implementing agencies relate to maintaining an internal science, rather than research capacity; making unpublished and especially tacit knowledge available through informal knowledge transfer; not underestimating the importance of intensity of effort required to create AC, driven by focussed motivation; and the potential use of a gatekeeper at national level (external to the implementing organisations), possibly playing a more general ‘bridging’ role, and multiple internal (organisational) gatekeepers playing the more limited role of ‘knowledge translators’. The role of AC as a unifying framework is also proposed.