用微波炉溶解分析样品

<正> 不久前我们发表了一个联合多种技术分析煤和煤飞灰中多种元素的方案。在该方案中,犬部分元素是在用Parr酸分解弹(一种带钢套的聚四氟乙烯耐压密封容器)溶解样品后进行测定的。这个方法需要预先在马弗炉(8小时)或低温射频灰化器(3天)中灰化煤样,然后将灰份混合酸在Parr弹中加热约两小时,进行溶解。虽然我们的实验室和其他实验室已经普     

Petroleum waste biodegradation with porous biomass support system (PBSS) on rotating biological contactor

A laboratory scale study was conducted to assess the feasibility of the new coupling of rotating biological contactor (RBC) plus porous biomass support system (PBSS) using polyurethane foam as porous support media to biodegrade petroleum refinery wastewater. Polyurethane foam was attached on disks of two four-stage laboratory scale cascade connected RBC units.The two RBC units were operated simultaneously at different but constant, flowrates giving hydraulic loading rates of 0.01, 0.02, 0.03, 0.04 m3/m2/d in two runs keeping the same rotational speed 10 r/min throughout. Organic loading was a less controllable factor in this study.For all of the hydraulic loadings, it was found that the removal efficiency of total chemical oxygen demand (TCOD) and oil were above 80 percent. Ammonia nitrogen and phenol removal were above 90 and 80 percent respectively. The maximum biomass concentration within polyurethane foam was about 30 g/m2 in the first stage for 0.03 m3/m2/d hydraulic loading.The results show that t     

Gas chromatographic separation and determination of chloroanthracene isomers on fly ash

An efficient, reproducible and rapid fused silica capillary column gas chromatographic method, in splitless mode, for analysing of the three chloroanthracene isomers is described. The method affords efficient separation and good linearity for each isomer in the range of 0.2 -200 μg/ml. The method can also be used in separation and determination of another thirty three aromatic and their halosubstituted compounds. This paper also presents the applications of the method in analysing of complex products mixture from reaction of the selected aromatic compounds with hydrogen chloride on fly ash surface from municipal incinerator.     

加拿大制浆造纸废水厌氧处理的进展

1960～980年间,加拿大用于清除制浆造纸工业污染的经费约达6.6亿美元。采取这些措施后,到1980年加拿大72％的制浆造纸厂达到了国家控制废水BOD排放的规定。进一步改进达标状况的措施之一是对许多新制浆厂的高浓度废水采用厌氧处理技术。但需首先要了解制浆造纸工业在采用厌氧技术以前,在几方面的数据(表1)。 1.制浆造纸废水的适应性、生化可降解性及毒性     

地质体中稀土金属元素的分析

尽管分析钇和镧系元素很困难,但人们至今仍有广泛兴趣并继续对其进行研究。用中子活化和X射线光谱仪器分析技术来测定地质体中的稀土元素需成本太高,而色层法在这方面所做的工作又是很少的。 最近,电泳法却提供了准确且成本低廉的分析。 艾艾特泽姆勒等应用高压电泳在移行距离为13厘米的醋酸脂薄膜上对所有15个镧系元素成功地进行了分离。有效分离的“持续时间”为4小时或4个多小     

酸雨的大气物理化学机理

1.输送过程中的化学转化对北美洲雨水样品的分析表明:雨水的酸度在很大程度上取决于它的硫酸盐和硝酸盐离子浓度,因此本文将着重讨论这两种污染物的形成过程。虽然,大气中有少量的硫酸盐和硝酸盐是被直接排放出来的,但据认为,降雨中这两种盐类的主要来源是硫氧化物和氮氧化物的进一步氧化。然而在燃油发电厂和炼油厂附近,硫酸盐的直接排放量还是较大的。由上述情况可以看出,了解排放点和接受点之间排     

Removal of copper from a copper sulphate solution using an ultrasonic-electrolysis process

The application of ultrasonic-electrolysis process for the removal of copper is studied.In the ultrasonic field cavitation acts as jets and agitates the solution and breaks the barrier layer between the cathode surface and the bulk of the solution.Thus increases metal deposition on the cathode surface.The results show that an ultrasonic field is successful for the removal of low copper concentrations in solution.     

一种富稀土型三效催化剂的性能考察

对一种富烯土型三效催化剂的性能进行了考察，结果表明：该催化剂具有较好的三效活性和较好的启燃温度特性，具有较宛的空速适应范围，在空速为84000h^-1时，CO,NOx的转化率仍在90％以上，HC转化率仍在70％以上，该催化剂具有较好的耐老化性能，经实验室快速老化实验，即相当于实车行驶8万km,CO劣化系数，1.09,HC劣化系1．05，NOx劣化系数1．06，该催化剂经桑塔纳轿车整车28工况测试，其交化效果与该车配置的美国Engelherd公司的催化剂相当。     

The uptake of particulates by an urban woodland: site description and particulate composition

Woodlands may improve local air quality by increasing the uptake rates of gaseous, particulate and aerosol pollutants from the atmosphere and can also act as relatively permanent sinks for some pollutants. Rough Wood, Walsall was selected for a study of the material which accumulates on tree foliage because of its location in a densely populated urban area, and its proximity to a motorway with high traffic flow (the M6) and to other pollutant sources. Methods were developed for leaf washing to allow determination of the quantity of dust and the identification of the dust particles present on oak leaves. Elemental analysis of particles was also undertaken using scanning electron microscopy coupled with electron probe microanalysis. A large proportion of particles were organic in origin. Of the inorganic particles, the majority contained silicon and aluminium in varying proportions suggesting that they were soil derived. Some particles were clearly identified as the products of combustion, and sea or road salt was present on leaf surfaces. Some particles contained copper, tin and titanium which may reflect the proximity of Rough Wood to local metal workings. The number of particles counted on leaf surfaces decreased as distance from the motorway increased.