Effects of marine biofouling on gas sensor membrane materials

The use of underwater gaseous sensors has increased rapidly in the last 10 years. The majority of such sensors employ a thin membrane through which the gas diffuses. These sensors are potentiometric gas-sensing probes and essentially they are ion-selective electrodes. The deployment time of these membranes is curtailed by the formation of biofouling on the membrane leading to erroneous results. The physical properties of a variety of commonly used membranes were investigated using SEM and AFM. This showed that there were differences in topography between the PTFE membranes, such as pore sizes and surface roughness, which may be attributed to the manner in which they are manufactured. The pore size of the PTFE membranes varied greatly, ranging from circular pores with a diameter of 500 nm to elongated pores measuring 1 x 22 microm. The contact angle of each membrane showed that they were all hydrophobic. The amount of fouling on each was also observed and its affect on oxygen diffusion was monitored. Fouling slowed down the response of the instrument and caused reduced diffusion through the membranes. The amount of fouling varied between the membranes with the YSI membrane fouling least. Some of the membranes tested did foul less than others and there could be lifetime advantages of choosing a membrane with a smoother surface and a small pore size.     

Partitioning and removal of perfluorooctanoate during rain events: the importance of physical-chemical properties

The potential for airborne emissions to undergo long-range transport or to be removed from the atmosphere is influenced by their physical-chemical properties. When perfluorooctanate (PFO) enters the environment, its physical-chemical properties can vary significantly, depending on whether it exists as an acid, a salt, or a dissociated ion. A summary of the physical-chemical properties of the three most likely environmental states: ammonium perfluorooctanoate (APFO), perfluorooctanoic acid (PFOA) and the dissociated perfluorooctanoate anion (PFO(-)) is presented to illustrate the distinct environmental properties of each. The most volatile species, PFOA, is shown to have a pH-dependent air-water partitioning coefficient (K(aw)). The variability of K(aw) with pH influences the potential for vapor formation from aqueous environments, including rain events. Using the pH-dependent K(aw) and measured rain and air concentrations, it is shown that vapor-phase PFOA is not likely to be present above measurable levels of 0.2 ng m(-3) (12 parts per quadrillion v/v) during a rain event. Because rain concentrations determined in this work are comparable to measurements in other parts of North America, it is unlikely that rain events are a significant source of vapor-phase PFOA for the general North American region. It is shown that PFOA exists primarily in the particle phase in ambient air near direct sources of emissions and is efficiently scavenged by rain droplets, making wet deposition an important removal mechanism for emissions originating as either PFOA or APFO. Washout ratios of particle-associated PFO were determined to range between 1 x 10(5) and 5 x 10(5), in the same range as other semi-volatile compounds for which wet deposition is an important mechanism for atmospheric removal and deposition onto soils and water bodies.     

Advanced oxidation processes for the treatment of olive-oil mills wastewater

In this work, the treatment of an actual industrial waste with three advanced oxidation processes (AOP) has been studied: conductive-diamond electrooxidation (CDEO), ozonation and Fenton oxidation. The wastewater comes from olive-oil mills (OMW) and contains a COD of nearly 3000 mg dm(-3). CDEO allowed achieving the complete mineralization of the waste with high current efficiencies. Likewise, both ozonation and Fenton oxidation were able to treat the wastes, but they obtained very different results in terms of efficiency and mineralization. The accumulation of oxidation-refractory compounds as final products excludes the use of ozonation and Fenton oxidation as a sole treatment technology. This confirms that besides the hydroxyl-radical mediated oxidation, CDEO combines other important oxidation processes such as the direct electro-oxidation on the diamond surface and the oxidation mediated by other electrochemically formed compounds generated on this electrode.     

XAFS studies of cobalt(II) binding by solid peat and soil-derived humic acids and plant-derived humic acid-like substances

This work has examined cobalt(II) binding by a variety of solid humic acids (HAs) isolated from peat, plant and soil sources at temperatures down to 60K. The results confirm that X-ray absorption near-edge spectroscopy (XANES) measurements cannot distinguish between aquo and carboxylato ligands in the inner coordination sphere of Co(II). However, between 1 and 2 inner-sphere carboxylato ligands can be detected in all the peat, plant and soil-derived HA samples by extended X-ray absorption fine structure (EXAFS) measurements, indicating inner-sphere coordination of HA-bound Co(II). The precision of C(carboxylate) detection is limited by the extent and quality of the data and the contribution from inner-sphere O to the Fourier transformed peaks used to detect carbon. Putative chelate ring formation is consistent with a relatively negative entropy change in step A, the stronger Co(II) binding step by HA functional groups, and could relate to 'non-exchangeable' metal binding by HSs.     

Comparison of lead residues among avian bones

To determine if significant differences exist in lead (Pb) accumulation in different bones, especially those most often used for bone-Pb studies in wildlife, we compared Pb concentrations in radius, ulna, humerus, femur, and tibia of Common Eider (Somateria mollissima); and radius/ulna (combined), femur, and tibia of American Woodcock (Scolopax minor). There were no significant differences in bone-Pb concentrations among woodcock bones over a wide range of Pb concentrations (3-311 microg/g). In eider, where bone-Pb concentrations were low (<10 microg/g), leg bones had significantly higher Pb concentrations (approximately 30-40%) than wing bones from the same individuals. The variation among individual birds was greater than the variation among different bones within a bird. Based on our findings, we conclude that one type of bone may be substituted for another in bone-Pb studies although the same bone type should be analyzed for all birds within a study, whenever possible.     

Phosphorus supply influences heathland responses to atmospheric nitrogen deposition

On an upland moor dominated by pioneer Calluna vulgaris and with an understorey of mosses and lichens, experimental plots were treated with factorial combinations of nitrogen (N) at +0 and +20kg Nha(-1)yr(-1), and phosphorus (P) at +0 and +5kg Pha(-1)yr(-1). Over the 4-year duration of the experiment, the cover of the Calluna canopy increased in density over time as part of normal phenological development. Moss cover increased initially in response to N addition but then remained static; increases in cover in response to P addition became stronger over time, eventually causing reductions in the cover of the dominant Calluna canopy. Lichen cover virtually disappeared within 4 years in plots receiving +20kg Nha(-1)yr(-1) and also in separate plots receiving +10kg Nha(-1)yr(-1), but this effect was reversed by the addition of P.     

Factors affecting river health and its assessment over broad geographic ranges: the Western Australian experience

AusRivAS is an Australia-wide program that measures river condition using predictive models to compare the macroinvertebrate families occurring at a river site with those expected if the site were in natural condition. Results of assessment of 685 sites across all major rivers in Western Australia are presented. Most rivers were in relatively natural condition in the northern half of the state where the human population is low and pastoralism is the major land use. In the south, where the human population is higher and agriculture is more intensive, rivers were mostly more disturbed. AusRivAS assessment produced some erroneous results in rivers of the south-west cropping zone because of the lack of appropriate reference site groups and biased distribution of sampling sites. Collecting low numbers of animals from many forested streams, because of low stream productivity and samples that were difficult to sort, also affected assessments. Overall, however, AusRivAs assessment identified catchment processes that were inimical to river health. These processes included salinisation, high nutrient and organic loads, erosion and loss of riparian vegetation. River regulation, channel modification and fire were also associated with river degradation. As is the case with other assessment methods, one-off sampling at individual sites using AusRivAS may be misleading. Seasonal drought, in particular, may make it difficult to relate conditions at the time of sampling to longer-term river health. AusRivAS has shown river condition in Western Australia is not markedly different from other parts of Australia which, as a whole, lacks the substantial segments of severely degraded river systems reported in England.     

Pesticide Residues in Bovine Milk from a Predominantly Agricultural State of Haryana, India

One hundred forty seven samples of bovine milk were collected from 14 districts of Haryana, India during December 1998–February 1999 and analysed for the presence of organochlorine pesticide (OCPs) residues. ∑HCH, ∑DDT, ∑endosulfan and aldrin were detected in 100%, 97%, 43% and 12% samples and with mean values of 0.0292, 0.0367, 0.0022 and 0.0036 μg/ml, respectively. Eight percent samples exceeded the maximum residue limit (MRL) of 0.10 mg/kg as recommended by WHO for ∑HCH, 4% samples of 0.05 mg/kg for α-HCH, 5% samples of 0.01 mg/kg for γ-HCH, 26% samples of 0.02 mg/kg for β-HCH as recommended by PFAA and 24% samples of 0.05 mg/kg as recommended by FAO for ∑DDT. Concentrations of β-HCH and p,p′-DDE were more as compared to other isomers and metabolites of HCH and DDT.     

Serial Correlation and Inter-annual Variability in Relation to the Statistical Power of Monitoring Schemes to Detect Trends in Fish Populations

We studied the effects of inter-annual variability and serial correlation on the statistical power of monitoring schemes to detect trends in biomass of bream (Abramis brama) in Lake Veluwemeer (The Netherlands). In order to distinguish between 'true' system variability and sampling variability we simulated the development of the bream population, using estimates for population structure and growth, and compared the resulting inter-annual variabilities and serial correlations with those from field data. In all cases the inter-annual variability in the field data was larger than in simulated data (e.g. for total biomass of all assessed bream sigma = 0.45 in field data, and sigma = 0.03-0.14 in simulated data) indicating that sampling variability decreased statistical power for detecting trends. Moreover, sampling variability obscured the inter-annual dependency (and thus the serial correlation) of biomass, which was expected because in this long-lived population biomass changes are buffered by the many year classes present. We did find the expected serial correlation in our simulation results and concluded that good survey data of long-lived fish populations should show low sampling variability and considerable inter-annual serial correlation. Since serial correlation decreases the power for detecting trends, this means that even when sampling variability would be greatly reduced, the number of sampling years to detect a change of 15%.year(-1) in bream populations (corresponding to a halving or doubling in a six-year period) would in most cases be more than six. This would imply that the six-year reporting periods that are required by the Water Framework Directive of the European Union are too short for the existing fish monitoring schemes.     

Organic pollutants in compost and digestate. Part 1. Polychlorinated biphenyls, polycyclic aromatic hydrocarbons and molecular markers

In Europe, 9.3 x 10(6) t(dry weight (dw)) of compost and digestate are produced per year. Most of this is applied to agricultural land, which can lead to considerable inputs of organic pollutants, such as polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH) to soil. This paper presents an inventory of the pollutant situation in source-separated composts, digestates and presswater in Switzerland by a detailed analysis of over 70 samples. PCB concentrations ( summation PCB 28, 52, 101, 118, 138, 153, 180) were significantly higher in urban (median: 30 microg kg(-1)dw, n = 52) than in rural samples (median: 14 microg kg(-1)dw, n = 16). Together with low concentrations in general, this points to aerial deposition on compost input material as the major contamination pathway. Enantiomeric fractions of atropisometric PCB were close to racemic. Median PAH concentration was 3010 microg kg(-1)dw( summation 15PAH, n = 69), and one quarter of the samples exhibited concentrations above the relevant Swiss guide value for compost (4000 microg kg(-1)dw). The levels were influenced by the treatment process (digestate > compost), the season of input material collection (spring-summer > winter > autumn), the particle size (coarse-grained > fine-grained), and maturity (mature > less mature). The main source of PAH in compost was pyrogenic, probably influenced mainly by liquid fossil fuel combustion and some asphalt abrasion, as suggested by multiple linear regression. This study, together with a companion paper reporting on other organic contaminates including emerging compound classes, provides a starting point for a better risk-benefit estimation of the application of compost and digestate to agricultural soil in Switzerland.