Organochlorine levels in human blood from residents in areas of limited pesticide use in Sudan

Ninety-nine human blood samples were collected from the riverine region of northern Sudan and the traditional and mechanized rain-fed areas of western and eastern Sudan, representing areas of limited pesticide use in Sudan. Blood samples were analyzed for organochlorine pesticides by gas liquid chromatography (GLC) followed by electron-capture detection (ECD). p,p′-DDE (a metabolite of DDT), heptachlor epoxide, β-hexachlorocyclohexane (β-HCH), and dieldrin were detected in all locations surveyed. The level of total organochlorine burden was highest in the traditional rain-fed area, followed by the mechanized rain-fed area, and the riverine area. A highly significant correlation was observed between total organochlorine blood burden and the age of the donors (r = 0.608**).     

Groundwater quality of north-east Libya

The quality of groundwater was assessed to their suitability for drinking at six places of north-east Libya viz. El-Marj, Albayda, Shahat, Susa, Ras al-Hilal and Derna, during November, 2003 to March, 2004, by determining their physicochemical parameters (17 parameters) and water quality index (15 parameters). The temperatures of water samples averaged 15.1 degree C, pH values were alkaline and dissolved oxygen values were in safe ranges. Electrical conductivity, total dissolved solids and hardness of water at all places except Susa were within the standard limits. Alkalinity of well water at all six places exceeded, and chlorine and chloride (except Susa) were within the desirable limits set for them. Fluoride and nitrate contaminations of well water were not observed, and only very low values of phosphorus, manganese, chromium, iron and zinc were recorded. Copper in well water was generally high, and at Susa and Ras al-Hilal, it exceeded the desirable limit. Parametric ratios showed that all parameters studied except those of pH, dissolved oxygen, alkalinity and total chlorine originated from sources different from that of hardness. Water quality index (WQI) revealed that well water of Albayda and Shahat were good for drinking and were only slightly polluted, whereas those of El-Marj, Ras al-Hilal and Derna were moderately polluted. However, the well water of Susa was excessively polluted and was unsuitable for drinking. Suitable suggestions were made to improve the quality of groundwater of N.E. Libya.     

Predicting Gran alkalinity and calcium concentrations in river waters over a national scale using a novel modification to the G-BASH model

Monthly stream water calcium and Gran alkalinity concentration data from 11 sub-catchments of the Nether Beck in the English Lake District have been used to appraise the transferability of the Scottish, River Dee-based G-BASH model. Readily available riparian zone geochemistry and flow paths were used initially to predict minimum and mean stream water concentrations at the Nether Beck, based on calibration equations from the River Dee catchment data. Predicted values significantly exceeded observed values. Differences in runoff between the two areas, leading to a dilution effect in the Nether Beck, explained most of the difference between observed and predicted values. Greater acid deposition in the Lake District also reduced stream water Gran alkalinity concentrations in that area. If regional differences in precipitation, evapotranspiration and pollutant deposition are incorporated into the model, it may then be used reliably to predict catchment susceptibility to acidification over a wide regional (national) scale.     

Development of an empirical model to estimate real-world fine particulate matter emission factors: the traffic air quality model

The purpose of the study was to quantify the impact of traffic conditions, such as free flow and congestion, on local air quality. The Borman Expressway (I-80/94) in Northwest Indiana is considered a test bed for this research because of the high volume of class 9 truck traffic traveling on it, as well as the existing and continuing installation of the Intelligent Transportation System (ITS) to improve traffic management along the highway stretch. An empirical traffic air quality (TAQ) model was developed to estimate the fine particulate matter (PM2.5) emission factors (grams per kilometer) based solely on the measured traffic parameters, namely, average speed, average acceleration, and class 9 truck density. The TAQ model has shown better predictions that matched the measured emission factor values more than the U.S. Environmental Protection Agency (EPA)-PART5 model. During congestion (defined as flow-speeds < 50 km/hr [30 mi/hr]), the TAQ model, on average, overpredicted the measured values only by a factor of 1.2, in comparison to a fourfold underprediction using the EPA-PART5 model. On the other hand, during free flow (defined as flow-speeds > 80 km/hr [50 mi/hr]), the TAQ model was conservative in that it overpredicted the measured values by 1.5-fold.     

An experimental investigation of fluid flow and combustion characteristics of dual-fuel in a cylindrical combustion chamber

Combustion and fluid flow characteristics of coflowing LPG and kerosene have been investigated experimentally. A cylindrical water cooled combustion chamber was used to investigate the effect of changing the injection location and percentage of liquid fuel during gaseous fuel combustion. It was found that the injection of liquid fuel leads to an increase in the absolute value of maximum positive axial velocity and reduces the absolute value of the maximum negative axial velocity compared to the case of LPG alone. Also, a stable temperature distribution is noticed at axial distance of X/D approximately equal to 2.15 (where X is the axial distance measured from the inlet of diffuser, and D is chamber diameter). This is less than that of gaseous fuel combustion (approximately equal to 2.91). The change of injection location leads to a reduction in values of gas temperatures at X_inj/D=0.15 then it increased to reach maximum values at X_inj/D=0.35 which is approximately the same value for combustion of LPG fuel only. Any further increase in the injection location leads to a reduction in gas temperature, especially at the upstream sections of the combustion chamber. Also, it was found that values of temperature along the combustion chamber were decreased with increasing the percentage of the injected liquid fuel due to incomplete combustion of liquid fuel. Values of combustion chamber efficiency (η) for all percentage of liquid fuel at X_inj/D=0.35 are higher than those for combustion of LPG alone.     

Design of unsurfaced roads constructed with large-size shredded rubber tires: a case study

Stockpiles of scrap tires are serious fire hazard, public health hazard, and an environmental burden. The construction of road embankments, using tire shreds as a lightweight fill, can consume large quantities of scrap tires and has certain engineering benefits. All the previous research focused on small size tire shreds (3–6 in. size) in terms of its use in civil engineering applications and determination of the engineering/environmental properties. This research specifically focuses on large size tire shreds (12 in. size) and its direct comparison with the other sizes of the tire shreds to develop mechanistic-empirical practical design model and so that the use of tire shreds in road bases could be used on regular basis with enhanced reliability instead of on an empirical basis. The research also examines the potential environmental implications of the use of shredded rubber tires and the comparison of the short-term results with other long-term monitoring studies.