Investigation the effect of adding graphene oxide into diesel/higher alcohols blends on a diesel engine performance

ABSTRACT

This article aims to study the influence of the addition of graphene oxide nanoparticles (GO) to diesel/higher alcohols blends on the combustion, emission, and exergy parameters of a CI engine under various engine loads. The higher alcohols mainly n-butanol, n-heptanol, and n-octanol are blended with diesel at a volume fraction of 50%. Then, the 25 and 50 mg/L concentrations of GO are dispersed into diesel/higher alcohols blends using an ultrasonicator. The GO structures are examined using TEM, TGA, XRD and FTIR. The findings show that there is a reduction in p_max. and HRR when adding higher alcohols with diesel fuel. Regarding engine emission, there is a significant improvement in emissions formation with adding higher alcohols. The addition of GO into diesel/higher alcohols blends improves the brake thermal efficiency by 15%. Moreover, the p_max. and HRR are both enhanced by 4%. The CO, UHC and smoke formation are reduced considerably by 40%, 50 and 20%, respectively, while NO_x level is increased by 30% with adding GO. Finally, adding high percentages of n-butanol, n-heptanol, and n-octanol with diesel fuel with the presence of GO has the potential to achieve ultra-low CO, UHC, and smoke formation meanwhile keeping high thermal efficiency level.     

Seasonal variations of aerosol residence time in the lower atmospheric boundary layer

During a one year period, from Jan. 2002 up to Dec. 2002, approximately 130 air samples were analyzed to determine the atmospheric air activity concentrations of short- and long-lived (222Rn) decay products 214Pb and 210Pb. The samples were taken by using a single-filter technique and gamma-spectrometry was applied to determine the activity concentrations. A seasonal fluctuation in the concentration of 214Pb and 210Pb in surface air was observed. The activity concentrations of both radionuclides were observed to be relatively higher during the winter/autumn season than in spring/summer season. The mean activity concentration of 214Pb and 210Pb within the whole year was found to be 1.4+/-0.27 Bq m(-3) and 1.2+/-0.15 mBq m(-3), respectively. Different 210Pb:214Pb activity ratios during the year varied between 1.78 x 10(-4) and 1.6 x 10(-3) with a mean value of 8.9 x 10(-4) +/- 7.6 x 10(-5). From the ratio between the activity concentrations of the radon decay products 214Pb and 210Pb a mean residence time (MRT) of aerosol particles in the atmosphere of about 10.5+/-0.91 d could be estimated. The seasonal variation pattern shows relatively higher values of MRT in spring/summer season than in winter/autumn season. The MRT data together with relative humidity (RH), air temperature (T) and wind speed (WS), were used for a comprehensive regression analysis of its seasonal variation in the atmospheric air.     

Evaluation of groundwater and soil pollution in a landfill area using electrical resistivity imaging survey

Landfills are sources of groundwater and soil pollution due to the production of leachate and its migration through refuse. This study was conducted in order to determine the extent of groundwater and soil pollution within and around the landfill of Seri Petaling located in the State of Selangor, Malaysia. The condition of nearby surface water was also determined. An electrical resistivity imaging survey was used to investigate the leachate production within the landfill. Groundwater geochemistry was carried out and chemical analysis of water samples was conducted upstream and downstream of the landfill. Surface water was also analyzed in order to determine its quality. Soil chemical analysis was performed on soil samples taken from different locations within and around the landfill in the vadose zone (unsaturated zone) and below the water table (in the soil saturated zone). The resistivity image along line L–L₁ indicated the presence of large zones of decomposed waste bodies saturated with highly conducting leachate. Analysis of trace elements indicated their presence in very low concentrations and did not reflect any sign of heavy metal pollution of ground and surface water or of soil. Major ions represented by Na, K, and Cl were found in anomalous concentrations in the groundwater of the downstream bore hole, where they are 99.1%, 99.2%, and 99.4%, respectively, higher compared to the upstream bore hole. Electrical conductivity (EC) was also found in anomalous concentration downstream. Ca and Mg ions represent the water hardness (which is comparatively high downstream). There is a general trend of pollution towards the downstream area. Sulfates (SO₄) and nitrates (NO₃) are found in the area in low concentrations, even below the WHO standards for drinking water, but are significantly higher in the surface water compared to the groundwater. Phosphate (PO₄) and nitrite (NO₂), although present in low levels, are significantly higher at the downstream. There is no significant difference in the amount of fluoride (F) in the different locations. In the soil vadose zone, heavy metals were found to be in their typical normal ranges and within the background concentrations. Soil exchangeable bases were significantly higher in the soil saturated zone compared to the vadose zone, and no significant difference was obtained in the levels of inorganic pollutants. With the exception of Cd, the concentration ranges of all trace elements (Cu, Zn, Cr, Pb, and Ni) of Seri Petaling landfill soils were below the upper limits of baseline concentrations published from different sources.     

Potential environmental impact of dissolution of raw phosphate in sea water of the Gulf of Aqaba

Dissolution of raw phosphate (apatite) in sea water of the Gulf of Aqaba was investigated through lab incubation experiments. Three types from three different sources (Al-Hasa, Al-Abyad and Esh-Shydiya) have been used for these experiments. Impact of quantity, grain size, and source (type) of raw phosphate on dissolution rate were studied. Statistical analysis shows significant differences between the results obtained from comparing each two weights; as weight of apatite increased, dissolved inorganic phosphate-phosphorus (DIP) and fluoride in sea water solution increased. The differences between the dissolution rates of raw phosphate from the three sites were not significant while the differences between the different grain size fractions were significant. Dissolution rates were inversely related to particle size. Using a worst-case scenario, a conservative estimate of the maximum increase in DIP in seawater of the Gulf of Aqaba due to the apatite particles lost to the sea during ship loading resulted in DIP concentrations of 0.03 μM per year. As the residence time of the water in the Gulf of Aqaba is about one year, the DIP concentration will not increase by more than 0.03 μM under the estimated annual quantity of exported phosphate. Fluoride will not increase by more than 0.03 mg/l under the same conditions.     

Validation of QuEChERS-based method for determination of flusilazole residues in grape by high-performance liquid chromatography with photodiode array detector

A high-performance liquid chromatography with photodiode array detector analytical method was developed to determine the residue levels of flusilazole in grape and investigate the dissipation pattern and safety. The results showed that the mean recoveries were in the range of 86%–90%. Limits of detection and quantification were 0.008 and 0.02 mg/kg, respectively. The residue levels of flusilazole were best described by first-order rate kinetics and with half-lives ranging from 4.2 days (recommended dose) to 4.6 days (double the recommended dose). In conclusion, flusilazole at the recommended or even at double the recommended doses does not pose any apparent hazards to consumers.     

Prevalence of Rotaviruses Groups A and C in Egyptian Children and Aquatic Environment

The objective of this study is to compare the prevalence of rotaviruses groups A and C in Egyptian children and aquatic environment. From 110 stool specimens of children with acute diarrhea and using RT-PCR, 35 samples (31.8 %) were positive for human rotavirus group A and 15 samples (13.6 %) were positive for human rotavirus group C. From 96 samples collected from Zenin wastewater treatment plant over a 2-year period (November 2009–October 2011) and using RT-PCR, rotavirus group A was detected in (4/24) 16.7 %, (5/24) 20.8 %, (4/24) 16.7 %, and (4/24) 16.7 %, while rotavirus group C was detected in (2/24) 8.3 %, (3/24) 12.5 %, (3/24) 12.5 %, and (0/24) 0 % in raw sewage, after primary sedimentation, after secondary sedimentation, and after final chlorination, respectively. Moreover, from 96 samples collected from El-Giza water treatment plant over a 2-year period (November 2009–October 2011), rotavirus group A was detected in (7/24) 29.2 %, (6/24) 25 %, (5/24) 20.8 %, and (3/24) 12.5 %, while rotavirus group C was detected in (3/24) 12.5 %, (1/24) 4.2 %, (1/24) 4.2 %, and (0/24) 0 % in raw Nile water, after sedimentation, after sand filtration, and after final chlorination, respectively. Using SYBR Green real-time RT-PCR, the number of human rotavirus group A genome or infectious units was higher than rotavirus group C. VP6 sequence analysis of the RT-PCR positive rotavirus group C samples revealed that four clinical specimens and three environmental samples showed similar sequences clustered with Moduganari/Human Nigerian strain AF 325806 with 98 % homology, and two clinical specimens and one environmental sample showed similar sequences clustered with Dhaka CB/Human Bangladesh strain AY 754826 with 97 % homology.