Simulation of soil loss processes based on rainfall runoff and the time factor of governance in the Jialing River Watershed,China

Jialing River is the largest tributary in the catchment area of Three Gorges Reservoir, and it is also one of the important areas of sediment yield in the upper reaches of the Yangtze River. In recent years, significant changes of water and sediment characteristics have taken place. The "Long Control" Project implemented since 1989 had greatly changed the surface appearance of the Jialing River Watershed (JRW), and it had made the environments of the watershed sediment yield and sediment transport change significantly. In this research, the Revised Universal Soil Loss Equation was selected and used to predict the annual average amount of soil erosion for the special water and sediment environments in the JRW after the implementation of the "Long Control" Project, and then the rainfall–runoff modulus and the time factor of governance were both considered as dynamic factors, the dynamic sediment transport model was built for soil erosion monitoring and forecasting based on the average sediment yield model. According to the dynamic model, the spatial and temporal distribution of soil erosion amount and sediment transport amount of the JRW from 1990 to 2007 was simulated using geographic information system (GIS) technology and space-grid algorithm. Simulation results showed that the average relative error of sediment transport was less than 10% except for the extreme hydrological year. The relationship between water and sediment from 1990 to 2007 showed that sediment interception effects of the soil and water conservation projects were obvious: the annual average sediment discharge reduced from 145.3 to 35 million tons, the decrement of sediment amount was about 111 million tons, and decreasing amplitude was 76%; the sediment concentration was also decreased from 2.01 to 0.578 kg/m³. These data are of great significance for the prediction and estimation of the future changing trends of sediment storage in the Three Gorges Reservoir and the particulate non-point source pollution load carried by sediment transport from watershed surface.     

上海自来水和天然水源中放射性铀含量的分布

本文介绍了上海城乡居民饮用水和长江、黄浦江、淀山湖、雨水、雪水中放射性铀含量及其测量和采样方法。对铀含量进行了3年连续监测,比较了不同水源中铀含量,对天然水中铀分布作了客观描述,并与其它省市比较。同一时期水中铀含量分布均匀,均在本底范围内。     

干法煤粉磁选脱硫的试验研究

本工作首次在国内完成了干法煤粉磁选脱硫的试验,探讨了脱硫机理,简述了磁法脱硫的工艺及高梯度磁分离器(HGMS)装置。试验结果表明:最佳梯度磁场强度为0.65—0.75T,最佳煤粉颗粒度在100目—120目,脱硫率最高达70％左右,费用估计为7.5元/t煤左右。     

氧化铁脱除SO_2本征动力学研究

研究了温度、SO_2浓度、氧浓度及水蒸汽含量对α-Fe_2O_3脱除SO_2的影响规律.实验得到了幂函数型本征动力学模型中的各项参数值.结合流-固相反应理论,选择了流-固相反应模型,结果表明,在动力学控制区采用随机孔模型时,反应率-时间关系的实验数据与模型计算值能较好的吻合.     

土壤重金属污染的酶学诊断——紫色土中的镉、铜、铅、砷对水稻根系过氧化物酶的影响

通过四川酸性紫色土、中性紫色土,石灰性紫色土中不同浓度的Cd、Cu、Pb、As对水稻根系过氧化物酶的影响研究,揭示了过氧化物酶受抑制与产生抗性的过程.在低浓度时,上述元素对过氧化物酶的影响能反映土壤类型影响的差别.确定了三种紫色土中Cd、Cu、Pb、As的临界浓度.     

浙江拔茅银矿地质特征及成因

拔茅银矿是浙东中生代火山岩带中近几年新发出的金银矿田,矿床发育于破火山口机构内,矿体主要受NW及近SN向张性硅化破碎带控制。矿床的各种特征表明,其成因属浅成低温热液型。     

Status of air pollution in Beijing

A study has been made on elements organic constituents, TSP, SO2,NO2 of atmospheric pollutants in Beijing. 17 elements, and some PAHs, e. g. B(a)P, B(b, j, k)P, and B(g, h, i)P, in airborne particles by X-ray fluorescence spectroscopy and HPLC, GC/MS, have been determined respectively. It has been shown that the elements Pb, Zn, S and Cu were more enriched in fine particles and different valence states of sulfur at various sites. It was found that the concentrations of S6+ and S2-were more than 85% and less than 15% of the total sulfur respectively. Concentrations of major PAHs and sulfur-containing compounds increased in winter and in urban area. High values for Pb and Zn in city, Fe and Mn at industrial area and Cu, Al rural sites were obtained respectively. This implies the functions of different elemental sources of various sites. Thus, elements can be from distingushed anthropogenic and natural sources.The main contribution of SO2 was found of to have same seasonal variation as the anthropogenic el     

Effects of fluoride on growth and reproduction of the army worm, Mythimna separata (Walker)

This paper deals with effects of airborne fluorine on the army worm, Mythimna separata (Walker), by rearing the larvae on the wheat foliage exposed to HF or fumigating the larvae on the artificial diet with the pollutant. Larval relative growth rate (GR) and index of population trend of the insect reduced by 5% and 11%, respectively, when the larvae were reared on the foliage taken from the wheat plants exposed to 0.87 g·dm-2·day-1 of fluorine compared with those of the control. An extra instar appeared in a majority of the larvae treated. Survival rate and GR of the larvae on the wheat plant being exposure to the same concentration of fluorine in field open-top fumigation device were 40% and 15% lower than that of the control, respectively. Similar experiment with the insect on the artificial diet also showed that direct impact of the pollutant on the army worm was greater than its indirect effect via their host plant.     

Application and Evaluation of Two Air Quality Models for Particulate Matter for a Southeastern U.S. Episode

Abstract

The Models-3 Community Multiscale Air Quality (CMAQ) Modeling System and the Particulate Matter Comprehensive Air Quality Model with extensions (PMCAMx) were applied to simulate the period June 29–July 10, 1999, of the Southern Oxidants Study episode with two nested horizontal grid sizes: a coarse resolution of 32 km and a fine resolution of 8 km. The predicted spatial variations of ozone (O₃), particulate matter with an aerodynamic diameter less than or equal to 2.5 μm (PM_2.5), and particulate matter with an aerodynamic diameter less than or equal to 10 μm (PM₁₀) by both models are similar in rural areas but differ from one another significantly over some urban/suburban areas in the eastern and southern United States, where PMCAMx tends to predict higher values of O₃ and PM than CMAQ. Both models tend to predict O₃ values that are higher than those observed. For observed O₃ values above 60 ppb, O₃ performance meets the U.S. Environmental Protection Agency's criteria for CMAQ with both grids and for PMCAMx with the fine grid only. It becomes unsatisfactory for PMCAMx and marginally satisfactory for CMAQ for observed O₃ values above 40 ppb.

Both models predict similar amounts of sulfate (SO₄ ^2?) and organic matter, and both predict SO₄ ^2? to be the largest contributor to PM_2.5. PMCAMx generally predicts higher amounts of ammonium (NH₄ ⁺), nitrate (NO₃ ^?), and black carbon (BC) than does CMAQ. PM performance for CMAQ is generally consistent with that of other PM models, whereas PMCAMx predicts higher concentrations of NO₃ ^?,NH₄ ⁺, and BC than observed, which degrades its performance. For PM₁₀ and PM_2.5 predictions over the southeastern U.S. domain, the ranges of mean normalized gross errors (MNGEs) and mean normalized bias are 37–43% and –33–4% for CMAQ and 50–59% and 7–30% for PMCAMx. Both models predict the largest MNGEs for NO₃ ^? (98–104% for CMAQ, 138–338% for PMCAMx). The inaccurate NO₃ ^? predictions by both models may be caused by the inaccuracies in the ammonia emission inventory and the uncertainties in the gas/particle partitioning under some conditions. In addition to these uncertainties, the significant PM overpredictions by PMCAMx may be attributed to the lack of wet removal for PM and a likely underprediction in the vertical mixing during the daytime.     

The Adsorptive Capacity of Vapor-Phase Mercury Chloride onto Powdered Activated Carbon Derived from Waste Tires

Abstract

Injection of powdered activated carbon (PAC) upstream of particulate removal devices (such as electrostatic precipitator and baghouses) has been used effectively to remove hazardous air pollutants, particularly mercury-containing pollutants, emitted from combustors and incinerators. Compared with commercial PACs (CPACs), an alternative PAC derived from waste tires (WPAC) was prepared for this study. The equilibrium adsorptive capacity of mercury chloride (HgCl₂) vapor onto the WPAC was further evaluated with a self-designed bench-scale adsorption column system. The adsorption temperatures investigated in the adsorption column were controlled at 25 and 150 °C. The superficial velocity and residence time of the flow were 0.01 m/sec and 4 sec, respectively. The adsorption column tests were run under nitrogen gas flow. Experimental results showed that WPAC with higher Brunauer–Emmett–Teller (BET) surface area could adsorb more HgCl₂ at room temperature. The equilibrium adsorptive capacity of HgCl₂ for WPAC measured in this study was 1.49 × 10^?1 mg HgCl₂/g PAC at 25 °C with an initial HgCl₂ concentration of 25 μg/m³. With the increase of adsorption temperature ≤150 °C, the equilibrium adsorptive capacity of HgCl₂ for WPAC was decreased to 1.×34 10^?1 mg HgCl₂/g PA≤C. Furthermore,WPAC with higher sulfur contents could adsorb even more HgCl₂ because of the reactions between sulfur and Hg²⁺ at 150 °C. It was demonstrated that the mechanisms for adsorbing HgCl₂ onto WPAC were physical adsorption and chemisorption at 25 and 150 °C, respectively. Experimental results also indicated that the apparent overall driving force model appeared to have the good correlation with correlation coefficients (r) >0.998 for HgCl₂ adsorption at 25 and 150 °C. Moreover, the equilibrium adsorptive capacity of HgCl₂ for virgin WPAC was similar to that for CPAC at 25 °C, whereas it was slightly higher for sulfurized WPAC than for CPAC at 150 °C.