Displacement and sweep efficiencies in a DNAPL recovery test using micellar and polymer solutions injected in a five-spot pattern

Soil washing with micellar solutions is a promising alternative for the remediation of DNAPL source zones. As with any flushing technology, the success of soil washing with micellar solutions depends in a very large part on the ability of the solution to contact the contaminant (sweep efficiency) and then on the efficiency of contaminant removal once this contact is made (displacement efficiency). We report here on a field test where a micellar solution was used to recover a DNAPL in an open five-spot pattern in which polymer solutions were also injected before and after the washing solution to improve sweep efficiency. The washing solution formulation was optimised in the laboratory prior to the test to obtain good dissolution capacity. For a high-concentration and low-volume soil flushing remediation test such as the one performed (0.8 pore volumes of actual washing solution injected), slug sizing of the washing solution is critical. It was evaluated by an analytical solution. In a five-spot pattern, the displacement efficiency of the washing solution was observed to vary in the porous medium as a function of the radial distance from the injection well because: (1) the volume of the washing solution flowing through a section of the test cell changes (maximum close to the injection well and minimal at the pumping wells); (2) the in situ velocity changes (maximum at the wells and minimum between the wells) and; (3) the contact time of the washing solution with the NAPL changes as a function of the distance from the injection well. The relative importance of the recovery mechanisms, mobilisation and dissolution, was also observed to vary in the test cell. The reduced velocity increased the contact time of the washing solution with the DNAPL enhancing its dissolution, but the decrease of the capillary number caused less mobilisation. The washing process is much more extensive around the injection well. The use of an injection-pumping pattern allowing a complete sweep of the remediated area is essential. Following a comprehensive characterisation, modeling is an efficient tool to design the injection-pumping scheme and to optimise injection and pumping rates providing the best areal sweep. The vertical sweep can be controlled by using a polymer solution (Xanthan gum). The polymer solution also has a positive effect on front stability between the solutions injected. The injection rate of the polymer solution that follows the washing solution must be kept minimal initially to prevent dilution of the washing solution by fingering.     

A temporary social parasite of tropical plant-ants improves the fitness of a myrmecophyte

Myrmecophytes offer plant-ants a nesting place in exchange for protection from their enemies, particularly defoliators. These obligate ant–plant mutualisms are common model systems for studying factors that allow horizontally transmitted mutualisms to persist since parasites of ant–myrmecophyte mutualisms exploit the rewards provided by host plants whilst providing no protection in return. In pioneer formations in French Guiana, Azteca alfari and Azteca ovaticeps are known to be mutualists of myrmecophytic Cecropia (Cecropia ants). Here, we show that Azteca andreae, whose colonies build carton nests on myrmecophytic Cecropia, is not a parasite of Azteca–Cecropia mutualisms nor is it a temporary social parasite of A. alfari; it is, however, a temporary social parasite of A. ovaticeps. Contrarily to the two mutualistic Azteca species that are only occasional predators feeding mostly on hemipteran honeydew and food bodies provided by the host trees, A. andreae workers, which also attend hemipterans, do not exploit the food bodies. Rather, they employ an effective hunting technique where the leaf margins are fringed with ambushing workers, waiting for insects to alight. As a result, the host trees’ fitness is not affected as A. andreae colonies protect their foliage better than do mutualistic Azteca species resulting in greater fruit production. Yet, contrarily to mutualistic Azteca, when host tree development does not keep pace with colony growth, A. andreae workers forage on surrounding plants; the colonies can even move to a non-Cecropia tree.     

Oviposition strategies of conifer seed chalcids in relation to host phenology

Insects are considered the most important predators of seed cones, the female reproductive structures of conifers, prior to seed dispersal. Slightly more than 100 genera of insects are known to parasitize conifer seed cones. The most diverse (i.e., number of species) of these genera is Megastigmus (Hymenoptera: Torymidae), which comprises many important seed pests of native and exotic conifers. Seed chalcids, Megastigmus spp., lay eggs inside the developing ovules of host conifers and, until recently, oviposition was believed to occur only in fertilized ovules. Ovule development begins just after pollination, but stops if cells are not fertilized. The morphological stage of cone development at the time of oviposition by seed chalcids has been established for many species; however, knowledge of ovule development at that time has been documented for only one species, M. spermotrophus. Megastigmus spermotrophus oviposits in Douglas-fir ovules after pollination but before fertilization. Unlike the unfertilized ovules, those containing a M. spermotrophus larva continue to develop, whether fertilized or not, stressing the need to broaden our understanding of the insect–plant interactions for this entire genus. To achieve this task, we reviewed the scientific literature and assembled information pertaining to the timing of oviposition and to the pollination and fertilization periods of their respective host(s). More specifically, we were searching for circumstantial evidence that other species of Megastigmus associated with conifers could behave (i.e., oviposit before ovule fertilization) and impact on female gametophyte (i.e., prevent abortion) like M. spermotrophus. The evidence from our compilation suggests that seed chalcids infesting Pinaceae may also oviposit before ovule fertilization, just like M. spermotrophus, whereas those infesting Cupressaceae seemingly oviposit after ovule fertilization. Based on this evidence, we hypothesize that all species of Megastigmus associated with Pinaceae can oviposit in unfertilized ovules, whereas those exploiting Cupressaceae cannot, and thus oviposit only in already fully developed fertilized seeds. Furthermore, we predict that the presence of a larva in unfertilized ovules of all Pinaceae will influence the development of the female gametophyte by preventing its abortion. This influence on the Pinaceae can be interpreted as an ability to parasitize any of the potential seeds present in a seed cone, and as such represents a much more efficient oviposition strategy than searching and locating only fertilized seeds. Concomitantly, this ability has likely led to an overestimation of the impact of the species of seed chalcid infesting Pinaceae on seed production.     

A new C12 alcohol identified as a sex pheromone and a trail-following pheromone in termites: the diene (<Emphasis Type="Italic">Z</Emphasis>,<Emphasis Type="Italic">Z</Emphasis>)-dodeca-3,6-dien-1-ol

The diunsaturated C12 alcohol (Z,Z)-dodeca-3,6-dien-1-ol (dodecadienol) has been characterized by GC-MS and FTIR as a novel releaser pheromone in termites. This alcohol identified in Ancistrotermes pakistanicus (Termitidae, Macrotermitinae) possesses a double pheromonal function which again illustrates the chemical parsimony of termites compared with other social insects. In workers, dodecadienol elicits trail-following at a very low concentration (activity threshold at 0.1 pg/cm of trail); in male alates it induces trail-following at a low concentration (1–10 pg/cm) and sexual attraction at a higher concentration (about 1 ng). Traces of the monounsaturated C12 alcohol (Z)-dodec-3-en-1-ol (dodecenol), known as a trail pheromone of several Macrotermitinae, were also found in the sternal gland extracts of A. pakistanicus, although only dodecadienol was present at the surface of the sternal gland. Workers of A. pakistanicus are not sensitive to dodecenol, but they are as sensitive to dodecatrienol as to dodecadienol. However, in the study area (Vietnam), A. pakistanicus is living in sympatry only with those Macrotermitinae using dodecenol as a trail pheromone, the foraging populations therefore being well isolated through their respective trail pheromones. The presence of three types of unsaturated C12 alcohols as releaser pheromones in the only Macrotermitinae subfamily is discussed, and a possible biosynthetic pathway from linoleic acid is proposed for dodecadienol.     

Wasps robbing food from ants: a frequent behavior?

Food robbing, or cleptobiosis, has been well documented throughout the animal kingdom. For insects, intrafamilial food robbing is known among ants, but social wasps (Vespidae; Polistinae) taking food from ants has, to the best of our knowledge, never been reported. In this paper, we present two cases involving social wasps robbing food from ants associated with myrmecophytes. (1) Polybioides tabida F. (Ropalidiini) rob pieces of prey from Tetraponera aethiops Smith (Formicidae; Pseudomyrmecinae) specifically associated with Barteria fistulosa Mast. (Passifloraceae). (2) Charterginus spp. (Epiponini) rob food bodies from myrmecophytic Cecropia (Cecropiaceae) exploited by their Azteca mutualists (Formicidae; Dolichoderinae) or by opportunistic ants (that also attack cleptobiotic wasps). We note here that wasps gather food bodies (1) when ants are not yet active; (2) when ants are active, but avoiding any contact with them by flying off when attacked; and (3) through the coordinated efforts of two to five wasps, wherein one of them prevents the ants from leaving their nest, while the other wasps freely gather the food bodies. We suggest that these interactions are more common than previously thought.     

A development in energy flow/barrier analysis

In this paper, the occupational accidents and their effects on people are modeled. The basis of energy flow/barrier analysis is used to define an accident as the impact of a hazardous agent on a target, as a result of failure of control and protective barriers. This definition is enhanced to include serial and parallel barriers and to distinguish energy barriers from target barriers. The barrier attributes are defined and used to create a quantitative scenario-building model. The probability and severity of various accidents are estimated, by studying barrier reliability and efficiency. This approach is used to develop and simulate accident scenarios and to calculate their consequences. This model can be used in complex systems for analyzing the risk and estimating the importance of barriers.     

When attempts at robbing prey turn fatal

Because group-hunting arboreal ants spread-eagle insect prey for a long time before retrieving them, these prey can be coveted by predatory flying insects. Yet, attempting to rob these prey is risky if the ant species is also an effective predator. Here, we show that trying to rob prey from Azteca andreae workers is a fatal error as 268 out of 276 potential cleptobionts (97.1?%) were captured in turn. The ant workers hunt in a group and use the “Velcro?” principle to cling firmly to the leaves of their host tree, permitting them to capture very large prey. Exceptions were one social wasp, plus some Trigona spp. workers and flies that landed directly on the prey and were able to take off immediately when attacked. We conclude that in this situation, previously captured prey attract potential cleptobionts that are captured in turn in most of the cases.     

Prenatal diagnosis of congenital my asthenia with arthrogryposis in a myasthenic mother

We studied two children born to a myasthenic mother. The first child, a female, had multiple flexion contractures. She died 1 h after birth. In the second pregnancy, 3 years later, ultra-sonographic examination at 20 weeks showed decreased fetal movements and multiple flexion contractures. The pregnancy was interrupted. Eight other cases of congenital rnyasthenia with arthrogryposis are known; four of them are siblings. The recurrence risk may be as high as 100 per cent. Our second case demonstrates that prenatal diagnosis is possible early enough to allow termination of pregnancy.     

Load Estimation Method Using Distributions with Covariates: A Comparison with Commonly Used Estimation Methods

Load estimates obtained using an approach based on statistical distributions with parameters expressed as a function of covariates (e.g., streamflow) (distribution with covariates hereafter called DC method) were compared to four load estimation methods: (1) flow‐weighted mean concentration; (2) integral regression; (3) segmented regression (the last two with Ferguson's correction factor); and (4) hydrograph separation methods. A total of 25 datasets (from 19 stations) of daily concentrations of total dissolved solids, nutrients, or suspended particulate matter were used. The selected stations represented a wide range of hydrological conditions. Annual flux errors were determined by randomly generating 50 monthly sample series from daily series. Annual and interannual biases and dispersions were evaluated and compared. The impact of sampling frequency was investigated through the generation of bimonthly and weekly surveys. Interannual uncertainty analysis showed that the performance of the DC method was comparable with those of the other methods, except for stations showing high hydrological variability. In this case, the DC method performed better, with annual biases lower than those characterizing the other methods. Results show that the DC method generated the smallest pollutant load errors when considering a monthly sampling frequency for rivers showing high variability in hydrological conditions and contaminant concentrations.     

Co-assessment of biomass and soil organic carbon stocks in a future reservoir area located in Southeast Asia

An assessment of the organic carbon stock present in living or dead vegetation and in the soil on the 450 km² of the future Nam Theun 2 hydroelectric reservoir in Lao People??s Democratic Republic was made. Nine land cover types were defined on the studied area: dense, medium, light, degraded, and riparian forests; agricultural soil; swamps; water; and others (roads, construction sites, and so on). Their geographical distribution was assessed by remote sensing using two 2008 SPOT 5 images. The area is mainly covered by dense and light forests (59%), while agricultural soil and swamps account for 11% and 2%, respectively. For each of these cover types, except water, organic carbon density was measured in the five pools defined by the Intergovernmental Panel on Climate Change: aboveground biomass, litter, deadwood, belowground biomass, and soil organic carbon. The area-weighted mean carbon densities for these pools were estimated at 45.4, 2.0, 2.2, 3.4, and 62.2 tC/ha, respectively, i.e., a total of about 115 ± 15 tC/ha for a soil thickness of 30 cm, corresponding to a total flooded organic carbon stock of 5.1 ± 0.7 MtC. This value is much lower than the carbon density for some South American reservoirs for example where total organic carbon stocks range from 251 to 326 tC/ha. It can be mainly explained by (1) the higher biomass density of South American tropical primary rainforest than of forests in this study and (2) the high proportion of areas with low carbon density, such as agricultural or slash-and-burn zones, in the studied area.