Survey of phthalates, alkylphenols, bisphenol A and herbicides in Spanish source waters intended for bottling

Background, aim and scope

Groundwaters and source waters are exposed to environmental pollution due to agricultural and industrial activities that can enhance the leaching of organic contaminants. Pesticides are among the most widely studied compounds in groundwater, but little information is available on the presence of phthalates, alkylphenols and bisphenol A. These compounds are used in pesticide formulations and represent an emerging family of contaminants due to their widespread environmental presence and endocrine-disrupting properties. Knowledge on the occurrence of contaminants in source waters intended for bottling is important for sanitary and regulatory purposes. So the aim of the present study was to evaluate the presence of phthalates, alkylphenols, triazines, chloroacetamides and bisphenol A throughout 131 Spanish water sources intended for bottling. Waters studied were spring waters and boreholes which have a protection diameter to minimize environmental contamination.

Materials and methods

Waters were solid-phase extracted (SPE) and analysed by gas chromatography coupled to mass spectrometry (GC-MS). Quality control analysis comprising recovery studies, blank analysis and limits of detection were performed.

Results and discussion

Using SPE and GC-MS, the 21 target compounds were satisfactorily recovered (77?C124?%) and limits of quantification were between 0.0004 and 0.029???g/L for pesticides, while for alkylphenols, bisphenol A and phthalates the limits of quantification were from 0.0018???g/L for octylphenol to 0.970???g/L for bis(2-ethylhexyl) phthalate. Among the 21 compounds analysed, only 9 were detected at levels between 0.002 and 1.115???g/L. Compounds identified were triazine herbicides, alkylphenols, bisphenol A and two phthalates. Spring waters or shallow boreholes were the sites more vulnerable to contaminants. Eighty-five percent of the samples did not contain any of the target compounds.

Conclusions

Target compounds were detected in a very low concentration and only in very few samples. This indicates the good quality of source waters intended for bottling and the effectiveness of the protection measures adopted in Spain. None of the samples analysed exceeded the maximum legislated levels for drinking water both in Spain and in the European Union.     

Effect of soil moisture dynamics on dense nonaqueous phase liquid (DNAPL) spill zone architecture in heterogeneous porous media

The amount, location, and form of NAPL in contaminated vadose zones are controlled by the spatial distribution of water saturation and soil permeability, the NAPL spill scenario, water infiltration events, and vapor transport. To evaluate the effects of these processes, we used the three-phase flow simulator STOMP, which includes a new permeability-liquid saturation-capillary pressure (k-S-P) constitutive model. This new constitutive model considers three NAPL forms: free, residual, and trapped. A 2-D vertical cross-section with five stratigraphic layers was assumed, and simulations were performed for seven cases. The conceptual model of the soil heterogeneity was based upon the stratigraphy at the Hanford carbon tetrachloride (CT) spill site. Some cases considered co-disposal of NAPL with large volumes of wastewater, as also occurred at the Hanford CT site. In these cases, the form and location of NAPL were most strongly influenced by high water discharge rates and NAPL evaporation to the atmosphere. In order to investigate the impact of heterogeneity, the hydraulic conductivity within the lower permeability layer was modeled as a realization of a random field having three different classes. For six extreme cases of 100 realizations, the CT mass that reached the water table varied by a factor of two, and was primarily controlled by the degree of lateral connectivity of the low conductivity class within the lowest permeability layer. The grid size at the top boundary had a dramatic impact on NAPL diffusive flux just after the spill event when the NAPL was present near the ground surface. NAPL evaporation with a fine grid spacing at the top boundary decreased CT mass that reached the water table by 74%, compared to the case with a coarse grid spacing, while barometric pumping had a marginal effect for the case of a continuous NAPL spill scenario considered in this work. For low water infiltration rate scenarios, the distribution of water content prior to a NAPL spill event decreased CT mass that reached the water table by 98% and had a significant impact on the formation of trapped NAPL. For all cases simulated, use of the new constitutive model that allows the formation of residual NAPL increased the amount of NAPL retained in the vadose zone. Density-driven advective gas flow from the ground surface controlled vapor migration in strongly anisotropic layers, causing NAPL mass flux to the lower layer to be reduced. These simulations indicate that consideration of the formation of residual and trapped NAPLs and dynamic boundary conditions (e.g., areas, rates, and periods of different NAPL and water discharge and fluctuations of atmospheric pressure) in the context of full three-phase flow are needed, especially for NAPL spill events at the ground surface. In addition, NAPL evaporation, density-driven gas advection, and NAPL vertical movement enhanced by water flow must be considered in order to predict NAPL distribution and migration in the vadose zone.     

Biodegradability of alkylates as a sole carbon source in the presence of ethanol or BTEX

The biodegradability of alkylate compounds in serum bottles was investigated in the presence and absence of ethanol or benzene, toluene, ethylbenzene, and p-xylene (BTEX). The biomass was acclimated to three different alkylates, 2,3-dimethylpentane, 2,4-dimethylpentane and 2,2,4-trimethylpentane in porous pot reactors. The alkylates were completely mineralized in all three sets of experiments. They degraded more slowly in the presence of BTEX than in their absence because BTEX inhibited the microbial utilization of alkylates. However, in the presence of ethanol, their slower biodegradation was not related to inhibition by the ethanol. Throughout the experiments alkylates, ethanol, and BTEX concentrations did not change in the sterile controls.     

Integrated catalytic wet air oxidation and aerobic biological treatment in a municipal WWTP of a high-strength o-cresol wastewater

This study examines the feasibility of coupling a Catalytic Wet Air Oxidation (CWAO), with activated carbon (AC) as catalyst, and an aerobic biological treatment to treat a high-strength o-cresol wastewater. Two goals are pursued: (a) To determine the effect of the main AC/CWAO intermediates on the activated sludge of a municipal WasteWater Treatment Plant (WWTP) and (b) To demonstrate the feasibility of coupling the AC/CWAO effluent as a part of the influent of a municipal WWTP. In a previous study, a high-strength o-cresol wastewater was treated by AC/CWAO aiming to establish the distribution of intermediates and the biodegradability enhancement. In this work, the biodegradability, toxicity and inhibition of the most relevant intermediates detected in the AC/CWAO effluent were determined by respirometry. Also, the results of a pilot scale municipal WWTP study for an integrated AC/CWAO-aerobic biological treatment of this effluent are presented. The biodegradation parameters (i.e. maximum oxygen uptake rate and oxygen consumption) of main AC/CWAO intermediates allowed the classification of the intermediates into readily biodegradable, inert or toxic/inhibitory compounds. This detailed study, allowed to understand the biodegradability enhancement exhibited by an AC/CWAO effluent and to achieve a successful strategy for coupling the AC/CWAO step with an aerobic biological treatment for a high-strength o-cresol wastewater. Using 30%, as COD, of AC/CWAO effluent in the inlet to the pilot scale WWTP, the integrated AC/CWAO-biological treatment achieved a 98% of total COD removal and, particularly, a 91% of AC/CWAO effluent COD removal without any undesirable effect on the biomass.     

Distributional patterns of adult male loggerhead sea turtles (<Emphasis Type="Italic">Caretta caretta</Emphasis>) in the vicinity of Cape Canaveral,Florida, USA during and after a major annual breeding aggregation

Satellite transmitters were attached to 25 reproductively active and four inactive adult male loggerhead sea turtles (86.6–107.0 cm SCLmin) captured from the Port Canaveral, FL, USA shipping channel to assess horizontal and vertical distributions. During the breeding period, male loggerheads aggregated (44% of 755 turtle days) in a 117.6 km² core area that encompassed the shipping channel. Median dive duration during the breeding period was 27 min (IQR = 15–42 min) and males spent 4% (IQR = 3–5%) of the time at the surface, with significantly shorter dives associated with reproductively active males. Migrant and resident males dispersed concurrently, with residents shifting > 30 km east across the continental shelf over a more protracted departure schedule than migrants. Dive duration and time spent at the surface increased through the fall. Cluster analysis revealed the strongest association for dive duration with sea state during and after the breeding period, with significantly longer dives during more turbulent conditions. In contrast, univariate associations with surface interval duration were not elucidated.     

Seasonal distribution patterns of juvenile loggerhead sea turtles (<Emphasis Type="Italic">Caretta caretta</Emphasis>) following capture from a shipping channel in the Northwest Atlantic Ocean

Thirty-four juvenile loggerhead sea turtles captured by trawling from the Charleston, South Carolina (USA), shipping channel (32°42′N; −79°47′W) between May 2004 and August 2007 were tagged with satellite transmitters to assess the extent to which they remained near the capture location given their collection along a seasonal migratory corridor. Seventy-five percent of juveniles were classified as seasonal residents. Migrants predominantly swam north in the spring and nomads wandered south in the summer, but predictive indicators for non-resident status were not identified. All but one juvenile generally remained south of 34°N, within 40 km of shore, and in waters <30 m deep throughout the year. Nine of 14 loggerhead sea turtles monitored during the winter remained exclusively over the continental shelf, three briefly occurred in oceanic habitats, and two foraged extensively in oceanic habitats. Residents distributed >15 km from shore between spring and autumn were three times as likely to occur in oceanic habitats in winter. Modest seasonal movements contrasted with adults tagged at similar latitudes and with juveniles tagged further north and suggest distinct foraging groups within a regional foraging ground.     

Flow Dynamics in Eccentrically Rotating Flasks Used for Dispersant Effectiveness Testing

The evaluation of dispersant effectiveness used for oil spills is commonly done using tests conducted in laboratory flasks. We used a Hot Wire Anemometer (HWA) to characterize mixing dynamics in the Swirling Flask (SF) and the Baffled Flask (BF), the latter is being considered by the EPA to replace the prior to test dispersant effectiveness in the laboratory. Five rotation speeds of the orbital shaker carrying the flasks were considered, Ω = 50, 100, 150, 175 and 200 rpm. The radial and azimuthal water speeds were measured for each Ω. It was found that the flow in the SF is, in general, two-dimensional changing from horizontal at low Ω to axi-symmetric at high Ω. The flow in the BF appeared to be three-dimensional at all rotation speeds. This indicates that the BF is more suitable for representing the (inherently) 3-D flow at sea. In the SF, the speeds and energy dissipation rates ɛ increased gradually as the rotation speed increased. Those in the BF increased sharply at rotation speeds greater than 150 rpm. At 200 rpm, the Kolmogorov scale (i.e., size of smallest eddies) was about 250 and 50 μm in the SF and BF, respectively. Noting that the observed droplet sizes of dispersed oils range from 50 to 400 μm (hence most of it is less than 250 μm), one concludes that the mixing in the SF (even at 200 rpm) is not representative of the vigorous mixing occurring at sea.     

A framework for assessment and monitoring of arthropods in a lowland tropical forest

By applying principles of adaptive management, and by using the valuable information that arthropods provide from assessment and monitoring programs, managers can identify and reduce possible impacts on biodiversity in development projects. In 1996, the Smithsonian Institution's Monitoring and Assessment of Biodiversity program worked together with Shell Prospecting and Development Peru to establish an adaptive management program to protect biodiversity in a natural gas exploration project in a Peruvian rainforest. In this paper, we outlined the conceptual steps involved in establishing an assessment and monitoring program for arthropods, including setting objectives, evaluating the results and making decisions. We also present the results of the assessment using some of groups of arthropods, and summarize the steps taken to identify appropriate groups for monitoring.     

Bioavailability of residual polycyclic aromatic hydrocarbons following enhanced natural attenuation of creosote-contaminated soil

The impact of residual PAHs (2250 ± 71 μg total PAHs g⁻¹) following enhanced natural attenuation (ENA) of creosote-contaminated soil (7767 ± 1286 μg total PAHs g⁻¹) was assessed using a variety of ecological assays. Microtox™ results for aqueous soil extracts indicated that there was no significant difference in EC₅₀ values for uncontaminated, pre- and post-remediated soil. However, in studies conducted with Eisenia fetida, PAH bioaccumulation was reduced by up to 6.5-fold as a result of ENA. Similarly, Beta vulgaris L. biomass yields were increased 2.1-fold following ENA of creosote-contaminated soil. While earthworm and plant assays indicated that PAH bioavailability was reduced following ENA, the residual PAH fraction still exerted toxicological impacts on both receptors. Results from this study highlight that residual PAHs following ENA (presumably non-bioavailable to bioremediation) may still be bioavailable to important receptor organisms such as earthworms and plants.     

Sea salt concentrations across the European continent

The oceans are a major source for particles that play an important role in many atmospheric processes. In Europe sea salt may contribute significantly to particulate matter concentrations. We have compiled sodium concentration data as a tracer for sea salt for 89 sites in Europe to provide more insight in the distribution of sea salt across Europe. The annual average sea salt concentrations above land were estimated to range between 0.3 and almost 13 μg m^?3. Maximum concentrations are found at the Irish coast. At coastal sites along the Atlantic and North Sea coast concentrations tend to be around 5 μg m^?3. More inland locations up to about 300 km away from the coast tend to show concentrations between 2 and 5 μg m^?3, whereas sites further away from the coast are characterized by lower concentrations. An analysis of the representativity of the data with respect to a long term average showed that the long average is associated with a standard deviation of around 15%. The compilation of observations provides an improved overview of sea salt concentrations in Europe as well as an improved basis for model validation. Verification of the results of the LOTOS-EUROS model learned that the model represents well the spatial variability of the observed sea salt concentrations very well. However, the absolute concentrations are significantly overestimated due to large uncertainties in the emission and dry deposition parameterizations. Using the high explained variability in the gradients across Europe, the bias-corrected modelled distribution serves as a best estimate of the sea salt distribution across Europe for 2005.