Emissions from the burning of vegetative debris in air curtain destructors

Although air curtain destructors (ACDs) have been used for quite some time to dispose of vegetative debris, relatively little in-depth testing has been conducted to quantify emissions of pollutants other than CO and particulate matter. As part of an effort to prepare for possible use of ACDs to dispose of the enormous volumes of debris generated by Hurricanes Katrina and Rita, the literature on ACD emissions was reviewed to identify potential environmental issues associated with ACD disposal of construction and demolition (C&D) debris. Although no data have been published on emissions from C&D debris combustion in an ACD, a few studies provided information on emissions from the combustion of vegetative debris. These studies are reviewed, and the results compared with studies of open burning of biomass. Combustion of vegetative debris in ACD units results in significantly lower emissions of particulate matter and CO per unit of mass of debris compared with open pile burning. The available data are not sufficient to make general estimates regarding emissions of organic or metal compounds. The highly transient nature of the ACD combustion process, a minimal degree of operational control, and significant variability in debris properties make accurate prediction of ACD emissions impossible in general. Results of scoping tests conducted in preparation for possible in-depth emissions tests demonstrate the challenges associated with sampling ACD emissions and highlight the transient nature of the process. The environmental impacts of widespread use of ACDs for disposal of vegetative debris and their potential use to reduce the volume of C&D debris in future disaster response scenarios remain a considerable gap in understanding the risks associated with debris disposal options.     

Atrazine leaching through surface and subsurface of a tropical Oxisol

The fate of (14)C atrazine was investigated using microcosms and an undisturbed Red-Yellow Latossol (Oxisol) under simulated rainfall conditions of 200 mm water month(-1). Experiments were carried out using microcosm cores, the first with an uncovered surface soil; the second set with uncovered subsurface soil; the third with subsurface soil covered with 3 cm of cow manure and the last with subsurface soil covered with 5 cm of grass straw. Average values for the amount of atrazine leached after 60 days were as follows: surface soil 1.6%; subsurface 47.3%; subsurface plus manure 17.3% and subsurface plus straw 24.8%. In the surface soil, 53% of the (14)C atrazine remained within the upper 1 cm, while in the subsurface microcosms the atrazine was more evenly distributed. The authors report that surface soil was retained atrazine and its metabolites for 60 days. The addition of a straw or manure covering to exposed subsoil helped to retard atrazine leaching.     

Influence of synthetic surfactants on the uptake of Pd, Cd and Pb by the marine macroalga, Ulva lactuca

Uptake of Pd, Cd and Pb by the marine macroalga, Ulva lactuca, has been studied in the presence of an anionic (sodium dodecyl sulphate, SDS), cationic (hexadecyltrimethylammonium bromide; HDTMA) and non-ionic (Triton X-100; TX) surfactant. Compared with the surfactant-free system, metal sorption was reduced in the presence of SDS or TX. Neither surfactant, however, had any measurable impact on cell membrane permeability, determined by leakage of dissolved free amino acids (DFAA), or on metal internalisation. We attribute these observations to the stabilisation of aqueous Cd and Pb by SDS and the shielding of otherwise amenable sorption sites by TX. Presence of HDTMA resulted in a reduction in the extent of both sorption and internalisation of all metals and a significant increase in the leakage of DFAA. Thus, by enhancing membrane permeability, HDTMA exerts the greatest influence on metal behaviour in the presence of U. lactuca.     

Effectiveness and kinetics of ferrate as a disinfectant for ballast water

This study examined whether ferrate could meet the international standards for successful ballast water treatment, including final concentrations of less than 1 CFU/mL of Enterococci, less than 2.5 CFU/mL of Escherichia coli, and less than 1 CFU/100 mL of Vibrio cholerae. Pure cultures of E. coli, Klebsiella pneumoniae, and V. cholerae, and a mixed culture of Enterococcus faecium and E. faecilis were grown in saline solution to simulate ballast water and were treated with dosages of ferrate ranging from 0.25 to 5.0 mg/L. A ferrate dose of 5 mg/L resulted in complete disinfection of all organisms tested, and smaller dosages were also very effective. Tailing was consistently observed, and the Hom's model (1972) appeared to most accurately represent the action of ferrate on these organisms. Salinity and pH did not adversely affect results, and regrowth was not a problem. Ferrate shows good potential as an effective disinfectant in the treatment of ballast water.     

Organizational diversity,integration and performance

This research examines how integrative methods of open communications, involvement, and conflict resolution in implementing an organizational change initiative moderate the relationship between cognitive diversity among employees and organization performance. In this longitudinal study of 37 medical clinics, we find that the interaction of integrative methods and diversity of models for organizing among employees has a significant positive effect on clinic revenue, productivity, and patient satisfaction. An important practical implication of these findings is that instead of seeking consensus on a singular vision of a strategic change initiative, managers are more likely to improve organization performance by focusing their interventions on creating integrative methods for encouraging and learning from diverse and opposing views of an organizational change initiative. Copyright © 2007 John Wiley & Sons, Ltd.     

Remediation of PAH contaminated soils: application of a solid-liquid two-phase partitioning bioreactor

The feasibility of a two-step treatment process has been assessed at laboratory scale for the remediation of soil contaminated with a model mixture of polycyclic aromatic hydrocarbons (PAHs) (phenanthrene, pyrene, and fluoranthene). The initial step of the process involved contacting contaminated soil with thermoplastic, polymeric pellets (polyurethane). The ability of three different mobilizing agents (water, surfactant (Biosolve) and isopropyl alcohol) to enhance recovery of PAHs from soil was investigated and the results were compared to the recovery of PAHs from dry soil. The presence of isopropyl alcohol had the greatest impact on PAH recovery with approximately 80% of the original mass of PAHs in the soil being absorbed by the polymer pellets in 48 h. The second stage of the suggested treatment involved regeneration of the PAH loaded polymers via PAH biodegradation, which was carried out in a solid-liquid two-phase partitioning bioreactor. In addition to the PAH containing polymer pellets, the bioreactor contained a microbial consortium that was pre-selected for its ability to degrade the model PAHs and after a 14 d period approximately 78%, 62% and 36% of phenanthrene, pyrene, and fluoranthene, respectively, had been desorbed from the polymer and degraded. The rate of phenanthrene degradation was shown to be limited by mass transfer of phenanthrene from the polymer pellets. In case of pyrene and fluoranthene a combination of mass transfer and biodegradation rate might have been limiting.     

Laboratory investigation of flux reduction from dense non-aqueous phase liquid (DNAPL) partial source zone remediation by enhanced dissolution

This study investigated the benefits of partial removal of dense nonaqueous phase liquid (DNAPL) source zones using enhanced dissolution in eight laboratory scale experiments. The benefits were assessed by characterizing the relationship between reductions in DNAPL mass and the corresponding reduction in contaminant mass flux. Four flushing agents were evaluated in eight controlled laboratory experiments to examine the effects of displacement fluid property contrasts and associated override and underride on contaminant flux reduction (R(j)) vs. mass reduction (R(m)) relationships (R(j)(R(m))): 1) 50% ethanol/50% water (less dense than water), 2) 40% ethyl-lactate/60% water (more dense than water), 3) 18% ethanol/26% ethyl-lactate/56% water (neutrally buoyant), and 4) 2% Tween-80 surfactant (also neutrally buoyant). For each DNAPL architecture evaluated, replicate experiments were conducted where source zone dissolution was conducted with a single flushing event to remove most of the DNAPL from the system, and with multiple shorter-duration floods to determine the path of the R(j)(R(m)) relationship. All of the single-flushing experiments exhibited similar R(j)(R(m)) relationships indicating that override and underride effects associated with cosolvents did not significantly affect the remediation performance of the agents. The R(j)(R(m)) relationship of the multiple injection experiments for the cosolvents with a density contrast with water tended to be less desirable in the sense that there was less R(j) for a given R(m). UTCHEM simulations supported the observations from the laboratory experiments and demonstrated the capability of this model to predict R(j)(R(m)) relationships for non-uniformly distributed NAPL sources.     

Clear and present danger? The use of a yeast biosensor to monitor changes in the toxicity of industrial effluents subjected to oxidative colour removal treatments

Discharges of coloured effluents into surface waters provide conspicuous evidence of the impact of industry on the environment. The textile industry is an obvious candidate for sources of such discharges. Conventional treatment methods appear to alleviate this situation by removing colour, however the affect on toxicity is less obvious. The objective of this study was to examine the changes in effluent toxicity during the course of two alternative wastewater treatment methods, ozonation and electrochemical oxidation, using a novel toxicity biosensor, GreenScreen EM. The biosensor is capable of measuring both general acute toxicity (cytotoxicity), and more specifically genotoxicity, that is damage to a cell's DNA structure, replication or distribution, caused by substances that may be mutagenic and/or carcinogenic. The biosensor utilises a modified strain of the brewers yeast Saccharomyces cerevisiae, incorporating a gene encoding green fluorescent protein (GFP) linked to the inducible promoter of the DNA damage responsive RAD54 gene. Upon exposure to a genotoxin, the production of GFP is up-regulated in parallel with RAD54, and the resulting cellular fluorescence provides a measure of genotoxicity. Acute toxicity is simultaneously determined by monitoring relative total growth of the cell culture during incubation. The results presented in this paper show that a reduction in colouration does not necessarily correspond to a reduction in effluent toxicity.     

Impediments to recovery in New Orleans' Upper and Lower Ninth Ward: one year after Hurricane Katrina

In the aftermath of Hurricane Katrina, a rapid succession of plans put forward a host of recovery options for the Upper and Lower Ninth Ward in New Orleans. Much of the debate focused on catastrophic damage to residential structures and discussions of the capacity of low-income residents to repair their neighbourhoods. This article examines impediments to the current recovery process of the Upper and Lower Ninth Ward, reporting results of an October 2006 survey of 3,211 plots for structural damage, flood damage and post-storm recovery. By examining recovery one year after Hurricane Katrina, and by doing so in the light of flood and structural damage, it is possible to identify impediments to recovery that may disproportionately affect these neighbourhoods. This paper concludes with a discussion of how pre- and post-disaster inequalities have slowed recovery in the Lower Ninth Ward and of the implications this has for post-disaster recovery planning there and elsewhere.     

The Scaling of Water Governance Tasks: A Comparative Federal Analysis of the European Union and Australia

Conflicts over how to “scale” policy-making tasks have characterized environmental governance since time immemorial. They are particularly evident in the area of water policy and raise important questions over the democratic legitimacy, economic efficiency and effectiveness of allocating (or “scaling”) tasks to some administrative levels as opposed to others. This article adopts a comparative federalism perspective to assess the “optimality” of scaling—either upward or downward—in one issue area, namely coastal recreational water quality. It does so by comparing the scaling of recreational water quality tasks in the European Union (EU) and Australia. It reveals that the two systems have adopted rather different approaches to scaling and that this difference can partly be accounted for in federal theoretical terms. However, a much greater awareness of the inescapably political nature of scaling processes is nonetheless required. Finally, some words of caution are offered with regard to transferring policy lessons between these two jurisdictions.