Agricultural drainage ditches serve as P transport pathways from fields to surface waters. Little is known about the spatial variation of P at the soil-water interface within ditch networks. We quantified the spatial variation of surficial (0-5 cm) soil P within vegetated agricultural ditches on a farm in Princess Anne, MD with an approximately 30-yr history of poultry litter application. Ditch soils from 10 ditches were sampled at 10-m intervals and analyzed for acid ammonium oxalate-extractable P, Fe, Al (P(ox), Fe(ox), Al(ox)), and pH. These variables were spatially autocorrelated. Oxalate-P (min = 135 mg kg(-1), max = 6919 mg kg(-1), mean = 700 mg kg(-1)) exhibited a high standard deviation across the study area (overall 580 mg kg(-1)) and within individual ditches (maximum 1383 mg kg(-1)). Several ditches contained distinct areas of high P(ox), which were associated with either point- or nonpoint-P sources. Phosphorus was correlated with Al(ox) or Fe(ox) within specific ditches. Across all ditches, Al(ox) (r = 0.80; p < 0.001) was better correlated with P(ox) than was Fe(ox) (r = 0.44; p < 0.001). The high level of spatial variation of soil P observed in this ditch network suggests that spatially distributed sampling may be necessary to target best management practices and to model P transport and fate in ditch networks. 相似文献
In areas of varying geology, it is difficult to infer water quality from specific conductance or electrical conductivity (EC) data without an understanding of the expected range of EC values based on local bedrock composition. This paper describes a user-friendly graphical screening method that addresses this issue by plotting the EC against concurrent alkalinity data, which correlates well with the presence of carbonate bedrock under natural conditions, and thus serves as an index of bedrock type. The upper limit of EC vs. alkalinity expected in a stream is determined using regional groundwater quality data, based on the assumption that stream chemistry reflects groundwater under baseflow conditions. Stream samples with EC/alkalinity values that consistently plot above this limit are considered impacted by anthropogenic sources. The effect of dilution and runoff on the EC vs. alkalinity plot of stream samples is considered using a simple baseflow/storm runoff-mixing model. The graphical method's utility as a screening tool is demonstrated by application to stream chemistry data from watersheds of southeastern Pennsylvania and northwestern New Jersey in several distinct geologic settings; however the method is general and widely applicable to watersheds in humid temperate regions. Its use is intended for watershed stewards of both professional and nonprofessional qualification. 相似文献
Wild polioviruses still remain endemic in three countries (Afghanistan, Pakistan, and Nigeria) and re-emergency of wild polio has been reported in previously polio-free countries. Environmental surveillance has been used as a supplementary tool in monitoring the circulation of wild poliovirus (PVs) and/or vaccine-derived PVs even in the absence of acute flaccid paralysis cases. This study aimed to monitor the presence of polioviruses in wastewater samples collected at one wastewater treatment plant located in the municipality of Rio de Janeiro, Brazil. From December 2011 to June 2012 and from September to December 2012, 31 samples were collected and processed. RD and L20B cell cultures were able to isolate PVs and non-polio enteroviruses in 27/31 samples. Polioviruses were isolated in eight samples (type 1 Sabin = 1, type 2 Sabin = 5, and type 3 Sabin = 2). Vaccine-derived polioviruses were not detected nor evidence of recombination with other PVs or non-polio enterovirus serotypes were observed among the isolates. The Sabin-related serotypes 2 and 3 presented nucleotide substitutions in positions associated with the neurovirulent phenotype at the 5′-UTR. Changes in important Amino acid residues at VP1 were also observed in the serotypes 2 and 3. Environmental surveillance has been used successfully in monitoring the circulation of PVs and non-polio enteroviruses and it is of crucial importance in the final stages of the WHO global polio eradication initiative. Our results show the continuous circulation of Sabin-like PVs and non-polio enteroviruses in the analyzed area during the study period. 相似文献
A mechanically stirred anaerobic sequencing batch reactor (ASBR) containing granular biomass was applied to the treatment of a wastewater simulating the effluent from a personal care industry. The ASBR was operated with cycle lengths (tC) of 8, 12 and 24 h and applied volumetric organic loads (AVOL) of 0.75, 0.50 and 0.25 gCOD/L.d, treating 2.0 L liquid medium per cycle. Stirring frequency was 150 rpm and the reactor was kept in an isothermal chamber at 30 °C. Increase in tC resulted in efficiency increase at constant AVOL, reaching 77% at tC of 24 h versus 69% at tC of 8 h. However, efficiency decreased when AVOL decreased as a function of increasing tC, due to the lack of substrate in the reaction medium. Moreover, replacing part of the wastewater by a chemically balanced synthetic one did not yield the expected effect and system efficiency dropped. 相似文献
The establishment of rules to manage Health Care Waste (HCW) is a challenge for the public sector. Regulatory agencies must ensure the safety of waste management alternatives for two very different profiles of generators: (1) hospitals, which concentrate the production of HCW and (2) small establishments, such as clinics, pharmacies and other sources, that generate dispersed quantities of HCW and are scattered throughout the city. To assist in developing sector regulations for the small generators, we evaluated three management scenarios using decision-making tools. They consisted of a disinfection technique (microwave, autoclave and lime) followed by landfilling, where transportation was also included. The microwave, autoclave and lime techniques were tested at the laboratory to establish the operating parameters to ensure their efficiency in disinfection. Using a life cycle assessment (LCA) and cost analysis, the decision-making tools aimed to determine the technique with the best environmental performance. This consisted of evaluating the eco-efficiency of each scenario. Based on the life cycle assessment, microwaving had the lowest environmental impact (12.64 Pt) followed by autoclaving (48.46 Pt). The cost analyses indicated values of US$ 0.12 kg?1 for the waste treated with microwaves, US$ 1.10 kg?1 for the waste treated by the autoclave and US$ 1.53 kg?1 for the waste treated with lime. The microwave disinfection presented the best eco-efficiency performance among those studied and provided a feasible alternative to subsidize the formulation of the policy for small generators of HCW. 相似文献
The following papers were presented at a technical session held during the 76th APCA Annual Meeting and Exhibition in Atlanta, Georgia in June 1983. The session, which focussed on the relationship between atmospheric deposition and forest activity, was organized by J. S. Jacobson and S. B. McLaughlin, Jr., and sponsored Jby APCA's TT-8 Acid Deposition Committee. 相似文献
Causal relationships involving role stressors, physical symptomatology, and turnover intentions were examined within three alternative specifications. These specifications stemmed from Beehr and Newman's (1978) and Schuler's (1982) models of role stress and Locke's (1976) theory of job satisfaction. The results, derived from LISREL VI analyses, indicate that a revised Schuler model is the most plausible specification. Findings are discussed in terms of implications for understanding role stress and employee withdrawal. 相似文献
Climate change is a global phenomenon that affects biophysical systems and human well-being. The Paris Agreement of the United Nations Framework Convention on Climate Change entered into force in 2016 with the objective of strengthening the global response to climate change by keeping global temperature rise this century well below 2 °C above pre-industrial levels and to pursue efforts to limit the temperature increase even further to 1.5 °C. The agreement requires all Parties to submit their “nationally determined contributions” (NDCs) and to strengthen these efforts in the years ahead. Reducing carbon emissions from deforestation and forest degradation is an important strategy for mitigating climate change, particularly in developing countries with large forests. Extensive tropical forest loss and degradation have increased awareness at the international level of the need to undertake large-scale ecological restoration, highlighting the need to identify cases in which restoration strategies can contribute to mitigation and adaptation. Here we consider Brazil as a case study to evaluate the benefits and challenges of implementing large-scale restoration programs in developing countries. The Brazilian NDC included the target of restoring and reforesting 12 million hectares of forests for multiple uses by 2030. Restoration of native vegetation is one of the foundations of sustainable rural development in Brazil and should consider multiple purposes, from biodiversity and ecosystem services conservation to social and economic development. However, ecological restoration still presents substantial challenges for tropical and mega-diverse countries, including the need to develop plans that are technically and financially feasible, as well as public policies and monitoring instruments that can assess effectiveness. The planning, execution, and monitoring of restoration efforts strongly depend on the context and the diagnosis of the area with respect to reference ecosystems (e.g., forests, savannas, grasslands, wetlands). In addition, poor integration of climate change policies at the national and subnational levels and with other sectorial policies constrains the large-scale implementation of restoration programs. The case of Brazil shows that slowing deforestation is possible; however, this analysis highlights the need for increased national commitment and international support for actions that require large-scale transformations of the forest sector regarding ecosystem restoration efforts. Scaling up the ambitions and actions of the Paris Agreement implies the need for a global framework that recognizes landscape restoration as a cost-effective nature-based solution and that supports countries in addressing their remaining needs, challenges, and barriers.
Environmental vulnerability analysis has been sparsely used in environmental performance evaluation (EPE) of technological innovations. The present paper proposes a methodological approach to carry out vulnerability analysis of watersheds and to integrate this analysis into methods of environmental performance evaluation of agro-industrial innovations. This approach is applied to the Ambitec-Life Cycle method, described in Part 1 (this issue) of this study. The case study of green coconut substrate compared to ripe coconut substrate, also described in Part 1 (this issue), is now presented considering the vulnerability analysis of the watersheds where the life cycle stages of these products occur. The integration of vulnerability analysis in Ambitec-Life Cycle contributes to a better understanding of the environmental aspects of agro-industrial technological innovations with potential to cause significant impacts in watersheds where these innovations are implemented. 相似文献
The life of a product begins with the initial product design concepts; the costs and potential impacts of a product are heavily influenced by the final design, the production processes, the economic and environmental costs of all raw materials. Additionally, both of these factors are very much affected by how the products are managed during and after consumer usage. Thus, there is an urgent need for a tool to facilitate the integration and assessment of environmental and economic demands into the product planning and development processes. The introduction of environmental accounting based on emergy as a tool to assist in product design is proposed. This complementary tool may be inserted into the conventional design methodology to facilitate in the selection of materials and processes as well as in the actual design of the products. To illustrate the application of the proposed method for material selection, PET (polyethylene terephthalate) bottles and aluminum cans for beverage packaging are compared. Despite the exceptional condition of aluminum recycling in Brazil, results show that the best option for beverage packages is the PET bottles. 相似文献