Surface Air Pollutant Concentration Frequency Distributions: Implications for Urban Modeling

With the development of ambient air quality standards (AAQS), the need arises to describe the characteristics of regional surface air-pollutant concentration frequency distributions. In the evaluation of land use plans, numerous agencies will be concerned with evaluating the effectiveness of emission zoning and/or control actions. On a regional basis, one means of performing this assessment lies in determining the changes in the pollutant frequency distributions resulting from control actions.

This study presents new data concerning the surface air-pollutant concentration frequency distributions observed for area sources and continuous point sources, and compares these distributions with those of the pertinent meteorological variables describing the transport and diffusion of the pollutant. The observed surface air pollutant frequency distributions are compared to those corresponding to simple modeling concepts from either an urban area source or a continuous point source. For an urban source and a relatively inert pollutant like CO, we found that the observed frequency distribution for CO surface air concentration parallels the approximately log-normal frequency distribution of the reciprocal of the wind speed. We show that the constant relating these two well-correlated frequency distributions can be determined either experimentally or with a numerical simulation model of air pollution. The usefulness of numerical models in air pollution is discussed.     

Variance Design and Air Pollution Control

Confronted with shortages of low sulfur content residual fuel oil and, consequently, faced with the threat of social and economic upheaval, several air pollution control authorities in the Northeastern states were forced to relax hard-won air quality standards during the winter of 1972. The authorities did so by granting variances to their sulfur content standards for residual fuel oil. This paper examines the institutional characteristics of these variance policies from an economic incentive standpoint. After setting up desirable structural criteria for institutional design of such crisis policies, the authors examine the experience of the winter of 1972 and arrive at policy guidelines which recommend themselves for consideration in future periods of fuel oil shortages.     

Status and Problems of Regenerable Flue Gas Desulfurization Processes

Fourteen sulfur and/or sulfuric acid producing regenerate FGD processes were discussed at the 1974 FGD Symposium in Atlanta. During the period elapsed since then, considerable status change has occurred on many of these regenerable processes. Other regenerable processes which were not as well known during 1974 have surfaced in 1975. The problems of obtaining reducing gases (hydrogen sulfide, carbon monoxide, and hydrogen) for the reduction of sulfur dioxide product streams to elemental sulfur have become severe due to shortages of natural gas or other petroleum based feedstock. A new sulfur producing process which employs CO and H₂ directly (rather than the H₂S required for liquid and vapor base Claus reactions) is gaining attention. This paper discusses briefly: (1) the announced status of the many regenerable FGD processes, (2) the problem of reductant gas supply, and (3) the effect on FGD processes of using coal based reducing gas instead of reformed natural gas.     

Results of Field Measurements of Industrial Particulate Sources and Electrostatic Precipitator Performance

This paper presents results of source size distribution measurements over the size range from 0.1 μm to 5 μm for six classes of particulate sources and fractional efficiency measurements on five full scale electrostatic precipitators and one pilot scale precipitator. The precipitators all showed moderately high to high particulate collection efficiencies for particles having diameters larger than a few micrometers or smaller than a few hundredths of a micrometer and a minimum in collection efficiency for particles having diameters of a few tenths of a micrometer.     

Characterization of Particulates from Power Plants

The emphasis on participate control from industrial processes has been shifted recently towards fine particulates, having diameters less than 3 microns. There exists an urgent need for more scientific information of fine particle characterization.^1,2 Coal and oil fired power plants are among the largest anthropogenic point sources of particulate matter.³ Limited knowledge is available on particle size distribution and trace metal composition in power plant emissions.^4-7 The morphological properties of particle emissions have been largely neglected. In this report we present some information on particle characteristics for an oil-fired and coal-fired power plant.     

Weekday-Weekend Pollutant Studies of the Los Angeles Basin

Pollutant data from the Los Angeles Basin were analyzed for weekday-weekend differences for the smog months of June through September 1972 and 1973. The pollutants investigated were oxidant, NO, NO₂, total hydrocarbons (HC), CO, and particulates. In order to maintain the diurnal variation, the concentration percentiles were calculated for each weekday and weekend hour.     

The Formation of Mg3Ca(S04)4 during the Sulfation Reaction of Dolomite

Abstract

Inspection and maintenance programs for motor vehicles in the United States increasingly use loaded mode mass emissions testing (IM240). A method was developed to predict mass emission rates and mass emission changes, particularly from repair benefits, using a low-cost, portable four-gas non-dispersive infrared (NDIR) vehicle exhaust gas analyzer. A single vehicle was tested several times with the analyzer while on the dynamometer and undergoing successive repairs. Excellent correlations for CO and HC were observed. Five vehicles were measured using an on-road driving loop before and after emissions-related repairs, while another three vehicles were tested with no repairs performed. The on-road concentration data used to guide the repair process were converted to grams per gallon; when divided by estimated miles per gallon, this gave grams per mile emissions for comparison to IM240. Correlation coefficients (r²) of 0.87 for CO and 0.76 for HC were achieved for the 13 tests. The linear correlations between IM240 and emissions measured by this method would allow repair facilities to perform a relatively inexpensive test for diagnostic purposes and to estimate repair effectiveness without the need for a dynamometer.     

A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.     

The Effects of Precipitation on Aquatic and Terrestrial Ecosystems: A Proposed Precipitation Chemistry Network

Precipitation is one of the most important factors determining the nature and productivity of terrestrial and aquatic ecosystems. Detailed historical and contemporary records are available indicating the amount of water deposited at thousands of locations throughout the world. Comparatively, however, knowledge of the changing chemistry of precipitation has developed only recently and is still very fragmentary. Our present ignorance of the total impact of changes in precipitation quality on the productivity and stability of ecosystems is especially profound. This paper has a fourfold purpose: (1) to describe the myriad of trace chemical constituents transferred from the atmosphere into the biosphere of the earth; (2) to define the range of beneficial and injurious ecological effects of perturbations in atmospheric deposition; (3) to explain the concepts of sensitive areas, life stages, and life forms; and (4) to describe briefly plans for a National Deposition Network and associated research on the terrestrial and aquatic ecosystems of the United States.     

Desulfurization of Flue Gases in A Fluidized Bed of Modified Limestone

This publication concerns the dry removal of SO₂ from gases using limestone absorbents. It reports bench-scale experiments made with commercial samples of powdered limestone (CaCO₃) activated by addition of a cheap substance, namely CaCl₂. The absorption was carried out in a fluidized bed traversed by the flue gases, between 600° and 900° C. The degree and rate of transformation of CaCO₃ to CaSO₄ in the presence of SO₂ and air have been compared for unmodified and modified absorbents. Initial rates of reaction, and the variation of the rate of absorption with time have been measured. The influence of the SO₂ content of the gas has been assessed. At 700° C, the maximum degree of transformation of activated limestone to sulfate exceeds 90%, whereas untreated CaCO₃ transforms only to 16–20%. At the same temperature, more than 90% of SO₂ contained In a gas carrying 0.35% SO₂ is removed. Because of the much smaller quantity of solid absorbent required, dry absorption processes based on the modified absorbents might get renewed interest. The modified absorbents might also be used for in situ absorption in fluidized bed combustion, in which the temperatures are in the range studied in the present paper.