Adsorption of imidazolinone herbicides on ferrihydrite-humic acid associations.

Adsorption of the imidazolinone herbicides imazapyr, imazethapyr and imazaquin was studied on two binary systems (ferrihydrite-humic acid) prepared by treating ferrihydrite (Fh) immediately after its precipitation with a soil humic acid (HA) at different loadings (4% and 8% HA content), and on a blank ferrihydrite sample prepared in the same way, but without HA addition. Imidazolinone adsorption on pure Fh and on the 4% Fh-HA decreased with increasing of the herbicide hydrophobicity (imazaquin相似文献   

Sorption of ametryn and imazethapyr in twenty-five soils from Pakistan and Australia.

Sorption of ametryn and imazethapyr in 25 soils from Pakistan and Australia was investigated using the batch method. The soils varied widely in their intrinsic capacities to sorb these herbicides as shown by the sorption coefficients, Kd, which ranged from 0.59 to 47.6 for ametryn and 0.02 to 6.94 for imazethapyr. Generally the alkaline soils of Pakistan had much lower Kd values of both herbicides than the soils of Australia. Both soil pH and soil organic carbon (SOC) were correlated significantly with the sorption of ametryn, whereas only soil pH was strongly correlated with imazethapyr sorption. No correlation was found between Kd values of the herbicides and the clay contents of the soils. Multiple regression analysis showed that Kd values were better correlated (r2=0.94 and 0.89 for ametryn and imazethapyr, respectively) if SOC and pH were simultaneously taken into account. The study indicated that sorption of these herbicides in the alkaline soils of Pakistan was low and consequently there is considerable risk of groundwater contamination.     

Analysis of photochemical pollution in summer and winter using a photochemical box model in the center of Tokyo, Japan.

In order to give an effective and rapid analysis of the photochemical pollution and information for emission control strategies, a photochemical box model (PBM) was applied to one moderate summer episode, 11 July 1996, and one typical winter episode, 3 December 1996, in the center of Tokyo, Japan. The box model gave a good prediction of the photochemical pollution with minimal investment. As expected, the peak ozone in summer is higher than in winter. The NOx concentrations in winter are higher than those in summer. In summer, NO and NO2 have one peak in the morning. In winter, NO and NO2 show two peaks during the day. Three model runs including no reactions, a zero ozone boundary condition and dark reactions were conducted to understand the photochemical processes. The effects of emission reduction on the formation of the photochemical pollution in the center of Tokyo have been studied. The results show that the reduction of NMHC emission can decrease the ozone, however, the reduction of NOx emission can increase the ozone. It can be concluded that if the NOx emission are reduced, the reduction of NMHC should be more emphasized in order to decrease the ozone concentration in the center of Tokyo, Japan, especially the reduction of the NMHC from stationary source emission.     

Primary biodegradation of veterinary antibiotics in aerobic and anaerobic surface water simulation systems

The primary aerobic and anaerobic biodegradability at intermediate concentrations (50-5000 microg/l) of the antibiotics olaquindox (OLA), metronidazole (MET), tylosin (TYL) and oxytetracycline (OTC) was studied in a simple shake flask system simulating the conditions in surface waters. The purpose of the study was to provide rate data for primary biodegradation in the scenario where antibiotics pollute surface waters as a result of run-off from arable land. The source of antibiotics may be application of manure as fertilizer or excreta of grazing animals. Assuming first-order degradation kinetics, ranges of half-lives for aerobic degradation of the four antibiotics studied were 4-8 days (OLA), 9.5-40 days (TYL), 14-104 days (MET) and 42-46 days (OTC). OLA and OTC were degraded with no initial lag phase whereas lag phases from 2 to 34 days (MET) and 31 to 40 days (TYL) were observed for other substances. The biodegradation behaviour was influenced by neither the concentrations of antibiotics nor the time of the year and location for sampling of surface water. Addition of 1 g/l of sediment or 3 mg/l of activated sludge from wastewater treatment increased the biodegradation potential which is believed to be the result of increased bacterial concentration in the test solution. Biodegradation was significantly slower in tests conducted in absence of oxygen. Assessments of the toxic properties of antibiotics by studying the influence on the biodegradation rates of 14C-aniline at different concentrations of antibiotics showed that no tests were conducted at toxic concentrations.     

The acute toxicity of agricultural surfactants to the tadpoles of four Australian and two exotic frogs

Nonionic surfactants are frequently incorporated into pesticide formulations, and are therefore a group of chemicals to which amphibians may be exposed in agricultural or urban landscapes. However, little is known about the effects of surfactant exposure in amphibians. Feeding stage tadpoles of Bufo marinus, Xenopus laevis and four species of Australian frogs (Crinia insignifera, Heleioporus eyrei, Limnodynastes dorsalis and Litoria moorei) were exposed to nonylphenol ethoxylate (NPE) and alcohol alkoxylate in static-renewal acute toxicity tests. All species exhibited nonspecific narcosis following exposure to both these surfactants. The 48-h EC50 values for NPE ranged between 1.1 mg/l (mild narcosis) and 12.1 mg/l (full narcosis). The 48-h EC50 values for alcohol alkoxylate ranged between 5.3 mg/l (mild narcosis) and 25.4 mg/l (full narcosis). Replicate acute toxicity tests with B. narinus exposed to NPE at 30 degrees C over 96 h indicated that the narcotic effects were not particularly time dependant. The mean 24, 48, 72, and 96-h EC50 (mild narcosis) values were 3.6, 3.7, 3.5 and 3.5 mg/l, respectively. The mean 24, 48, 72 and 96-h EC50 (full narcosis) were 4.0, 4.1, 4.2 and 4.0, respectively. Acute toxicity tests with B. marinus exposed to NPE at 30 degrees C under conditions of low dissolved oxygen (0.8-2.3 mg/l) produced a two to threefold increase in toxicity.     

Formation of PCDDs and PCDFs during the combustion of polyvinylidene chloride

In laboratory-scale combustion of polyvinylidene chloride (PVDC) with a quartz tubular furnace designed and fabricated to provide the desired combustion temperature and mixing state of combustion gas with air, it was found that at 800 degrees C or higher the level of polychlorinated dibenzo-p-dioxins/polychlorinated dibenzofurans [corrected] (PCDDs/PCDFs) resulting from PVDC combustion was no higher than that from heating air alone, and thus far below the levels which resulted from PVDC combustion at 750 degrees C or lower. The results provide the first laboratory confirmation of the relation between PVDC incineration temperature and PCDD/PCDF formation, and of the primary importance of high temperature, turbulence for mixing between air and combustion gas, and sufficient residence time, as governing factors for the minimization of PCDD/PCDF formation in municipal solid waste incinerators.     

A reproducible approach to the reporting of organochlorine compounds in epidemiologic studies

A growing body of research indicates that the most biologically active PCB congeners and organochlorines are not the most abundant components in human and wildlife samples. As researchers attempt measurement on a wider pool of less abundant compounds, they inevitably face quantification problems. To address this problem and enhance comparability across studies, we propose a standardized approach to report organochlorines that is based on a reproducible method to determine the limit of quantification (LQ). Two statistical methods are incorporated into our approach, one by Gibbons termed the Alternative Minimum Level (AML), and one based on determining a region of stable relativestandard deviation in instrument response (RSD). We illustrate our approach using historical samples collected during the 1960s from a cohort of pregnant women enrolled in the Child Health and Development Study. The results are applicable to determining the LQ of any method, and are of utmost importance to environmental scientists conducting trace organic analyses of complex mixtures. Our results demonstrate that: (1) precision as measured by RSD is the most important criterion in determining LQ; (2) the AML routinely isolates a region of constant RSD; and (3) the precision of the instrument detector response as measured with pure standards locates the LQ applicable for real samples - that is, the true limits of quantification reside in the detector, not the matrix effects or analyte recoveries associated with real samples. A corollary of these findings is that bias due to matrix effects and analyte recoveries can be assessed separately from precision and LQdetermination. Previous approaches involved spiking matrix blanks to determine LQ, a problematic strategy for real world, complex matrices. We have now validated the use of pure standards in LQ determination, an approach that is practical and accessible to most analysts.     

The organic precursors affecting the formation of disinfection by-products with chlorine dioxide

The object of this research was to study the formation of disinfection by-products by using chlorine dioxide (ClO2) as a disinfectant reacting with different properties of organic substance in natural aquatic environment. The adsorbent resin (XAD-4, XAD-7) was used to divide the organic matters in raw water into three groups. The influence of the function groups on structure, reaction tendency, and formation of disinfection by-products generated by the reaction of these organic substances with chlorine dioxide was explored. The experimental results show that the three different organic groups formed using adsorbent resin were hydrophobic substance, hydrophilic acid, and non-acid hydrophilics in proportions of 43%, 41%, and 16%, respectively. Within the raw water in our study, the hydrophilic substance had a higher distribution proportion than that described in general articles and journals, which indicates that this water was contaminated with pollution from human beings. The exploration of the reactivity of the three different organic substances with chlorine dioxide shows that the unit consumption of disinfection agent per unit organic matters (represented by ClO2/DOC) is in the following sequence hydrophobic substance > hydrophilic substance > non-acid hydrophilics. It indicated that larger molecular organic precursors had larger consumption of disinfectant. We also discovered that after the reaction of the three different organic substances with chlorine dioxide, the largest amount of disinfection by-products were generated by the non-acid hydrophilics.     

Biodegradation during contaminant transport in porous media: 4. Impact of microbial lag and bacterial cell growth

Miscible-displacement experiments were conducted to examine the impact of microbial lag and bacterial cell growth on the transport of salicylate, a model hydrocarbon compound. The impacts of these processes were examined separately, as well as jointly, to determine their relative effects on biodegradation dynamics. For each experiment, a column was packed with porous medium that was first inoculated with bacteria that contained the NAH plasmid encoding genes for the degradation of naphthalene and salicylate, and then subjected to a step input of salicylate solution. The transport behavior of salicylate was non-steady for all cases examined, and was clearly influenced by a delay (lag) in the onset of biodegradation. This microbial lag, which was consistent with the results of batch experiments, is attributed to the induction and synthesis of the enzymes required for biodegradation of salicylate. The effect of microbial lag on salicylate transport was eliminated by exposing the column to two successive pulses of salicylate, thereby allowing the cells to acclimate to the carbon source during the first pulse. Elimination of microbial lag effects allowed the impact of bacterial growth on salicylate transport to be quantified, which was accomplished by determining a cell mass balance. Conversely, the impact of microbial lag was further investigated by performing a similar double-pulse experiment under no-growth conditions. Significant cell elution was observed and quantified for all conditions/systems. The results of these experiments allowed us to differentiate the effects associated with microbial lag and growth, two coupled processes whose impacts on the biodegradation and transport of contaminants can be difficult to distinguish.     

Development and evaluation of a continuous coarse (PM10-PM2.5) particle monitor

In this paper, we describe the development and laboratory and field evaluation of a continuous coarse (2.5-10 microm) particle mass (PM) monitor that can provide reliable measurements of the coarse mass (CM) concentrations in time intervals as short as 5-10 min. The operating principle of the monitor is based on enriching CM concentrations by a factor of approximately 25 by means of a 2.5-microm cut point round nozzle virtual impactor while maintaining fine mass (FM)--that is, the mass of PM2.5 at ambient concentrations. The aerosol mixture is subsequently drawn through a standard tapered element oscillating microbalance (TEOM), the response of which is dominated by the contributions of the CM, due to concentration enrichment. Findings from the field study ascertain that a TEOM coupled with a PM10 inlet followed by a 2.5-microm cut point round nozzle virtual impactor can be used successfully for continuous CM concentration measurements. The average concentration-enriched CM concentrations measured by the TEOM were 26-27 times higher than those measured by the time-integrated PM10 samplers [the micro-orifice uniform deposit impactor (MOUDI) and the Partisol] and were highly correlated. CM concentrations measured by the concentration-enriched TEOM were independent of the ambient FM-to-CM concentration ratio, due to the decrease in ambient coarse particle mass median diameter with an increasing FM-to-CM concentration ratio. Finally, our results illustrate one of the main problems associated with the use of real impactors to sample particles at relative humidity (RH) values less than 40%. While PM10 concentrations obtained by means of the MOUDI and Partisol were in excellent agreement, CM concentrations measured by the MOUDI were low by 20%, and FM concentrations were high by a factor of 5, together suggesting particle bounce at low RH.