Three-year lifecycle,large body,and very high threshold temperature in the cricket <Emphasis Type="Italic">Gryllus argenteus</Emphasis> for special adaptation to desiccation cycle in Malawi

In temperate climates, the initiation and termination of diapause synchronize the stress-tolerant stage with the stressful season and reproduction with the non-stressful season in many insects. Synchronization is often regulated by photoperiodism.Voltinism and the ultimate size of adults are also important determinants for their lifecycle, and different diapause stages and voltinism patterns are known in crickets.Here, we investigated the life history of the African cricket Gryllus argenteus from Malawi, which is a typical arid tropical highland. The climate is characterized by alternating arid and wet seasons, each of which lasts for half a year, and where the available heat mass is much less than lowlands at the same latitude. We first measured the nymphal duration at each rearing temperature and calculated the lower developmental threshold (t ₀) to be 20.19 °C based on Ikemoto and Takai (2000) and 19.38 °C based on a conventional line-fitting method. These values are very high relative to many other insects. The local temperature in winter does not fall below 15 °C, but this is much higher than the lethal limit. This suggested that critical stress in this locality was not coldness but low precipitation in winter. We estimated, based both on local temperature change and the Ikemoto and Takai’s t ₀, that G. argenteus required 3 years to complete its lifecycle unlike wet lowland species, where univoltinism or multi-voltinism are commonplace. Photoperiodism was observed in this species, but due to a lag between annual cycles in photoperiod, temperature, and humidity, photoperiodism alone cannot atune their lifecycle with local conditions.Synchronization in this species was achieved by three different adaptations: photoperiodism, high t ₀, and large body size, which give it a long lifecycle. Although the species cannot achieve a univoltine lifecycle because of its high t₀ value, it can escape from dry season by entering diapause at moderate temperatures, probably thereby achieving adaptive synchrony of lifecycle with both favorable and unfavorable seasons. A comparison between a conventional photothermogram and a newly formulated photohydrogram or photohygrogram demonstrates that even though sufficient heat is available, scarcity of water and thus scarcity of foliage should force the cricket to maintain diapause at intermediate temperature. The results suggested that high t ₀, large body size, and multi-ennial lifecycle mutually affect each other and formulate a unique adaptation under such an extreme environment.     

Hans-Joachim Schallna? (1957–2007)

Ohne Zusammenfassung     

Treibhausgasemissionen zukünftiger Erdgasbereitstellung für Deutschland

Ohne Zusammenfassung Original erschienen in UWSF – Z Umweltchem ?kotox 20(2):133–144 (2008) DOI: Herausgeber: Martin Pehnt und Eckard Helmers     

Phosphorus removal from municipal wastewater by hydrous ferric oxide reactive filtration and coupled chemically enhanced secondary treatment: part I--performance.

This work examines the performance of a hydrous ferric oxide (HFO) reactive filtration (RF) process with coupled chemically enhanced secondary treatment (RECYCLE) for phosphorus removal from municipal wastewater (HFO-RF-RECYCLE). A 3-month, 0.95-ML/d (0.25-mgd) demonstration of HFO-RF-RECYCLE was performed at a municipal wastewater treatment plant equipped with oxidation ditches and secondary clarifiers. Influent to the plant averaged 6.0 mg/L phosphorus, with a tertiary effluent average of 0.011 mg/L phosphorus. Iron doses to the plant were low, at 5 mg/L. Inline recycling of HFO solution rejects to the plant influent resulted in a maximum 90.3%, dose-dependent reduction of phosphorus in the secondary effluent at 4.5 ML/d (1.2 mgd). Other results included reduction of total suspended solids and turbidity. A mass balance analysis was performed. We conclude that HFO-RF-RECYCLE may allow very low levels of phosphorus discharge from municipal wastewater treatment plants with a ferric-iron-based tertiary filtration process and residual recycling.     

Aerobic and anaerobic transformations of sulfide in a sewer system--field study and model simulations.

The formation and fate of sulfide in a force main and a downstream-located gravity sewer were investigated in an extensive field study. Sulfide formation in the force main was significant. However, during 14 minutes of transport in the gravity sewer, the sulfide concentration decreased 30%, on average. An application of a conceptual sewer process model for simulating the formation and fate of sulfide was demonstrated. Overall, the model predicted that approximately 90% of the decrease of the sulfide concentration in the gravity sewer was the result of sulfide oxidation and that only a small fraction entered the sewer atmosphere, causing odor and corrosion. Even so, the model predicted concrete corrosion rates of up to 1.2 mm/y in the gravity sewer section.     

Application of microbial hot spots enhances pesticide degradation in soils

Through transfer of an active, isoproturon degrading microbial community, pesticide mineralization could be successfully enhanced in various soils under laboratory and outdoor conditions. The microbes, extracted from a soil having high native ability to mineralize this chemical, were established on expanded clay particles and distributed to various soils in the form of microbial "hot spots". Both, diffusion controlled isoproturon mass flow towards these "hot spots" (6microg d(-1)) as well as microbial ability to mineralize the herbicide (approximately 5microg d(-1)) were identified as the main processes enabling a multiple augmentation of the native isoproturon mineralization even in soils with heavy metal contamination. Soil pH-value appears to exert an important effect on the sustainability of this process.     

The rationales behind the unit-segment theory and its analysis methodology for modeling vehicular movement networks

The theory of space accessibility analysis, space syntax, has been considered for capturing trip-makers’ route-choice decisions with an understanding that, while selecting routes, trip-makers tend to follow forward-facing fields traditionally represented by axial lines. But the idea of treating axial lines as a set of roadway segments representing an urban texture has remained under scrutiny when distinct procedures have been tested without much success. Nor has the axial-line theory seemed to gain much popularity within the orthodox transportation planning community. Studies show that a long axial line is found gaining configurational centrality, in general, for being well connected to its incident lines. Fragmenting a long axial line results in weakening it (in centrality terms), but also in generating a locally oriented model. Recent investigations, dealing with this problem, have resulted in the emergence of the unit-segment theory, which has turned out to be more sensitive to the local structures located within a large urban texture than the axial counterpart for the purpose of modeling vehicular movement networks without using origin–destination trip-counts. Essentially, the question now is: Is the unit-segment analysis also capable of generating syntax configurations that are equally sensitive to large and complex urban textures? What should be the methodology of such an analysis? This paper throws deeper insights into these questions by producing theoretical and empirical research findings and seeks to develop a common ground for both transportation planning and space syntax communities to work together for gaining a better understanding of how urban configurations relate to urban vehicular movement networks.     

Static and Dynamic Behavior of Fibrous Polymeric Composite Materials at Different Environmental Conditions

The study of static and dynamic behavior of environmentally conditioned fibre reinforced polymeric (FRP) composites is necessary and crucial to examine the durability, reliability and sustainability of these noble materials. FRP composites are being used all around the globe and substituting the conventional materials, starting from mini toys to large aerospace components. Present review has introduced to accumulate and understand the disseminate literature in concentrating the significance of understanding the static and dynamic behavior of FRPs with changing environmental conditionings (hygrothermal, low and high temperature, salt solution, freeze thaw, UV light) and with the interaction of different nano-fillers. Their stability and integrity in diverse service environments may be reformed by their reactions against different nature of loadings i.e. static or dynamic and the components such as fibre, matrix and fibre/matrix interfaces in those environments. The static and dynamic states of loading may come with a possible weaker region to encounter the durability and integrity of the composites. To understand the exact failure modes that correlates the position of environmentally conditioned interfaces and dynamic state of loadings, thus confusing the estimation of its overall performance and mechanical behavior. Interface reliability and durability is vital since in-service environments the degradation in the interfacial region leads to complete composite failure. Therefore, the study of combined effects of various in-service environmental conditions and the role of static and dynamic behavior on the interface will be a crucial part related to the multiaxial dynamic states of failures occurring in FRP’s.