Role of illumination intensity in microcystin development using Microcystis aeruginosa as the model algae

Environmental Science and Pollution Research - Microcystis aeruginosa (M. aeruginosa) is one of the most common genera of cyanobacteria in algal blooms. In the present work, the impact of the...     

Comparative studies of the Fe–UV, H2O2–UV, TiO2–UV/vis systems for the decolorization of a textile dye X-3B in water

The degradation of a common textile dye, Reactive-brilliant red X-3B, by several advanced oxidation technologies was studied in an air-saturated aqueous solution. The dye was resistant to the UV illumination (wavelength λ  320 nm), but was decolorized when one of Fe³⁺, H₂O₂ and TiO₂ components was present. The decolorization rate was observed to be quite different for each system, and the relative order evaluated under comparable conditions followed the order of Fe²⁺–H₂O₂–UV  Fe²⁺–H₂O₂ > Fe³⁺–H₂O₂–UV > Fe³⁺–H₂O₂ > Fe³⁺–TiO₂–UV > TiO₂–UV > Fe³⁺–UV > TiO₂–visible light (λ  450 nm) > H₂O₂–UV > Fe²⁺–UV. The mechanism for each process is discussed, and linked together for understanding the observed differences in reactivity.     

Heavy metal pollution in sediments of the largest reservoir (Three Gorges Reservoir) in China: a review

The Three Gorges Dam in China is the world’s largest dam. Upon its completion in 2003, the Three Gorges Reservoir (TGR) became the largest reservoir in China and plays an important role in economic development and national drinking water safety. However, as a sink and source of heavy metals, there is a lack of continuous and comparative data on heavy metal pollution in sediments. This study reviewed all available literatures published on heavy metals in TGR sediments and further provided a comprehensive assessment of the pollution tendency of these heavy metals. The results showed that heavy metal concentrations in TGR sediments varied spatially and temporally. Temporal variations indicated that Hg in tributaries, as well as As, Cd, Cr, Cu, Ni, Pb, and Zn in the mainstream, exhibited a higher probability to exceed background values after the impoundment of TGR. Pollution assessments by contamination factor, geoaccumulation index, and potential ecological risk were similar. High Cd and Hg concentrations in both the mainstream and tributaries are a cause for much concern. However, sediment quality guidelines produced different results, as most previous studies adopted different sampling and measurement strategies. The data inconsistencies and lack of continuity regarding the reservoir confirm the need for a continuous monitoring network and the development of quality criteria relevant to the sediments of the TGR in the future.     

腐熟蓝藻与厌氧污泥混合厌氧发酵特性

采用批次小试实验对不同腐熟程度的蓝藻进行厌氧发酵产沼气实验研究。结果表明,新鲜蓝藻在30-35℃时腐熟7 d后,可在35℃的厌氧温度下获得最高的产气速率和246 mL/g COD的产气量,产气潜力为354 mL/g（VS）。厌氧反应15 d后,累计产气量、COD和VFA浓度趋于稳定。淀粉酶和脱氢酶的活性在厌氧反应初期受到抑制,蛋白酶活性和辅酶F420浓度在厌氧系统中逐渐增加,分别在第6天达到27.66μmol/（g VS·min）和第15天达到0.62μmol/g（VS）。15-18d是腐熟蓝藻适宜的中温厌氧发酵时间,少于以新鲜蓝藻为基质的厌氧消化时间。蓝藻腐熟过程促进了厌氧反应,腐熟7 d的蓝藻厌氧系统具有更高的微生物活性和产甲烷能力。     

Fe3O4/Ag磁性纳米颗粒去除水中的铅离子

采用水相共沉淀法制备小尺寸磁性Fe₃O₄纳米颗粒,以没食子酸作为还原剂和表面修饰剂,还原Ag[(NH₃)₂]⁺制备出Fe₃O₄/Ag磁性纳米颗粒。研究该磁性纳米颗粒对水溶液中铅离子的吸附行为,研究结果表明,pH为7.0,吸附温度30℃时可得到最好的处理效果,铅的去除率可达99.7%以上,Fe₃O₄/Ag颗粒吸附行为符合二级动力学模型(R² > 0.99)。该磁性纳米颗粒经过多次再生处理后,仍具有很好的吸附效果,表明Fe₃O₄/Ag在水处理方面拥有良好的应用前景。     

骨炭对水中不同形态Sb吸附和解吸的影响

采用骨炭作为吸附剂,研究其在不同骨炭用量、pH值和温度条件下对水中Sb（Ⅲ）和Sb（Ⅴ）吸附和解吸的影响。结果表明,骨炭对Sb（Ⅲ）的吸附效果远好于Sb（Ⅴ）,在0.2~8.0 mmol/L的Sb（Ⅲ）和Sb（Ⅴ）浓度下,骨炭对这2种形态Sb的去除率分别为46.1%~78.6%和9.6%~31.7%。采用Langmuir方程和Freundlich方程均可以很好地拟合骨炭对Sb（Ⅲ）和Sb（Ⅴ）的吸附,Sb（Ⅲ）和Sb（Ⅴ）的最大吸附容量分别为110.1034 mg/g和17.4167 mg/g。骨炭对Sb（Ⅲ）的解吸也大于对Sb（Ⅴ）的解吸。骨炭对Sb（Ⅲ）和Sb（Ⅴ）的吸附受不同骨炭用量、pH值和温度影响。     

响应面分析法优化稀土废水MAP沉淀法脱氮

经过预处理后的稀土生产废水,其氨氮浓度大幅降低,但并未达到中华人民共和国《稀土工业污染物排放标准》（GB26451-2011）中氨氮浓度限值。实验通过响应面分析法中的Box-Behnken实验设计（BBD）,取pH、n（Mg）：n（N）、n（P）：n（N）3因素,采用Design-Expert 8.0.6,建立合适的剩余氨氮浓度及剩余总磷浓度模型,得到回归方程,并分析模型各项指标,各因素及其相互作用对剩余氨氮浓度及剩余总磷浓度的影响。利用预测模型预测最佳实验条件,在最佳实验条件下验证预测结果,并对沉淀物进行X射线衍射（XRD）分析。结果显示,二次响应模型适用于剩余氨氮浓度及剩余总磷浓度,2个模型均拥有较好的拟合程度、可信度及精密度,最优反应条件为：pH=9.88、n（Mg）：n（N）=1.50：1、n（P）：n（N）=1.38：1时,剩余氨氮浓度为46.58 mg/L,剩余总磷浓度为7.85 mg/L。在最优条件下所得到的沉淀物并非纯净的MgNH₄PO₄·6H₂O,还有Mg₃（PO₄）₂·22H₂O生成。     

Pollution characteristics of ambient volatile organic compounds (VOCs) in the southeast coastal cities of China

With the rapid urbanization, the southeast coastal cities of China are facing increasing air pollution in the past decades. Large emissions of VOCs from vehicles and petrochemical factories have contributed greatly to the local air quality deterioration. Investigating the pollution characteristics of VOCs is of great significance to the environmental risk assessment and air quality improvement. Ambient VOC samples were collected simultaneously from nine coastal cities of southeast China using the Tedlar bags, and were subsequently preprocessed and analyzed using a cryogenic preconcentrator and a gas chromatography–mass spectrometry system, respectively. VOC compositions, spatial distributions, seasonal variations and ozone formation potentials (OPFs) were discussed. Results showed that methylene chloride, toluene, isopropyl alcohol and n-hexane were most abundant species, and oxygenated compounds, aromatics and halogenated hydrocarbons were most abundant chemical classes (62.5–95.6 % of TVOCs). Both industrial and vehicular exhausts might contribute greatly to the VOC emissions. The VOC levels in the southeast coastal cities of China were sufficiently high (e.g., 6.5 μg?m^?3 for benzene) to pose a health risk to local people. A more serious pollution state was found in the southern cities of the study region, while higher VOC levels were usually observed in winter. The B/T ratio (0.26?±?0.09) was lower than the typical ratio (ca. 0.6) for roadside samples, while the B/E (1.6–7.6) and T/E (7.2–26.8) ratios were higher than other cities around the world, which indicated a unique emission profile in the study region. Besides, analysis on ozone formation potentials (OFPs) indicated that toluene was the most important species in ozone production with the accountabilities for total OFPs of 22.6 to 59.6 %.     

不同来源高浓度有机废水的集中处理

按照水质情况,将多种来源于不同工业生产过程中的高浓度有机废水划分为高悬浮固体乳化液废水、难生化高浓度有机废水、高悬浮固体不含油有机废水、含铬有机废水和杂质含量较少的乳化液废水5类,分别采用酸化破乳/Fen-ton氧化/混凝/絮凝、Fenton氧化/混凝/絮凝、混凝/絮凝、还原/混凝/絮凝、震动膜过滤技术作为生化预处理技术,并通过小试和中试验证了各技术的效果。实验结果表明,按照上述分类结果,采用不同预处理技术可以得到良好的效果,废水水质明显改善,满足继续生化处理的基本条件。各预处理生产装置处理效果稳定,同时生化系统已经稳定运行120天以上,COD去除率超过90%,出水经过低剂量的Fenton试剂处理后可达到《污水排入城镇下水道水质标准》(CJ343-2012)。     

中国南方某城市自来水厂处理工艺对多环芳烃的去除效果研究

讨论了中国南方某城市自来水厂饮用水中的多环芳烃残留规律以及现有净水工艺对多环芳烃的去除效果。研究结果表明,该自来水厂饮用水中检出多环芳烃以2~4环芳烃为主,强致癌性高环数多环芳烃均在检出限以下,且多环芳烃总量未超出中国供水行业标准(2000年)的相关限值。各处理工艺段中,砂滤过程对多环芳烃的去除效果最好,相较于原水对多环芳烃总量的去除率可达64%。