Chemical Treatments of Natural Fiber for Use in Natural Fiber-Reinforced Composites: A Review

Studies on the use of natural fibers as replacement to man-made fiber in fiber-reinforced composites have increased and opened up further industrial possibilities. Natural fibers have the advantages of low density, low cost, and biodegradability. However, the main disadvantages of natural fibers in composites are the poor compatibility between fiber and matrix and the relative high moisture sorption. Therefore, chemical treatments are considered in modifying the fiber surface properties. In this paper, the different chemical modifications on natural fibers for use in natural fiber-reinforced composites are reviewed. Chemical treatments including alkali, silane, acetylation, benzoylation, acrylation, maleated coupling agents, isocyanates, permanganate and others are discussed. The chemical treatment of fiber aimed at improving the adhesion between the fiber surface and the polymer matrix may not only modify the fiber surface but also increase fiber strength. Water absorption of composites is reduced and their mechanical properties are improved.     

Transparent exopolymer particles (TEPs)-associated protobiofilm: A neglected contributor to biofouling during membrane filtration

• Bacteria could easily and quickly attached onto TEP to form protobiofilms. • TEP-protobiofilm facilitate the transport of bacteria to membrane surface. • More significant flux decline was observed in the presence of TEP-protobiofilms. • Membrane fouling shows higher sensitivity to protobiofilm not to bacteria level. Transparent exopolymer particles (TEPs) are a class of transparent gel-like polysaccharides, which have been widely detected in almost every kind of feed water to membrane systems, including freshwater, seawater and wastewater. Although TEP have been thought to be related to the membrane fouling, little information is currently available for their influential mechanisms and the pertinence to biofouling development. The present study, thus, aims to explore the impact of TEPs on biofouling development during ultrafiltration. TEP samples were inoculated with bacteria for several hours before filtration and the formation of “protobiofilm” (pre-colonized TEP by bacteria) was examined and its influence on biofouling was determined. It was observed that the bacteria can easily and quickly attach onto TEPs and form protobiofilms. Ultrafiltration experiments further revealed that TEP-protobiofilms served as carriers which facilitated and accelerated transport of bacteria to membrane surface, leading to rapid development of biofouling on the ultrafiltration membrane surfaces. Moreover, compared to the feed water containing independent bacteria and TEPs, more flux decline was observed with TEP-protobiofilms. Consequently, it appeared from this study that TEP-protobiofilms play a vital role in the development of membrane biofouling, but unfortunately, this phenomenon has been often overlooked in the literature. Obviously, these findings in turn may also challenge the current understanding of organic fouling and biofouling as membrane fouling caused by TEP-protobiofilm is a combination of both. It is expected that this study might promote further research in general membrane fouling mechanisms and the development of an effective mitigation strategy.     

Coupled Monte Carlo simulation and Copula theory for uncertainty analysis of multiphase flow simulation models

Environmental Science and Pollution Research - Simulation-optimization techniques are effective in identifying an optimal remediation strategy. Simulation models with uncertainty, primarily in the...     

江汉平原湖区农田防护林的小气候效应研究

在区域开发中,平原湖区的林业发展潜力很大,同时,湖区农田防护林的建设,也是促进生态平衡的一项重要措施,防护林能进一步改善湖区小气候环境,尤其对保障农业生产有着相当重要的意义。通过对江汉平原湖区的农田防护林网内的小气候效应温度,湿度,风速等要素的观测数据进行研究,我们得出的结果表明：江汉平原湖区农田林网的建设,除提供工农业生产所需的林木外,随着林木的增多,林网的完善,还可调节气候,保持水土,防风固沙     

废铁屑-改性粉煤灰联用处理铬渣渗滤液

针对铬渣严重污染环境问题,以"以废治废"为研究目标,采用室内静态实验方法,进行废铁屑-改性粉煤灰联用处理铬渣渗滤液中Cr(Ⅵ)和总铬实验研究。实验结果表明,废铁屑与聚合氯化铝改性粉煤灰联用处理Cr(Ⅵ)和总铬效果优于单独采用其中一种物质;处理Cr(Ⅵ)浓度208 mg/L、总铬浓度260 mg/L的200 mL高浓度含铬废水最佳反应条件为:反应时间30 min,总投加量40 g,配比为1:1, pH值4.1,对应Cr(Ⅵ)去除率99.93%,总铬去除率99.72%。处理后水质满足《污水综合排放标准》(GB 8978-1996)要求。     

Polycyclic aromatic hydrocarbons in urban street dust: sources and health risk assessment

Environmental Geochemistry and Health - Urban street dust samples from 49 sampling sites in Xuzhou (China) were collected and analyzed for 16 polycyclic aromatic hydrocarbons (PAHs) using gas...     

部分水溶性偶氮染料的光催化降解研究

本研究以高压汞灯为光源,系统地研究了１６种偶氮染料在水溶液中的ＴｉＯ２光催化降解。结果表明,这些偶氮染料的光解为一级动力学反应,采用ＴｉＯ２光催化降解方法处理所研究的偶氮染料是可行的,并初步探讨了染料的结构与光解反应表观速率常数之间的关系。     

油田作业人员安全培训的信息化管理

1 问题的提出 胜利油田各培训机构多年来为油田培养了大批的专业人才。但是,目前安全教育培训仍然采用传统的面对面的教学管理方式,培训计划、培训人员、办班情况、培训内容、成绩单等信息均采用人工记录,上报安全处、劳资处等管理部门的材料还是采用传统的纸质材料,工作效率受到限制。     

快速断电安全技术中半导体中性点开关结构性能的研究

对我国目前半导体中性点开关的结构 ,工作过程 ,性能进行了分析 ;现行中性点开关所存在的问题为电路拓扑结构不合理 ,关断时间过长或过短 ,过长不满足快速断电安全技术的要求 ,过短又易引起过电压 ,使中性点开关失控。笔者提出了采用绝缘门极双极性晶体管 (IGBT) ,构成半导体中性点开关的可行方案。同时指出 ,开发新型快速断电安全技术装置 ,将大大提高我国煤矿安全技术水平