Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Phytoremediation of levonorgestrel in aquatic environment by hydrophytes

Adsorption and degradation of levonorgestrel （LNG） by two hydrophytes, Cyperus alternfolius （CA） and Eichhornia crassipes （EC）, were investigated under light-shielding conditions in the water column. Variations of LNG concentrations in water, plant root epidermis, root, stem and leaf of the plants were analyzed. The results indicated that the removal efficiency of LNG by hydrophytes over the period of 50 days was significantly greater than the blank control （p 〈 0.05）, with the removal rates of 79.80%± 3.10% and 78.86% ± 2.55% for CA and EC, respectively. Compared with bio-adsorption, bio-conversion of LNG was found to be the dominant elimination pathway, evidenced by relatively high conversion rates （77.31% ±2.68% for CA and 77.82% ± 2.95% for EC）, while the adsorption rates were lower （1.77% ± 0.90% for CA and 1.05% ± 0.40% for EC）. The bio-adsorption and conversion of LNG showed no significant differences between the two hydrophytes. Additionally, the mineralization on root epidermis played an important role in the reduction of LNG in water.     

浙江省污水污泥处理处置状况的调查

通过对丽水、宁波、衢州、诸暨等浙江省境内十几个地区的污水处理厂的调查发现:目前浙江省内的污水处理工艺中,A2/O、A/O、氧化沟三种工艺占了近50%的份额。而SBR因其方法特点正在受到越来越多的重视。在污泥处理工艺中,填埋占了最大的一部分,有近70%的污水处理厂将产生的污泥进行填埋处理。目前,污泥处理技术单一,需要继续探寻污泥的减量和资源化技术,为日益增多的污泥探寻出路。     

老化的生物质炭性质变化及对菲吸持的影响

将稻壳分别在350℃和550℃热解温度下制备成生物质炭,避光条件下恒温培养300 d,通过傅里叶变换红外光谱、扫描电镜和核磁共振等技术手段及平衡吸附实验,探究生物质炭老化前后的动态结构变化及对菲吸持作用的影响.结果表明,生物质炭老化过程中氧含量增加,含氧基团增多,对菲的非线性吸附行为显著增强.热解温度的不同决定了生物质炭老化过程中性质变化的差异,350℃热解的生物质炭,老化后极性增强,芳香性减弱,而550℃热解的生物质炭,老化后脂肪族碳类物质增加,羧基减少,芳香性增强,Langmiur预测的菲在350℃热解的生物质炭上老化前后的最大吸附量分别为3.57 mg·g-1、2.35mg·g-1,主要是老化后性质变化抑制了表面吸附作用,而550℃热解的生物质炭上老化前后的最大吸附量分别为0.42mg·g-1、4.17 mg·g-1,老化后吸附量的显著增加主要是生物质炭性质变化促进了对菲的分配作用与表面吸附作用.研究生物质炭在自然环境中的老化行为对环境污染物固定的稳定性有着重要意义.     

桑树(Morus alba)幼苗对铅污染的生理耐性和积累能力的性别差异

以桑树(Morus alba)雌雄幼苗为实验材料,研究了施铅处理对其生长发育、生理过程和铅元素积累的影响,以揭示桑树幼苗对铅污染的生理耐性和积累能力的性别差异.结果表明:施铅后桑树雌雄幼苗的可溶性蛋白(Pr)含量和超氧化物歧化酶(SOD)活性显著增加,雄株增幅略高于雌株,而丙二醛(MDA)含量和相对电导率无显著变化;雌雄幼苗的净光合速率(Pn)、气孔导度(Gs)和蒸腾速率(Tr)显著增加,雄株比雌株具有更高的Pn和Tr;雌雄幼苗的叶绿素a、叶绿素b、总叶绿素及叶绿素相对含量显著增加,雄株增幅高于雌株;雌雄幼苗的形态生长与地上部生物量显著增加,根冠比显著降低,而雄株比雌株具有更高的株高、基径和总叶片数;铅在植物体内的分布为根叶茎,雄株根、叶中的铅含量和转移系数略高于雌株.综上,灌施剂量为800 mg·kg-1的铅离子对桑树雄株幼苗生长的促进作用高于雌株,雄株比雌株具有更强的生理耐性和积累能力.     

静置/好氧/缺氧序批式反应器（SBR）脱氮除磷效果研究

以静置段代替传统厌氧段,采用后置缺氧方式,考察了静置/好氧/缺氧序批式反应器(SBR)(R1)的生物脱氮除磷(BNR)性能,并与传统厌氧/好氧/缺氧序批式反应器(SBR)(R2)进行对比.两反应器进水乙酸钠、氨氮(NH+4-N)及磷酸盐(PO3-4-P)浓度均分别为350 mg·L-1(以COD计)、40 mg·L-1及12 mg·L-1,水力停留时间(HRT)为12 h.研究结果表明,R1长期运行中磷的去除率与R2相当,分别为92.4%和92.1%,而总氮(TN)去除率则较R2高,分别为83.5%和77.0%.R1静置段省去搅拌但仍能起到厌氧段的作用,为好氧快速摄磷奠定了基础,同时R1缺氧段发生反硝化摄磷,使出水磷降至0.91 mg·L-1.好氧段内R1发生了同步硝化-反硝化(SND),贡献了18.0%的TN去除量,R2也存在SND,但脱氮贡献率较少,仅为9.8%.R1和R2后置缺氧反硝化均以糖原驱动,反硝化速率分别为0.98、0.84 mg·g-1·h-1(以每g VSS产生的N(mg)计),出水TN分别为6.62、9.21 mg·L-1.研究表明,静置段代替传统厌氧段后,可获得更好的脱氮效果,且工艺更为简化.     

东亚大气可吸入颗粒物时空分布的数值模拟研究

利用嵌套网格空气质量模式(Nested Air Quality Prediction Model System,NAQPMS)模拟研究了2010年东亚地区可吸入颗粒物(PM10)的时空演变,并初步评估了其对人群健康的危险度.结果表明,NAQPMS模式能够合理地反映东亚地区PM10的时空分布,不同季节观测值和模拟值的总体相关系数达到0.65~0.85.2010年东亚PM10的地面浓度高值区(100μg·m-3)出现在我国华北、华中和内蒙古中西部等地区.其中,无机盐(硫酸盐、硝酸盐和铵盐)对我国东部PM10的贡献最大(10~70μg·m-3,20%~50%);一次PM10次之(5~50μg·m-3,10%~30%),有机物(5~30μg·m-3,10%~20%)和黑炭(3~20μg·m-3,3%~5%)紧随其后.PM10可以引起我国东部人群急性总死亡率增加2%~5%,对我国居民的健康水平构成了一定威胁.     

舰船海水管路腐蚀状态评估技术研究

目的研究建立舰船海水管路的腐蚀状态评估指标体系及评估方法。方法通过经验选择影响舰船海水管路腐蚀状态的重要指标,并确定相应评估方法、评价标准及权重。结果选择管材腐蚀程度、阴极保护状态、电绝缘保护状态、海水流速控制状态、密封材料密封状态5项参数组成海水管路系统腐蚀状态评估指标体系。结论可选用层次-模糊法对海水管路腐蚀状态进行评估,其中层次分析法(AHP)用来确定评价指标权重,模糊综合评判法用来处理评价指标值。     

城市垃圾渗滤液污染控制技术综述

介绍了垃圾填埋场渗滤液的来源以及水质特点,结合国内外研究和应用实例,对垃圾渗滤液处理方式及处理技术进行了综述。比较了合并处理等三种垃圾渗滤液处理方式的优缺点,阐述了物化处理技术和生物处理技术在垃圾渗滤液处理中的应用。在此基础上,建议渗滤液处理应综合考虑水质水量、经济技术及环境等因素,优先考虑场内建设渗滤液处理系统,对于难处理的渗滤液可以考虑采用"预处理-生化处理-高效物化"联合工艺处理。