Concentrations and chemical compositions of PM10 during hazy and non-hazy days in Beijing

In order to study the concentrations of major components,characteristics and comparison in hazy and non-hazy days of PM_(10) in Beijing,aerosol samples were collected at urban site in Beijing from December 29,2014 to January 22,2015.Heavy metals like Zn,Pb,Mn,Cu,As,V,Cr and Cd were deeply studied considering their toxic effects on human being;nine water-soluble inorganic ions(SO_4~(2-),NO_3~-,NH_4~+,Na~+,K~+,Cl~-,Ca~(2+) and Mg~(2+)) and carbon fractions(OC and EC) were also analyzed.The concentrations of heavy metals were 1.03–1.98 times higher in hazy days than those in non-hazy days,mainly due to biomass burning and coal burning.The trends in total heavy metals concentrations were basically consistent with the trends in PM concentrations except for two obvious periods(12.29–12.30;1.14–1.15);but when air masses accumulated locally or around Beijing,trends in PM concentrations and heavy metals were opposite.The proportion for NO_3~-/SO_4~(2-) indicated that mobile sources such as automobiles were important reasons for haze in Beijing.Correlation between OC and EC during non-hazy days was strong(R~2= 0.95) but it was low(R~2= 0.67) during hazy days,and large variations for OC/EC values occurred in hazy days.The calculated mass concentration of SOC is 2.58 μg/m~3,which only accounted for 10.1% of the OC concentration.When air masses from the far north-west,they decreased PM concentration in Beijing and they were relatively clean;however,those from the near east,south-east and south of the mainland increased PM concentration and they were dirty.     

Green innovation efficiency across China’s 30 provinces: estimate,comparison, and convergence

Mitigation and Adaptation Strategies for Global Change - Considering government and market failure of environmental regulation to combat increasing GHG (greenhouse gas) emissions, green innovation...     

机载产品盐雾试验结果评定判据分析与探讨

针对当前机载产品盐雾试验标准中缺少明确、可量化评估指标,试验结果评定判据粗略笼统且以定性评价为主,已不能满足产品发展和使用环境扩展需求等现状,在总结国内外现行盐雾试验标准的结果评定要求基础上,分析当前机载产品盐雾结果评定判据存在的问题与不足,从管理和技术两个层面提出改进试验结果评定可操作性的建议,指导机载产品盐雾试验实施与评价。     

新型防腐涂层对直升机典型结构材料防护性能研究

目的研究新型防腐涂层对直升机典型结构用铝合金及复合材料在热带海洋性气候环境下的防护性能,并与原防护涂层进行对比。方法通过测试涂层腐蚀后的形貌、光泽度、色差、电化学阻抗等,对比新/原涂层对直升机典型结构用铝合金和复合材料的防护性能。结果经过2年腐蚀后,新涂层表面无明显变化,而原涂层表面有轻微腐蚀,光泽度和色差下降较大。电化学阻抗测试表明,暴露前后涂层结构无明显变化,涂层阻抗值呈现持续下降的趋势,但是原涂层阻抗下降更快。结论新涂层对直升机典型铝合金和复合材料有更好的防护性,更加适于海洋性环境的使用。     

石英灯辐射加热条件下低密度碳/酚醛复合材料高温响应及分析

目的研究低密度碳/酚醛复合材料在不同地面加热实验测试响应的差异性,指导材料在实际应用环境下的高温响应分析。方法对低密度碳/酚醛复合材料开展了热流为400 kW/m~2的单侧石英灯辐射加热实验,利用热电偶测温系统测量试件在加热过程中不同位置的温度时间历程,并对试件的烧蚀形貌和微观结构进行观测。同时与热流为464k W/m~2的氧乙炔加热陶瓷板辐射加热实验结果进行对比分析,并且采用有限元方法对材料的传热传质多场耦合计算进行分析。结果对于石英灯辐射加热,在测量点升温到接近200℃时,温度响应拐点都依次出现。由于加热的辐射热源不同,在不同的辐射波段下,多孔材料吸收和发射的热量不同,短时间内氧乙炔加热陶瓷板辐射加热使材料内部升温速率比石英灯辐射加热实验的要快,但长时间加热时现象刚好相反。结论进行传热传质多场耦合计算材料高温响应时,合理确定材料宏观性能随温度的变化至关重要。     

纤维增强气凝胶复合材料高温结构转变及热稳定性研究

目的研究高温受热条件下纳米复合隔热材料的结构转变特征及热稳定性。方法采用扫描电镜、X射线衍射仪、红外光谱仪及热重仪等检测方法。结果纤维增强气凝胶材料从室温到650℃存在连续的质量损失,从室温到放热前,质量损失为1.66%;365℃开始出现放热,温度升至398℃时达到峰值,整个放热过程对应质量损失约为1.3%;从435℃放热结束开始到650℃的质量损失为1.46%。经过400℃热处理后,试样比表面积从268m~2/g增加到437m~2/g;当试样热处理温度达到600℃时,试样的比表面积明显随之降低至198m~2/g。结论 SiO_2气凝胶复合材料以无定形结构为主,存在少量的二氧化钛晶体。在400℃左右,SiO_2气凝胶结构中硅甲基Si—CH_3发生氧化,产生明显的放热峰,之后硅羟基Si—OH之间发生缩聚反应,使600℃热处理后气凝胶中Si—O—Si网络骨架强度有所提高。未处理的纤维增强气凝胶材料试样上气凝胶纳米颗粒构成的块体较为良好地包裹在玻璃纤维表面,而经过600℃的高温热处理1 h后,块体气凝胶脱离了光滑的纤维表面,气凝胶纳米粒子发生收缩,致使材料比表面积下降。     

油气田在役管道高后果区识别与完整性评价方法

根据油气管道建设与管理的相关标准与规范或导则,针对目前油气田在役管道,明确了其高后果区识别的划分及其在不同标准中的差异以及识别的原则和时间间隔,分别介绍了在管道的相关数据采集的基础上开展地质灾害和第三方破坏造成的管道风险评价方法,管道内外腐蚀的直接评价以及包括剩余强度、剩余寿命和材料在内的管道适用性评价方法,同时给出了这些评价工作所涉及到的相关内容项,对油田管道的完整性管理具有重要的指导作用和应用价值。