A novel approach to rapid detection of acute water toxicity and its policy implications for grassroots sustainable environmental monitoring

Unknown chemicals, emerging contaminants, and the resulting reactions among them make early detection and warning of acute water toxicity extremely challenging. The conventional approach using small fish for toxicity monitoring normally requires a designated species of fish and over a week's time to complete, including dilution of the wastewater, a pre-test, and a full test. It often increases chances for error and delays emergency management. This paper reports a novel approach, based on grassroots knowledge and field and lab experience in Jilin, China. This approach uses a combination of different species of aquarium fish to achieve fast and reliable monitoring. It tests the original source water directly without going through the dilution procedure, while paying attention to the time factor. The approach does not require a pre-test and may shorten the time needed for detecting acute toxicity to a few minutes, using a new classification of aquatic toxicity levels. It is inexpensive to use and may be easily adopted by grassroots organizations. The approach is "greener" and more financially and socially sustainable than traditional approaches. The wide use of the approach has the potential to encourage policy innovations for making toxicity monitoring grassroots based and more effective in reducing acute contamination emergencies.     

M3法测定土壤有效态Cd、Cr、Pb和Ni

通过M3法对耕地土壤重金属的联合测定,为土壤重金属污染监测应用提供快速联合测定的方法。用M3法测定北方耕地土壤的有效Cd、Cr、Pb和Ni,通过对M3法与其他方法进行有效重金属测定值差异性及其相关性比较,与全量的浸出率分析等探讨M3法对耕地土壤有效重金属测定的特征。结果表明,M3法在《土壤环境质量标准》(GB 15618—1995)的土壤重金属含量范围内可以测定土壤有效态重金属Cd、Cr、Pb和Ni,且呈线性极显著相关。M3法与其他方法有效Cd、Cr、Pb和Ni有较好的相关性,与DTPA法呈极显著相关;与NaNO₃法除有效Pb外,呈极显著和显著相关;与HCl法除褐土和潮土的有效Pb外,也呈极显著和显著相关。M3法的有效态Cd、Cr、Pb和Ni的测定值均为最大。M3法对4种耕地土壤有效Cd、Cr、Pb和Ni的浸出率,因土壤类型不同,有效重金属含量所占比率不同,但利用M3法测定的有效态Cd、Cr、Pb和Ni的浸出率最大。     

Characteristic, composition, and sources of TSP investigated by HRTEM/EDS and ESEM/EDS

Total suspended particle (TSP) collected at the fifth floor of House Dust in Hunan University, China, was analyzed in terms of microscopic morphology and chemical composition. The fine particles (50?nm-2?μm) in the TSP were analyzed by a high-resolution transmission electron microscope equipped with an energy-dispersive X-ray analyzer (HRTEM/EDS). Results showed that the particles were in shapes of plate, irregular and agglomerate. Based on EDS results, these fine particulate matter was primarily composed of Fe-rich (35.82-61.29%), Ca-rich (30.18-36.77%) and Si-rich (18.95-32.28%) particles. Other elements mainly including Mg (0.47-4.97%), Al (0.45-14.57%), S (0.45-4.73%), K (1.13-2.13%) and Zn (0.67-3.85%) were also observed. The sources analysis indicated that the HRTEM particles mainly originated from coal combustion, traffic emission, vehicles exhaust emission and fugitive soil or cement particulate matter. The coarse particles (4-50?μm) were detected by environmental scanning electron microscopy coupled with energy-dispersive X-ray detector (ESEM/EDS). Based on a simple algorithm, ESEM particles were categorized into five groups: C-bearing (46.15%, 67% and 86.98%), Si + Ca-bearing (21.48?+?11.80%, 16.51?+?10.81% and 16.32?+?10.62%), Si + Al-bearing (20.06?+?12.40%, 20.16?+?11.22% and 15.31?+?11.25%), Si-bearing (34.40%, 26.92% and 27.15%) particles and aggregates, most of which exhibit obvious crystalline structure, and these ESEM particles mainly derived from vehicles exhaust emission, coal combustion, soil, and biomass burning, while the aggregates are indicative of atmospheric reaction progress. HRTEM/EDS and ESEM/EDS are mutual complementary in analyzing the characteristic and determining the sources of TSP.     

Real-time discharge measurement in tidal streams by an index velocity

Discharge measurement in a tidal stream is always a difficult task. Owing to the complex flow conditions, discharge measurement in tidal streams has to be finished quickly, and must be highly efficient in order to yield an accurate measurement of real-time discharge. Measuring the discharge of tidal streams is done in three steps: (1) establishing the stage and cross-sectional area relation, (2) estimating the index velocity by using a velocity distribution equation based on the probability concept, (3) establishing the relationship between the index and mean velocities. Then the cross-sectional area and mean velocity can be estimated by the gage height and index velocity, respectively. The discharge of tidal streams is computed as the product of the cross-sectional area and mean velocity. The velocity distribution of the Taipei Bridge and Guan-du Bridge in the Tanshui River were established and analyzed to demonstrate the use of discharge measurement by index velocity for estimating the discharge of this tidal stream. The results reveal no large difference between the discharges measured by the conventional methods and the index velocity. This pilot study proposed a cost-effectiveness and efficient method. It is an easy, quick, and accurate model for measuring the real-time discharge of a tidal stream. It makes automatic, real-time, and continuous monitoring of the discharge in a tidal stream become possible.     

Estimation of phosphorus flux in rivers during flooding

Reservoirs in Taiwan are inundated with nutrients that result in algal growth, and thus also reservoir eutrophication. Controlling the phosphorus load has always been the most crucial issue for maintaining reservoir water quality. Numerous agricultural activities, especially the production of tea in riparian areas, are conducted in watersheds in Taiwan. Nutrients from such activities, including phosphorus, are typically flushed into rivers during flooding, when over 90 % of the yearly total amount of phosphorous enters reservoirs. Excessive or enhanced soil erosion from rainstorms can dramatically increase the river sediment load and the amount of particulate phosphorus flushed into rivers. When flow rates are high, particulate phosphorus is the dominant form of phosphorus, but sediment and discharge measurements are difficult during flooding, which makes estimating phosphorus flux in rivers difficult. This study determines total amounts of phosphorus transport by measuring flood discharge and phosphorous levels during flooding. Changes in particulate phosphorus, dissolved phosphorus, and their adsorption behavior during a 24-h period are analyzed owing to the fact that the time for particulate phosphorus adsorption and desorption approaching equilibrium is about 16 h. Erosion of the reservoir watershed was caused by adsorption and desorption of suspended solids in the river, a process which can be summarily described using the Lagmuir isotherm. A method for estimating the phosphorus flux in the Daiyujay Creek during Typhoon Bilis in 2006 is presented in this study. Both sediment and phosphorus are affected by the drastic discharge during flooding. Water quality data were collected during two flood events, flood in June 9, 2006 and Typhoon Bilis, to show the concentrations of suspended solids and total phosphorus during floods are much higher than normal stages. Therefore, the drastic changes of total phosphorus, particulate phosphorus, and dissolved phosphorus in rivers during flooding should be monitored to evaluate the loading of phosphorus more precisely. The results show that monitoring and controlling phosphorus transport during flooding can help prevent the eutrophication of a reservoir.     

Factor analysis of H2S emission at a wastewater lift station: a case study

Odor and corrosion are common problems in domestic wastewater collection, transportation, pumping, and treatment processes. Based on the comparison among odorous compounds and onsite observations at a wastewater lift station, H₂S is more likely to have caused the odor and corrosion problems than methanethiol and other organic sulfides. The field data from both air and wastewater quality monitoring demonstrated that more H₂S (1 ppmv) was formed at a more negative redox potential, lower pH, and a higher temperature of wastewater. Since the lower detection level of most current analytical techniques is much greater than human’s smell and the reference concentration for adverse health effects, automatic monitoring on the threshold of H₂S formation provides a mechanism to trigger control techniques only when necessary for cost saving purposes. Based on Gibbs free energy, a more negative redox potential is required to form H₂S with an increase in pH and a decrease in temperature and SO ₄ ^2? concentration. However, pH effect is more significant than both temperature and SO ₄ ^2? concentration for H₂S formation. It is recommended that H₂S control techniques be started when the redox potential is below ?44 mV, the pH is lower than 5.6, and the temperature is higher than 11.5 °C to control H₂S below the reference concentration. Corroded concrete particles were examined by X-ray diffraction, which showed that the dominant crystal form was quartz.     

Land use change and landslide characteristics analysis for community-based disaster mitigation

On August 8, 2009, Typhoon Morakot brought heavy rain to Taiwan, causing numerous landslides and debris flows in the Taihe village area of Meishan Township, Chiayi County, in south-central Taiwan. In the Taihe land is primary used for agriculture and land use management may be a factor in the area’s landslides. This study explores Typhoon Morakot-induced landslides and land use changes between 1999 and 2009 using GIS with the aid of field investigation. Spot 5 satellite images with a resolution of 2.5 m are used for landslide interpretation and manually digitalized in GIS. A statistical analysis for landslide frequency–area distribution was used to identify the landslide characteristics associated with different types of land use. There were 243 landslides with a total area of 2.75 km² in the study area. The area is located in intrinsically fragile combinations of sandstone and shale. Typhoon Morakot-induced landslides show a power–law distribution in the study area. Landslides were mainly located in steep slope areas containing natural forest and in areas planted with bamboo, tea, and betel nut. Land covered with natural forest shows the highest landslide ratio, followed by bamboo, betel nut, and tea. Landslides thus show a higher ratio in areas planted with shallow root vegetation such as bamboo, betel nut, and tea. Furthermore, the degree of basin development is proportional to the landslide ratio. The results show that a change in vegetation cover results in a modified landslide area and frequency and changed land use areas have higher landslide ratios than non-changed. Land use management and community-based disaster prevention are needed in mountainous areas of Taiwan for hazard mitigation.     

Molecular detection and comparison of Acanthamoeba genotypes in different functions of watersheds in Taiwan

The protistan genus Acanthamoeba is a free-living amoeba existing in various environments. Within this protistan genus, there are some species recognized as potential human pathogens, which may cause granulomatous amoebic encephalitis, Acanthamoeba keratitis and chronic granulomatous lesions of the skin. In this study, 211 water samples were collected from two watersheds in southern Taiwan. We detected Acanthamoeba based on the PCR amplification with a genus-specific primer pair and investigation of Acanthamoeba in Puzih River and Kaoping River in southern Taiwan. Acanthamoeba species were detected in 34 (16.1%) samples. The presence or absence of Acanthamoeba within the water samples showed significant difference with the levels of water temperature and total coliforms. The most frequently identified Acanthamoeba genotype was T4 (n = 19), followed by T5 (n = 8), and then T15 (n = 3). Genotype T6, T7/T8, T11 and T12 were all detected once. Genotype T4, T5, T6, T11 and T15 of Acanthamoeba are responsible for Acanthamoeba keratitis and should be considered a potential health threat associated with human activities in environmental surface water watersheds.     

泰州市冬季空气质量变化特征

为了解泰州市冬季空气质量变化特征,于2013年12月27日—2014年1月7日对NO2,SO2,O3,CO,PM10和PM2.5进行了监测,结合地面气象资料和HYSPLIT轨迹模式分析了污染物的来源与传输过程。结果表明,观测期间AQI优良率仅为25%,PM10和PM2.5日均值超标率分别为58.3%,75.0%;有机碳是泰州市ρ(PM2.5)中最高的化学组分,其次是富钾和元素碳。PM2.5主要来源为汽车尾气、工业源、燃煤,分别占来源比例21.76%,16.52%,15.54%。局地污染源和不利气象条件是造成大气污染的主要原因。