采用支持向量机算法优化电化学处理油田污水的工艺参数

采用支持向量机(SVM)算法,将Box-Behnken设计法与支持向量回归算法(SVR)实验参数优化软件相结合,优化电化学去除油田污水COD的工艺参数。通过量子粒子群算法对SVM算法参数进行优化,从建立的回归模型中找到工艺参数的全局最佳点:电解时间60 min,电解电流3 A,三维电极填充料中石英砂质量695 g。模型得到的COD理论最优去除率为92.48%,验证实验得到的COD去除率为91.43%。     

海上含聚污水电化学处理装置的优化

为解决传统电化学方法在含聚污水处理时电极板消耗严重、絮渣量大的问题,通过改进电极板材料、组合数及结构等,研究适度降解-除油一体化电化学技术,在降低渣泥量的同时保证处理效果。实验结果表明:最佳电极板组合为"网状惰性金属复合物极板(阳)-网状铝极板(阴)-网状铝极板(阴)-网状惰性金属复合物极板(阳)";在电解电流为4.0 A、极板间距为8.0 cm、面体比(电极板面积与处理污水量的比值)为2/17 cm~2/mL、电解时间为30 min的最佳处理条件下,几乎无絮渣产出,含聚污水的浊度去除率为93.3%、聚合物降解率为92.0%、除油率为95.0%,展现了优良的处理效果。     

Hydrothermal liquefaction phase behavior of microalgae & model compounds in fused silica capillary reactor

A fused silica capillary reactor combined with a heating/cooling stage, a microscope and a digital camera were used to investigate phase behavior during the hydrothermal liquefaction of microalgae (Dunaliella tertiolecta) and model compounds, including soya protein and glycine, starch, glucose and xylose, stearic acid and palmitic acid. Bubbles were generated at 246°C and disappeared at 360°C upon heating when Dunaliella tertiolecta used as feedstocks. Moreover, liquid products were generated at 300°C upon heating and oily liquid products began to separate out at 250°C upon cooling. The phase behavior of soya protein was similar to that of the Dunaliella tertiolecta. Meanwhile, there only observed the bubbles generation during hydrothermal liquefaction of glycine. Heating the starch, glucose and xylose above 350°C generated black solids from carbonization. Stearic acid and palmitic acid only had the process of melting, dissolution, dispersion and precipitation.     

Triboelectrostatic separation for PP and ABS plastics in end of life passenger vehicles

Journal of Material Cycles and Waste Management - The recovery and utilization of automotive plastics are global concerns because of the increasing number of end-of-life vehicles. Passenger...     

表面活性剂对多壁碳纳米管吸附Pb~(2+)的影响

多壁碳纳米管(MWNT)在吸附有毒气体和重金属离子方面具有极高的应用价值.针对MWNT对水溶液中Pb2+的净化吸附进行了研究,从吸附量,吸附速率、动力学角度考察了表面活性剂、Pb2+浓度对MWNT吸附Pb2+的影响.结果表明,司班-60、吐温-20、阿拉伯树胶等表面活性剂的加入,促进了MWNT在溶液中的分散,导致在Pb2+摩尔浓度为3～18 mmol/L的Lang-muir和Freundlich等温吸附方程中的吸附常数(K)变大,使得MWNT对Pb2+的吸附速率和平衡吸附量都得到提高;随着溶液中Pb2+浓度的增大,MWNT对其吸附量渐至饱和,随后由于Pb2+的位阻作用.吸附量下降;在这3种表面活性剂中,由于司班-60具有相对较小的分子量,其分散的MWNT在Pb2+摩尔浓度为14 mmol/L时,吸附量最大,为230 mg/g.     

GC/MS法测定润滑油基础油中多环芳烃

对润滑油基础油中多环芳烃的气相色谱/质谱(GC/MS)测定方法进行了研究,探讨了样品的提取,固相萃取柱净化等前处理方法,同时也对仪器测定条件进行了优化.结果表明,在检测润滑油基础油中多环芳烃时,经优化的GC/MS法的加标回收率和精密度均达到较满意的水平.     

Continuous measurement of peroxyacetyl nitrate (PAN) in suburban and remote areas of western China

Knowledge on atmospheric abundance of peroxyacetyl nitrate (PAN) is important in assessing the severity of photochemical pollution, and for understanding chemical transformation of reactive odd nitrogen and its impact on the budget of tropospheric ozone (O₃). In summer 2006, continuous measurements of PAN were made using an automatic GC–ECD analyzer with an on-line calibrator at a suburban site of Lanzhou (LZ) and a remote site of Mt. Waliguan (WLG) in western China, with concurrent measurements of O₃, total reactive nitrogen (NO_y) and carbon monoxide (CO). At LZ, several photochemical episodes were observed during the study, and the average mixing ratio of PAN (plus or minus standard deviation) was 0.76 (±0.89) ppbv with the maximum value of 9.13 ppbv, compared to an average value of 0.44 (±0.16) ppbv at remote WLG. The PAN mixing ratios in LZ exhibited strong diurnal variations with a maximum at noon, while enhanced concentrations of PAN were observed in the evening and a minimum in the afternoon at WLG. The daily O₃ and PAN concentration maxima showed a strong correlation (r² = 0.91) in LZ, with a regression slope (PAN/O₃) of 0.091 ppbv ppbv^?1. At WLG, six well-identified pollution plumes (lasting 2–8 h) were observed with elevated concentrations of PAN (and other trace gases), and analysis of backward particle release simulation shows that the high-PAN events at WLG were mostly associated with the transport of air masses that had passed over LZ.     

Polychlorinated biphenyls and organochlorine pesticides in various bird species from northern China

Little data are available on organochlorine contamination in Chinese terrestrial birds of prey. This study examined the presence of PCBs, DDTs and other organochlorine pesticides in various raptors from northern China. DDE exhibited the highest concentrations among targeted compounds. Greatest levels (23.5-1020 mg/kg lipid weight) were observed in Eurasian sparrowhawks. This may be due to their stopover in southeastern China, where high DDT and dicofol applications have been documented. Residential kestrels exhibited much lower DDE, but similar PCB and HCH concentrations. ΣTEQs and PCB-126/-77 concentration ratios exhibited significant positive correlations with ΣPCB concentrations, respectively. Similar results were also demonstrated by a meta-analysis of previously published data across avian species. Possible hepatic sequestration of coplanar PCB-77, -126, -169 and -118 was observed as liver TEQs increased in Eurasian sparrowhawks. These observations may indicate an induction of CYP1A enzymes, as a result of elevated contamination in some species.     

双水相气浮浮选光度法处理环境水样中痕量土霉素残留物

建立了一种新型分离方法--双水相气浮浮选光度法,使其处理环境水样中痕量土霉紊(OTC)残留物,研究了其工作原理,并用高效液相色谱法对该方法的可靠性进行了验证.利用自制的双水相气浮浮选装置,选择四氢呋喃作亲水有机溶剂、质量分数为10%的NaCl溶液作分相剂,NaOH溶液调节pH,将Cu2+与OTC形成的疏水配合物浮选至有机相,实现OTC与水样分离.浮选完毕后,经紫外-可见分光光度法分析,线性回归方程为A=1.532×105c+0.1230(其中:A为有机相的吸光度;c为水样的OTC摩尔浓度,mol/L),相关系数为0.9998,该方法的线性范围为4.8×10-7～7.3×10-5 mol/L,OTC加标回收率为99.5%～100.1%.     

Single particle mass spectrometry of oxalic acid in ambient aerosols in Shanghai: Mixing state and formation mechanism

Oxalic acid in individual aerosol particles was measured using single particle aerosol time-of-flight mass spectrometry (ATOFMS) in the summer of 2007 in Shanghai, China. Oxalate was found in 3.4% of total particles with diameters in the range of 0.2 – 2.0 μm. Size, chemical composition and hourly temporal counts of single particles that contained oxalic acid were measured. The predominant types of oxalate-containing particles were characterized to distinguish the primary and secondary sources of oxalic acid. Biomass burning was revealed as a major primary source of oxalic acid which contributed more than 20% of the oxalate-containing particles. Evidences for two different formation pathways of oxalic acid were observed in our experiment. The number fraction of oxalate-containing particles correlated with that of sulfate particles and the changes of air parcel backward trajectories, suggesting that in-cloud processing played important roles in oxalic acid formation. The diurnal patterns of dust and sea salt particle counts fitted well with the ambient relative humidity variation, suggesting that heterogeneous reactions occurring in hydrated/deliquesced aerosols also contributed to the production of oxalic acid.