有害物质环境测试组合舱的研制及性能评价

研制了一种新型有害物质环境测试组合舱,该测试舱由舱体系（内舱和外舱）、恒温恒湿空气处理系统、空气循环装置和信号控制与处理软件组成。该测试舱具有可分别使用内舱和外舱对样品进行测试的特点,并采用美国FLUNT公司开发的air pack软件包对内舱和外舱的气流进行模拟与计算,并划分出内舱的层流区域,同时也对舱体系的性能进行了测试与评价。结果表明,有害物质环境测试组合舱的温湿度的相对标准偏差分别为0.04℃和0.7%,混合性达到90.7%。因此,该有害物质环境测试组合舱对温湿度控制精准,气流稳定,混合性能良好,能为室内空气污染研究提供条件稳定的室内仿真环境。     

电解-水生植物-软隔离带复合技术治理重污染河流的中试研究

为了探索重污染河流的治理技术,2011年3月在无锡市新区鸿山镇徐塘桥河开展生态治理示范工程,通过电解技术、种植高等水生植物和构建软隔离带复合工程技术改善河流水质。实验结果表明,通过电解技术,可以迅速降低TP、氨氮（NH4＋-N）和COD;但较难减少TN。通过软隔离带可以有效隔离外源污染,在较短时间内改善河流TN、TP、COD的平均水平,但是难以提高河流的生态系统稳定性。电解能够有效的降解大分子有机物,为水生植物提供良好的生长环境,之后再种植水生植物,能够进一步降低的TN、TP。通过电解一水生植物一软隔离带复合技术不仅能够全面改善河流水质的平均水平,而且能够修复水生生态系统,提高生态系统稳定性。     

四环素高效降解酵母菌Trichosporon mycotoxinivorans XPY-10降解特性

Trichosporon mycotoxinivorans XPY-10是一株分离自抗生素制药厂的高效四环素降解酵母菌。为了建立该菌株降解四环素的适宜条件,分别研究了碳源、有机氮源、金属离子等营养物质及初始底物浓度、接种量、pH、温度、装液量、摇床转速等理化因素对菌体生长及四环素降解效率的影响。结果表明,菌株XPY-10生长的最适碳源和氮源分别为蔗糖和蛋白胨。在含有0．05％FeSO4的培养基中,菌株XPY—10降解四环素的适宜条件为：接种量2％,pH8,温度3422,装液量100mL（250mL三角瓶）,摇床转速180r／min。在此条件下,菌株XPY—10在7d内对初始浓度为600mg／L的四环素降解率为83．63％。本菌株对养殖废水及制药废水中四环素的污染治理有一定的应用前景。     

脱硫石膏粒径分布与脱水性能实验研究

脱硫石膏粒径分布是影响脱硫石膏浆液脱水性能的重要因素之一,以干法、湿法筛分和研磨破碎获得不同粒径分布的脱硫石膏,在相同的过滤条件下,对不同粒径分布脱硫石膏浆液脱水性能进行了研究,实验结果表明,当脱硫石膏粒径d50大于50μm且（d90-d10）小于100μm,真空过滤最大真空度不低于0．098MPa,过滤时间不少于2．5min,滤饼厚度不超过20mm时,石膏滤饼含水率可以降低到12％以下（最低可达10％）;d50在17μm为脱硫石膏在相同的过滤条件下能够实现真空脱水干燥的转折点;d50和（d90-d10）共同影响石膏脱水性能,d50小于20μm时,仅表现为d50的影响。     

Effects of pig manure compost and nonionic-surfactant Tween 80 on phenanthrene and pyrene removal from soil vegetated with Agropyron elongatum

This paper evaluates the effects of pig manure compost (PMC) and Tween 80 on the removal of phenanthrene (PHE) and pyrene (PYR) from soil cultivated with Agropyron elongatum. Soils spiked with about 300mgkg(-1) of PHE and PYR were individually amended with 0%, 2.5%, 5% and 7.5% (dry wt) of PMC or 0, 20 and 100mgkg(-1) of Tween 80. Unplanted and sterile microcosms were prepared as the controls. PAH concentration, total organic matter (TOM), dissolved organic carbon (DOC), total heterotrophic and PAH degrading microbial populations in soil were quantified before and after 60d period. The results indicated that A. elongatum could significantly enhance PYR removal (from 46% to 61%) but had less impact on PHE removal (from 96% to 97%). Plant uptake of the PAHs was insignificant. Biodegradation was the key mechanism of PAH removals (<3% losses in the sterile control). Increase in PMC or Tween 80 levels increased the removal of PYR but not of PHE. Maximal PYR removal of 79% and 92% were observed in vegetated soil receiving 100mgkg(-1) Tween 80 and 7.5% PMC, respectively. Enhanced PYR removal in soil receiving PMC could be explained by the elevated levels of DOC, TOM and microbial populations as suggested by Pearson correlation test. While the positive effect of Tween 80 on PYR removal could probably due to its capacities to enhance PYR bioavailability in soil. This paper suggests that the addition of either PMC or nonionic-surfactant Tween 80 could facilitate phytoremediation of PAH contaminated soil.     

炭催化剂吸附剂标准物质的研制

本文介绍了炭催化剂吸附剂标准物质的研制过程。对标准物质的制备技术、均匀性检验、稳定性考察及定值和不确定度进行了逐项分析。采用活性炭浸渍、煅烧技术制得炭催化剂吸附剂标准物质。试验结果表明,该标准物质定值结果准确,均匀性、稳定性良好。铜含量的标准值为11．06％,扩展不确定度为0．13％。     

一种湿度计的校准方法——测量不确定度分析校准法

本文提出了校准湿度计的一种新方法一测量不确定度分析校准法,以利用5121湿度发生器校准可输出（0-5）V的湿度传感器的基本误差为例,介绍了其校准方法确定了该方法校准湿度计的置信度和准确葭：     

湿度传感器在防护性能检测中动态湿度的测量方法

1引言 防护装备在核、生、化环境下起着防放射性灰尘、防生物细菌和防化学毒剂的作用。防护装备的防护性能检测准确与否。直接影响着防护装备产品的质量乃至使用者的生命安全。防护装备的防护性能受湿度的影响很大,以前,在防护装备的防护性能检测过程中是利用干、湿球温度计来检测测试管路中的湿度。     

Thermogravimetric analysis and kinetic study on pyrolysis of representative medical waste composition

To obtain detailed information on the pyrolysis characteristics, a thermogravimetric study on the pyrolysis of 14 typical medical waste compositions was carried out in thermogravimetric analysis (TGA) equipment using dynamic techniques in a stream of N(2). An index representing pyrolysis reactivity of waste was presented. Kinetic parameters were obtained by Coats-Redfern method and used to model the TG curve. The results showed that: (a) Plastic, protein, cellulosic material, synthetic fibre, and rubber entered pyrolysis process in succession. (b) There was one decomposition stage in the pyrolysis of one-off medical glove, operating glove, cellulosic waste, absorbable catgut suture and adhesive plaster, while other components had two obvious weight loss stages. (c) The obtained apparent activation energy for second stage pyrolysis was comparably higher than that for first stage. (d) Each stage was controlled by only one kinetic mechanism, in which kinetic parameters were constant. (e) The degradation kinetics of medical waste may be affected by special physical and chemical treatment in the product manufacturing process. (f) Among 13 waste samples, the pyrolysis index of cellulosic matter was the highest, which indicated cellulosic matter had strong pyrolysis reactivity. (g) With increasing heating rate, TG curve and DTG peak shifted to high temperatures and main reaction interval of the sample became longer.     

Application of MSWI fly ash on acid soil and its effect on the environment

This study evaluated the feasibility of using municipal solid waste incinerator (MSWI) fly ash as acid soil amendment. In particular, changes in soil physicochemical properties and the potential environmental problems caused by the application of MSWI fly ash were investigated. The results showed that application of MSWI fly ash to the acid soil could raise the soil pH. The contents of rapidly available P and K, and slowly available K in the amended soil had a linear relationship with the addition ratio of MSWI fly ash. An addition of less than 20% of MSWI could raise the soil respiratory intensity after incubation for 3-5 days. Application of MSWI fly ash to the soil increased its content of water soluble salts and heavy metals, which could cause phytotoxicity in the plants. Therefore, the addition of MSWI fly ash to the soil should not be excessive, and less than 5-10% is an advisable addition level depending on the acidity of the soil and the plants growing on it.