二氧化铅电极的制备、表征及其电催化性能研究

以电沉积法制备了Ti/PbO2和Ti/MnO2/PbO22种电极.采用SEM、XRD和XPS等分析方法表征了电极的形貌、元素组成及元素化学态,并以罗丹明B为目标有机物,考察了所制备电极的析氧极化曲线和电催化活性以及Ti/MnO2/PbO2电极的循环伏安曲线.研究结果表明,Ti/MnO2/PbO2电极的稳定性、使用寿命、析氧电位和电催化活性较Ti/PbO2电极都有所提高,并且罗丹明B在Ti/MnO2/PbO2电极上的反应主要发生在析氧反应区,且反应不可逆.     

Influences of metals on kinetics of methyl tert-butyl ether biodegradation by Ochrobactrum cytisi

The influence of zinc, manganese, and nickel on the degradation of MTBE (methyl tert-butyl ether), by an aerobic MTBE-degrading strain, Ochrobactrum cytisi, were investigated. The result showed that unlike previous findings, O. cytisi was able to degrade MTBE through direct metabolism when MTBE was present as the only carbon source. The degradation rate of MTBE was rapid, completed within 80 h. MTBE biodegradation by this strain was stimulated at low concentrations of Zn(2+) (1-5 mg l(-1)) and Mn(2+) (1-5 mg l(-1)) but inhibited at high concentrations of Zn(2+) (20 mg l(-1)) and Mn(2+) (20 mg l(-1)), and at low concentration of Ni(2+) (1-4 mg l(-1)). Kinetic parameters for MTBE degradation in the presence or absence of metals were obtained through nonlinear regression and a least-square minimization procedure. In all cases, a good agreement was achieved between kinetic simulations and experimental results.     

膜生物反应器生物降解与膜分离共作用特性研究

膜生物反应器实质是生物降解与膜分离相互影响,共同作用的过程,污泥浓度与通量之间存在一定的相关关系,膜分离对生和性能尤其是细菌活性有着重要的影响,而生物反应器内细菌胞外聚合物,溶解性有机物及微细胶体可能成为形成凝胶层导致通量下降的主要因素。     

不同浓度养殖废水对青萍生长能力的影响

为了探讨废水浓度对青萍(Lemna minor)净化能力、生物质和能量积累能力的影响,以猪场养殖废水为供试废水,分析了在不同废水浓度下青萍对废水中总氮(TN)、氨氮和总磷(TP)的净化能力,青萍的生长情况,以及青萍中碳(C)、氮(N)、磷(P)元素含量和热值的变化情况。研究表明,青萍在1%浓度的废水中表现出最高的污染物净化能力。虽然青萍的C、N、P含量和热值均随废水浓度的增加而增加,但是由于相对增长率以1%的废水中生长的青萍最高,青萍的最高生产力、C和能量的固定能力均出现在1%废水浓度培养的青萍中,其次是5%废水浓度培养的青萍。多项式回归分析表明,可以使青萍获得最大C和能量固定能力的废水浓度为3.4%,对应的氨氮浓度为26 mg/L,TP浓度为3.4 mg/L。研究结果为进一步优化高生物质生产、高污染物去除率的养殖废水-浮萍培养体系提供了一定的基础。     

SBR降解动力学研究

采用SBR工艺处理有机废水,在已有工艺条件下对生物降解动力学进行了研究,得出生物降解反应为一级反应。研究表明,用Monod公式能较好反映出有机物的降解规律,确定了其动力学参数V_max=14.6306 d^-1,K_s=83.2993 mg/L,得出SBR降解动力学模型为V=14.6306X·S/(83.2993+S)。利用以动力学为基础的动态模拟法优化SBR工艺,实验结果表明该方法合理可行,对SBR的设计与运行有一定的指导作用,可作为SBR反应器扩大实验和设计的依据。     

负载壳聚糖膨润土的制备及其吸附性能的影响

以天然膨润土和壳聚糖为原料,制得一种新型水处理剂——负载壳聚糖膨润土,研究了制备条件对酸性大红印染废水处理效果的影响。实验表明,当壳聚糖的浓度为30 g/L、膨润土质量与壳聚糖溶液体积之比为0.7、浸泡时间80 min、微烘时间15 min时,壳聚糖改性膨润土对酸性大红印染废水的脱色率可达97%。对改性土进行比表面积测定、电镜扫描及X-射线衍射等结构特性分析,证明壳聚糖的引入改变了膨润土在水中的分散状态,增强了其对污染物的吸附和离子交换能力。     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

Assessing heavy metal pollution in the surface soils of a region that had undergone three decades of intense industrialization and urbanization

Heavy metals in the surface soils from lands of six different use types in one of the world’s most densely populated regions, which is also a major global manufacturing base, were analyzed to assess the impact of urbanization and industrialization on soil pollution. A total of 227 surface soil samples were collected and analyzed for major heavy metals (As, Cd, Co, Cr, Cu, Fe, Hg, Mn, Ni, Pb, and Zn) by using microwave-assisted acid digestion and inductively coupled plasma–mass spectrometry (ICP-MS). Multivariate analysis combined with enrichment factors showed that surface soils from the region (>7.2?×?10⁴ km²) had mean Cd, Cu, Zn, and As concentrations that were over two times higher than the background values, with Cd, Cu, and Zn clearly contributed by anthropogenic sources. Soil pollution by Pb was more widespread than the other heavy metals, which was contributed mostly by anthropogenic sources. The results also indicate that Mn, Co, Fe, Cr, and Ni in the surface soils were primarily derived from lithogenic sources, while Hg and As contents in the surface soils were controlled by both natural and anthropogenic sources. The pollution level and potential ecological risk of the surface soils both decreased in the order of: urban areas?>?waste disposal/treatment sites?～?industrial areas?>?agricultural lands?～?forest lands?>?water source protection areas. These results indicate the significant need for the development of pollution prevention and reduction strategies to reduce heavy metal pollution for regions undergoing fast industrialization and urbanization.     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

上海市机动车尾气VOCs组成及其化学反应活性

采用钢罐采样-气相色谱/质谱法,采集并分析了上海市主要交通干道和隧道废气样品中挥发性有机物(VOCs)的污染水平。分析结果表明,交通干道和隧道废气样品的总挥发性有机污染物(TVOC)质量浓度分别为(227.1±40.9)、(2209.9±1228.0)μg/m3;隧道废气样品中的TVOC浓度是交通干道平均浓度的4.3～15.2倍;交通干道废气样品中VOCs主要组分与隧道废气样品中VOCs主要组分非常类似,说明交通干道废气样品中VOCs主要来源于机动车尾气排放。交通干道废气样品中TVOC的.OH消耗速率为(17.21±4.49)s-1,延安东路隧道和打浦路隧道废气样品中TVOC的.OH消耗速率分别为(300.37±120.78)、(138.09±25.30)s-1,烯烃对TVOC的.OH消耗速率贡献最大,其对废气化学反应活性贡献率在70%以上。交通干道和隧道废气样品中关键活性组分是C2～C5的烯烃组分,这些组分也是机动车尾气中的特征污染物,因此可以判断机动车尾气是上海市大气化学反应活性的最大贡献者。