微波催化氧化法处理垃圾渗滤液的正交试验

在微波辐射条件下,采用活性炭与Fenton试剂处理垃圾渗滤液,并通过正交试验考察了微波辐射时间、pH、活性炭用量、硫酸亚铁用量和H2O2用量对处理效果的影响.结果表明:pH对处理效果的影响最大,其次为活性炭用量、微波辐射时间、硫酸亚铁用量和H2O2用量;在100 mL水样中,最佳处理条件为活性炭2 g、H2O20.2 mL、硫酸亚铁0.834 g、pH 6、微波辐射时间10 min,垃圾渗滤液中的COD去除率达到75.36%.     

基于实时交通信息的道路机动车动态排放清单模拟研究

以上海市为例开展了实际道路车流分布、行驶工况和车辆技术的实地调查,建立了道路车流、VSP分布和车辆技术数据库.在此基础上,基于实时的车流、车速等交通信息,构建了动态化的道路机动车污染物排放清单模拟方法,并开展了城区典型道路的机动车小时排放模拟案例研究.调查结果表明,上海市城区道路车流以轻型客车和出租车为主,分别占各时段车流总量的48%～72%和15%～43%;VSP分布与平均车速存在较好的规律,各车型VSP峰值随平均车速的上升向高负荷去移动,且峰值逐渐降低;当前上海市车辆以国2和国3车型为主,经过年检站调查结果的校正,国2和国3车型分别占各车型的11%～70%和17%～51%.模拟案例结果显示,道路机动车CO、VOC、NOx和PM日排放峰谷比可达3.7、4.6、9.6和19.8左右,CO和VOC排放主要来自轻型客车和出租车,与车流变化的相关性较好,而NOx和PM排放主要来自重型客车和公交车,且主要集中在早晚高峰时段.采用建立的动态排放模拟方法可实时反映实际道路的机动车排放变化,获取高排放路段和时段,为交通环境管理提供重要的技术手段和决策依据.     

国家自主贡献机制下的减排力度调控机制设计

现有国家自主贡献机制存在约束力弱、减排力度小的问题,对此,本文在论证该机制内在缺陷的基础上,基于信息不对称理论的委托代理模型设计了减排力度调控机制。该减排力度调控机制既能使各国的自主贡献额具有强约束力,又能灵活调控各国的减排力度,并发掘各国的减排潜力。该减排力度调控机制有助于弥补现有国家自主贡献机制的缺陷,促进国际社会的减排。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

A review of measurement methods for peracetic acid (PAA)

• Physical and chemical properties and application of peracetic acid solution. • Determination method of high concentration peracetic acid. • Determination method of residual peracetic acid (low concentration). Peroxyacetic acid has been widely used in food, medical, and synthetic chemical fields for the past several decades. Recently, peroxyacetic acid has gradually become an effective alternative disinfectant in wastewater disinfection and has strong redox capacity for removing micro-pollutants from drinking water. However, commercial peroxyacetic acid solutions are primarily multi-component mixtures of peroxyacetic acid, acetic acid, hydrogen peroxide, and water. During the process of water treatment, peroxyacetic acid and hydrogen peroxide (H₂O₂) often coexist, which limits further investigation on the properties of peroxyacetic acid. Therefore, analytical methods need to achieve a certain level of selectivity, particularly when peroxyacetic acid and hydrogen peroxide coexist. This review summarizes the measurement and detection methods of peroxyacetic acid, comparing the principle, adaptability, and relative merits of these methods.     

典型类雌激素的降解方法及其影响因素研究进展

类雌激素是一类新兴污染物,目前在环境中普遍存在,且在极低浓度下可对生物体和环境产生重大威胁.本文重点介绍了酚类、天然类固醇类和邻苯二甲酸酯等3种典型类雌激素的来源、环境分布特征及其生物毒性,综述了典型类雌激素的最新化学降解法(直接光解法和高级氧化法)和生物降解法(菌类降解法和藻类降解法)及其特点.直接光解法操作简便,但降解效果不佳;高级氧化法能快速高效地去除类雌激素,但操作相对复杂、影响因素较多;生物降解法的应用性强,但处理周期长、受环境因素影响大.此外还阐述了类雌激素的降解机理及其影响因素,最后对典型类雌激素的多种高效联合降解技术提出了展望.     

华中地区冬季灰霾天气下PM2.5中重金属污染特征及健康风险评价:以湖北黄冈为例

为探究华中地区灰霾天PM_2.5中重金属元素的污染特征及其潜在健康风险,于2018年1月13~24日对华中区域观测点——黄冈站点加密采集PM_2.5样品.采用电感耦合等离子体质谱仪（ICP-MS）对PM_2.5中Cr、Mn、Co、Ni、Cu、Zn、As、Cd、Sn和Pb进行分析,通过富集因子法对其污染特征进行探讨,并采用美国环保署推荐的暴露模型对其潜在风险进行评估.结果表明,观测期间PM_2.5中Zn质量浓度最高,致癌物质As、Cd质量浓度均高于我国环境空气质量标准（GB 3095-2012）的二级标准限值,70%的元素质量浓度在灰霾中期占比最大.富集因子分析显示,Cd、Sn、Co、Pb和Zn富集程度最高,特别是在灰霾中期,这些物质主要来源于交通和燃煤.人体健康风险评价结果显示,手口摄食是引起非致癌风险的主要途径,儿童的暴露量和非致癌风险均明显高于成人.Pb对儿童存在非致癌风险,PM_2.5中重金属对成人不具有非致癌风险且致癌重金属不具有致癌风险.     

绿色设计方法——设计领域发展的新趋势

 简要地介绍了设计领域发展的新趋势—绿色设计的基本思想，综述了绿色设计各主要研究领域的现状和问题以及发展趋势，阐明了我国开展绿色设计的研究与应用的必要性与可行性．     

A regional environmental management information system for Chinese EPA—the system analysis and design

REMIS is one of key research projects sponsored by the central government. It is recommended to regional EPAs as a main tool of the environmental management. REMIS simulates the functions of the regional EPAs and aimed to improve their management level. The national environmental management information system will base on REMIS.Functional analysis is the kernel of the REMIS system analysis. Data and data flow analysis are used to support the functional analysis.Investigations on the functions of the local EPAs of eight provinces and 12 cities have been taken. The functions were carefully sorted. Modular design method was used in system analysis and system design.The system analysis included functional analysis, data analysis and data flow analysis. The system design is based on the system analysis. HIPO diagram of each modular, data base structure, menu design, selection of hardware and software environment were the main items of the system design.     

电旋风除尘模型实验研究

本研究试图将电除尘器与旋风除尘器组合为一体,以求取得较高的除尘效率,并利用旋转气流实现自动清灰。本文介绍了切向进气直流式电旋风除尘的模型试验,通过实测不同工况下的除尘效率和压力损失,应用经典除尘理论,建立了相应的数学模型。