Automated data analysis to rapidly derive and communicate ecological insights from satellite-tag data: A case study of reintroduced red kites

Analysis of satellite-telemetry data mostly occurs long after it has been collected, due to the time and effort needed to collate and interpret such material. Delayed reporting reduces the usefulness of such data for nature conservation where timely information about animal movements is required. To counter this problem, we present a novel approach which combines automated analysis of satellite-telemetry data with rapid communication of insights derived from such data. A relatively simple algorithm (based on radial and angular velocity calculated from fixes) allowed instantaneous detection of excursions away from settlement areas and automated calculation of home ranges on the remaining data. Automating the detection of both excursions and home-range calculations enabled us to disseminate ecological insights from satellite-tag data instantaneously through a dedicated web portal. The automated analysis, interpretation, and communication of satellite-tag and other ecological data offer clear benefits to nature conservation research and practice.     

北京市“十三五”大气污染物排放总量控制基本思路探讨

随着各项环保措施的深入实施,北京市大气环境质量进一步改善的难度逐渐加大。对北京市"十二五"时期的大气污染物排放总量控制工作进行了经验总结,并分析了"十三五"时期大气污染物的排放形势和减排压力。在此基础上,从6个方面提出了北京市"十三五"期间大气污染物排放总量控制的基本思路。     

Characterization of the extracellular biodemulsifiers secreted by Bacillus cereus LH-6 and the enhancement of demulsifying efficiency by optimizing the cultivation conditions

A highly efficient demulsifying strain, LH-6, was isolated from petroleum-contaminated soil and identified as Bacillus cereus by 16S rDNA gene analysis. It achieved 95.61 and 95.40 % demulsifying ratios within 12 h for water-in-oil (W/O) and oil-in-water (O/W) model emulsions, respectively. Fourier transform infrared spectroscopy (FT-IR) and thin-layer chromatography (TLC) detections indicated that the LH-6’s extracellular biodemulsifiers were different types of lipopeptides for the W/O and O/W emulsions. Optimization of the culture medium composition was conducted to improve the biosynthesis and demulsifying efficiency of the biodemulsifier. The optimal carbon source was liquid paraffin, while waste frying oil could also be an alternative carbon source. The optimal nitrogen sources were ammonium sulfate and yeast extract. To further enhance the biodemulsifier efficiency, the optimal cultivation conditions were determined using response surface methodology (RSM) based on central composite rotation design (CCRD). Using the optimized cultivation conditions, the demulsifying ratios increased to 98.23 and 97.65 % for the W/O and O/W model emulsions, respectively.     

生物滴滤塔处理氯苯废气的工艺性能

将活性污泥培养及驯化后接种于生物滴滤塔中,挂膜启动后处理模拟氯苯废气（简称氯苯废气）,考察了生物滴滤塔在挂膜启动阶段及稳定运行阶段的性能。实验结果表明：接种41 d后生物滴滤塔成功挂膜,此时氯苯去除率稳定在90%以上;生物滴滤塔稳定运行阶段,随着进气中氯苯质量浓度由303.82 mg/m³逐渐增至1 489.05 mg/m³,氯苯去除率从85.1%降至70.1%。处理氯苯废气适宜的工艺条件为：空塔停留时间超过45 s,喷淋液流量31.8 mL/min,氯苯负荷23.97~128.01 g/（m³·h）。生物滴滤塔对喷淋液的酸性环境有较好的适应性,喷淋液pH的变化对氯苯去除率无显著影响。     

聚甲亚胺酰胺树脂对水中Cu~(2+)的吸附

制备了聚甲亚胺酰胺树脂,对其进行傅里叶变换红外光谱分析。采用批处理方法实验了pH、铜离子初始浓度、吸附时间、吸附剂用量对吸附量的影响,研究了等温吸附模型和吸附动力学模型。优化后的吸附条件为:在铜离子溶液体积50 mL、初始浓度为300 mg/L、pH为6.0时,吸附剂投放量50 mg、吸附时间60 min,此时吸附量达到269.1 mg/g,去除率达89.7%。25℃时在研究浓度范围内,铜离子吸附过程用Langmuir等温线模型和Freundlich等温线模型描述均可;与准一级动力学方程、Elovich方程及内扩散方程相比,准二级动力学方程能更好地描述其吸附动力学过程。     

改性活性炭对水中铬离子(Ⅵ)的吸附性能

为了研究改性前后活性炭对水中铬离子(Ⅵ)的吸附效果,以磷酸活性炭(PAC)为原料,用10%硝酸改性得到硝酸改性活性炭(N-PAC)及直接蒸发法载铁改性得到载铁活性炭(Fe-PAC)。通过静态吸附研究表明,改性后活性炭对Cr(Ⅵ)的吸附率有较大提高。在常温、自然pH条件下,0.2 g活性炭处理50 mL浓度为100 mg/L的含Cr(Ⅵ)溶液,N-PAC和Fe-PAC对Cr(Ⅵ)的吸附率分别为79.21%和90.59%,都高于原PAC对Cr(Ⅵ)的吸附率49.58%。pH从2.2升高到11.92,Fe-PAC对Cr(Ⅵ)的吸附率从99.86%降低到14.77%,N-PAC则从99.86%降低到3.23%,PAC从97.05%降低到2.53%。温度从25℃升高到70℃,3种活性炭对Cr(Ⅵ)吸附率都有较大提高,都增加到98%以上。且吸附过程较符合Langmuir等温吸附模型。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

Development of IC-ELISA for detection of organophosphorus pesticides in water

Diethyl (carboxymethyl) phosphonate (DECP) was used as the hapten to develop an indirect competitive enzyme-linked immunosorbent assay (IC-ELISA) for detecting organophosphorus pesticides (OPs). Conjugator of DECP with bovin serum albumin (BSA) was used as the immunogen for producing the polyclonal antibodies (PcAbs). Three antisera were obtained after the immune procedure. Characterization studies of the PcAbs indicated that the titer of antiserum-1 was highest in 3 antisera, and antiserum-1 had high affinity and specificity to the parathion, dichlorvos and pirimiphos. The IC-ELISA showed an IC₅₀ of 0.428 μ g/mL with a detection limit of 0.0125 μ g/mL to parathion. The assay also indicated that the IC₅₀ values of pirimiphos and dichlorvos were 0.331 μ g/mL and 1.25 μ g/mL respectively, and the detection limits of pirimiphos and dichlorvos were 0.0116 μ g/mL and 0.048 μ g/mL respectively. Recoveries of parathion, pirimiphos and dichlorvos spiked into water samples ranged from 90% to 160%. The results indicated that the ELISA could be a convenient and supplemental analytical tool for monitoring OPs residues in environmental water samples.     

Simultaneous Sampling of Gas- and Aerosol-Phase TDI with a Triple Filter System

Abstract

A new triple filter system sampler/model is proposed for the precise and accurate simultaneous sampling and determination of gas- and aerosol-phase 2,4-toluene diisocyanate (TDI). The system consists of two front Teflon filters for sampling aerosol-phase TDI and a final coated glass fiber filter to collect gas-phase TDI. The aerosol-phase TDI is collected on the first Teflon filter, while the second Teflon filter is used to estimate gaseous TDI adsorbed by the first. According to the gas adsorption test of two Teflon filters in series, the TDI gas adsorption fraction of the two filters is almost the same. Results of the evaporation test using pure TDI aerosols collected on the Teflon filter show that significant evaporation of the compound does not occur during sampling. These two findings allow the use of a model to estimate accurate gasand aerosol-phase TDI concentrations. The comparison test with an annular denuder shows that the triple filter system can minimize the TDI sampling bias between the dual filter and the annular denuder systems.