Evaluation of bioremediation effectiveness on crude oil-contaminated sand

A treatability study was conducted using sea sand spiked with 3% or 6% (w/w) of Arabian light crude oil to determine the most effective bioremediation strategies for different levels of contamination. The sea sand used in the study was composed of gravel (0.1%), sand (89.0%), and silt and clay (10.9%). The water content of the sea sand was adjusted to 12.6% (w/w) for the study. Different combinations of the following treatments were applied to the sand in biometer flasks: the concentration of oil (3% or 6%), the concentration of a mixture of three oil-degrading microorganisms (Corynebacterium sp. IC-10, Sphingomonas sp. KH3-2 and Yarrowia sp. 180, 1x10(6) or 1x10(8) cells g-1 sand), the concentration of the surfactant Tween 80 (1 or 10 times the critical micelle concentration), and the addition of SRIF in a C:N:P ratio of 100:10:3. Three biometer flasks per combination of experimental conditions were incubated, and the performance of each treatment was examined by monitoring CO2 evolution, microbial activity, and oil degradation rate. The results suggest that the addition of inorganic nutrients accelerated the rate of CO2 evolution by a factor of 10. The application of oil-degrading microorganisms in a concentration greater than that of the indigenous population clearly increased biodegradation efficiency. The application of surfactant slightly enhanced the oil degradation rate in the contaminated sand treated with the higher concentration of oil-degrading microorganisms. The initial CO2 evolution rate was shown to efficiently evaluate the treatability test by providing significant data within a short period, which is critical for the rapid determination of the appropriate bioremediation approach. The measurements of microbial activity and crude oil degradation also confirmed the validity of the CO2 evolution rate as an appropriate criterion.     

Comparison of PCDD/F and coplanar PCB concentrations in Japanese human adipose tissue collected in 1970-1971, 1994-1996 and 2000

Concentrations of polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs) and coplanar biphenyls (Co-PCBs) were determined in Japanese human adipose tissues. Temporal trends were assessed by comparing data collected during 1970-1971, 1994-1996 and 2000. Mean TEQ levels of PCDD/Fs in human adipose tissue showed a significant decrease from 31.6 +/- 9.2 pg-TEQ/g fat wt in 1970-1971 to 11.9 +/- 7.4 pg-TEQ/g fat wt in 2000, and coplanar PCBs decreased from 35.4 +/- 21.9 pg-TEQ/g fat wt in 1970-1971 to 15.3 +/- 8.2 pg-TEQ/g fat wt in 2000. However, some PCB congener concentrations did not change during this time. A comparison of data using the latest PCB-TEQ showed no significant changes. Therefore, research on source characterization and monitoring of short-term temporal trends on these compounds should be carried out continuously.     

Concentrations of perfluorinated acids in livers of birds from Japan and Korea

Livers of birds collected from Japan and Korea (n = 83) were analyzed to determine the concentrations of perfluorooctanesulfonate (PFOS), perfluorooctanesulfonamide (FOSA), perfluorooctanoic acid (PFOA) and perfluorohexanesulfonate (PFHS). PFOS was found in the livers of 95% of the birds analyzed at concentrations greater than the limit of quantitation (LOQ) of 10 ng/g, wet weight. The greatest concentration of PFOS of 650 ng/g, wet weight, was found in the liver of a common cormorant from the Sagami River in Kanagawa Prefecture. Concentrations of PFOS in bird livers from Japan and Korea were within the ranges of values reported for those from the United States and certain European countries. PFOA and PFHS were found in 5-10% of the samples analyzed. The greatest concentrations of PFOA and PFHS in bird livers were 21 and 34 ng/g, wet weight, respectively. FOSA was found in all the samples (n = 10) of cormorants collected from the Sagami River in Japan. The greatest concentration of FOSA in cormorant liver was 215 ng/g, wet weight. There was no significant correlation between the concentrations of PFOS and FOSA in cormorants collected from the Sagami River. These results suggested that the distribution of FOSA is localized. No age- or gender-specific differences in fluorochemical concentrations could be discerned in birds.     

Remediation of arsenic-contaminated soils and washing effluents

Laboratory experiments were conducted to determine the distribution of various arsenic species in tailings and soils. Other specific goal of the tests were to evaluate the extraction efficiency of arsenic using alkaline or acid washing, to determine optimum operational parameters of alkaline washing, and to evaluate the arsenic precipitation of washing effluents by pH adjustment or ferric chloride addition. Alkaline washing using sodium hydroxide was found to be favorable in removing arsenic from tailings or soils having a higher portion of arsenic in the operationally defined crystalline mineral fraction of crystalline oxide and amorphous aluminosilicates. This is due to the ligand displacement reaction of hydroxyl ions with arsenic species and high pH conditions that can prevent readsorption of arsenic because predominant negatively charged crystalline oxides do not attract the negatively charged oxyanions. For tailings, sodium hydroxide had 10-20 times higher extraction efficiencies than hydrochloric- or citric acid. The optimum concentration of sodium hydroxide for soil washing was determined to be 200 mM for all samples, while the optimum ratios were 10:1 and 5:1 for tailings and field/river sedimentary soils, respectively. The washing effluent of river soil was effectively treated by adjusting pH to 5-6 with hydrochloric acid, resulting in arsenic concentrations of <50 microgl(-1). In the case of field soil effluent, an addition of ferric chloride with a minimum mass ratio of 11 (Fe/As) was needed to reduce the arsenic below 50 microgl(-1).     

Interferometric Microwave Radiometers for High-Resolution Imaging of the Atmosphere Brightness Temperature Based on the Adaptive Capon Signal Processing Algorithm

Passive microwave remote sensing from satellites and ground stations has contributed uniquely, and substantially, to the study of atmospheric chemistry, meteorology, and environmental monitoring. As user requirements are raised, in terms of the accuracy and the spatial resolution, a mechanically scanning radiometer, with a real aperture, becomes impractical due to the requirement for a very large antenna size. However, an aperture synthesis interferometric radiometer presents a valuable alternative. The work presented in this paper was devoted to high spatial resolution imaging, using the 37 GHz band interferometric radiometer, developed by ourselves. The spatially adaptive Capon beamforming method was exploited for the imaging, which outperformed the conventional Fourier Transform method. We concluded that the high spatial resolution imaging of the brightness temperature of the atmosphere could be accomplished with an interferometric radiometer equipped with the developed Capon beamforming imaging algorithm.     

Enhanced photocatalytic degradation of lindane using metal–semiconductor Zn@ZnO and ZnO/Ag nanostructures

To achieve enhanced photocatalytic activity for the degradation of lindane, we prepared metal–semiconductor composite nanoparticles (NPs). Zn@ZnO core–shell (CS) nanocomposites, calcined ZnO, and Ag-doped ZnO (ZnO/Ag) nanostructures were prepared using pulsed laser ablation in liquid, calcination, and photodeposition methods, respectively, without using surfactants or catalysts. The as-prepared catalysts were characterized by using X-ray diffraction (XRD), field-emission scanning electron microscopy, high-resolution transmission electron microscopy, ultraviolet–visible (UV–vis) spectroscopy, and photoluminescence spectroscopy. In addition, elemental analysis was performed by energy dispersive X-ray spectroscopy. The obtained XRD and morphology results indicated good dispersion of Zn and Ag NPs on the surface of the ZnO nanostructures. Investigation of the photocatalytic degradation of lindane under UV–vis irradiation showed that Zn@ZnO CS nanocomposites exhibit higher photocatalytic activity than the other prepared samples. The maximum degradation rate of lindane was 99.5% in 40 min using Zn@ZnO CS nanocomposites. The radical trapping experiments verified that the hydroxyl radical (·OH) was the main reactive species for the degradation of lindane.     

Forest-based biomass supply potential and economics for the pellet production in Nepal

In the current study, the potential of forest-based biomass supply for the pellet production in Nepal is investigated. This study showed that about 2.76 million tonnes (Mt) biomass in the form of pellets are potentially available from forest-based biomass. Considering a processing capacity of 6 tonnes (t)/hr of a pellet plant, the production cost of the pellets was calculated to be $43.53/t. Pellets are generally used as fuel to produce thermal energy in industries, which helps to save the economy and the environment of the country.     

Determination of low (137)Cs concentration in seawater using ammonium 12-molybdophosphate adsorption and chemical separation method

A new method has been developed for analyzing (137)Cs in a small volume of seawater. Ammonium 12-molybdophosphate (AMP) was used two times during pretreatment procedure. The first step was to adsorb (137)Cs in seawater samples into AMP in order to reduce sample volume, and the second was to remove (87)Rb, interference nuclide for beta counting. The AMP adsorbing (137)Cs was dissolved by sodium hydroxide solution, and then (137)Cs was finally formed to be cesium chloroplatinate precipitate by adding 10% hexachloroplatinic acid. The beta rays emitted from (137)Cs were measured with a low background gas-proportional alpha/beta counter. This method was applied to several seawater samples taken in the East Sea of Korea. Compared to the routinely used gamma-spectrometry method, this new AMP method was reliable and suitable for analyzing (137)Cs in deep seawater.     

Removal of As(V) and Sb(V) in aqueous solution by Mg/Al-layered double hydroxide-incorporated polyethersulfone polymer beads (PES-LDH)

To develop a novel granular adsorbent to remove arsenic and antimony from water, calcined Mg/Al-layered double-hydroxide (CLDH)-incorporated polyethersulfone (PES) granular adsorbents (PES-LDH) were prepared using a core-shell method having 25% PES in an N,N-dimethylformamide solution. The PES-LDH displayed a spherical hollow shape having a rough surface and the average particle size of 1–2 mm. On the PES-LDH surface, nanosized CLDH (100–150 nm) was successfully immobilized by consolidation between PES and CLDH. The adsorption of Sb(V) by PES-LDH was found to be more favorable than for As(V), with the maximum adsorption capacity of As(V) and Sb(V) being 7.44 and 22.8 mg/g, respectively. The regeneration results indicated that a 0.5 M NaOH and 5 M NaCl mixed solution achieved an 80% regeneration efficiency in As(V) adsorption and desorption. However, the regeneration efficiency of Sb(V) gradually decreased due to its strong binding affinity, even though the PES-LDH showed much higher Sb(V) adsorption efficiency than As(V). This study suggested that PES-LDH could be a promising granular adsorbent for the remediation of As(V) and Sb(V) contained in wastewater.