Standard purity and response factors of perfluorinated compounds

It has been reported that the relative response factors of isotopically labeled standards and unlabeled standards of the same perfluorinated compounds could be different. Individual (100 ng mL^?1) solutions of perfluorooctanoic acid (PFOA) and perfluorooctane sulfonate (PFOS) were analyzed using high-performance liquid chromatography tandem mass-spectrometry under negative-ion electrospray to detect any impurities present down to 0.5%–0.1% relative to the major component. Purity of the standards ranged from approximately 86% to ≥ 97%. Standard solutions of unlabeled and isotopically labeled materials were analyzed to compare the response factors of isotopically labeled analytes versus their nonlabeled counterparts in three different matrices at equivalent concentrations: organic solvent (methanol), serum extract, and water present individually and concurrently. Not all labeled analytes have the same response factor as their nonlabeled complement, and in at least one case the matrix in which the standard is present may cause significant suppression of response. Standard solutions of electrochemical fluorination produced PFOA and PFOS were quantified under multiple reaction monitoring mode, using calibration curves prepared from standards consisting primarily of linear standards only. The use of linear only standards may cause under-prediction of concentrations, and that the working range of these standards may be limited.     

The effect of preparation conditions of Pt/Al2O3 on its catalytic performance for the H2-SCR in the presence of oxygen

Selective catalytic reduction of NO _x by H₂ in the presence of oxygen has been investigated over Pt/ Al₂O₃ catalysts pre-treated under different conditions. Catalyst preparation conditions exert significant influence on the catalytic performance, and the catalyst pre-treated by H₂ or H₂ then followed by O₂ is much more active than that pre-treated by air. The higher surface area and the presence of metallic Pt over Pt/Al₂O₃ pre-treated by H₂ or pretreated by H₂ then followed by O₂ can contribute to the formation of NO₂, which then promotes the reaction to proceed at low temperatures.     

First-trimester screening for Down syndrome; the role of nasal bone assessment in the Korean population

Objectives The aim of this study was to evaluate the role of nasal bone assessment in first-trimester screening for Down syndrome (DS) in the Korean population. Methods From July 2004 to March 2006, we prospectively evaluated the fetal nasal bones at 11–14 weeks' gestation in the Korean population. Results A successful evaluation was possible in 6490 of 6787 fetuses (95.6%). Absent, hypoechoic, and short nasal bones were seen in 4 (26.7%), 4 (26.7%), and 1 (6.7%) of 15 fetuses with DS, respectively, whereas in 5 (0.1%), 11 (0.2%), and 246 (3.8%) of 6456 normal fetuses. The incidence of absent and hypoechoic nasal bone showed significant differences between normal fetuses and fetuses with DS (P < 0.0005, both). Screening for DS using an absent or hypoechoic nasal bone resulted in a sensitivity of 53.3%, a specificity of 99.8%, a positive likelihood ratio of 215.2, and a negative likelihood ratio of 0.5. Conclusion Our study showed that nasal bone abnormality at 11–14 weeks of gestation had a high association with DS in the Korean population. This suggests that nasal bone assessment can be used to supplement the current first-trimester screening for DS in the Korean population. Copyright © 2007 John Wiley & Sons, Ltd.     

Decision support for prioritizing energy technologies against high oil prices: A fuzzy analytic hierarchy process approach

To provide national energy security in the 21st century, establishing a long-term strategic energy technology development is essential through selection and specialization. We established a strategic energy technology roadmap (ETRM) taking economic spin-offs, commercial potential, inner capacity, and technical spin-off into account. In this research, we suggest an integrated multi-criteria decision making (MCDM) approach, which is composed of more than two criteria as the assessment of the optimal alternatives and solutions in the real world with the fuzzy theory and analytic hierarchy process (AHP), to prioritize the weights of energy technologies of ETRM as we allocate R&D budget using a fuzzy analytic hierarchy process. Building technology is the most preferred technology in the sector of energy technologies against high oil prices. And the coal technology and transportation technology follows and take the 2nd and 3rd place with the fuzzy AHP approach.     

Development of a SWAT Patch for Better Estimation of Sediment Yield in Steep Sloping Watersheds1

Abstract: The watershed scale Soil and Water Assessment Tool (SWAT) model divides watersheds into smaller subwatersheds for simulation of rainfall‐runoff and sediment loading at the field level and routing through stream networks. Typically, the SWAT model first needs to be calibrated and validated for accurate estimation through adjustment of sensitive input parameters (i.e., Curve Number values, USLE P, slope and slope‐length, and so on). However, in some instances, SWAT‐simulated results are greatly affected by the watershed delineation and Digital Elevation Models (DEM) cell size. In this study, the SWAT ArcView GIS Patch II was developed for steep sloping watersheds, and its performance was evaluated for various threshold values and DEM cell size scenarios when delineating subwatersheds using the SWAT model. The SWAT ArcView GIS Patch II was developed using the ArcView GIS Avenue program and Spatial Analyst libraries. The SWAT ArcView GIS Patch II improves upon the SWAT ArcView GIS Patch I because it reflects the topographic factor in calculating the field slope‐length of Hydrologic Response Units in the SWAT model. The simulated sediment value for 321 subwatersheds (watershed delineation threshold value of 25 ha) is greater than that for 43 subwatersheds (watershed delineation threshold value of 200 ha) by 201% without applying the SWAT ArcView GIS Patch II. However, when the SWAT ArcView GIS Patch II was applied, the difference in simulated sediment yield decreases for the same scenario (i.e., difference in simulated sediment with 321 subwatersheds and 43 subwatersheds) was 12%. The simulated sediment value for DEM cell size of 50 m is greater than that for DEM cell size of 10 m by 19.8% without the SWAT ArcView GIS Patch II. However, the difference becomes smaller (3.4% difference) between 50 and 10 m with the SWAT ArcView GIS Patch II for the DEM scenarios. As shown in this study, the SWAT ArcView GIS Patch II can reduce differences in simulated sediment values for various watershed delineation and DEM cell size scenarios. Without the SWAT ArcView GIS Patch II, variations in the SWAT‐simulated results using various watershed delineation and DEM cell size scenarios could be greater than those from input parameter calibration. Thus, the results obtained in this study show that the SWAT ArcView GIS Patch II should be used when simulating hydrology and sediment yield for steep sloping watersheds (especially if average slope of the subwatershed is >25%) for more accurate simulation of hydrology and sediment using the SWAT model. The SWAT ArcView GIS Patch II is available at http://www.EnvSys.co.kr/~swat for free download.     

Polycyclic aromatic hydrocarbons in soils along the coastal and estuarine areas of the northern Bohai and Yellow Seas, China

Polycyclic aromatic hydrocarbons (PAHs) and their health risks in surface soils (n?=?31) collected from coastal and estuarine areas of the northern Bohai and Yellow Seas (CEANBYS), China, were investigated. Total concentrations of PAHs ranged from 6.6?×?10¹ to 9.2?×?10²?ng?g^?1 dry weight, with an average of 3.1?×?10²?ng?g^?1 dw. The locations where greater concentrations of PAHs were observed were all near factories emitting black smoke or on the edge of the urban areas. These observations are consistent with concentrations of PAHs in soils being influenced by human activities, especially industrialization and urbanization. Concentrations of PAHs were significantly correlated with concentrations of organic carbon in soils. The patterns of relative concentrations and types of PAHs observed as well as knowledge of the potential sources were consistent with the primary sources of PAHs in soils of the CEANBYS being derived from the pyrolytic processes such as combustion of fossil fuel. The incremental lifetime cancer risks of exposing to PAHs for child, youth, and adult were 1.6?×?10^?6, 1.2?×?10^?6, and 1.9?×?10^?6.     

Revised relative potency values for PCDDs, PCDFs, and non-ortho-substituted PCBs for the optimized H4IIE-luc in vitro bioassay

While the World Health Organization 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD) equivalency factors are useful estimates of relative potencies of mixtures when conducting risk assessments, they are not useful when comparing the results of bioassays such as the H4IIE-luc to concentrations of TCDD equivalents calculated from instrumental analyses. Since there are thousands of dioxin-like compounds (DLCs), one use of screening assays is to determine if all of the aryl hydrocarbon receptor (AhR) active DLCs in a mixture have been accounted for in instrumental analyses. For this purpose, bioassay-specific relative potency (ReP) values are needed. RePs of 21 polychlorinated dibenzo-p-dioxins, polychlorinated dibenzofurans, and dioxin-like polychlorinated biphenyls that exhibit effects mediated through the AhR were determined by use of the H4IIE-luc assay. Different values of RePs are derived, depending on the statistical, curve-fitting methods used to derive them from the dose–response relationships. Here, we discuss the various methods for deriving RePs from in vitro data and their assumptions and effects on values of RePs. Full dose–response curves of 2,3,7,8-TCDD and other representative DLCs were used to estimate effective concentrations at multiple points (e.g., EC20-50-80), which were then used to estimate ReP of each DLC to 2,3,7,8-TCDD.     

Sources and distribution of polychlorinated-dibenzo-p-dioxins and -dibenzofurans in soil and sediment from the Yellow Sea region of China and Korea

Polychlorinated-dibenzo-p-dioxins and -dibenzofurans (PCDD/Fs) were measured in soils and sediments from the Yellow Sea region. Korean soils and sediments mostly contained detectable PCDD/Fs and showed a widespread distribution among locations. Soil and sedimentary PCDD/Fs from China were comparable to or less than those in Korea. The patterns of relative concentrations of individual congeners in soils were different between the two countries, but similar in sediments. Sources of PCDD/Fs in China and Korea were found to be independent of each other and their distributions reflected matrix-dependent accumulation. Spatial distribution indicated some point sources in Korea while Chinese sources were more widespread and diffuse. PCDD/Fs measured in the coastal areas of the Yellow Sea were comparable to or less than those previously reported in for eastern Asia. However, ∑TEQs in soils and sediments were near to or, in some cases exceeded environmental quality guidelines.     

Transportation noise and exposed population of an urban area in the Republic of Korea

Using noise prediction models, we explored the transportation noise levels of Youngdeungpo-gu, an urbanized area of Seoul Metropolitan City in the Republic of Korea. In addition, we estimated the population exposed to transportation noise levels and determined how many people are vulnerable to noise levels that would cause serious annoyance and sleep disturbance. Compared with the World Health Organization [WHO] recommended levels, the daytime and nighttime transportation noise levels were still high enough to have the two psychosocial effects on people when considering the recommended levels of the World Health Organization (WHO; 55 decibels [dB[A]] and 40 dB[A] for daytime and nighttime, respectively). Particularly, nighttime transportation noise was discovered to be harmful to a wider area and more people than daytime noise. Approximately 91% of the Youngdeungpo-gu area experienced nighttime transportation noise levels exceeding those recommended by WHO. It was estimated that as much as 80% of the people in the study area were exposed to transportation noise levels >40 dB[A] during nighttime. Taking this into account, there is an urgent need to control and reduce transportation noise levels in Seoul, to protect residents against the potential ill health effects caused by urban transportation.     

Assessment of Flood Vulnerability Based on CMIP5 Climate Projections in South Korea

The objective of this article was to assess flood vulnerability based on the representative concentration pathways (RCP) scenarios at city and county levels. A quantile mapping method was adopted to correct bias that is inherent in climate change scenarios. A series of proxy variables related to climate exposure, sensitivity, and adaptive capacity were chosen to assess flood vulnerability. Proxy variables were standardized using the Z‐score method. Principal component analysis was carried out to calculate the weighting of proxy variables. The study area was the Korean peninsula. The spatial resolution was on a city and county basis and the temporal resolution was 1990s, 2025s, 2055s, and 2085s (divided into 1976‐2005, 2011‐2040, 2041‐2070, and 2071‐2100). In the spatial comparison, we found that the areas with high‐level flood vulnerability increased over time in the central region, including metropolitan areas, and near the southern coast. In the temporal comparison, we found that the RCP4.5 scenario showed a tendency to increase steadily and the RCP8.5 scenario showed a tendency to decrease in the 2055s slightly and increase again in the 2085s. The study findings may provide useful data for the determination of priority for countermeasure development, though robustness of these findings with additional future projections should be established.