Quantification of self pollution from two diesel school buses using three independent methods

We monitored two Seattle school buses to quantify the buses’ self pollution using the dual tracers (DT), lead vehicle (LV), and chemical mass balance (CMB) methods. Each bus drove along a residential route simulating stops, with windows closed or open. Particulate matter (PM) and its constituents were monitored in the bus and from a LV. We collected source samples from the tailpipe and crankcase emissions using an on-board dilution tunnel. Concentrations of PM₁, ultrafine particle counts, elemental and organic carbon (EC/OC) were higher on the bus than the LV. The DT method estimated that the tailpipe and the crankcase emissions contributed 1.1 and 6.8 μg m^?3 of PM_2.5 inside the bus, respectively, with significantly higher crankcase self pollution (SP) when windows were closed. Approximately two-thirds of in-cabin PM_2.5 originated from background sources. Using the LV approach, SP estimates from the EC and the active personal DataRAM (pDR) measurements correlated well with the DT estimates for tailpipe and crankcase emissions, respectively, although both measurements need further calibration for accurate quantification. CMB results overestimated SP from the DT method but confirmed crankcase emissions as the major SP source. We confirmed buses’ SP using three independent methods and quantified crankcase emissions as the dominant contributor.     

Controlling tailwater sediment and phosphorus concentrations with polyacrylamide in the Imperial Valley, California

External loading of phosphorus (P) from agricultural surface discharge (tailwater) is the main cause of excessive algae growth and the eutrophication of the Salton Sea, California. Continuous polyacrylamide (PAM) applications to agricultural irrigation water inflows were evaluated as a means of reducing sediment and P in tailwater. Zero (control) and 1 mg L(-1) PAM (PAM1) treatments were compared at 17 Imperial Valley field sites. Five and 10 mg L(-1) PAM treatments (PAM5, PAM10) were conducted at one site. The particulate phosphorus (Pp) fraction was determined as the difference between total phosphorus (Pt) and the soluble phosphorus (Ps) fraction. We observed 73, 82, and 98% turbidity reduction with PAM1, PAM5, and PAM10 treatments. Although eight field sites had control tailwater sediment concentrations above the New River total maximum daily loads (TMDL), all but one were made compliant during their paired PAM1 treatments. While PAM1 and PAM10 reduced tail water Pp by 31 and 78%, none of the treatments tested reduced Ps. This may have been caused by high irrigation water Na concentrations which would reduce Ca adsorption and Ca-phosphate bridging on the PAM. The PAM1 treatments resulted in <0.5 mg L(-1) drain water polyacrylamide concentrations 1.6 km downstream of PAM addition, while PAM5 and PAM10 treatments produced > 2 mg L(-1) drain water polyacrylamide concentrations. We concluded that, although PAM practically eliminates Imperial Valley tailwater sediment loads, it does not effectively reduce tailwater Ps, the P fraction most responsible for the eutrophication of the Salton Sea.     

Validation of a standardized portable fluorescence method for determining trace beryllium in workplace air and wipe samples

Beryllium is widely used in industry for its unique properties; however, occupational exposure to beryllium particles can cause potentially fatal disease. Consequently, exposure limits for beryllium particles in air and action levels on surfaces have been established to reduce exposure risks for workers. Field-portable monitoring methods for beryllium are desired in order to facilitate on-site measurement of beryllium in the workplace, so that immediate action can be taken to protect human health. In this work, a standardized, portable fluorescence method for the determination of trace beryllium in workplace samples, i.e., air filters and dust wipes, was validated through intra- and inter-laboratory testing. The procedure entails extraction of beryllium in 1% ammonium bifluoride (NH(4)HF(2), aqueous), followed by fluorescence measurement of the complex formed between beryllium ion and hydroxybenzoquinoline sulfonate (HBQS). The method detection limit was estimated to be less than 0.02 microg Be per air filter or wipe sample, with a dynamic range up to greater than 10 microg. The overall method accuracy was shown to satisfy the accuracy criterion (A< or = +/-25%) for analytical methods promulgated by the US National Institute for Occupational Safety and Health (NIOSH). Interferences from numerous metals tested (in >400-fold excess concentration compared to that of beryllium) were negligible or minimal. The procedure was shown to be effective for the dissolution and quantitative detection of beryllium extracted from refractory beryllium oxide particles. An American Society for Testing and Materials (ASTM) International voluntary consensus standard based on the methodology has recently been published.     

Indices of Benthic Community Tolerance in Contaminated Great Lakes Sediments: Relations with Sediment Contaminant Concentrations, Sediment Toxicity, and the Sediment Quality Triad

We evaluated the toxic-units model developed by Wildhaber and Schmitt (1996) as a predictor of indices of mean tolerance to pollution (i.e., Lenat, 1993; Hilsenhoff, 1987) and other benthic community indices from Great Lakes sediments containing complex mixtures of environmental contaminants (e.g., polychlorinated biphenyls – PCBs, polycyclic aromatic hydrocarbons – PAHs, pesticides, chlorinated dioxins, and metals). Sediment toxic units were defined as the ratio of the estimated pore-water concentration of a contaminant to its chronic toxicity as estimated by U.S. Environmental Protection Agency Ambient Water Quality Criteria (AWQC) or other applicable standard. The total hazard of a sediment to aquatic life was assessed by summing toxic units for all contaminants quantified. Among the benthic community metrics evaluated, total toxic units were most closely correlated with Lenat's (1993) and Hilsenhoff's (1987) indices of community tolerance (T _L and T _H , respectively); toxic units accounted for 42% T _L and 53% T _H of variability in community tolerance as measured by Ponar grabs. In contrast, taxonomic richness and Shannon-Wiener diversity were not correlated (P > 0.05) with toxic units. Substitution of order- or family-level identifications for lowest possible (mostly genus- or species-) level identifications in the calculation of T _L and T _H indices weakened the relationships with toxic units. Tolerance values based on order- and family-level identifications of benthos for artificial substrate samples were more strongly correlated with toxic units than tolerance values for benthos from Ponar grabs. The ability of the toxic-units model to predict the other two components (i.e., laboratory-measured sediment toxicity and benthic community composition) of the Sediment Quality Triad (SQT) may obviate the need for the SQT in some situations.     

Web-based surveys as an alternative to traditional mail methods

Environmental economists have long used surveys to gather information about people's preferences. A recent innovation in survey methodology has been the advent of web-based surveys. While the Internet appears to offer a promising alternative to conventional survey administration modes, concerns exist over potential sampling biases associated with web-based surveys and the effect these may have on valuation estimates. This paper compares results obtained from a travel cost questionnaire of visitors to Fraser Island, Australia, that was conducted using two alternate survey administration modes; conventional mail and web-based. It is found that response rates and the socio-demographic make-up of respondents to the two survey modes are not statistically different. Moreover, both modes yield similar consumer surplus estimates.     

Multiscale Analysis of Restoration Priorities for Marine Shoreline Planning

Planners are being called on to prioritize marine shorelines for conservation status and restoration action. This study documents an approach to determining the management strategy most likely to succeed based on current conditions at local and landscape scales. The conceptual framework based in restoration ecology pairs appropriate restoration strategies with sites based on the likelihood of producing long-term resilience given the condition of ecosystem structures and processes at three scales: the shorezone unit (site), the drift cell reach (nearshore marine landscape), and the watershed (terrestrial landscape). The analysis is structured by a conceptual ecosystem model that identifies anthropogenic impacts on targeted ecosystem functions. A scoring system, weighted by geomorphic class, is applied to available spatial data for indicators of stress and function using geographic information systems. This planning tool augments other approaches to prioritizing restoration, including historical conditions and change analysis and ecosystem valuation.     

Bankfull Regional Curves for North and Northwest Florida Streams1

Abstract: Regional curves, which relate bankfull channel dimensions and discharge to watershed drainage area, are developed to aid in identifying the bankfull stage in ungaged watersheds, and estimating the bankfull discharge and dimensions for river studies and natural channel design applications. This study assessed 26 stable stream reaches in two hydro‐physiographic regions of the Florida Coastal Plain: the Northwest Florida Coastal Plain (NWFCP) and the North Florida Coastal Plain (NFCP). Data from stream reaches in Georgia and Alabama were also used to develop the Florida regional curves, since they are located in the same hydro‐physiographic region. Reaches were selected based on the presence of U.S. Geological Survey gage stations and indicators of limited watershed development (e.g., <10% impervious surface). Analyses were conducted to determine bankfull channel dimensions, bankfull discharge, average channel slope, and Rosgen stream classification. Based on these data, significant relationships were found between bankfull cross‐sectional area, width, mean depth, and discharge as a function of drainage area for both regions. Data from this study suggested that bankfull discharges and channel dimensions were larger from NWFCP streams than from Coastal Plain streams in North Carolina and Maryland. Bankfull discharges were similar between NFCP and Georgia coastal plain streams; therefore, the data were combined into one regional curve. In addition, the data were stratified by Rosgen stream type. This stratification strengthened the relationships of bankfull width and mean depth as a function of drainage area.     

Real-world vehicle emissions: a summary of the Sixteenth Coordinating Research Council On-Road Vehicle Emissions Workshop

The Coordinating Research Council held its 16th workshop in March 2006, with 83 presentations describing the most recent mobile source-related emissions research. In this paper, we summarize the presentations from researchers who are engaged in improving our understanding of the contribution of mobile sources to air quality. Participants in the workshop discussed evaluation of in-use emissions control programs, effects of fuels on emissions, emission models and emission inventories, results from gas- and particle-phase emissions studies from spark-ignition and diesel-powered vehicles, and efforts to improve our capabilities in performing on-board emissions measurements, as well as topics for future research.     

Florida seagrass habitat evaluation: a comparative survey for chemical quality

Contaminant concentrations were determined for media associated with 13 Florida seagrass beds. Concentrations of 10 trace metals were more commonly detected in surface water, sediment and two seagrass species than PAHs, pesticides and PCBs. Concentrations of copper and arsenic in surface water exceeded Florida aquatic life criteria more frequently than other trace elements. Total organic carbon, mercury, chromium, zinc, total chlordane, total PAHs, total PCBs, DDD and DDE were significantly greater in seagrass-rooted sediments than adjacent non-vegetated sediments. Total DDT, DDD, DDE, total chlordane, arsenic, copper and nickel exceeded proposed sediment quality guidelines at six of 13 grass beds. Pesticides, PAHs, and PCBs were below detection in seagrass tissues. Mercury, cadmium, nickel, lead and silver were detected in 50% or more of the tissues for Thalassia testudinum (turtle grass) and Halodule wrightii (shoal grass). Spatial, interspecific and tissue differences were usually an order of magnitude or less.