Evaluation of airborne particulate matter and metals data in personal,indoor and outdoor environments using ED-XRF and ICP-MS and co-located duplicate samples

Factors and sources affecting measurement uncertainty associated with monitoring metals in airborne particulate matter (PM) were investigated as part of the Windsor, Ontario Exposure Assessment Study (WOEAS). The assessment was made using co-located duplicate samples and a comparison of two analytical approaches: ED-XRF and ICP-MS. Sampling variability was estimated using relative percent difference (RPD) of co-located duplicate samples. The comparison of ICP-MS and ED-XRF results yields very good correlations (R² ≥ 0.7) for elements present at concentrations that pass both ICP-MS and ED-XRF detection limits (e.g. Fe, Mn, Zn, Pb and Cu). PM concentration ranges (median, sample number) of 24-h indoor PM₁₀ and personal PM₁₀ filters, and outdoor PM_2.5 filters were determined to be 2.2–40.7 (11.0, n = 48) μg m^?3, 8.0–48.3 (11.9, n = 48) μg m^?3, and 17.1–42.3 (21.6, n = 18) μg m^?3, respectively. The gravimetric analytical results reveal that the variations in PM mass measurements for same-day sampling are insignificant compared to temporal or spatial variations: 92%, 100% and 96% of indoor, outdoor and personal duplicate samples, respectively, pass the quality criteria (RPD ≤ 20%). Uncertainties associated with ED-XRF elemental measurements of S, Ca, Mn, Fe and Zn for 24-h filter samples are low: 78%–100% of the duplicate samples passed the quality criteria. In the case of 24-h filter samples using ICP-MS, more elements passed the quality criteria due to the lower detection limits. These were: Li, Na, K, Ca, Si, Al, V, Fe, Mn, Co, Cu, Mo, Ag, Zn, Pb, As, Mg, Sb, Sn, Sr, Th, Ti, Tl, and U. Low air concentrations of metals (near or below instrumental detection limits) and/or inadvertent introduction of metal contamination are the main causes for excluding elements based on the pass/fail criteria. Uncertainty associated with elemental measurements must be assessed on an element-by-element basis.     

Herbicide residues in grapes and wine

Abstract

The persistence of several common herbicides from grapes to wine has been studied. Shiraz, Tarrango and Doradillo grapes were separately sprayed with either norflurazon, oxyfluorfen, oxadiazon or trifluralin ‐ persistent herbicides commonly used for weed control in vineyards. The dissipation of the herbicides from the grapes was followed for 28 days following treatment. Results showed that norflurazon was the most persist herbicide although there were detectable residues of all the herbicides on both red and white grapes at the end of the study period. The penetration of herbicides into the flesh of the grapes was found to be significantly greater for white grapes than for red grapes. Small‐lot winemaking experiments showed that norflurazon persisted at levels close to the initial concentration through vinification and into the finished wine. The other herbicides degraded, essentially via first‐order kinetics, within the period of “ first fermentation”; and had largely disappeared after 28 days. The use of charcoal together with filter pads, or with diatomaceous earth was shown to be very effective in removing herbicide residues from the wine. A 5% charcoal filter removed more than 96% of the norflurazon persisting in the treated wine.     

Emissions into the Atmosphere Due to the Ceramic Salt Glazing Process

The techniques of Principal Component Analysis (PCA) and subsequent regression analysis were used in an attempt to describe local and upwind chemical and physical factors which affect the variability of SO₄ ^–2 concentrations observed in a rural area of the northeastern U.S. The data used in the analyses included upwind and local O₃ concentrations, temperature, relative humidity and other climatological information, SO₂, and meteorological information associated with backward trajectories. The investigation identified five principal components, three major (eigenvalues >1) and two minor (eigenvalues < one), which accounted for 52% (r = 0.72) of the variability in the SO₄ ^–2 regression model. These components can be described as representing local and upwind photochemistry, droplet growth, SO₂ emissions, and air mass characteristics. The study also indicated that in future studies it will be necessary to a priori select air pollution and meteorological variables for measurement to potentially increase the sensitivity of this type of receptor model.     

Gas and Particle Emissions from Automobile Tires in Laboratory and Field Studies

This paper is directed to air pollution scientists interested in special mobile emission sources. The purpose was to determine the contribution which automobile tires make to air pollution. The gaseous hydrocarbon and sulfur compounds emitted in laboratory tests were identified. Although these hydrocarbons can participate in smog reactions, their mass emission rate is less than 0.1 % of the current exhaust hydrocarbon emission rate. Hydrocarbons from tires are not measurable near a freeway. The particulate emitted from tires ranges in size from 0.01 μm to more than 30 μm, with the larger particles dominating the total mass. Measurements along a California freeway showed that most of the tire debris had settled within 5 m of the pavement edge. Airborne rubber concentrations were less than 0.5 μg/m³, or less than 5% of the total tire wear. These field measurements confirm the indoor emission pattern and verify that tire wear products are not a significant air pollution problem.     

The role of intergenerational influence in waste education programmes: the THAW project

Whilst the education of young people is often seen as a part of the solution to current environmental problems seeking urgent attention, it is often forgotten that their parents and other household members can also be educated/influenced via home-based educational activities. This paper explores the theory of intergenerational influence in relation to school based waste education. Waste Watch, a UK-based environmental charity (www.wastewatch.org.uk), has pioneered a model that uses practical activities and whole school involvement to promote school based action on waste. This methodology has been adopted nationally. This paper outlines and evaluates how effective school based waste education is in promoting action at a household level. The paper outlines Waste Watch's 'Taking Home Action on Waste (THAW)' project carried out for two and half years in Rotherham, a town in South Yorkshire, England. The project worked with 6705 primary age children in 39 schools (44% of primary schools in the project area) to enable them to take the "reduce, reuse and recycle message" home to their families and to engage these (i.e. families) in sustainable waste management practices. As well as substantial increases in students' knowledge and understanding of waste reduction, measurement of the impact of the project in areas around 12 carefully chosen sample schools showed evidence of increased participation in recycling and recycling tonnages as well as declining levels of residual waste. Following delivery of the project in these areas, an average increase of 8.6% was recorded in recycling set out rates which led to a 4.3% increase in paper recycling tonnages and an 8.7% increase in tonnages of cans, glass and textiles collected for recycling. Correspondingly, there was a 4.5% fall in tonnages of residual waste. Waste Watch's THAW project was the first serious attempt to measure the intergenerational influence of an education programme on behaviour at home (i.e. other than schools' own waste). It clearly shows that household recycling behaviour can be positively impacted by intergenerational influence via a practical school-based waste education model. However, although the model could potentially have a big impact if rolled out nationally, it will require seed funding and the long-term durability of the model has not yet been fully quantified.     

Mobile passive samplers: concept for a novel mode of exposure

Integrative passive sampling with devices such as semipermeable membrane devices generally relies on rigs for month-long static exposures in water. We evaluate here whether mobile exposures of passive samplers can provide reliable estimates of dissolved contaminant concentrations. Mobile exposures were obtained by towing samplers fastened to the end of a benthic trawl net. Significant and reproducible absorption of polycyclic aromatic hydrocarbons during 5 h-long deployments was made possible by high sampling rates resulting from high water turbulences during towing at 1.2-1.5 knots. Sampling rates (72-215 L d⁻¹) estimated from the dissipation of performance reference compounds were supported by in situ calibration with samplers exposed for a 30 days in the vicinity of the test site. Higher fluoranthene and pyrene absorption in samplers exposed to the trawling-induced sediment plume could be attributed to desorption from re-suspended sediments. This mode of exposure has the potential to be used in monitoring programmes.     

Stream Restoration and Enhancement Projects: Is Anyone Monitoring?

Declines in salmon stocks and general watershed health in Washington State, USA, have led to an increase in stream restoration and enhancement projects initiated throughout the state. The increasing number of projects has also raised questions regarding the monitoring of these efforts. Project managers receiving hydraulic project approvals (HPAs) were surveyed to determine whether monitoring was taking place on their projects. About half the project managers surveyed reported the collection of baseline data and the use of biological, physical, chemical, or other water quality measures for their projects. Of those who reported collection of monitoring data, only 18% indicated that monitoring was required. Respondents were also asked to rank the importance of various project goals on a Likert scale. Project managers with projects focusing on “engineering” goals (e.g., roadbed stabilization) were less likely than other project managers to collect baseline monitoring data. Project managers with projects focusing on “restoration/ecological” or “fisheries” goals were more likely than other project managers to collect monitoring measures. Although monitoring appears to be taking place in slightly more than half of the projects surveyed, the nature of the data collected varies widely across projects, and in most cases the monitoring effort is voluntary. This suggests that project sponsors, funders, and managers must consider the issues involved in requiring appropriate monitoring, establishing standardized monitoring guidelines, the time frames in which to monitor, providing other incentives for conducting monitoring, and ensuring adequate funding for monitoring efforts.     

Adaptive Management: From More Talk to Real Action

The challenges currently facing resource managers are large-scale and complex, and demand new approaches to balance development and conservation goals. One approach that shows considerable promise for addressing these challenges is adaptive management, which by now is broadly seen as a natural, intuitive, and potentially effective way to address decision-making in the face of uncertainties. Yet the concept of adaptive management continues to evolve, and its record of success remains limited. In this article, we present an operational framework for adaptive decision-making, and describe the challenges and opportunities in applying it to real-world problems. We discuss the key elements required for adaptive decision-making, and their integration into an iterative process that highlights and distinguishes technical and social learning. We illustrate the elements and processes of the framework with some successful on-the-ground examples of natural resource management. Finally, we address some of the difficulties in applying learning-based management, and finish with a discussion of future directions and strategic challenges.     

Implications of simultaneity in a physical damage function

A modeler must often rely on highly simplified representations of complex physical systems when analyzing associated economic issues. Herein, we consider a management problem in which a bioeconomic system exhibits simultaneity in processes governing productivity and damage. In this case, it may benefit the producer to sacrifice productivity to reduce the costs associated with increased damage. We specify empirically a structural damage relationship that explains the biological process by which an invasive species damages a host and estimate the structural model and its reduced form with an exceptional dataset on infestation of olives by the olive fruit fly. We contrast the results of these models with the approach typically taken in the economic literature, which expresses damage as a function of pest density. The population-based approach introduces significantly greater bias into the individual grower's choice of damage-control inputs than estimates based on the structural model.     

Thiram‐induced toxic liver injury in male sprague‐dawley rats

Abstract

A single i.p. dose (120 mg/kg) of thiram given to male Sprague‐Dawley rats caused a significant increase in the activity of SGOT and SGPT 24 hr post‐treatment indicating liver damage. A considerable diminution in the serum cholinesterase activity was also noted in the treated rats as against the control animals. Additional evidence for thiram‐induced liver toxicity is provided by the observation that there was approximately 50% inhibition of the activity of hepatic microsomal benzphetamine N‐demethylase with a concomitant decrease in the concentration of cytochrome P‐450, an important component of the mixed‐function oxidase system. Although not significant, hepatic glutathione levels were also depleted by thiram, probably making the liver susceptible to toxic injury.