顶空毛细柱气相色谱法测定水中七种苯系物研究

选用Elite-FFAP色谱柱,利用顶空-毛细柱气相色谱技术对水中的苯、甲苯、乙苯、对二甲苯、间二甲苯、邻二甲苯、苯乙烯七种挥发性苯系物进行同时测定,并对样品的平衡温度、保温时间、程序升温的条件控制、水中含盐量等影响因素进行了探讨,优化了检测条件,使七种挥发性苯系物得到不错的分离。样品平衡温度控制在70℃,样品平衡时间19 min,进样口温度180℃,检测器温度230℃,10 mL水样中加入4 g NaCl的条件下,分离效果最佳。     

亚甲基蓝分光光度法测定废水硫化物的不确定度评定研究

分析了应用亚甲基蓝分光光度(GB/T16489-1996)测定废水硫化物测试过程中不确定度影响因素,主要来源为硫化物标准溶液、标准曲线拟合、随机效应、分光光度计和取样体积这五部分。本测量合成相对标准不确定度0.025 9;其中由测定样品质量引入的不确定度为0.024 7;由样品体积引入的不确定度为0.007 7。本次废水中硫化物测量结果为:0.110±0.006 mg/L,k=2(包含概率约为95%)。     

氟磺隆水解动力学研究

采用试验室内模拟试验的方法,研究不同pH的缓冲溶液和不同自然水体对氟磺隆水解的影响。实验结果表明,不同pH缓冲溶液和不同自然水体对氟磺隆水解速率均有不同程度的影响。在碱性条件下氟磺隆的水解速率最快,半衰期为0.2 d,酸性条件下次之,半衰期为6.0 d,在中性条件下水解较慢,半衰期为15.7 d,而在不同自然水体中氟磺隆的降解速率为:伊通河水稻田水青湖水蒸馏水。     

饥饿对硫自养反硝化反应器生物群落结构的影响

采用颗粒硫磺/白云石和黄铁矿/白云石自养反硝化反应器处理二沉尾水,探究饥饿忍耐对反应器去除效果、微生物群落变化的影响及其性能恢复时间.结果表明,在12~14℃的低温条件下,经过30 d的不进水饥饿忍耐后,颗粒硫磺/白云石和黄铁矿/白云石反应器出水NO_3~--N浓度分别从1.78 mg·L~(-1)、11.32 mg·L~(-1)增加到27.87 mg·L~(-1)、26.56 mg·L~(-1).颗粒硫磺/白云石和黄铁矿/白云石自养反硝化反应器分别在重启后的第5 d和11 d使得NO_3~--N去除性能恢复至饥饿前的水平,并且在低温条件下保持了良好的脱氮效果.MiSeq高通量测序结果表明,2个反应器的细菌群落的丰度和多样性饥饿期均低于恢复期,且优势菌门均为Proteobacteria,主要的纲类为β-Proteobacteria.硫磺/白云石反应器中鉴别出Thiobacillus菌属为主要反硝化类群.     

数字城市防震减灾

数字城市减灾战略的提出城市发展战略的各种研讨,总是要讨论安全城市概念中重要的灾害安全的涵义。同样,讨论安全战略的场合中,或者在讨论国家安全战略的著作中,也要讨论自然灾害或地震安全,或防灾减灾战略方面的内容。就是在国家长期科     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

Concentrations and accumulation rates of polychlorinated biphenyls in soil along an urban–rural gradient in Shanghai

Environmental Science and Pollution Research - This study proposed an in situ soil experimental system to quantify concentration and accumulation rates of polychlorinated biphenyl (PCB) congeners...     

Determination of Steroid Estrogens in Wastewater Treatment Plant of A Controceptives Producing Factory

Steroid estrogens such as estrone (E1), 17β-estradiol (E2), estriol (E3), and 17α-ethynylestradiol (EE2) have been suspected to be the main contaminants, which can affect the endocrine system of animals. Many authors have investigated these chemicals in the domestic wastewater treatment plants (WTP). However, wastewater from industries producing steroid contraceptives has not got ample attention. From the environmental point of view, the four steroids are very significant because even very low concentrations (ng/L) can cause reproductive disturbances in human, livestock and wildlife. The main purpose of the present investigation was to develop an analytical method for the determination of the four steroid estrogens present in WTP of a pharmacy factory, mainly producing contraceptive medicine in Beijing, China. Analysis was performed by solid-phase extraction (SPE) system and liquid chromatography combined with tandem mass spectrometry (LC/MS/MS). The average recoveries from effluent samples ranged from 88% to 103% and the precision of the method ranged from 9% to 4%. Based on 0.5-L wastewater samples, the limit of quantification (LOQ) was determined at 0.7 ng/L for E1, 0.8 for E2, 0.9 ng/L for E3, and 0.5 ng/L for EE2 in influent, and 1.0 ng/L for E2 and EE2, and 2.0 ng/L for E1 and E3 in effluent. In the influent samples, average concentrations of 80, 85, 73 and 155 ng/L were determined for E1, E2, E3 and EE2, respectively, showing that they were removed in this WTP to the extent of 79, 73, 85 and 67%, respectively.     

碘量法测定水中溶解氧有关问题的探讨及改进

碘量法测定溶解氧时,采用NH3·H2O—KI代替NaOH(KOH)—KI固定溶解氧,用H2SO4—H3PO(41+1)混合酸代替H2SO4溶解沉淀,使沉淀沉降速度加快,分界线明显,沉淀溶解也更完全。同时做样品空白实验,校正了氧化还原性物质产生的干扰,对废水有明显的抗干扰能力。通过对蒸馏水、自来水、池塘水、废水进行溶解氧测定,结果均非常满意。