Biomonitoring heavy metals in estuaries: a field comparison of two brown algae species inhabiting upper estuarine reaches

Biomonitoring dissolved heavy metals within estuaries,particularly at their upper reaches, frequently has to relyon several biomonitors; rarely a single species thrives allalong the salinity gradient. To properly do so, it must beestablished whether those biomonitors actually accumulateheavy metals alike. In this study, two brown seaweeds fromthe upper section of three NW Spain estuaries – the widely-known Fucus vesiculosus and the estuarine Fucusceranoides – were compared as metal biomonitors. Bothspecies were collected at five locations where they eithercoexist or live close to each other and their heavy metalcontent (Cu, Cr, Mn, Zn, Fe, Al) was measured. Analyseswere appropriately replicated for each species x locationcombination to allow a statistically reliable detection ofdifferences in bioaccumulation, with particular emphasis onthe magnitude of interspecific differences. The lack of significant differences for Cu, Mn, and Zncontents in F. ceranoides and F. vesiculosussupports the feasibility of their joint use to monitorthese metals along the estuaries. Conversely, F.ceranoides concentrated significantly higher levels of Cr,Fe, and Al than F. vesiculosus and hence combiningdata for both fucoids to monitor these elements seemsimpractical. The correlation of species differencestogether with a similar Al:Fe ratio in both weed tissue andsediment suggest that Cr, Fe, and Al tissue-burdens mightbe considerably biased by sediment retained on the surfaceof the weed. Parallel analyses of Al and/or Fe in seaweedsand sediments could serve to keep track of thisinterference and may help to combine data from both fucoidsfor monitoring elements like Cr.     

Aerosol Scavenging: Model Application and Sensitivity Analysis in the Indian Context

Sulfate aerosols have been found to bethe major contributors to precipitation acidity. Thus,in view of the long-term ecological repercussions theyhave on aquatic ecosystems and their acidity-potential,the present analysis focuses on a case study applicationof the layer-averaged aerosol-scavenging model (Okita et al., 1996) for predicting values of the wet scavengingcoefficient and sulfate concentrations in precipitationsamples on the basis of the information available forsome selected Indian cities. Through sensitivityanalysis (Pandey et al., 1997) the scavengingcoefficient has been found to be very strongly dependenton precipitation intensity. Comparison of modelpredictions has been done with the measured values forDelhi, Mumbai, Calcutta and Chennai in India.     

Forest Area in Costa Rica: A Comparative Study of Tropical Forest Cover Estimates over Time

Forest area figures, at a given point in time and for a given region of interest, differ considerably, affecting the calculation of deforestation rates and thus confuse the political and scientific discussion on the state and change of the resource forest. This article discusses the variation of published forest cover figures, using Costa Rica as an example. A list of published figures on the forest cover of Costa Rica from 1940 onwards is analyzed. Reasons for the differences are hypothesized and discussed. These differences are mainly in the definition of forest and forest classes included, in the type of the studies conducted (mapping and/or sampling), in the precision of the estimates, and in the information sources used. It is concluded that part of the problem is inherent in the nature of the resource `forest'. Quality and completeness of the presentation of the forest cover estimates are a clue to their correct understanding and interpretation. The latter point being especially relevant, as forest cover data have both a technical-scientific and a political meaning and are used as relevant arguments in many discussions. In the example of Costa Rica, a general downward trend is observed up to about 1985/1990, whereas after that forest area figures are on the average at a markedly higher level. Some hypotheses for this change in the trend are discussed.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

A framework for assessment and monitoring of arthropods in a lowland tropical forest

By applying principles of adaptive management, and by using the valuable information that arthropods provide from assessment and monitoring programs, managers can identify and reduce possible impacts on biodiversity in development projects. In 1996, the Smithsonian Institution's Monitoring and Assessment of Biodiversity program worked together with Shell Prospecting and Development Peru to establish an adaptive management program to protect biodiversity in a natural gas exploration project in a Peruvian rainforest. In this paper, we outlined the conceptual steps involved in establishing an assessment and monitoring program for arthropods, including setting objectives, evaluating the results and making decisions. We also present the results of the assessment using some of groups of arthropods, and summarize the steps taken to identify appropriate groups for monitoring.     

Accumulation of metals in the soil of an overland flow wastewater treatment system

Accumulation of Co, Cu, Cr, Mo, Ni, Pb and Zn was evaluated in a soil profile of an overland flow system used for the post-treatment of urban wastewater. A pilot version of the overland flow system received urban wastewater from five up-flow anaerobic filters filled with bamboo (Bambusa tuldoides) rings. The anaerobic effluent was applied as feed over 18 months at rates varying from 7 to 28 L min(-1), to a vegetated slope length covered with Tifton 85 (Cynodon) sp. grass. Soil and plant samples were collected in triplicate from the top to the bottom of the slope. In addition, the soils were sampled at the depths 0-20 and 20-40 cm. The metal concentrations found in the overall system were compared to those obtained in a control area located at the beginning of the slope onto which nothing was applied. A month of monitoring the urban wastewater of Limeira City (S?o Paulo State, Brazil) showed a drastic change in metals concentration due to the irregular discharge of industrial waste. This irregular discharge introduces Cr, Cu, Ni, Pb and Zn into the system used to treat domestic wastewater. The mass balance indicates the accumulation of metals in the soil and the translocation to the plants; also that they could be evapotranspirated, percolated and discharged.     

Optimization of a multielement sequential extraction method employing an experimental design approach for metal partitioning in soils and sediments

The optimisation of a simple multielement extraction method employing an experimental design approach is described. The method uses centrifugation to pass one extractant solution at varying pH through a contaminated soil sample. The nature and concentration of the acid, rate of centrifugation and time, number of sequential leachates and the ratio of extractant volume: sample weight have been studied in order to obtain the optimum conditions for extraction. A fractional factorial experimental design was performed, and the results were used to identify significance which was then evaluated by carrying out a central composite experimental approach. Once optimum conditions had been obtained, sequential leaches were analysed by ICP-AES and chemometrics were employed to identify the composition of each component. Comparisons have been made with previous studies and tentative assignments, based on well defined separated fractions and percentage compositions for individual elements, used to identify the different physico-chemical components in the sample.     

Nitrogen isotope ratios in pine bark as an indicator of N emissions from anthropogenic sources

The article describes the use of Scots pine bark to identifynitrogen sources in eastern Germany, as well as background areas in Russia and Bulgaria, by using natural isotope ratios of total nitrogen (N_t) and individual N compoundssuch as ammonium (NH₄ ⁺), nitrate (NO₃ ^-)and amid nitrogen (amide-N). The samples collected were analysed using an elemental analyser in connection with a gas isotope mass spectrometer (EA-IRMS). Natural ¹⁵N abundances in pine bark from impact areas suggest that the ammonium accumulated on the surface of the bark is releasedfrom livestock management. Bark of Scots pines growing near agricultural land had highly depleted ¹⁵N_t values (between –8 and –12), while bark from background areas (unpolluted areas) displayed slightly negative ¹⁵N_t values (mean ¹⁵N_t = –3.8). It is assumed that part of the N adsorbed on the bark surface is mainly derived from ammonia(mean ¹⁵N_t = –40.3) escaping from livestock housing and during the application of manure. This assumption is confirmed by experiments under controlled conditions in which manure samples were spread on soil. In addition, temporal and spatial variations of ¹⁵N_t abundances in pine bark from various locations in eastern Germany as wellas pine stands in Nature Park Dübener Heath are discussed.     

Evaluation of two adsorbents for diffusive sampling and thermal desorption-gas chromatographic analysis of monoterpenes in air

Tube type samplers with two different adsorbents, Chromosorb 106 and Tenax TA, were evaluated by laboratory experiments and field tests for simultaneous diffusive sampling of alpha-pinene, beta-pinene and delta 3-carene and subsequent thermal desorption-gas chromatographic analysis. No statistically significant effects of exposure time, concentrations of monoterpenes or relative humidity were found for samplers with Chromosorb 106 when running a factorial design, with the exception of the adsorption of delta 3-carene, for which some weak effects were noted. Samplers with Tenax TA were affected by the sampling time as well as the concentration for all terpenes, with a strong interaction effect between these two factors. The terpenes showed good storage stability on both adsorbents. No effect of back-diffusion was noted when using Chromosorb 106, while Tenax TA showed some back-diffusion effects. The uptake rates, in ml min-1, for the terpenes on Chromosorb 106 were 0.36 for alpha-pinene, 0.36 for beta-pinene and 0.40 for delta 3-carene. The corresponding average values on Tenax TA were 0.30 for alpha-pinene, 0.32 for beta-pinene and 0.38 for delta 3-carene. The field validation proved that diffusive sampling on Chromosorb 106 agreed well with pumped sampling on charcoal for stationary samples, while the personal samples indicated a discrepancy of 25% between Chromosorb 106 and charcoal samples. Tenax TA generally gave lower results than Chromosorb 106 in all field samples. Samplers packed with Chromosorb 106 could be used to monitor terpene levels in workplaces such as sawmills. The major advantages with this method are the sampling procedure, which is simple to perform compared to other techniques, the easily automated analysis procedure and the possibility to reuse the samplers.