Spontaneous abortion after transcervical chorionic villus sampling: A case report

A case of spontaneous abortion after transcervical CVS is presented. Despite no evidence of bacteria in the vagina and cervix prior to sampling and the prophylactic use of Metronidazole, pathological evidence of chorioamnionitis was found. The implications of this are discussed.     

The effect of oxygen tension on colony formation and cell proliferation of amniotic fluid cellsin vitro

The effects of reduced oxygen concentrations in the gas phase over the culture medium on colony formation and cell proliferation were investigated in high and low cell density primary and secondary cultures of amniotic fluid cells. Using two standard culture methods (25 cm² plastic flasks and Leighton type tubes) a significantly reduced culture time was observed at high cell density for mass cultures by incubation within a low oxygen tension gas phase (2.5 per cent to 7.5 per cent O₂) instead of conventional air (18 per cent O₂). At low cell density colony formation was significantly enhanced in cultures grown at reduced oxygen tension. Using gas permeable membranes as support, lowering the oxygen tension from 7.5 per cent to 2.5 per cent yielded an increase in plating efficiency of cells from approximately 5 per cent to 25 per cent, whereas plating efficiency was less than 2 per cent for cells grown at ambient 18 per cent O₂. It is suggested that low oxygen tension in the gas phase is an effective means of enhancing clonal growth in amniotic fluid cell cultures, thereby reducing both culture time and risk of culture failure.     

Prenatal diagnosis of cystic fibrosis using linked DNA probes

This paper presents data collected in Europe on 107 prenatal diagnoses of cystic fibrosis (CF) using linked DNA markers. To date, 38 children have been born without CF, as predicted, demonstrating the present rapid move from research to clinical genetic service.     

High-performance permanent magnets

 High-performance permanent magnets (pms) are based on compounds with outstanding intrinsic magnetic properties as well as on optimized microstructures and alloy compositions. The most powerful pm materials at present are RE–TM intermetallic alloys which derive their exceptional magnetic properties from the favourable combination of rare earth metals (RE=Nd, Pr, Sm) with transition metals (TM=Fe, Co), in particular magnets based on (Nd,Pr)₂Fe₁₄B and Sm₂(Co,Cu,Fe,Zr)₁₇. Their development during the last 20 years has involved a dramatic improvement in their performance by a factor of >15 compared with conventional ferrite pms therefore contributing positively to the ever-increasing demand for pms in many (including new) application fields, to the extent that RE–TM pms now account for nearly half of the worldwide market. This review article first gives a brief introduction to the basics of ferromagnetism to confer an insight into the variety of (permanent) magnets, their manufacture and application fields. We then examine the rather complex relationship between the microstructure and the magnetic properties for the two highest-performance and most promising pm materials mentioned. By using numerical micromagnetic simulations on the basis of the Finite Element technique the correlation can be quantitatively predicted, thus providing a powerful tool for the further development of optimized high-performance pms.     

Scots pine needle surfaces on radial transects across the north boreal area of Finnish Lapland and the Kola Peninsula of Russia

To gain an understanding of the characteristics of the needle surfaces of naturally regenerated Scots pine (Pinus sylvestris L.) and their geographical distribution, eight physicochemical variables were investigated within the north boreal forest area. The visibly undamaged needles were collected in autumn 1990 from 114 plots (3-5 pines per plot) along radial transects from the Monchegorsk and Nikel smelters, emitting SO2 and heavy metals, on the Kola Peninsula, Russia, to Finnish Lapland. The needles were examined by scanning electron microscopy (SEM) and measured for surface wettability using the droplet contact angle (DCA) method. Significant geographical south-north and west-east patterns could be observed in needle surface characteristics, correlating with emissions from the smelters and to climate. Despite the slightly higher initial DCAs (61.4-87.6 degrees) towards the north, the pine needle surfaces of the northernmost transects exhibited higher annual needle wettability change (ANWC) and wax erosion rate (AWER), expressed as the reduction in DCAs and epistomatal wax tube distribution (WTD) during one year, respectively, but a lower occurrence of particles and fungal hyphae than those of more southern transects. The higher ANWC was related to higher atmospheric SO2 concentration, and to the lower long-term temperature sum, but not clearly to annual precipitation. In the Monchegorsk smelter area, the current needles exhibited, on average, a 15% higher WTD and seven degree larger DCA, resulting in more hydrophobic needle surfaces than in Finnish Lapland, but during their first year, both the AWER and ANWC, were greatly increased. In Finnish Lapland, 30%, of all the epistomatal wax tubes disappeared from the needle surface during the first year, the value being 70% for the pines located 8 km from the smelter. The mineral composition of the particles deposited on the needle surfaces mirrored that of the minerals being produced by the smelters (e.g. FexSx, CuFeS2, NixSx, FexOx). Stomatal densities were in the range of 71.1-141.7 stomata mm(-2). The lower densities of stomata on needles close to the smelters correlated with reduced number of needle age classes of the pines, higher dry weights, higher pollutant accumulation and lower Mn and Zn concentrations in the needles. The AWER and ANWC were able to indicate the most seriously deteriorated needle surfaces on a regional scale, e.g. including the surroundings of both smelters, although the plot-specific relationships between 'needle surface variables' and 'pollution variables' were generally weak. The present study showed that the exposure of pine needles to the combined effects of ambient pollutants and harsh climate led to a deterioration in the physicochemical characteristics of the epicuticular wax, which may have serious ecophysiological consequences in the long term.     

Vertical gradients of ozone and carbon dioxide within a deciduous forest in Central Pennsylvania

Ambient concentrations of ozone (O(3)) and carbon dioxide (CO(2)) were measured at locations from the forest floor to the top of the canopy in a deciduous forest at the Moshannon State Forest in northcentral Pennsylvania. O(3) concentrations were measured from May-September for three years (1993-1995) while CO(2) concentrations were measured only during July and August of 1994. O(3) concentrations increased steadily during the day at all locations, peaking during the middle to late afternoon hours. O(3) concentrations then steadily declined to their lowest point, just before dawn. Vertical O(3) concentration gradients varied seasonally and among years. However, O(3) concentrations were highest within the forest canopy and lowest at the forest floor, with an average difference of approximately 13%. Differences in O(3) concentrations between the canopy and forest floor were greatest at night. O(3) concentrations were slightly higher at locations within the canopy than above the canopy. CO(2) concentrations were consistenly higher near the forest floor and were higher above the canopy than within the canopy. CO(2) concentrations were higher at night than during the day at all locations, especially near the forest floor.     

Organic carbon concentration profiles in recent cave sediments: records of agricultural pollution or diagenesis?

Recent (<7 years old) cave sediments in Speedwell Cavern, Derbyshire, show an approximately exponential decay of organic carbon with depth. This phenomenon was thought to be due to one of two causes: (i) changing agricultural practice within the catchment feeding the cave, especially the increased use of sewage sludge and animal slurry as fertilizer; (ii) a relatively constant organic carbon concentration over time in the input sediment, with subsequent carbon mineralization during diagenesis. Carbon isotope composition of the organic material and the evolution of H/C ratio with depth indicate that the latter hypothesis is correct and that the profiles result from microbial diagenesis, not increased organic carbon inputs. By comparison with sediment of known (7 years) age, temporal decay constants for organic matter can be derived; these lie between rates previously determined for organic matter decomposition in marine sediments and soils. The H/C ratio of organic matter can be modelled as a function of time and proceeds in a similar fashion to soil organic material.     

The uptake of particulates by an urban woodland: site description and particulate composition

Woodlands may improve local air quality by increasing the uptake rates of gaseous, particulate and aerosol pollutants from the atmosphere and can also act as relatively permanent sinks for some pollutants. Rough Wood, Walsall was selected for a study of the material which accumulates on tree foliage because of its location in a densely populated urban area, and its proximity to a motorway with high traffic flow (the M6) and to other pollutant sources. Methods were developed for leaf washing to allow determination of the quantity of dust and the identification of the dust particles present on oak leaves. Elemental analysis of particles was also undertaken using scanning electron microscopy coupled with electron probe microanalysis. A large proportion of particles were organic in origin. Of the inorganic particles, the majority contained silicon and aluminium in varying proportions suggesting that they were soil derived. Some particles were clearly identified as the products of combustion, and sea or road salt was present on leaf surfaces. Some particles contained copper, tin and titanium which may reflect the proximity of Rough Wood to local metal workings. The number of particles counted on leaf surfaces decreased as distance from the motorway increased.     

Selectivity in the complexation of actinides by humic substances

The interactions of a range of actinide elements (Th, U, Np, Pu, Am) with humic substances from the Needle's Eye natural analogue site were studied by gel permeation chromatography. Bulk humic substances were isolated by ammonia extraction, followed by dialysis against distilled water and freeze-drying. The gel permeation results suggest that Needle's Eye humic substances can be fractionated into three incompletely resolved fractions with average molecular weights determined by analytical ultracentrifugation around 49 000 for Fraction 1, around 14 700 for Fraction 2 and around 8000 for Fraction 3. Although there are significant differences between the organic matter elution patterns in individual gel permeation experiments, presumably due to differences in column packing, these are much smaller than the differences between metal ions. The uranium that is naturally present in these humic substances is largely bound in the late-eluting fraction. Spikes of the early actinides, including Np and Pu in controlled valency states, have been added to the humic substances, and gel permeation of the spiked humic substances shows that the three humic fractions vary greatly in their effectiveness and selectivity as ligands for early actinides.