Assessment of uncertainty of NO2 measurements by the chemiluminescence method and discussion of the quality objective of the NO2 European Directive

Hereafter, an assessment of the ability of the chemiluminescence method to measure ambient NO2 with an accuracy within 15%, as requested by the data quality objective of European directive 1999/30/CE, is presented. In general, uncertainty is evaluated using the response to reference materials or by means of inter-comparisons used to determine some statistics like repeatability, reproducibility and calibration bias. These are incomplete approaches and the method of the Guide to the Expression of Uncertainty in Measurement, advised by the Directive, should be preferred. In fact, even if it requires a large data set, it allows the relative influence of all possible sources of uncertainty to be studied. The extent of NO2 uncertainty is mainly dependent on the level of NO. It is decreased by NOx and the correlation between NOx and NO. Furthermore, the uncertainty budget reveals that the contribution of accuracy of calibration standard, linearity, converter efficiency and drift of the analyser between calibration checks to the overall uncertainty is less important than the contribution of interference, mainly humidity and PAN in rural areas. The relative expanded uncertainty of the NO2 hourly average exceeds 30% for NO2 concentrations lower than 40 microg m(-3). Nevertheless, the data quality objective of 15% is reached for 200 microg m(-3), the hourly limit value of the European directive. On the contrary, at the limit value on the annual average, 40 microg m(-3), the data quality objective is not met if NO is higher than 100 microg m(-3). However, the data quality objective could be reached by correcting the measurements with the bias due to interference.     

Application of cryofocusing hydride generation and atomic fluorescence detection for dissolved mercury species determination in natural water samples

The concentration levels of mercury (Hg) species in natural water samples are usually low. Consequently, accurate analysis with low detection limits is still a major problem. In this work, a method was applied for the simultaneous direct determination of dissolved mercury species in water samples by on-line hydride generation (HG), cryogenic trapping (CT), gas chromatography (GC) and detection by atomic fluorescence spectrometry (AFS). The suitability of the method for real samples with different organic matter and chloride contents was evaluated by recovery experiments in synthetic and natural spiked water samples. The HG method was compared with other current available methods for mercury analysis with respect to the different fraction of mercury analysed, i.e. 'reactive', 'reducible' or total. HG derivatization and SnCl2 reduction (with and without previous oxidation with BrCl) were applied to synthetic and natural (spiked and non-spiked) water samples. The influence of chloride and dissolved organic matter concentrations was studied. The results suggest that the HG procedure is suitable for the simultaneous determination of Hg2+ and MeHg+ in surface water samples. Inorganic mercury analysed by HG (i.e. reducible) is close to the total inorganic mercury.     

Solid-phase microextraction to monitor the sonochemical degradation of polycyclic aromatic hydrocarbons in water

Solid-phase microextraction (SPME) coupled with GC-MS has been used to monitor the degradation of polycyclic aromatic hydrocarbons (PAHs) by ultrasound treatment. Immersion SPME sampling enabled the fast and solventless extraction of target contaminants at the low microg l(-1) concentration level. The developed protocol was found to be linear in the concentration range from 0.1 to 50 microg l(-1) for most target analytes, with the limits of detection ranging between 0.01 and 0.70 microg l(-1) and the relative standard deviations between 4.31 and 27%. The developed SPME protocol was used to follow concentration profiles of aqueous solutions containing 16 PAHs, which were subject to low frequency ultrasonic irradiation. At the conditions employed in this study (80 kHz of ultrasound frequency, 130 W l(-1) of applied electric power density, 30 microg l(-1) of initial concentration for each of the 16 PAHs), sonochemical treatment was found capable of destroying the lower molecular weight PAHs (naphthalene, acenaphthylene, acenaphthene, fluorene, phenanthrene, anthracene, fluoranthene and pyrene) within 120-180 min of irradiation. The higher molecular weight PAHs were more recalcitrant to ultrasound treatment.     

Adenine nucleotides in snail muscles as one of biomarkers of fluoride toxicity

The aim of this work was to determine the extent of bioaccumulation of fluorides in tissues of Helix aspersa maxima. The toxicity of fluorides administered orally on the energy balance of the snail's foot was investigated based on measurements of concentrations of adenine nucleotides and their metabolism degradation products. Quantitation of fluoride levels was done in soft tissues (foot, hepatopancreas) and shells of mature snails. Qualitative and quantitative analysis of purine compounds was performed in slices of foot from mature snails. Fluoride concentrations in pulverized shells were measured using an ion-selective electrode. Gas chromatography was used to determine fluoride concentrations in soft tissues (hepatopancreas and foot). Purines were measured in foot muscle slices with high-performance liquid chromatography (HPLC). Fluoride levels in soft tissues of the snail cannot serve as an indicator for biomonitoring purposes as no significant accumulation was observed during exposure to maximum allowable concentrations of fluoride in drinking water. Contrary to this, levels of fluoride in the shell rose significantly with this concentration of fluoride in drinking water. The effect of fluorides on energy metabolism of foot muscle was evidenced by elevated AMP levels, increased adenine nucleotide pool and reduced conversion of ADP to ATP. Exposure to rising F(-) concentrations was accompanied by decreasing values of the adenylate energy charge AEC. Determination of AMP or AEC in foot muscle of exposed snails seems to be a useful indicator of fluoride effects on metabolic activity.     

用广义λ—分布拟合空气污染数据

广义λ-分布是一个四参数可变通的概率模型,包括多种单变量分布,这一模型可用于表示空气污染浓度的频率分布。本文采用土耳其安卡拉每日的烟和SO_2监测数据,来证明广义λ-分布具有良好的拟合性质。这里还讨论了与分位数估计和拟合优度有关的一些结果,并与经典对数正态分布进行了比较。     

Development of an ombrotrophic peat bog (low ash) reference material for the determination of elemental concentrations

Given the increasing interest in using peat bogs as archives of atmospheric metal deposition, the lack of validated sample preparation methods and suitable certified reference materials has hindered not only the quality assurance of the generated analytical data but also the interpretation and comparison of peat core metal profiles from different laboratories in the international community. Reference materials play an important role in the evaluation of the accuracy of analytical results and are essential parts of good laboratory practice. An ombrotrophic peat bog reference material has been developed by 14 laboratories from nine countries in an inter-laboratory comparison between February and October 2002. The material has been characterised for both acid-extractable and total concentrations of a range of elements, including Al, As, Ca, Cd, Cr, Cu, Fe, Hg, Mg, Mn, Na, Ni, P, Pb, Ti, V and Zn. The steps involved in the production of the reference material (i.e. collection and preparation, homogeneity and stability studies, and certification) are described in detail.     

Quantitative PCR analysis of house dust can reveal abnormal mold conditions

Indoor mold concentrations were measured in the dust of moldy homes (MH) and reference homes (RH) by quantitative PCR (QPCR) assays for 82 species or related groups of species (assay groups). About 70% of the species and groups were never or only rarely detected. The ratios (MH geometric mean : RH geometric mean) for 6 commonly detected species (Aspergillus ochraceus, A. penicillioides, A. unguis, A. versicolor, Eurotium group, and Cladosporium sphaerospermum) were >1 (Group I). Logistic regression analysis of the sum of the logs of the concentrations of Group I species resulted in a 95% probability for separating MH from RH. These results suggest that it may be possible to evaluate whether a home has an abnormal mold condition by quantifying a limited number of mold species in a dust sample. Also, four common species of Aspergillus were quantified by standard culturing procedures and their concentrations compared to QPCR results. Culturing underestimated the concentrations of these four species by 2 to 3 orders of magnitude compared to QPCR.     

Trace Element Analyses in an Epiphytic Lichen and its Bark Substrate to Assess Suitability for Air Biomonitoring

Total concentrations of Cd, Cr, Fe, Ni, Pb and Zn were compared from October 1996 to April 1998 in Physcia biziana (Massal.) Zhalbr. v. leptophylla Vezda and in the bark of Quercus ilex L. sampled from the same trees at an urban park. Trace metal concentrations were also measured in the bark covered by the lichen thalli. The lichens showed significantly higher Cr, Fe, Ni and Zn concentrations than both uncovered and covered barks. By contrast, both types of barks had higher concentrations of Cd and Pb than lichens. Trace elements showed a wide temporal variation of concentrations both in the lichens and barks. No relationship was found between the analysed matrices as regards the time course of trace element concentrations.     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.