比较两种表面活性剂淋洗去除土壤中的重金属

以停车场和湿地2种土壤为研究对象,分别使用表面活性剂鼠李糖脂和月桂基醚硫酸钠对土壤样品进行淋洗,考察2种表面活性剂对这2种土壤中重金属的去除能力差异及形态分布的影响,并分析淋洗后残留在土壤中表面活性剂的生物毒性。结果表明,2种表面活性剂均可在一定程度上去除2种土壤中的Cu、Cd、Pb和Zn。与湿地土壤相比,2种表面活性剂对停车场土壤中重金属的去除率均较高,且月桂基醚硫酸钠的去除能力优于鼠李糖脂。2种表面活性剂对可交换态重金属的去除效果最好,对残渣态重金属去除率较低。淋洗后2种土样中残留的鼠李糖脂及停车场土样中残留的月桂基醚硫酸钠的生物毒性低,湿地土壤中残留的月桂基醚硫酸钠具有一定生物毒性。     

生物炭基固定化菌剂对石油类污染物的高效降解

以生物炭为载体,采用吸附法制备固定化菌剂,通过分析不同材料生物炭的结构差异,探讨了不同生物炭的结构在固定化中的影响机制。SEM和EDS分析表明,降解菌主要固定在生物炭表面。生物炭内含有C、N和P成分,能为降解菌提供营养物质。生物炭的多孔结构能促进石油污染物的降解。结果表明,经玉米芯和秸秆生物炭固定化后F-3、R-7及其混合菌的除油率显著提高,分别为41.7%和29.5%、52.5%和42.8%、63.8%和53.2%。玉米芯生物炭固定化菌剂的除油率比秸秆生物炭固定化菌剂高10.6%。玉米芯生物炭表面比秸秆生物炭粗糙,其固定的微生物量为4.2×1010 cfu·g-1,固定效率达71.2%;秸秆生物炭固定的微生物量为2.5×1010 cfu·g-1,固定效率为57.6%。固定化菌剂的最佳制备条件为：选择500℃下热解3 h的玉米芯生物炭为载体,微生物接种量为10%,载体投加量为10 g·L-1,置于35℃、130 r·min-1摇床中固定18 h。     

催化湿式氧化技术处理山梨酸生产废水的研究

采用催化湿式氧化技术处理生产山梨酸过程中产生的高浓度有机废水,对催化剂组分进行优选.对反应温度、O2分压(Po2)和废水pH等工艺条件进行考察.实验结果表明:采用自制CuO-Cr2O3-La2O3/TiO2为复合催化剂处理该有机废水时表现出较好的催化活性;在190℃、Po2=2.1 MPa、pH=6.1、COD=10 030.0 mg/L时,反应90 min的COD去除率达到98.3%,而在相同条件下未加催化剂的湿式氧化的COD去除率只有60.1%.     

反胶束漆酶/纤维素酶体系中油酸酯化的优化

漆酶和纤维素酶在反胶束水核中心具有较强的催化活性。为了对反胶束酶体系中油酸酯化反应深入研究,采用生物表面活性剂鼠李糖脂构建反胶束体系作为漆酶与纤维素酶酯化油酸的催化反应场所。通过实验研究了反胶束体系的不同条件对酯化产物含量的影响。对于反胶束漆酶体系,最佳酯化条件为：含水量W0 40%,鼠李糖脂临界胶束浓度20 mmol·L-1,pH值4,温度40 ℃;对于反胶束纤维素酶体系,最佳酯化条件为：含水量20%,鼠李糖脂临界胶束浓度80 mmol·L-1,pH值4,温度30 ℃。综合考虑几个因素,漆酶比纤维素酶更适合应用于反胶束中油酸的酯化。研究同时采用荧光光谱法对漆酶和纤维素酶在反胶束体系中结构性能的变化进行研究,结果表明,当反胶束体系处于最佳酯化反应条件时,荧光强度最高。     

压力环境下活性污泥的耐盐驯化过程

通过逐步提高盐浓度的梯度盐度方法驯化耐盐活性污泥,采用加压-常压对比实验,探讨活性污泥耐盐驯化过程中,0.3 MPa的压力环境对有机物降解规律、污泥脱氢酶活性及胞外聚合物（EPS）含量的影响。结果表明,经耐盐驯化的活性污泥在5%的高盐度环境下仍可达到75%以上的有机物去除率;当驯化盐度达3.5%及以上,加压耐盐活性污泥有机物去除率及污泥脱氢酶活性均高于常压,其优势更为突出。耐盐驯化过程中活性污泥胞外聚合物（EPS）含量较稳定,加压系统EPS含量低于常压,这可能是加压活性污泥法可以实现原位污泥减量的重要原因之一。     

Contents and sources of polycyclic aromatic hydrocarbons and organochlorine pesticides in vegetable soils of Guangzhou, China

We investigated contents, distribution and possible sources of PAHs and organochlorine pesticides (Ops) in 43 surface and subsurface soils around the urban Guangzhou where variable kinds of vegetables are grown. The results indicate that the contents of PAHs (16 US EPA priority PAHs) range from 42 to 3077 microg/kg and the pollution extent is classified as a moderate level in comparison with other investigations and soil quality standards. The ratios of methylphenanthrenes to phenanthrene(MP/P), anthracene to anthracene plus phenanthrene (An/178), benz[a]anthracene to benz[a]anthracene plus chrysene (BaA/228), indeno[1,2,3-cd]pyrene to indeno[1,2,3-cd]pyrene plus benzo[ghi]perylene (In/In+BP) suggest that the sources of PAHs in the soil samples are mixed with a dominant contribution from petroleum and combustion of fossil fuel. The correlation analysis shows that the PAHs contents are significantly related to total organic carbon contents (TOC) (R2=0.75) and black carbon contents (BC) (R2=0.62) in the soil samples. Dichlorodiphenyltrichloroethane and metabolites (DDTs) and hexachlorocyclohexanes and metabolites (HCHs) account largely for the contaminants of OPs. The concentrations of DDTs range from 3.58 to 831 microg/kg and the ratios for DDT/(DDD+DDE) are higher than 2 in some soil samples, suggesting that DDT contamination still exists and may be caused by its persistence in soils and/or impurity in the pesticide dicofol. The concentrations of HCHs are 0.19-42.3 microg/kg.     

Influence of metal oxides on PCDD/Fs formation from pentachlorophenol

Chlorophenols (ClPhs) are considered as important precursors for PCDD/Fs formation. The influences of series of metal oxides including MgO, Al2O3, CaO, BaO, TiO2, V2O5, MnO2, Fe2O3, Co3O4, CuO, Ag2O, ZnO, HgO, SnO, PbO, La2O3, CeO2, and Eu2O3 on PCDD/Fs formation from pentachlorophenol (PCP) were investigated in a laboratory-scale reactor. The results indicated that most of the above metal oxides have obvious suppressing effects on the total amount of PCDD/Fs formation from precursor PCP except for CuO, ZnO, MnO2, TiO2 and Co3O4 with promotion effects at 280 degrees C for 2 h. Although MgO, Al2O3, Fe2O3, PbO, La2O3 and Eu2O3 could reduce the amount of octachlorinated dibenzo-p-dioxin (OCDD), they promote the formation of more toxic 1,2,3,4,6,7,8-HpCDD at the same time. The total suppressing efficiencies of several metal oxides including CaO, BaO, PbO, Ag2O, HgO and SnO which have lower Z/r (charge to radius ratio) <2 are all over 90%. The theories of generalized acid-base and atomic parameter (Z/r) were used to speculate the effecting mechanisms. The factors including time and temperature on suppressing efficiencies of CaO, BaO and PbO have also been studied in the present paper. The results showed that the total suppressing efficiencies of CaO, BaO and PbO increase with the increase of heated time and temperature.     

基于AERMOD模式的固定源对不同楼层大气污染预测研究

环境影响评价中,大气污染预测通常考虑地面的浓度影响,对高层住宅楼不同楼层影响的考虑较少.通过案例设计,模拟4种不同的污染排放情景,采用预测推荐模式AERMOD分别计算各情景下5个代表高度共20种组合情况的预测受体结果,并基于三维可视仪软件VOXLER直观显示各情景污染物浓度的空间连续分布情况,对小时最大浓度的分布规律利用分析工具CANOCO进行了分析.结果表明:(1)污染源高为15～80 m时,不同楼层间小时浓度分布差异性较大;污染源高为120～240 m时,楼层间差异性较小.(2)污染源高为15m时,小时最大浓度以50 m为分界线随楼层高度的增加先增后降;污染源高为80～240 m时,小时最大浓度随楼层高度的增加而增加.     

Quantitative evaluation of environmental risks of flotation tailings from hydrothermal sulfidation–flotation process

Floatation tailings (FT) are the main by-products of the hydrothermal sulfidation–flotation process. FT (FT₁ and FT₂) were obtained by treating two different neutralization sludges (NS) (NS₁ and NS₂). This paper quantitatively evaluated the environmental risks of heavy metals (Zn, Cd, Cu, Pb, and As) in FT versus NS. The total concentration and leaching rates (R ₂) of heavy metals in FT were much lower than those in NS, demonstrating that the hydrothermal sulfidation–flotation process was able to effectively suppress the mobility and leachability of heavy metals. The BCR-three sequence leaching procedure of FT confirmed that all metals were transformed into more stable forms (residue and oxidizable forms) than were found that in NS. The potential ecological risk index indicated that the overall risks caused by heavy metals decreased significantly from 6627.59 and 7229.67 (very serious risk) in NS₁ and NS₂, respectively, to 80.26 and 76.27 (low risk) in FT₁ and FT₂, respectively. According to the risk assessment code, none of the heavy metals in FT posed significant risk to the natural environment except Zn (with low risk). In general, the risk of heavy metals in FT had been well controlled.     

液体旋流分离器分离效率的研究

液体旋流分离器是水环境污染治理的主要设备之一.分离效率是衡量液体旋流分离器分离过程进行完善程度的最重要的技术指标,它能从质与量两方面反映出设备性能的优劣.当前液体旋流分离器设计过程还缺少具体量化的理论依据,为了给液体旋流分离器的设计提供理论依据,通过液体旋流分离器从水中分离固体粒子的性能实验,得出了液体旋流分离器各部结构尺寸、形状、相对比例对分离效率的不同影响程度,提出了结构参数的最佳取值范围.按照本研究提出的设计原则和方法,可以制造出性能优良的液体旋流分离器.