Cosorption of organic chemicals with different properties: their shared and different sorption sites

Complementary sorption of different chemicals was expected and investigating the relationship between the sorption inhibition of primary sorbate (ΔQ(pri)) and sorption of secondary sorbate (Q(sec)) could provide a new angle to understand coadsorption of different chemicals. This study used bisphenol A (BPA) as the primary adsorbate, sulfamethoxazole (SMX) as the competitor, and carbon nanotubes as model adsorbents to study their complementary and competitive adsorption. At low BPA concentrations, the sorption of SMX (Q(sec)) exceeded BPA sorption inhibition (ΔQ(pri)), indicating that these two chemicals complementarily adsorbed on their respectively preferred sorption sites. At high BPA concentrations, higher ΔQ(pri) was observed in comparison to Q(sec), which may be resulted from different packing efficiencies of the adsorbed SMX and BPA. This study emphasized that both competitive and complementary sorption should be discussed in binary sorption system.     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.     

1，4-二氯苯降解菌的分离及其降解特性研究

从某污水处理曝气池的活性污泥中分离出一株能够以1,4-二氯苯为唯一碳源和能源生长的菌株DEB-1,通过形态特征和生理生化试验初步鉴定为黄杆菌属（Flavobacterium sp.）。实验结果表明,该菌株最适降解温度为32℃、最适降解pH为7.8,24 h对100 mg/L的1,4-二氯苯的降解率达94.5%。菌株DEB-1的降解谱较广,对5种氯苯类物质具有较高的降解率。并进一步研究了DEB-1的1,4-二氯苯降解酶粗酶液的性质,其最适反应温度和pH分别为30℃和8.5。对处理含氯代芳香化合物的有机废水具有一定的意义。     

A biomimetic absorbent for removal of trace level persistent organic pollutants from water

A novel biomimetic absorbent containing the lipid triolein was developed for removing persistent organic pollutants (POPs) from water. The structural characteristics of the absorbent were obtained by SEM and a photoluminescence method. Under optimum preparation conditions, triolein was perfectly embedded in the cellulose acetate (CA) spheres, the absorbent was stable and no triolein leaked into the water. Dieldrin, endrin, aldrin and heptachlor epoxide were effectively removed by the CA--triolein absorbent in laboratory batch experiments. This suggests that CA-triolein absorbent may serve as a good absorbent for those selected POPs. Triolein in the absorbent significantly increased the absorption capacity, and lower residual concentrations of POPs were achieved when compared to the use of cellulose acetate absorbent. The absorption rate for lipophilic pollutants was very fast and exhibited some relationship with the octanol--water partition coefficient of the analyte. The absorption mechanism is discussed in detail.     

催化湿式氧化技术处理山梨酸生产废水的研究

采用催化湿式氧化技术处理生产山梨酸过程中产生的高浓度有机废水,对催化剂组分进行优选.对反应温度、O2分压(Po2)和废水pH等工艺条件进行考察.实验结果表明:采用自制CuO-Cr2O3-La2O3/TiO2为复合催化剂处理该有机废水时表现出较好的催化活性;在190℃、Po2=2.1 MPa、pH=6.1、COD=10 030.0 mg/L时,反应90 min的COD去除率达到98.3%,而在相同条件下未加催化剂的湿式氧化的COD去除率只有60.1%.     

Degradation of octylphenol and nonylphenol by ozone - part I: direct reaction

This aqueous reaction between ozone and two alkylphenols (APs), namely octylphenol (OP) and nonylphenol (NP), has been investigated. Both compounds are important endocrine disrupting chemicals, which arise from the biodegradation of alkylphenol ethoxylates and are often found at relatively high concentrations in wastewater effluents. In this paper the results of an experimental study are presented which provide values for the reaction rate constants between molecular ozone and undissociated OP and NP, and overall reaction rate constants for the degradation of the two APs at pH values in the range of 7-9. The kinetic rate constants for OP and NP degradation by molecular ozone were 4.33(+/-0.18) x 10(4) and 3.90(+/-0.10) x 10(4) M(-1) s(-1), and the reaction stoichiometry was similar in both cases and equal to approximately 1.3:1 ([O3]:[AP]). The overall second order reaction rate constants for the two APs increased significantly with increasing pH, which is believed to be mainly due to the increasing influence of indirect radical reaction with increasing pH; this aspect is considered in more detail in a companion paper. A preliminary investigation of the reaction mechanism suggests that an initial product of ozonation is hydroxyl-alkyl phenol.     

Decolorization of cationic red X-GRL by wet air oxidation: performance optimization and degradation mechanism

The decolorization of a strong colored azo dye solution of cationic red X-GRL was investigated by wet air oxidation under relatively mild conditions (60-180 degrees C, PO2 = 0-1.2 MPa). Mono-factor experiments were carried out to investigate the effect of the operation factors and the relatively important parameters were selected for optimization using response surface methodology to explore the interactions of these relatively important parameters. Model regeneration analysis and the check experiments showed that the data of the general linear model agreed with the experiment results well. With multistage Monte-Carlo optimization, the best region of these variables could be predicted to dye color removal. At typical operational conditions, the intermediates of dye degradation were detected and confirmed by GC/MS system. Considering the intermediates and the structure analysis with the help of Gaussian 03W (version 6.0) and the theory of dye color, a possible degradation mechanism for the wet air oxidation of cationic red X-GRL was discussed and the probable degradation pathway was deduced.     

零价铁复合有机膨润土处理染料废水的研究

针对目前印染废水处理现状及膨润土在水处理中回收困难等问题,提出将零价铁复合到有机膨润土中制成零价铁复合有机膨润土(ZVI-OB),以达到高效吸附并降解污染物的目的。以染料废水(Orange II) 作为研究对象,考察了废水中染料的初始浓度、pH以及吸附时间对ZVI-OB去除染料效率的影响,并研究了吸附后降解过程中时间和pH对污染物降解的影响以及降解前后膨润土层结构的变化。研究结果表明,ZVI-OB相对于CTMAB改性的有机膨润土而言,其吸附量有所降低,但ZVI-OB在吸附污染物之后能有效降解有机物。ZVI-OB在饱和吸附Orange II后经催化氧化,总有机碳含量降低为原来的19%,可以重复利用。     

林可霉素菌(Streptomyces lincolnensis)利用吡唑酮废水的研究

采用被吡唑酮废液驯化、分离、筛选后的林可霉素菌,并对其在摇瓶上利用吡唑酮废液中的硫酸铵发酵(7 d)生产林可霉素进行了研究。实验结果表明,废液加入培养基体积比都为1∶10,实验1中菌丝代谢和对照比正常,其中还原糖利用最快,在发酵后期为0.24 mg/L,林可霉素起步效价最低为2 100 IU/mL,与对照相比最后发酵效价降低了70 IU/mL;实验2发酵过程pH值偏低,全程为5.86～6.50,氨基氮代谢缓慢为40 mg/100 mL,最后林可霉素效价最低为4 480 IU/mL;实验3中废液在发酵进入48 h中后期的时候补入能促进菌丝体分泌,最后林可霉素为5 180 IU/mL,比对照发酵水平高出8.82%。可见实验3的实验设计有利于林可霉素菌利用吡唑酮废液生产林可霉素,为废物循环利用、变废为宝的可行性作了有意义尝试。