Half-lives of serum PCB congener concentrations in environmentally exposed early adolescents

The aim was to determine half-life of six most abundant PCB congeners in the body of early adolescents. In 304 environmentally exposed children, PCB serum concentration was determined at the age of 8 and 12 years. Half-life was determined for each child assuming exponential decrease or for the whole cohort using multiple regression. Results obtained by both approaches were in agreement. PCB reuptakes corrupting half-life estimates for each child and each congener were evaluated. If one of the serum PCB concentration values fell below the level of detection (LOD) the pair was excluded and if PCB half-life value exceeded the arbitrary value of 30 years. The following median half-lives in years 4.46, 10.59, 9.7, 4.7, 9.1 and 9.8 were obtained for PCB congeners 118, 138⁺¹⁶³, 153, 156⁺¹⁷¹, 170 and 180, respectively. The elimination half-life values were not systematically related to PCB serum concentration at any examination age. Between half-life values, percentage of children with significant reuptakes and PCB congener abundance in serum were found significant associations.     

An experimental design for the optimization of the extraction methods of metallic mobile fractions from environmental solid samples

The evaluation of the cadmium and lead mobile forms from environmental solid samples provides information about their mobility and bioavailability. In the present study, the Cd and Pb mobile fractions were obtained by two modified extraction methods applied to industrial and acidic pH soils or to polluted sediments. In order to highlight that the extraction procedure does not significantly influence the quantitative atomic absorption spectrometric determination of cadmium and lead, the robustness of the extraction methods was evaluated and proven applying a Youden and Steiner factorial design. Within this experimental design, the shaking rate, the shaking time, and the solid/liquid extraction ratio were modified. The measurement uncertainty of the whole analytical procedure was assessed, the contribution of the factors involved in the extraction process being insignificant compared to the other uncertainty sources. The importance of the study is related to the fact that it proves the applicability in the routine laboratory practice of the modified extraction methods by increasing the extraction ratio following thorough optimization and robustness studies.     

Metal exposures in an inner-city neonatal population

ObjectivesWe measured concentrations of lead (Pb), manganese (Mn), chromium (Cr), and copper (Cu) in umbilical cord whole blood and examined sources of environmental Pb exposures in a predominantly African-American population.MethodsBetween April and July 2006, we collected reproductive histories, questionnaires, and blood samples from 102 women, aged 16–45 years, who delivered at a Memphis, TN hospital.ResultsThe prevalence of preeclampsia and low birth weight infancy in the study population was 11% and 10%, respectively. Twenty-eight percent of mothers reported living near a potential Pb-contaminated area, while 43% lived in a residence built before 1978. Geometric mean (GM) concentrations for umbilical cord blood in the study population were 1.3, 3.5, 9.0, and 52.0 µg/dL for Pb, Mn, Cr, and Cu, respectively. Six neonates had cord blood Pb (CBL) concentrations above 10 µg/dL, while 20 had CBL concentrations ≥ 2 µg/dL. GM umbilical CBL levels were higher in neonates born to women living near a potential Pb-contaminated area (2.2 vs. 1.1 µg/dL) and those with friends, family or household members exposed to lead products (1.6 vs. 1.1 μg/dL). Some evidence of an exposure–response relationship was also detected between all four metal concentrations and an increasing number of maternal lead exposures. After adjustment for confounding, proximity to a Pb-contaminated area was the strongest environmental determinant of CBL levels among neonates with CBL concentrations of ≥ 2 µg/dL (odds ratio = 5.1; 95% CI = 1.6, 16.7).ConclusionsMetal concentrations were elevated in this population, and CBL levels were associated with proximity to Pb-contaminated areas.     

The IMPROVE_A temperature protocol for thermal/optical carbon analysis: maintaining consistency with a long-term database

Thermally derived carbon fractions including organic carbon (OC) and elemental carbon (EC) have been reported for the U.S. Interagency Monitoring of PROtected Visual Environments (IMPROVE) network since 1987 and have been found useful in source apportionment studies and to evaluate quartz-fiber filter adsorption of organic vapors. The IMPROVE_A temperature protocol defines temperature plateaus for thermally derived carbon fractions of 140 degrees C for OC1, 280 degrees C for OC2, 480 degrees C for OC3, and 580 degrees C for OC4 in a helium (He) carrier gas and 580 degrees C for EC1, 740 degrees C for EC2, and 840 degrees C for EC3 in a 98% He/2% oxygen (O2) carrier gas. These temperatures differ from those used previously because new hardware used for the IMPROVE thermal/optical reflectance (IMPROVE_TOR) protocol better represents the sample temperature than did the old hardware. A newly developed temperature calibration method demonstrates that these temperatures better represent sample temperatures in the older units used to quantify IMPROVE carbon fractions from 1987 through 2004. Only the thermal fractions are affected by changes in temperature. The OC and EC by TOR are insensitive to the change in temperature protocol, and therefore the long-term consistency of the IMPROVE database is conserved. A method to detect small quantities of O2 in the pure He carrier gas shows that O2 levels above 100 ppmv also affect the comparability of thermal carbon fractions but have little effect on the IMPROVE_TOR split between OC and EC.     

Oxidation of Cr(III) to Cr(VI) during chlorination of drinking water

Drinking water treatment typically uses strong oxidants such as chlorine which are capable of converting Cr(III) to Cr(VI). The rates and extent of Cr(III) oxidation by chlorine are not well established. Cr(III) oxidation experiments were therefore conducted in distilled deionized water and New York City tap water dosed initially with Cr(III) and supplemented with sodium hypochlorite to increase free chlorine residual. Reaction progress was monitored using capillary electrophoresis which quenched reactions and allowed for quantification of Cr(VI). Three different forms of Cr(III) were used as reactants: a Cr(III) nitrate salt, Cr(III)-EDTA, and Cr(III) hydroxide. Rates of Cr(VI) production for all three forms of Cr(III) were rapid, on the order of hours. However, oxidation rates slowed and a plateau in Cr(VI) concentrations was reached. This resulted in less than 100% conversion of Cr(III) to Cr(VI) even at relatively high chlorine doses (10 to 100 mg L(-1) as Cl(2)). The loss of free chlorine due to a non-Cr chlorine demand, the precipitation of Cr(III) to Cr(OH)(3)(s), and the partial oxidation of Cr(III) to intermediate oxidation states (i.e. Cr(IV) and Cr(V)) were examined and eliminated as possible explanations for this behavior. Consumption of chlorine via reaction with intermediate oxidation states of Cr is therefore offered as a possible explanation for the plateau in Cr(VI) concentrations.     

Weekday versus weekend activity patterns for ozone precursor emissions in California's South Coast Air Basin

Ambient O3 concentrations in California's South Coast Air Basin (SoCAB) can be as much as 55% higher on weekends than on weekdays under comparable meteorological conditions. This is paradoxical because emissions of O3 precursors (hydrocarbons, CO, and nitrogen oxides [NOx]) are lower on weekends. Day-of-week emissions activity data were collected and analyzed to investigate the hypothesized causes of the "weekend O3 effect." Emission activity data were collected for various mobile, area, and point sources throughout the SoCAB, including on-road vehicles, lawn and garden equipment, barbecues, fireplaces, solvent use, and point sources with continuous emission monitoring data. The results of this study indicate significant differences between weekday and weekend emission activity patterns and emissions. Their combined effect results in a 12-18% decrease in reactive organic gases (ROGs) and a 35-41% decrease in NOx emissions on Saturdays and Sundays, respectively, relative to weekdays in summer 2000. These changes in emissions result in an increase of more than 30% in the ROG/NOx ratio on weekends compared with weekdays, which, along with lower NOx emissions, leads to increased O3 production on weekends.     

Gyrinid searching tactics: empirical observations and a tactical model

Summary Data on Gyrinus picipes were collected to examine the influence of prey distribution and capture on search path configuration. All paths were analyzed before and after prey capture. Parameters measured were turning angles, step lengths, and step direction. Three indices of search efficiency were calculated: linear displacement, thoroughness, and straightness. Prey distribution had little impact on search configuration. However, prey capture caused significant reductions in step length, linear displacement, and straightness. Thoroughnnes and turning angle increased significantly after prey capture.A simulation model was developed to analyze influences of search parameters on search efficiency. Search paths, simulated using empirically derived parameters, did not differ from actual search paths indicating that the model accurately describes gyrinid search paths and may be used in these analyses. Actual search paths were compared to a simulated Brownian (random) search. Search paths before prey capture were significantly different from random, but Brownian search can describe search paths after prey capture. Comparisons of simulations using various input parameters indicate that step length has the greatest effect on search paths. Turning angles and direction are important before prey capture but not after. Offprint requests to: D.L. Winkelman at his current address     

Geoelectrical methods for monitoring geological CO2 storage: First results from cross-hole and surface–downhole measurements from the CO2SINK test site at Ketzin (Germany)

The feasibility of monitoring CO₂ migration in a saline aquifer at a depth of about 650 m with cross-hole and surface–downhole electrical resistivity tomography (ERT) is investigated at the CO₂SINK test site close to Ketzin (Germany). The permanent vertical electrical resistivity array (VERA) consists of 45 electrodes (15 in the injection well Ktzi201 and 15 in each of the two observation wells Ktzi200 and Ktzi202), successfully placed on the electrically insulated casings, in the depth range of about 590–740 m with a spacing of about 10 m. The three Ketzin wells are arranged as perpendicular triangle with distances of 50 and 100 m.First synthetic modelling studies indicate an increase of the electrical resistivity of about 200% caused by CO₂ injection, corresponding to a bulk CO₂ saturation of 50%, which is in good agreement with laboratory studies. Finite difference inversion of field data delivers three-dimensional resistivity distributions between the wells which are consistent with the reservoir modelling studies.To increase the limited observation area provided by the cross-hole measurements, additional surface–downhole measurements were deployed. A main CO₂ migration in SE–NW direction is deduced from surface to downhole resistivity experiments.The first cross-hole time-lapse results show that the resolution and the coverage of the electrode array in the Ketzin setting are sufficient to resolve the expected resistivity changes on the characteristic length scale of the electrode array. Significant resistivity changes could be measured, however, detailed information on the CO₂ plume could not be resolved yet by VERA under the existing geological circumstances.     

Do exurban communities want more development?

Most land-use surveys of exurban residents focus on eliciting preferences for residential development and open space conservation. This article, in contrast, reports on a stated preference study of exurban residents that assesses the relative attractiveness of a variety of commercial and recreational land uses. Focus group participants and town planners proclaimed a demand for certain commercial services such as modern grocery stores and fine-dining restaurants, but survey respondents generally exhibit a strong preference for no additional development beyond the current rate of development. Results show that if additional development is to occur, then recreational services are generally preferred over more traditional commercial development. Combining two commercial services in a single development project are strongly preferred to stand-alone developments. Our approach illustrates how planners may uncover misconceptions about and priorities for land conversion through examining residents’ preferences.