Pollution-induced community tolerance in benthic macroinvertebrates of a mildly lead-contaminated lake

Environmental Science and Pollution Research - Pollution-induced community tolerance (PICT) has been used to demonstrate effects of sediment contamination on microbes and meiofauna. Our study...     

Overview of surface measurements and spatial characterization of submicrometer particulate matter during the DISCOVER-AQ 2013 campaign in Houston,TX

The sources of submicrometer particulate matter (PM₁) remain poorly characterized in the industrialized city of Houston, TX. A mobile sampling approach was used to characterize PM₁ composition and concentration across Houston based on high-time-resolution measurements of nonrefractory PM₁ and trace gases during the DISCOVER-AQ Texas 2013 campaign. Two pollution zones with marked differences in PM₁ levels, character, and dynamics were established based on cluster analysis of organic aerosol mass loadings sampled at 16 sites. The highest PM₁ mass concentrations (average 11.6 ± 5.7 µg/m³) were observed to the northwest of Houston (zone 1), dominated by secondary organic aerosol (SOA) mass likely driven by nighttime biogenic organonitrate formation. Zone 2, an industrial/urban area south/east of Houston, exhibited lower concentrations of PM₁ (average 4.4 ± 3.3 µg/m³), significant organic aerosol (OA) aging, and evidence of primary sulfate emissions. Diurnal patterns and backward-trajectory analyses enable the classification of airmass clusters characterized by distinct PM sources: biogenic SOA, photochemical aged SOA, and primary sulfate emissions from the Houston Ship Channel. Principal component analysis (PCA) indicates that secondary biogenic organonitrates primarily related with monoterpenes are predominant in zone 1 (accounting for 34% of the variability in the data set). The relevance of photochemical processes and industrial and traffic emission sources in zone 2 also is highlighted by PCA, which identifies three factors related with these processes/sources (~50% of the aerosol/trace gas concentration variability). PCA reveals a relatively minor contribution of isoprene to SOA formation in zone 1 and the absence of isoprene-derived aerosol in zone 2. The relevance of industrial amine emissions and the likely contribution of chloride-displaced sea salt aerosol to the observed variability in pollution levels in zone 2 also are captured by PCA.

Implications: This article describes an urban-scale mobile study to characterize spatial variations in submicrometer particulate matter (PM₁) in greater Houston. The data set indicates substantial spatial variations in PM₁ sources/chemistry and elucidates the importance of photochemistry and nighttime oxidant chemistry in producing secondary PM₁. These results emphasize the potential benefits of effective control strategies throughout the region, not only to reduce primary emissions of PM₁ from automobiles and industry but also to reduce the emissions of important secondary PM₁ precursors, including sulfur oxides, nitrogen oxides, ammonia, and volatile organic compounds. Such efforts also could aid in efforts to reduce mixing ratios of ozone.     

Application of 15N–18O double stable isotope tracer technique in an agricultural nonpoint polluted river of the Yangtze Delta Region

One strategy to combat nitrate (NO₃-N) contamination in rivers is to understand its sources. NO₃-N sources in the East Tiaoxi River of the Yangtze Delta Region were investigated by applying a ¹⁵N–¹⁸O dual isotope approach. Water samples were collected from the main channel and from the tributaries. Results show that high total N and NO₃-N are present in both the main channel and the major tributaries, and NO₃-N was one of the most important N forms in water. Analysis of isotopic compositions (δ ¹⁸O, δD) of water suggests that the river water mainly originated from three tributaries during the sampling period. There was a wide range of δ ¹⁵N-NO₃ (?1.4 to 12.4 ‰) and a narrow range of δ ¹⁸O-NO₃ (3.7 to 9.0 ‰) in the main channel waters. The δ ¹⁵N and δ ¹⁸O-NO₃ values in the upper, middle, and lower channels along the river were shifted as 8.2, 3.5, and 9.5 ‰, and 9.0, 4.2, and 6.0 ‰, respectively. In the tributary South Tiao, the δ ¹⁵N and δ ¹⁸O-NO₃ values were as high as 9.5 and 7.0 ‰, while in the tributaries Mid Tiao and North Tiao, NO₃-N in most of the samples had relatively low δ ¹⁵N and δ ¹⁸O-NO₃ values from 2.3 to 7.5 ‰ and 4.7 to 7.0 ‰, separately. Our results also suggest that the dual isotope approach can help us develop the best management practice for relieving NO₃-N pollution in the rivers at the tributary scale.     

Biodegradable Water Soluble Copolymer for Antimicrobial Applications

Synthesis and characterization of novel biodegradable, water soluble and optically active DL-malic acid (DMA) and citric acid (CA) copolymers were studied for possible use as antibacterial agents. The copolymers were synthesized by direct bulk melt condensation in the absence of a catalyst above 150 °C. Characterization of obtained copolymers was carried out with the help of infrared absorption spectra, differential scanning calorimetry and thermo gravimetric analysis. The antibacterial activity of copolymers against bacteria was investigated. The results obtained shows the above copolymers possess a broad wound dressing activity against different types of bacteria and may be useful as antibacterial agents.     

Fuel efficiency improvement of a dual-fuel engine fuelled with Honge oil methyl ester (HOME)–bioethanol and producer gas

Renewable and alternative fuels have numerous advantages compared with fossil fuels as they are renewable and biodegradable and provide food and energy security and foreign exchange savings besides addressing environmental concerns and socio-economic issues (Yaliwal et al. 2013. International Journal of Sustainable Engineering, doi:10.1080/19397038.2013.801530. Zhu et al. 2011a, Applied Thermal Engineering 31 (14–15): 2271–2278; Zhu et al. 2011b, Fuel 90: 1743-1750; Banapurmath, Tewari, and Hosmath 2008, Renewable Energy 33: 2007-2018; Banapurmath 2009, “Performance, Combustion and Emission Characteristics of a Single Cylinder Direct Injection CI Engine Operated on Dual Fuel Mode Using Honge Oil and Producer Gas.” PhD thesis, 1–195; Banapurmath et al. 2011, Waste and Biomass Valorization 2: 1–11). In this context, the main objective of the present work is to study methods of biofuel production such as Honge oil methyl ester (HOME) using a conventional transesterification process and bioethanol from the Calliandra calothyrsus shrub using a new pretreatment method known as hydrothermal explosion. Further, experimental investigations were carried out on a single-cylinder, four-stroke, direct-injection stationary diesel engine operating in a dual-fuel mode using HOME, bioethanol and producer gas combinations to determine its performance, combustion and emission characteristics. The performance of the dual-fuel engine was analyzed at optimized engine conditions. HOME-Bioethanol (BE) blends such as HOME+ 5% bioethanol (BE5), HOME+ 10% bioethanol (BE10) and HOME+ 15% bioethanol (BE15) were prepared by adding bioethanol to HOME (on volume basis) in different proportions ranging from 5 to 15% with an increment of 5%. In this present work, the effect of different BE blends on the performance of producer gas fuelled dual fuel engine was studied. Experimental investigation on dual fuel engine using BE5-Producer gas operation resulted in up to 4–9% increased brake thermal efficiency with decreased hydrocarbon (HC), carbon monoxide (CO) and marginally increased nitric oxide (NOx) emission levels compared to HOME-Producer gas, BE10-producer gas and BE15-producer gas mode of operation. However, it was observed that, the overall performance of BE-producer gas operation was found to be lower compared to diesel-producer gas operation.     

Studies on transitory laxative effects of sorbitol and maltitol I: Estimation of 50% effective dose and maximum non-effective dose

The dose-response relationship between low-caloric sweetening agents, sorbitol and maltitol, administered orally in single doses, and the induction of diarrheal symptoms was investigated. Seven healthy male and 7 healthy female Japanese each in their twenties, thirties, and forties, respectively, or a total of 42 subjects were admitted to the study. The 50% laxative effective dose of sorbitol was estimated to be 0.4 g/kg for males and 1.0 g/kg for females and that of maltitol was estimated to be 0.8 g/kg for both males and females. The maximum non-effective dose of sorbitol was estimated to be 0.15 g/kg for males and 0.3 g/kg for females and that of maltitol was estimated to be 0.3 g/kg for both males and females.     

The asiatic clam, Corbicula fluminea: An indicator of trace metal pollution in the Shatt al-Arab River, Iraq

The potential of Corbicula fluminea (Müller) as an indicator for trace metal pollution was investigated. Laboratory experiments show that Corbicula has the capability to accumulate and eliminate trace metals in relation to their concentrations in ambient water. However, an effect of individual size was observed. Seasonal variations in the concentrations of Cd, Co, Cu, Fe, Mn, Ni, Pb, V and Zn in Corbicula, water and particulate matter from the upper section of the Shatt al-Arab River were studied. Sediment samples were also analysed. Metal concentrations were determined by means of flameless AAS. It was found that Corbicula is a suitable bio-indicator for monitoring of trace metal pollution. Metal concentrations in Corbicula tissues correlated better with their corresponding concentrations in particulate matter than with the dissolved form. Temporal variations in metal concentrations were attributed to several factors, including fluctuations in metal inputs, and in geochemical and hydrological characteristics of the water. The obtained levels of trace metals were comparable to those reported for control sites, with the exception of Cd, Cu and Zn whose concentrations were higher in both Corbicula and particulate matter.     

Effects of ozone on yield, growth, and root starch concentrations of two alfalfa (Medicago sativ A L.) cultivars

Ozone (O3) is considered to be a major air pollutant that affects the yield of several sensitive crop species. Its concentration may reach phytotoxic levels several times during the growing season in Eastern Canada. This study was initiated to evaluate the O3 effects on alfalfa, a major crop species. The objective was to compare the yield and growth parameters of the main alfalfa cultivar used in Québec, Apica, to a cultivar more tolerant to O3, Team. Effects on root starch concentrations were also examined as this parameter is an important indicator of alfalfa perennity. The results obtained have shown that the forage yield of Apica was more reduced by O3 during two growing seasons than the yield of Team. For O3 concentrations of 20 to 40 nl liter(-1), yield reductions were 14-26% for Apica and 0-20% for Team. Whereas Apica could be considered more susceptible to O3 than Team, the latter has shown contrasting responses from year to year. This fact suggests that the mechanisms involved in O3-tolerance could be modulated by environmental conditions. At low O3 levels, Apica has shown reduced root growth in terms of dry matter and length. However, contrary to the current hypothesis that O3 would affect more root than shoot growth, we were unable to show a consistent alteration of the biomass allocation between the two. Ozone seems to reduce globally the growth of the whole plants. The greater O3-tolerance of Team could partly be associated to its capacity to maintain more leaves, to delay their senescence, or to keep a larger leaf:stem ratio under increasing levels of O3. At the end of the two growing seasons, the amount of starch reserves stored below ground was shown to be reduced by the current O3 levels. This reduction was mainly associated with a decrease in root biomass under O3 stress. This result support the hypothesis that O3 may accelerate alfalfa decline under field conditions.     

Assessment of trace metal distribution and contamination in surface soils of Hong Kong

An intensive investigation was conducted to study the distribution of trace metals in surface soils of Hong Kong and to assess the soil environmental quality. From results of cluster analysis, and comparisons among soil types and areas, it is clearly shown that increases in trace metal concentrations in the soils were generally extensive and obvious in urban and orchard soils, less so in vegetable soils, whilst rural and forest soils were subjected to the least impact of anthropogenic sources of trace metals. However, some of the forest soils also contained elevated levels of As, Cu, and Pb. Urban soils in Hong Kong were heavily polluted by Pb from gasoline combustion. Agricultural soils, both orchard and vegetable soils, usually accumulated As, Cd, Cu, and Zn originating from applications of pesticides, animal manures, and fertilizers. In general, trace metal pollution in soils of the industrial areas and Pb pollution in the soils of the commercial and residential areas were obvious.