以焦炭为填料的生物滴滤塔处理含挥发性脂肪酸臭气

在以焦炭为填料的生物滴滤塔对挥发性脂肪酸臭气的处理研究中考察了空床停留时间、臭气浓度、体积负荷以及进气温度等参数对净化效果的影响。结果表明,空床停留时间较长时对臭气降解有利。在停留时间超过97 s时,能实现完全降解;此外,净化率随臭气浓度和体积负荷的不断增加呈先增加后降低的趋势。当臭气浓度为24.29 mg/m³即臭气的体积负荷为3 g/（m³·h）时,去除率约为96%;当臭气浓度增至1 345.74 mg/m³即体积负荷增至18 g/（m³·h）,去除率达100%;然而,当臭气浓度增至4 934.38 mg/m³即体积负荷增至66 g/（m³·h）时,去除率降至73.1%。另外,进气温度对净化率也有一定程度影响。当进气温度较低时,净化效率相对较高。     

钢渣掺量对泡沫混凝土砌块性能的影响

泡沫混凝土是一种环保、节能的保温隔热材料,以其优良的保温性能,受到越来越多研究者的关注。对钢渣的特性进行了分析测试,对钢渣不同掺量对泡沫混凝土砌块特性的影响进行了研究,结果表明,采用添加5％～35％钢渣所制备的钢渣泡沫混凝土砌块,其密度等级为JC／T1062—2007中的B10级,掺人5％、15％钢渣的泡沫混凝土抗压强度达到A3．5等级,掺人25％、35％钢渣的泡沫混凝土抗压强度达到A2．5等级。随着钢渣掺量的增大,抗压强度、抗折强度降低,吸水率增大。在同一钢渣掺量的情况下,泡沫混凝土砌块的抗压强度变化率增加显著,而且随着钢渣的加入量升高而增大。钢渣的加入有利于提高泡沫混凝土砌块的后期抗压强度。     

Thermogravimetric analysis and kinetic study on pyrolysis of representative medical waste composition

To obtain detailed information on the pyrolysis characteristics, a thermogravimetric study on the pyrolysis of 14 typical medical waste compositions was carried out in thermogravimetric analysis (TGA) equipment using dynamic techniques in a stream of N(2). An index representing pyrolysis reactivity of waste was presented. Kinetic parameters were obtained by Coats-Redfern method and used to model the TG curve. The results showed that: (a) Plastic, protein, cellulosic material, synthetic fibre, and rubber entered pyrolysis process in succession. (b) There was one decomposition stage in the pyrolysis of one-off medical glove, operating glove, cellulosic waste, absorbable catgut suture and adhesive plaster, while other components had two obvious weight loss stages. (c) The obtained apparent activation energy for second stage pyrolysis was comparably higher than that for first stage. (d) Each stage was controlled by only one kinetic mechanism, in which kinetic parameters were constant. (e) The degradation kinetics of medical waste may be affected by special physical and chemical treatment in the product manufacturing process. (f) Among 13 waste samples, the pyrolysis index of cellulosic matter was the highest, which indicated cellulosic matter had strong pyrolysis reactivity. (g) With increasing heating rate, TG curve and DTG peak shifted to high temperatures and main reaction interval of the sample became longer.     

Geotechnical and leaching properties of flowable fill incorporating waste foundry sand

Waste foundry sand (WFS) can be converted into flowable fill for geotechnical applications. In this study, WFS samples were obtained from 17 independent metal casting facilities with different casting processes, thus representing a good range of WFS properties. The laboratory studies include physical, geotechnical and leaching properties of flowable fills consisting of WFS, cement, and fly ash mixed to different water contents. The main properties measured include WFS physical properties (density, particle gradation, grain shape, and fine content), WFS flowable fill geotechnical properties (unconfined compressive strength, hydraulic conductivity, setting time, and bleeding), and the fill's leaching properties (heavy metals and organics in the bleed water and the leachate extracted from hardened WFS flowable fills). The test results indicate that in terms of the physical properties, most of the data fall within narrow ranges, although data from the copper/aluminum-based WFS samples might fall beyond the ranges. Geotechnical properties of WFS flowable fills in both fresh and hardened phases were verified conforming to the features of specified flowable fills. Material leaching analyses indicate that the toxicity of WFS flowable fills is below regulated criteria. A mix formulation range originated from this study is proposed for the design of WFS made flowable fill.     

二氧化氯对有机染料脱色效果的研究

本文对二氧化氯二两种直接染料和两种活性染料脱色效果的影响因素－ClO2的投加量、染料的初始浓度、pH值、温度以及反应时间等进行了研究。结果表明,在适当的条件下,二氧化氯对这几种有机染料均具有很好的脱色效果。     

Polycyclic aromatic hydrocarbons in surface sediments from drinking water sources of Taihu Lake, China: sources, partitioning and toxicological risk

Sources, partitioning and toxicological risk of 15 priority polycyclic aromatic hydrocarbons (PAHs) in surface sediments from drinking water sources of Taihu Lake, with an area of 2428 km(2) located in the most developed and populated area of China, were studied, and the results were compared with those in other lakes of China and the USA. Concentrations of the 15 PAHs in sediments ranged from 436.6 to 1334.9 ng g(-1) (dw). Gasoline combustion, coal combustion, diesel combustion from shipping and spillage of petroleum were apportioned to be the main sources of PAHs in this area by principal component analysis, which contributed 35.19%, 26.43%, 25.41% and 12.97% to the PAH sources estimated by further multiple linear regression. Levels of PAHs in sediments were negatively correlated with contents of clay and fine silt (<16 μm), while positively with contents of medium silt, coarse silt and sand (>16 μm). Humin with size larger than 16 μm contained the largest part of the burden of PAHs in sediments, but the specific partitioning domain (bound humic acid, lipid or insoluble residue) depended on properties of organic matter reflected by optical absorbance at 465 and 665 nm. Total toxic benzo[a]pyrene equivalent (TEQ(carc)) of the carcinogenic PAHs in sediments varied from 31.8 to 209.3 ngTEQ(carc) g(-1). Benzo[a]pyrene and dibenzo[a,h]anthracene contributed 45.36 and 25.31% to total TEQ(carc), posing high toxicological risk to this area.     

Spatial and seasonal distribution of nitrogen in marsh soils of a typical floodplain wetland in Northeast China

Horizontal and profile distributions of nitrogen in marsh soils in different seasons were studied in a typical site within the Erbaifangzi wetland in Northeast China. Results showed that there was higher spatial heterogeneity for nitrate nitrogen (NO₃^--_{3}^{-}-N) and ammonium nitrogen (NH₄⁺_{4}^{+}–N), as well as available nitrogen (AN), in surface soils in July compared to that in September. Relative to July, the mean nitrogen contents in surface soils were slightly higher in September; however, in November, soils contained significantly lower NO₃^--_{3}^{-}-N and NH₄⁺_{4}^{+}–N, higher AN, organic nitrogen (Org-N), and total nitrogen (TN). Except for mineral nitrogen, no significant differences were observed between Org-N and TN contents in September and November. Nitrogen contents generally declined exponentially with depth along soil profiles in three sampling dates (July, September, and November), except for a significant accumulation peak of NO₃^--_{3}^{-}-N at the 20–30 cm depth in September. However, NH₄⁺_{4}^{+}–N contents showed a vertical alternation of “increasing and decreasing” in both July and September, while nearly kept constant with depth in November. The depth ranking of nitrogen showed the shallowest distribution for AN, followed by Org-N and TN, while deeper distributions for NO₃^--_{3}^{-}-N and NH₄⁺_{4}^{+}–N. TN, Org-N, and AN were significantly correlated with soil organic matter and total phosphorus. Soil pH values were significantly correlated with TN and AN contents in surface soils. Clay contents showed significant correlations with nitrogen contents except for NO₃^--_{3}^{-}-N in surface soils and NH₄⁺_{4}^{+}–N in profile soils. However, soil moisture was not significantly correlated with nitrogen contents among all soil samples.     

Assessment of urban sustainability efficiency based on general data envelopment analysis: a case study of two cities in western and eastern China

Sustainable urban development focuses on enhancing urban well-being, while also balancing the demands of urban social and economic development, natural resource consumption, and environmental pollution. This work used general data envelopment analysis to assess the urban sustainability efficiency (USE) and sustainability potential (SP) in Lanzhou and Xiamen, two cities that are characteristic of urban areas in western and eastern China. The assessment indicator system included important natural and urban welfare factors as input and output indices, respectively. The results showed that overall urban sustainability efficiency increased in Lanzhou and Xiamen from 1985 to 2010, but that the sustainability of natural resources clearly decreased. The urban sustainability efficiency of Xiamen was higher than that of Lanzhou, and the sustainability potential of Xiamen was lower than that of Lanzhou; this indicates that Xiamen performed better in terms of urban sustainable development. The urban sustainability efficiency in Xiamen has increased with increasing urban population, and the rate and scale of economic development have been higher than in Lanzhou. The assessment and analysis performed in this study show that cities with different natural resources and development characteristics have different forms, patterns, and trajectories of sustainable development.