Soil and vegetation carbon stocks in Brazilian Western Amazonia: relationships and ecological implications for natural landscapes

The relationships between soils attributes, soil carbon stocks and vegetation carbon stocks are poorly know in Amazonia, even at regional scale. In this paper, we used the large and reliable soil database from Western Amazonia obtained from the RADAMBRASIL project and recent estimates of vegetation biomass to investigate some environmental relationships, quantifying C stocks of intact ecosystem in Western Amazonia. The results allowed separating the western Amazonia into 6 sectors, called pedo-zones: Roraima, Rio Negro Basin, Tertiary Plateaux of the Amazon, Javari-Juruá-Purus lowland, Acre Basin and Rondonia uplands. The highest C stock for the whole soil is observed in the Acre and in the Rio Negro sectors. In the former, this is due to the high nutrient status and high clay activity, whereas in the latter, it is attributed to a downward carbon movement attributed to widespread podzolization and arenization, forming spodic horizons. The youthful nature of shallow soils of the Javari-Juruá-Purus lowlands, associated with high Al, results in a high phytomass C/soil C ratio. A similar trend was observed for the shallow soils from the Roraima and Rondonia highlands. A consistent east–west decline in biomass carbon in the Rio Negro Basin sector is associated with increasing rainfall and higher sand amounts. It is related to lesser C protection and greater C loss of sandy soils, subjected to active chemical leaching and widespread podzolization. Also, these soils possess lower cation exchangeable capacity and lower water retention capacity. Zones where deeply weathered Latosols dominate have a overall pattern of high C sequestration, and greater than the shallower soils from the upper Amazon, west of Madeira and Negro rivers. This was attributed to deeper incorporation of carbon in these clayey and highly pedo-bioturbated soils. The results highlight the urgent need for refining soil data at an appropriate scale for C stocks calculations purposes in Amazonia. There is a risk of misinterpreting C stocks in Amazonia when such great pedological variability is not taken into account.     

星形大分子液晶在气相色谱分析中的应用研究

将首次合成的偶氮苯硅氧烷类星形液晶大分子化合物用于毛细管柱气相色谱固定液 ,在其相转变温度附近具有良好的选择性 ,成功地分离了二甲酚异构体。     

秸秆焚烧对北京市空气质量的影响

用火焰原子吸收光谱法测试了北京市两个采样点 1 #站 (十三陵站 ,清洁对照点 )和 5#站 (天坛站 ,居民生活区 )1 1 0个大气颗粒物样品中的水溶性钾 ,以表征秸秆焚烧颗粒物。 1 #站水溶性钾的质量浓度年均值为 1 .2 1 μg/m3,其中以1 998年 6月份浓度 (3 .0 7μg/m3)最高 ,是 5月份 (1 .0 2μg/m3)的 3倍 ;5#站水溶性钾的质量浓度年均值为 1 .94μg/m3,6月份 (4 .2 2 μg/m3)最高 ,是 5月份 (1 .97μg/m3)的 2 .1倍。数据分析结果表明 1 998年 6月份麦收季节存在以秸秆焚烧为主的生物质燃烧现象 ,使大气颗粒物中有机碳浓度水平升高 ,并对北京市的空气质量带来负面影响     

The Need for Scale Sensitive Approaches in Spatially Explicit Land Use Change Modeling

This paper introduces some of the issues that are relevant to the spatially explicit modeling of land use systems. A short overview is given of the ways and means in which a number of different land use change models describe the land use system. Specific attention is given to the empirical modeling approach used in the CLUE (Conversion of Land Use and its Effects) modeling framework. This approach is demonstrated for three case studies in China, Ecuador and the Atlantic Zone of Costa Rica. These case-studies illustrate the methodology for multi-scale analysis of land use driving factors and their application in spatially explicit modeling exercises. Model functioning, performance and limitations are discussed. The presented case-studies indicate that empirical modeling results can contribute to a better theoretic imbedding of land use change research in scale sensitive and integrated theories.     

Principal response curves technique for the analysis of multivariate biomonitoring time series

Although chemical and biological monitoring is often used to evaluate the quality of surface waters for regulatory purposes and/or to evaluate environmental status and trends, the resulting biological and chemical data sets are large and difficult to evaluate. Multivariate techniques have long been used to analyse complex data sets. This paper discusses the methods currently in use and introduces the principal response curves method, which overcomes the problem of cluttered graphical results representation that is a great drawback of most conventional methods. To illustrate this, two example data sets are analysed using two ordination techniques, principal component analysis and principal response curves. Whereas PCA results in a difficult-to-interpret diagram, principal response curves related methods are able to show changes in community composition in a diagram that is easy to read. The principal response curves method is used to show trends over time with an internal reference (overall mean or reference year) or external reference (e.g. preferred water quality or reference site). Advantages and disadvantages of both methods are discussed and illustrated.     

Selection and application of a rainbow trout toxicity testing procedure for screening Sacramento River Watershed, California samples

A number of procedures have been developed to assess toxic effects on the early life stages of salmonid fish. In this study 13 rainbow trout embryo development relatively short-term (7 to 90 day) procedures were reviewed. Three 7-day methods from the published literature and three modifications developed at AQUA-Science (A-S) were evaluated in the laboratory. Based on that evaluation, A-S methods were selected for screening surface water samples (A-S 1) collected in the Sacramento River watershed (California) and for conducting toxicity identification evaluations (TIE) to identify cause(s) of toxicity. Test control performance, test sensitivity, and reference toxicant response variability in the A-S 1 were superior to those in commonly used freshwater toxicity testing methods. The incidence of Sacramento River watershed samples resulting in a notable decrease in embryo development was very low. Of 260 samples screened only 16 (6%) resulted in statistically significant inhibition of embryo development. Of the 16 toxic samples, nine caused minimal (less than 20% abnormal development) and four marginal (less than 30%) toxicity. Samples collected from the agriculture-dominated Colusa Basin Drain and rangeland/forest-dominated Battle Creek on June 16, 2005 caused significant toxicity. TIE procedures indicated that cationic chemicals were the primary cause of toxicity. Metals analysis did not reveal concentrations sufficient to inhibit embryo development, so the most probable cause of toxicity in the two samples was cationic chemicals (perhaps surfactants?) or metals that were not included in the analytical screening.     

Risk assessment of trihalomethanes from tap water in Fortaleza, Brazil

The cancer risks (CR) by oral ingestion, dermal absorption, and inhalation exposure of trihalomethanes (THM) from tap water of ten districts in Fortaleza, Brazil were estimated. The mean levels of THM compounds were obtained in Fortaleza tap water as follow: 63.9 microg L(-1) for chloroform (CHCl(3)), 40.0 microg L(-1) for bromodichloromethane (CHBrCl(2)), and 15.6 microg L(-1) for dibromochloromethane (CHBr(2)Cl). Bromoform (CHBr(3)) was not detected. The mean CR for THMs in tap water is 3.96 x 10(-4). The results indicate that Fortaleza residents have a higher CR by inhalation than dermal absorption and oral ingestion. The CR for CHCl(3) contributes with 68% as compared with the total CR, followed by CHBrCl(2) (21%), and CHBr(2)Cl (11%). The hazard index (HI) is about ten times lower than unity, not indicating non-cancer effects.     

Organic speciation of atmospheric particles in Alvão Natural Park (Portugal)

PM₁₀ continental rural background aerosols were collected during a summer field campaign (August–September 2006) at Lamas de Ôlo in the upper zone of the Alvão Natural Park, a mountain region of northern Portugal. In addition to the determination of the carbonaceous content by a thermal–optical method, the organic speciation of aerosols was performed by gas chromatography–mass spectrometry in an effort to evaluate photo-oxidation products of biogenic volatile organic compounds and other markers for source characterization. The detailed analysis revealed relatively high concentrations of polyols and short-chain dicarboxylic, tricarboxylic, hydroxycarboxylic, and oxocarboxylic acids, many of which are thought to be indicators of secondary aerosol formation, accounting for about 70% of global chromatographically resolved mass. Major photo-oxidation products of α- and β-pinene have been detected. The tracers for the photo-oxidation of isoprene comprise two diastereoisomeric 2-methyltetrols, C₅-alkene triols, and 2-methylglyceric acid, which have only recently been elucidated. In addition, the occurrence of levoglucosan and other biomass combustion tracers indicates that the site was affected by wildfires. This source contributed to more than 80% of the organic carbon mass during a period of strong forest fire influence.     

Closed cycle construction: an integrated process for the separation and reuse of C&D waste

In The Netherlands, construction and demolition (C&D) waste is already to a large extent being reused, especially the stony fraction, which is crushed and reused as a road base material. In order to increase the percentage of reuse of the total C&D waste flow to even higher levels, a new concept has been developed. In this concept, called 'Closed Cycle Construction', the processed materials are being reused at a higher quality level and the quantity of waste that has to be disposed of is minimised. For concrete and masonry, the new concept implies that the material cycle will be completely closed, and the original constituents (clay bricks, gravel, sand, cement stone) are recovered in thermal processes. The mixed C&D waste streams are separated and decontaminated. For this purpose several dry separation techniques are being developed. The quality of the stony fraction is improved so much, that this fraction can be reused as an aggregate in concrete. The new concept has several benefits from a sustainability point of view, namely less energy consumption, less carbon dioxide emission, less waste production and less land use (for excavation and disposal sites). One of the most remarkable benefits of the new concept is that the thermal process steps are fuelled with the combustible fraction of the C&D waste itself. Economically the new process is more or less comparable with the current way of processing C&D waste. On the basis of the positive results of a feasibility study, currently a pilot and demonstration project is being carried out. The aim is to optimise the different process steps of the Closed Cycle Construction process on a laboratory scale, and then to verify them on a large scale. The results of the project are promising, so far.