基于我国规范与PIARC标准的公路隧道需风量分析

以某长大高速公路隧道为例,结合我国隧道通风设计规范JTJ026.1-1999与PIARC2007标准(世界道路协会),针对不同行车速度,不同车辆更新情况、不同排放标准组合形式以及是否考虑NOx等情况,对各个不同工况的需风量分别进行计算,并从需风量计算方法、机动车排放量和污染物设计浓度三个方面对隧道需风量差异进行分析。研究结果表明:我国设计规范与PIARC2007存在较大差距,为了适应当前及今后我国交通量及机动车排放特点的发展趋势,我国现行规范应在机动车排放量、污染物设计浓度限值等方面做出必要改进以达到合理确定隧道需风量的目的。     

钢渣处理技术的环境性能比较

随着钢铁工业的快速发展,大量钢渣弃置堆积,不仅成为环境污染源,而且占用大量的土地。目前钢渣处理技术较多,其中主要的处理方法有冷弃法、热闷法、热泼法、浅盘法、水淬法、风淬法等。本研究采用生命周期评价方法,对主要钢渣处理技术进行评估,定义了生命周期评估边界和清单指标,建立了清单计算模型,得到了不同钢渣处理技术的生命周期清单。为了提高结果的可信性,对模型进行了不确定性分析。结果表明滚筒法和风淬法的环境性能较好,是值得推广的钢渣处理技术。     

Modeling assessment for ammonium nitrogen recovery from wastewater by chemical precipitation

Chemical precipitation to form magnesium ammonium phosphate (MAP) is an effective technology for recovering ammonium nitrogen (NH4 +-N). In the present research, we investigated the thermodynamic modeling of the PHREEQC program for NH4 +-N recovery to evaluate the effect of reaction factors on MAP precipitation. The case study of NH4 +-N recovery from coking wastewater was conducted to provide a comparison. Response surface methodology (RSM) was applied to assist in understanding the relative significance of reaction factors and the interactive effects of solution conditions. Thermodynamic modeling indicated that the saturation index (SI) of MAP followed a polynomial function of pH. The SI of MAP increased logarithmically with the Mg2+/NH4 + molar ratio (Mg/N) and the initial NH4 +-N concentration (CN), respectively, while it decreased with an increase in Ca2+/NH4 + and CO3 2??/NH4 + molar ratios (Ca/N and CO3 2??/N), respectively. The trends for NH4 +-N removal at different pH and Mg/N levels were similar to the thermodynamic modeling predictions. The RSM analysis indicated that the factors including pH, Mg/N, CN, Ca/N, (Mg/N) (CO3 2??/N), (pH)2, (Mg/N)2, and (CN)2 were significant. Response surface plots were useful for understanding the interaction effects on NH4 +-N recovery.     

改性灰岩除氟的实验研究

采用改性灰岩作为除氟材料,通过批实验和柱实验,考察不同条件下的除氟效果,并探讨了其实际应用的可能性。结果表明:FeCl3溶液联合灰岩除氟,可使高氟水中的氟浓度达到国家饮用水标准,在含氟水样中加灰岩后,直接加FeCl3会促进灰岩对氟的去除效率。在氟离子浓度为5 mg/L,粒径0.2～0.5 mm的灰岩为1 g的条件下,铁离子含量为0.016 mmol/L时,即可达到去除的最佳效果,除氟率可达95.74%。柱实验说明在FeCl3溶液浓度一定时,除氟率随着总出水量的增加而提高;填充的灰岩总量不变时,随着FeCl3溶液浓度的增加,除氟效果明显增加,说明本实验具有实际应用的可能性。     

进一步探讨内蒙古自治区环境突发性污染事件应急监测工作

随着内蒙古经济社会的快速发展,环境突发性事件应急监测存在一些新问题,根据内蒙古实际情况,探讨环境突发性污染事件应急监测工作思路,进一步保护环境和人类生命安全。     

进一步探讨内蒙古自治区环境突发性污染事件应急监测工作

随着内蒙古经济社会的快速发展,环境突发性事件应急监测存在一些新问题,根据内蒙古实际情况,探讨环境突发性污染事件应急监测工作思路,进一步保护环境和人类生命安全。     

承德市室内环境质量污染现状调查与研究

对承德市160家宾馆、饭店、歌舞厅等公共场所,80个民用建筑工程项目,80余家个人家庭装修进行室内环境检测,发现不同场所室内主要超标污染物不同,新建公共场所主要超标污染物为挥发性有机物、甲醛;已建成的重点公共场所空气超标污染物主要为茵落总数和CO2;民用建筑工程超标污染物主要为氨、甲醛;个人家装超标污染物主要为总挥发性有机物,甲醛。     

Reduction and characterization of bioaerosols in a wastewater treatment station via ventilation

Bioaerosols from wastewater treatment processes are a significant subgroup of atmospheric aerosols. In the present study,airborne microorganisms generated from a wastewater treatment station(WWTS) that uses an oxidation ditch process were diminished by ventilation.Conventional sampling and detection methods combined with cloning/sequencing techniques were applied to determine the groups,concentrations,size distributions,and species diversity of airborne microorganisms before and after ventilation. There were 3021 ± 537 CFU/m3 of airborne bacteria and 926 ± 132 CFU/m3 of airborne fungi present in the WWTS bioaerosol.Results showed that the ventilation reduced airborne microorganisms significantly compared to the air in the WWTS. Over 60% of airborne bacteria and airborne fungi could be reduced after4 hr of air exchange. The highest removal(92.1% for airborne bacteria and 89.1% for fungi) was achieved for 0.65–1.1 μm sized particles. The bioaerosol particles over 4.7 μm were also reduced effectively. Large particles tended to be lost by gravitational settling and small particles were generally carried away,which led to the relatively easy reduction of bioaerosol particles0.65–1.1 μm and over 4.7 μm in size. An obvious variation occurred in the structure of the bacterial communities when ventilation was applied to control the airborne microorganisms in enclosed spaces.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

黄石市典型农业土壤中重金属污染水平及评价

以黄石市阳新县某大型农场作为研究区,于2012年2月采集8个代表性表层(0~20 cm)土壤样品,采用火焰-原子吸收分光光度法分析了各重金属元素(Cu、Pb、Zn、Cd、Mn、Co)的总量及BCR连续提取法提取土壤中重金属的弱酸态、可还原态、可氧化态和残渣态含量。结果显示,Cu、Pb、Zn、Cd、Mn和Co总量的平均值分别为122.10、141.29、335.53、2.18、2 606.58和128.27 mg/kg,其中Cd超过了土壤环境三级标准限值,Mn具有最强的变异系数,受到外来污染因素的影响最大。通过地积累指数法和潜在生态危害法表明,6种重金属累积程度由高到低依次为CdCoCuPbZnMn,且Cd、Mn为主要生态风险因子。同时由形态分析可知,Cu、Pb、Cd、Zn、Mn和Co的化学形态分布均以残渣态为主,说明该农场土壤中重金属元素比较稳定,不易迁移转化,对生物的毒性较小。