磷酸根对水稻土中重金属镉汞铅吸附特性的影响研究

以合肥市郊的大兴镇和义城镇地区水稻土为主要研究对象,利用批量平衡法初步研究了重金属在两种土壤中的吸附热力学,据此分析研究水稻土对重金属的吸附性能及机理.在施磷情况下两种水稻土对三种重金属Cd,Hg,Pb吸附自由能均为负值,是常温常压下可以自发进行的过程,是物理和化学吸附并存的过程.两种水稻土对三种重金属Cd,Hg,Pb吸附过程均是熵增过程.     

浅谈液化气钢瓶(罐)灭火抢险技术

介绍了液化石油气的性质、火灾特点以及液化石油气钢瓶、液化石油气储罐的灭火抢险技术。     

井喷点火后对周边井和集气站的影响研究

以实际工程项目为例,利用计算流体动力学软件（CFD）,以3种不同压力、外界风速和2种出口直径为边界条件,分别对井喷情况下的流场分布进行了18组数值模拟计算,并对模拟结果及其对周边设施的影响进行了分析。数值模拟结果表明,在压力为10MPa,出口直径为62mm,风速为1m／s时,井喷后气流的出口速度超过400m／s,而火焰表面温度超过1500K,喷射火对周边建筑物的伤害范围超过65m,对周边的设备与建筑造成毁坏;超过104m才不会有明显伤害。     

常减压装置自燃危险分析及对策

通过对常减压装置内介质温度和自燃点的比较分析,绘制装置自燃危险分析图,确定自燃危险的重点防护区,并提出对策措施。     

一起工艺串料事故的故障树分析

受各种因素的影响,在炼化企业生产过程中发生工艺串料事故也屡见不鲜。某年3月,某炼厂成品车间在一特种油品通过机泵灌装汽车槽车的过程中发生工艺串料事故。现运用故障树分析的方法进行原因分析与对策措施研究。     

改性兰炭末对硝基苯生产废水的吸附处理

采用H_2O_2溶液对兰炭末进行改性,并将改性后的兰炭末用于硝基苯生产废水(COD为560 mg/L)的吸附处理。对改性前后的兰炭末进行了表征,考察了吸附效果的影响因素,并对吸附前后改性兰炭末的燃烧热进行了测定。表征结果显示,兰炭末经改性后比表面积和孔径均增大。实验结果表明:在改性兰炭末投加量为0.2 g/m L、吸附时间为180 min、吸附温度为30℃的条件下,废水的COD去除率为93.4%,处理出水达到GB 8978—1996《污水综合排放标准》中规定的排放标准;改性兰炭末对废水中COD的吸附过程符合准二级动力学方程和Freundlich等温吸附模型;吸附后的改性兰炭末燃烧热值增大。     

电镀污泥脱水稳定剂制备及应用研究

针对电镀污泥脱水过程中金属离子大量溶出带来的处理难题,以四甲基乙二胺、二硫化碳为主要原料,以氢氧化钾为引发剂,采用聚合法制备了一种脱水稳定剂,并考察了稳定剂投加量、污泥pH值、反应温度和反应时间对电镀污泥离心脱水时重金属溶出的影响。结果表明,在稳定剂投加量(稳定剂与污泥的质量比)为1%、反应温度为20℃、pH=1、反应时间为30 min、转速为3 000 r/min条件下对含Ni(Ⅱ)电镀污泥离心脱水后,Ni(Ⅱ)脱水稳定率达96.88%,且脱水稳定剂对混合电镀污泥中Ni(Ⅱ)、Cu(Ⅱ)的选择性大于Zn(Ⅱ)。脱水稳定剂的脱水稳定机理是其中的二硫代氨基甲酸盐与重金属离子M(Ⅱ)(Ni(Ⅱ)、Cu(Ⅱ)、Zn(Ⅱ)等)形成配位键,从而形成稳定的交联网状结构,达到化学稳定,实现了离心脱水极少重金属离子溶出(即脱水稳定)的效果。所合成的脱水稳定剂可广泛用于含镍、铜、锌等金属离子的电镀污泥脱水处理。     

SAFUIT/UF6环境评价模型验证与应用

作为核燃料循环过程中一种兼具辐射危害和化学毒性的中间产物,UF6的泄漏事故,特别是事故的环境评价技术越来越受到人们的重视.SAFUIT/UF6是专门针对此类事故的环境评价模型,目前已经开展了初步的验证工作.根据1987年法国UF6释放实验条件,对SAFUIT/UF6模型计算结果进行了误差分析,并与HG-SYSTEM/UF6模型进行了对比.初步认为SAFUIT/UF6模型可准确地模拟UF6扩散.此外,SAFUIT/UF6模型在某设施核事故应急评价系统中也得到了应用.     

Highlights and new Editorial Advisory Board members of the Journal of Environmental Sciences

正The Journal of Environmental Sciences(JES)is honored to welcome Professors/Drs William A.Mitch,Jiuhui Qu,Susan D.Richardson,Jerald L.Schnoor,Hongxiao Tang,Shu Tao,and Hugh A.Tilson to serve on the Editorial Advisory Board(EAB).Their tremendous experience in scientific publications,leading expertise in topic areas pertinent to JES,diverse international networks/perspectives,and exemplary dedication to scientific excellence will guide and help the continuing healthy growth of JES.     

A new process to improve short-chain fatty acids and bio-methane generation from waste activated sludge

As an important intermediate product, short-chain fatty acids(SCFAs) can be generated after hydrolysis and acidification from waste activated sludge, and then can be transformed to methane during anaerobic digestion process. In order to obtain more SCFA and methane,most studies in literatures were centered on enhancing the hydrolysis of sludge anaerobic digestion which was proved as un-efficient. Though the alkaline pretreatment in our previous study increased both the hydrolysis and acidification processes, it had a vast chemical cost which was considered uneconomical. In this paper, a low energy consumption pretreatment method, i.e. enhanced the whole three stages of the anaerobic fermentation processes at the same time, was reported, by which hydrolysis and acidification were both enhanced, and the SCFA and methane generation can be significantly improved with a small quantity of chemical input. Firstly, the effect of different pretreated temperatures and pretreatment time on sludge hydrolyzation was compared. It was found that sludge pretreated at 100°C for 60 min can achieve the maximal hydrolyzation. Further, effects of different initial p Hs on acidification of the thermal pretreated sludge were investigated and the highest SCFA was observed at initial p H 9.0with fermentation time of 6 d, the production of which was 348.63 mg COD/g VSS(6.8 times higher than the blank test) and the acetic acid was dominant acid. Then, the mechanisms for this new pretreatment significantly improving SCFA production were discussed. Finally,the effect of this low energy consumption pretreatment on methane generation was investigated.