非烟气工况下常规烟塔与改造烟塔内部结构的比较

根据流体力学理论,基于Fluent6.3.26计算平台,对常规冷却塔和改造后的排烟冷却塔进行了三维内部流场的模拟。分析非烟气工况下,两塔内部烟道布置对气流的影响,为进一步研究在工况条件下烟气、水蒸气塔内扰流与湿热蒸汽抬升作用提供理论基础。验证了改造烟塔内部烟道布置的优越性,对排烟冷却塔结构优化有一定的指导意义。     

浅海跃层底质对水下声的影响研究

本文针对海底底质对水下噪声传播具有显著影响的现象,选取典型负梯度温度跃层,加载三个典型海底底质,即细砂底质、粉砂底质及黏土-粉砂底质,声波参数为固定值。试验定性分析了浅海海底底质对水下声传播的影响,仿真计算了海底底质对声传播的影响,比较分析了不同底质条件下声波的衰减差异,总结了不同底质对水下声传播影响的特点,并同行参考。     

三峡库区典型退耕还林模式土壤养分流失控制

选择三峡库区典型退耕还林模式,包括园地(茶园)及林地(板栗)与原有坡耕地对照,观测并分析其土壤养分(氮磷)输出途径及数量情况,以评估实施退耕还林工程对流域土壤养分输出的影响.结果表明:1退耕后土壤养分氮磷年流失量(包括随泥沙和地表径流流失的量)减少;总氮(TN)年输出量从大到小依次为坡耕地(2 444.27 g·hm-2)茶园地(998.70g·hm-2)板栗林地(532.61 g·hm-2);总磷(TP)为坡耕地(1 690.48 g·hm-2)茶园地(488.06 g·hm-2)板栗林地(129.00 g·hm-2);与坡耕地比较,退耕还林模式(园地、林地)总氮、总磷年输出载荷分别减少了68.68%和81.75%.2茶园地、板栗林地与坡耕地相比,土壤养分速效态氮流失量明显减少,硝态氮(NO-3-N)输出总量依次为坡耕地(113.79g·hm-2)茶园地(73.75 g·hm-2)板栗林地(56.06 g·hm-2);铵态氮(NH+4-N)养分输出次序为茶园最大(69.34 g·hm-2),坡耕地次之(52.45 g·hm-2),板栗林地最小(47.23 g·hm-2).3硝态氮、铵态氮主要通过地表径流输出,所占总量比例分别为91.4%和92.2%;总氮和总磷主要通过泥沙输出,所占总量比例分别为86.6%和98.4%.通过退耕还林等措施,该地区地表径流以及土壤侵蚀输出明显减少,土壤养分流失得到有效控制.     

蜈蚣草中芘与砷的赋存特征及其相互作用

超富集植物蜈蚣草能够累积土壤环境中的砷,为探明蜈蚣草植株中芘的赋存特征及其与砷的相互作用,采用双光子激光共聚焦扫描显微技术检测观察芘在该植物中赋存和分布规律.结果表明,添加芘导致蜈蚣草各部位砷含量显著降低,其中叶部和茎部砷含量下降幅度达35%左右,根部砷含量减少20.5%.芘的添加使得植物各部位三价砷比例下降,五价砷比例升高,蜈蚣草叶部三价砷和五价砷赋存浓度下降幅度最大,下降幅度分别为42.2%和32.49%.添加砷可促进蜈蚣草根部和茎部中芘的积累,每株分别增加了9.8μg和139 ng,但对叶部中芘的积累无显著影响.芘主要分布于蜈蚣草细胞膜与细胞内部的细胞器膜结构及细胞核核膜附近,但细胞质中芘的含量较少,茎部韧皮部与皮层以及叶部栅栏组织和海绵组织中几乎没有检测到芘.     

光助芬顿反应催化降解气体中甲苯

以甲苯作为挥发性有机污染物(VOCs)的代表,利用连续进气动态实验装置,研究光助芬顿反应降解气体中甲苯的作用.考察了芬顿试剂溶液初始p H、H2O2浓度、Fe2+浓度以及甲苯初始浓度对降解甲苯的影响,并利用在线质谱和色谱对产物进行了定性、定量分析.结果表明,紫外光照加快了羟基自由基的生成,显著提高了气体中甲苯的去除率;p H=3.0、H2O2浓度为20 mmol·L-1、Fe2+浓度为0.3 mmol·L-1的条件下,甲苯去除率最高;当甲苯初始浓度为260 mg·m-3时,去除率能够达到98%;光助芬顿反应催化降解气体中甲苯实验未检测到CO2之外的中间产物,CO2产率分析表明去除的甲苯全部转化为CO2.     

好氧/除磷颗粒对亚硝化颗粒污泥启动的影响

在室温下,采用R1、R2、R3三组相同的SBR反应器接种污水厂回流污泥,比较了添加好氧颗粒、除磷颗粒对亚硝化颗粒污泥启动及稳定运行的影响.结果表明,在S1(0~22 d)阶段,R1、R2、R3均用了19 d启动亚硝化.在S2阶段(23~56d),R1不添加颗粒污泥,R2、R3分别添加20%好氧颗粒和20%除磷颗粒诱导亚硝化絮状污泥颗粒化,R1、R2和R3分别在76、42 d和56 d平均粒径达到412、468、400μm,均成功实现颗粒化.在S3阶段(57~108 d),进水氨氮负荷和COD负荷分别由0.4 kg·(m~3·d)~(-1)提高到0.5 kg·(m~3·d)~(-1)和0.2 kg·(m~3·d)~(-1)提高到0.5 kg·(m~3·d)~(-1),R1、R2反应器中颗粒粒径增加明显,但R3发生了污泥膨胀.在运行末期(108 d),R1和R2的平均粒径分别达到689μm和893μm.接种好氧颗粒和除磷颗粒均能快速实现亚硝化污泥的颗粒化,并且接种好氧颗粒的亚硝化颗粒污泥系统能适应较高C/N比进水,耐冲击负荷,能长期稳定运行.     

电磁波加载回流污泥对A2O厌氧池功能的影响

基于电磁波加载污泥的生物效应和溶出效应,将A²O系统的回流污泥进行电磁波加载,以期从微生物群落结构变化角度考察其对系统中厌氧池功能的影响.结果表明,电磁波加载回流污泥后,污泥絮体分解,细胞破壁;回流污泥中C、N、P的溶出效应显著.与加载前对比,厌氧池中TP富集效果更明显,富集率由122.9%增至152.2%;TN、COD去除率分别由7.3%、58.8%上升为32.1%和65.4%.MiSeq焦磷酸测序分析表明,回流污泥经电磁波加载后,厌氧池微生物群落的丰度增加,但其微生物多样性降低.碳源得到补充,厌氧池中微生物的代谢活性明显提高,活菌数量增加.厌氧池中富集了Zoogloea、Tolumonas、Dechloromonas等菌属.     

Glass fiber supported BiOI thin-film fixed-bed photocatalytic reactor for water decontamination under solar light irradiation

BiOI powder has been proved to be an efficient photocatalyst, but the difficulty in removing it from water after reaction limits its application in real water treatment. To solve this problem,a thin-film fixed-bed reactor(TFFBR) was set-up by developing a BiOI thin film on glass fiber cloth(GFC). The composition and structure of the as-prepared films were characterized with X-ray diffraction, X-ray photoelectron spectroscopy, field emission microscopy, transmission electron microscopy and Fourier transform infrared spectroscopy. The BiOI thin film was made by painting a silica sol containing BiOI on GFC, which could be tailored to desired sizes to accommodate the TFFBR. The mass of BiOI on the GFC increased with the number of iterations of the painting process. SiO2 sol glued the BiOI particles tightly onto the GFC,making the thin film strong enough to resist fluid flushing in the TFFBR. The photocatalytic activity of the BiOI thin film was investigated by degrading bisphenol A(BPA) under simulated sunlight. Ninety eight percent of BPA(20 mg/L in 2 L) was degraded by the BiOI thin film sample of seven layers(GFC-7) on the TFFBR within 8 hr irradiation. The GFC-7 displayed good photocatalytic ability toward artificial sewage containing BPA in a wide pH range(5–9),and also demonstrated excellent durability and reusability. The working conditions were optimized and it was found that the thickness of the fluid film and residence time over the thin film were key factors affecting the photocatalytic efficiency.     

Development of a model to simulate soil heavy metals lateral migration quantity based on SWAT in Huanjiang watershed, China

Lateral transportation of soil heavy metals in rainfall events could significantly increase the scope of pollution. Therefore, it is necessary to develop a model with high accuracy to simulate the migration quantity of heavy metals. A model for heavy metal migration simulation was developed based on the SWAT(Soil and Water Assessment Tool) model. This model took into consideration the influence of soil p H value, soil particle size, runoff volume, sediment amount,concentration of water-soluble heavy metals dissolved in runoff and insoluble absorbed to the soil particles. This model was reasonable in Huanjiang watershed, Guangxi Zhuang Autonomous Region, south China, covering an area of 273 km~2. The optimal drainage area threshold was determined by analyzing the effects of watershed subdivision on the simulation results to ensure the simulation accuracy. The main conclusions of this paper were:(1) watershed subdivision could affect simulation migration quantity of heavy metals;(2) the quantity of heavy metals transported by sediment accounted for 97%–99% of the total migration quantity in the study watershed. Therefore, sediment played the most important role in heavy metal migration;(3) the optimal drainage area threshold percentage to ensure high simulation accuracy was determined to be 2.01% of the total watershed;(4) with the optimal threshold percentage, this model could simulate the migration quantity of As, Pb and Cd accurately at the total watershed and subwatershed level. The results of this paper were useful for identifying the key regions with heavy metal migration.     

Highly catalytic activity of Mn/SBA-15 catalysts for toluene combustion improved by adjusting the morphology of supports

Rod-like, hexagonal and fiber-like SBA-15 mesoporous silicas were synthesized to support MnO_x for toluene oxidation. This study showed that the morphology of the supports greatly influenced the catalytic activity in toluene oxidation. MnO_x supported on rod-like SBA-15(R-SBA-15) displayed the best catalytic activity and the conversion at 230°C reached more than 90%, which was higher than the other two catalysts. MnO_x species consisted of coexisting MnO_2 and Mn_2O_3 on the three kinds of SBA-15 samples. Large amounts of Mn_2O_3 species were formed on the surface and high oxygen mobility was obtained on MnO_x supported on R-SBA-15, according to the H_2 temperature programmed reduction(H_2-TPR)and X-ray photoelectron spectroscopy(XPS) results. The Mn/R-SBA-15 catalyst with greater amounts of Mn_2O_3 species possessed a large amount of surface lattice oxygen, which accelerated the catalytic reaction rate. Therefore, the surface lattice oxygen and high oxygen mobility were critical factors on the catalytic activity of the Mn/R-SBA-15 catalyst.